Whirlpool WFW9151YW Support Question
Whirlpool WFW9151YW Support Question
Find answers below for this question about Whirlpool WFW9151YW.Need a Whirlpool WFW9151YW manual? We have 4 online manuals for this item!
Question posted by theinGer on August 11th, 2014
Whirlpool Washer Wfw9151yw How To Attach Pedestal
The person who posted this question about this Whirlpool product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Whirlpool WFW9151YW Manual Pages
Energy Guide - Page 1
Clothes Washer Capacity: Standard
Whirlpool Corporation Models: WFW9151Y*, WFW9351Y*
Cat. Government
Federal law prohibits removal of
$1.218 per kWh and natural gas cost of this label before consumer purchase. H1WB6A2B(...
Installation Guide - Page 2
... hypro-blue steel couplings (2 pack)
Available Accessories: An optional matching pedestal is available for installation are in the washer basket. To order, please
refer to toll-free numbers on model.)
Flashlight 2
... page of your washer. Beaded tie strap
Drain hose
Drain hose form and hose clamp
Optional tools:
Transport bolt hole plugs (Quantity will need:
Laundry tub or standpipe taller...
Installation Guide - Page 3
... kgs). n A level floor with foam backing is not recommended. n Hot and cold water faucets located within 6 ft (1.8 m) of power cord on back of washer to 120° F (49° C). Add spacing of 1" (25 mm) on pedestal):
51/4"
(133 mm)
3" (76 mm)
24 in low temperatures.
IMPORTANT: Do not install, store, or operate...
Installation Guide - Page 4
... an overhead sewer and need . Top of washer. (Additional hoses may be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Minimum siphon break height: 28" ...mm)
4" (102 mm)
See requirements for a standpipe drain: 2" (51 mm). See "Alternative Parts". Laundry tub drain system
1" (25 mm)
1" (25 mm)
DRAIN SYSTEM
Drain system can be purchased separately....
Installation Guide - Page 6
... included with pliers and slide over end of hole. Pull bolts and plastic spacers from
washer
6. Attach drain hose to center of drain hose. NOTE: If washer is to back of washer to allow free access to be transported.
4. For a laundry tub or standpipe drain, go to avoid suspension and structural damage.
6
Squeeze hose clamp...
Installation Guide - Page 7
Screw on coupling by hand until it is seated on valve when attaching to the washer.
7 Repeat this step with flat washers (B) (not provided).
IMPORTANT: Only 41/2" (113 mm) of particles in the water lines. do not force excess hose into a laundry tub, drainpipe, or bucket, to get rid of drain hose should be used...
Installation Guide - Page 8
... reduce risk of the drain hose into drainpipe or standpipe.
8 Turn faucets on top edges of washer
place level here
Attach hot water hose to laundry tub leg, drain standpipe, or inlet hoses for leaks.
NOTE: Installing washer on floor. n Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are firmly...
Installation Guide - Page 9
... -end or adjustable wrench to turn jam nuts clockwise on leveling feet tightly against washer cabinet. q Check that both hot and cold hoses are attached and water faucets are now installed. q Check for a medium-size load.
9 q Read "Using Your Washer" in contact with the floor, use a 9/16" or 14 mm open -end or...
Warranty Information - Page 1
... Phone number Model number Serial number Purchase date
22 WHIRLPOOL CORPORATION LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter "Whirlpool") will need repair service, first see the...
Use & Care Guide - Page 4
... are available on all models.
1
2
3
5
6
4
9
8
7
Model WFW9351**
1
2
3
9 10
5
4
8
6
Model WFW9151**
C
D A
B
1 POWER BUTTON Press to turn the washer on and off .
4 If you do not press START/PAUSE within 5 minutes of cycles that best suit your laundry load. Press to stop/cancel a cycle at any time.
2 WASH CYCLE KNOB Turn the Wash Cycle...
Use & Care Guide - Page 5
... cycles include which options. This option provides periodic tumbling for information on the washer.
A Release lever Press down to select more damp. This compartment cannot dilute... softener compartment Automatically dilutes and dispenses liquid fabric softener at any time to unload your laundry. See "Cycle Status Indicators" for the Whitest Whites cycle.
Delay Start Use this ...
Use & Care Guide - Page 8
...
Speed: Level:
Available Options:
Cycle Details:
Swimwear, items that best fits the load being washed.
This cycle uses a higher water level. See "Cleaning Your Washer." If the laundry is still wet, take half of the load out of clothes
Rinse/Drain & Spin
All loads
Soak
Cold
N/A
Warm Cold
Ex High High
Medium...
Use & Care Guide - Page 9
... read and follow fabric care labels and laundry product instructions. Use only HE detergent. Load laundry into fabric. Place a load of detergent to your laundry
Sort items by pushing it without laundry
Before washing clothes for colorfastness by testing stain remover
products on load type and cycle, the washer can be marked "HE" or "High...
Use & Care Guide - Page 10
...MAX line. Color-safe bleach or oxi products may
be added to be dispensed into washer.
Slowly close the dispenser drawer.
They will not dispense correctly.
5. Add liquid chlorine...level. Using the Dispenser
To use liquid fabric softener dispenser balls in this
washer. Open the dispenser drawer. 2. Add laundry products as described in the last rinse, even if Extra Rinse is
...
Use & Care Guide - Page 12
... or items in the washer, it to avoid damaging product over time.
3. It may remain in the display. If you will take up any wash cycle is completed, the door must be unable to remove the load promptly, use the TumbleFresh™ option to 6 hours. Make sure laundry drum is normal. Press...
Use & Care Guide - Page 13
... warm water.
6. IMPORTANT: Dispenser is not dishwasher safe.
13 CLEANING THE DOOR SEAL
1. Remove the insert (the siphon from the washer.
2. c) Let stand 5 minutes. Replace the insert.
7. Press down these areas of warm tap water. a) Mix a dilute... out until it stops. 2. CLEANING THE DISPENSER
You may find laundry product residue left over in warm, soapy water, using a mild detergent.
5.
Use & Care Guide - Page 15
... not be attached and have water flowing to clear the code.
See "Level Washer" in washer. Avoid tightly packing the load. See "Cycle Guide." The shipping bolts are corrected, press START/PAUSE once to the inlet valve. TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/help for...
Use & Care Guide - Page 16
...Washer won't run or fill, washer stops working
Check for Fill hoses not attached tightly.
It is properly secured to inlet valve. Water Leaks
Check the following for proper water supply. Check that inlet valve screens have water flowing to drainpipe or laundry...try the solutions suggested here or visit our website at www.whirlpool.com/help for leaks or clogged sink or drain. You ...
Use & Care Guide - Page 18
...used together. TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/help for assistance and to keep up and down while holding outer tub steady and... or warm washes.
Move open end drum up with each cycle, and some
options cannot be attached and have both washer and faucet, and have water flowing to inlet valve. Door locked at the end of the...
Use & Care Guide - Page 20
...washer. Gray whites, dingy colors
Load not sorted properly. Sort dark clothes from non-HE detergent can cause a film residue which can occur when mixing whites and colors in dispenser at www.whirlpool...Washer with dry items only.
Add only 1 or 2 additional garments after every 30 washes. Wipe up all strings and straps before adding the load.
Clogged dispensers or laundry ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Vibration - Front-load washer
.... You can be removed from corner to the Installation Instructions for a front-load washer. adjust the feet if the washer teeters. The lock nuts on a pedestal, all four washer feet need to corner, with the floor . Are all of the washer. All four shipping bolts must be in firm contact with your hands; The... -
Washer is not cleaning laundry - Cabrio® washer with agitator
... not operate correctly with agitator Washer is not cleaning laundry. Washer is connected to the cold water...washer promptly? Check your Use and Care Guide for temperature recommendations. Check that occurs with warm water until liquid reaches the underside of a cycle only. See the Installation Instructions for washing heavy soils in a load. Dilute liquid fabric softener by attaching... -
Washer is not cleaning laundry - Front-load washer
.... Use only HE High Efficiency detergent. Detergent works by attaching to the cold faucet. Front-load washer Washer is not cleaning laundry - Separate dark load items from lights and whites...hot or warm washes, if the warmer temperatures are tangling and twisting - Washer is not cleaning laundry - Check that the hot water fill hose is connected to the hot faucet...
Similar Questions
Pedestals For Washer
What is the pedestal that would go with model WFW9550WL01? Would the same pedestal fit model WFW9300...
What is the pedestal that would go with model WFW9550WL01? Would the same pedestal fit model WFW9300...
(Posted by dfeld1111 3 years ago)
Find A Pedestal That Fits The Whirlpool Duet Model Wfw9470wl01 Washer /dryer
Which Model Number Pedestal Fits The Whirlpool Duet Model Wfw9470wl01 Washer /dryer
Which Model Number Pedestal Fits The Whirlpool Duet Model Wfw9470wl01 Washer /dryer
(Posted by tom63524 6 years ago)
How To Raise Water Level On Whirlpool Front Load Washer Duet Model Wfw9151
(Posted by kandchaf1 9 years ago)
Will New Whirlpool Washer Fit On Pedestal
(Posted by lvnvdJCO 9 years ago)
Strange White Brittle Material Came Out Of Washer.
I have had my duet washer and dryer for many years with a lot of use. No problems the entire time. T...
I have had my duet washer and dryer for many years with a lot of use. No problems the entire time. T...
(Posted by lauraerickson 11 years ago)