Whirlpool WDT910SAYM Support Question
Whirlpool WDT910SAYM Support Question
Find answers below for this question about Whirlpool WDT910SAYM.Need a Whirlpool WDT910SAYM manual? We have 5 online manuals for this item!
Question posted by Blumattandjenny on December 31st, 2011
The Latch On This Dishwasher Seems Like It Is Stuck In The Lock Position. Ideas?
The door won't secrely latch and when I try to hit START, the light just flashes.
Current Answers
Related Whirlpool WDT910SAYM Manual Pages
Use & Care Guide - Page 1
... lado derecho o izquierdo del interior de la lavavajillas.
Always read and obey all safety messages. DISHWASHER USER INSTRUCTIONS
THANK YOU for additional information. If you still need your model and serial number located near the door on your appliance. If you should experience a problem not covered in this high-quality product. Table...
Use & Care Guide - Page 2
... has not been used for such a period, before using the dishwasher turn on the door, lid, or dish racks of the dishwasher.
■ To reduce the risk of California to reduce the ...; Do not wash plastic items unless they are not likely to damage the door seal;
and
2) Load sharp knives with the dishwasher; For plastic items not so marked, check the manufacturer's recommendations.
■...
Use & Care Guide - Page 3
...UN
3 The first cycle using the sensor will optimize your water and energy efficient dishwasher!
Energy efficient dishwashers use tablets and packs for improved drying performance and controlling buildup of rinse aid ... where previous detergents contained 8.7%. USE RINSE AID FOR Full
BETTER DRYING
Lock
Add Refill
Detergent
The United States has passed a restriction limiting the ...
Use & Care Guide - Page 5
... option (cycles and options vary by model).
5 Push door firmly closed. The door latches automatically. Select the wash cycle, options and press START/RESUME or press START/ RESUME to Clean Your Filter," in the previous wash cycle.
5 Unload and clean the filter. 1 Prepare and load dishwasher.
Quick Steps
4 Start dishwasher. See "Recommended Time Interval to repeat the same...
Use & Care Guide - Page 6
...results.
■ Avoid overlapping items like bowls or plates that when the dishwasher door is closed detergent
B
container in better cleaning. The hardness of the ...(0-6 grains per U.S.
Cover latch B.
Upper rack
Lower rack
■ Make sure nothing keeps spray arm(s) from containers before starting a cycle.
■ Fresh automatic
dishwasher
A
detergent results
in a
...
Use & Care Guide - Page 7
... the door, select wash cycle, option and press START/RESUME before adding rinse aid or adjusting the factory setting.
■ If you have hard water or notice rings or spots, try a higher setting. Lock
fill - -- 6 5 4
-- - --- Select Options (options vary by model) See "Cycle and Option Descriptions" charts in the following section.
For best dishwashing results...
Use & Care Guide - Page 10
..., the "Sanitized" indicator glows.
OPTION SELECTIONS
OPTIONS
PURPOSE
Control Lock
To avoid unintended use of your dishwasher is locked, the light flashes 3 times. The cycle will not resume until the door is closed and Start/Resume is finished.
When Control Lock is lit, all buttons are locked. The dishwasher door can happen if the cycle is interrupted, or the water could...
Use & Care Guide - Page 11
...or right to use this feature.
EZ Adjust Tines
Sliding lowerrack tines that is completely locked into place. NOTE: You must select the POWERSCOUR™ wash option to fit your ... row of items may have some or all the way before closing the dishwasher door.
in the door: 1.
Light Item Clips
The light item clips hold additional cups, stemware or long items such as cups, ...
Use & Care Guide - Page 12
... Removable Top Rack
The removable top rack allows you to removing the top rack from dishwasher. IMPORTANT: Remove dishes prior to wash larger items such as directed in "Removable Top ... pull tracks forward in the Up position and level. Open
track stops.
2. Slide rack into the dishwasher. The stops will automatically close when rack enters dishwasher.
Adjusters are located on each side...
Use & Care Guide - Page 14
... clean out the disposal. If the Upper Filter Assembly turns freely, it too often could be using the dishwasher during the summer months, turn the filter clockwise until the filter is locked into place. Stainless Steel Cleaner and Polish Part Number 31464. Vinegar is effective in place and the Upper Filter Assembly...
Use & Care Guide - Page 15
... automatically resets itself within the cycle times? If foam or suds are detected by pressing START/ RESUME and closing the door within 3 seconds. Forgetting to an overload?
If this sensor adjustment.
■ Water remains in models)
Is the dishwasher aligned with water.
Run a vinegar rinse as laundry detergent, hand soap, or dish detergent...
Installation Guide - Page 2
... injured if you don't follow instructions.
You Need to: ■ Slowly open door. WARNING
Tip Over Hazard Do not use dishwasher until latched.
■ Observe all governing codes and ordinances.
■ Install this manual and on open dishwasher door while someone grasps the rear
of the dishwasher. Remove shipping materials, drain hose and lower rack. The...
Installation Guide - Page 9
...the ³⁄₄" connection is a registered trademark of E.I. Tape drain hose to "ON" position. Flexible braided connection: Secure nut to elbow using copper tubing, it will be far enough into ...the cabinet opening to connect it to the dishwasher inlet on the front left side of the dishwasher. Slide the nut and ferrule forward and start the nut onto the elbow threads. This ...
Installation Guide - Page 10
... and at least 20" (50.8 cm) above the floor where the dishwasher will be installed. Use pliers to squeeze clamp open and move into position. Use pliers to squeeze clamp open and move into position. Using a hammer and screwdriver, knock plug into disposer.
2. no air...
no air gap
1. IMPORTANT: The drain hose connection of drain hose to squeeze clamp open and move into position.
Installation Guide - Page 11
...2. NOTE: Do not cut , use dishwasher until completely installed. Attach drain hose to squeeze clamp open door. Use pliers to air gap with air gap
Prepare Dishwasher
WARNING
1.
Do not push down on ...(provided). Tip Over Hazard Do not use a 1¹⁄₂" to 2" (3.8 to move into position. Failure to air gap and cut if needed. If your model does not have insulation, proceed to...
Installation Guide - Page 14
... can be installed (you have, the rear wheels are not pinched. Measure height of cabinet opening from underside of countertop to floor where dishwasher will be removed for wheel position and the number of turns needed , see website for 34¹⁄₂" [87.6 cm].)
■ Depending upon the type of cover...
Installation Guide - Page 15
....
add shims as shown. Turn both leveler legs to do so can result in the area shown to bring the dishwasher up floors: If the kitchen floor is in the required position determined from the package and insert into the new position. Failure to the same height. Built-up to move and install...
Installation Guide - Page 17
... frame.
The screw can be put into one of three holes (1, 2, 3) in the same notches on both sides of the dishwasher. Reattach door spring to rear frame. NOTE: Springs should be in the front leg of dishwasher. Refer to the section that applies to a lower number hole and replace the screw.
If the...
Installation Guide - Page 18
... right sides. If needed, adjust leveling leg until dishwasher is level from under dishwasher. Helpful Tip: Push up or down until dishwasher is all right if dishwasher fits tightly into cabinet opening .
Close and latch the door, and place level against the floor. Repeat for other side of dishwasher door panel with your cabinets.
18 With some installations...
Installation Guide - Page 23
... or lower part of rinse aid for future reference.
23 Start/Resume light may flash: When pressing Start/Resume, you have all parts have been installed and no steps were skipped. Check that dishwasher is used .
■ Start dishwasher and allow it again. (You must make sure the door is not working properly. If none of these instructions...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Dishwasher will not start
... displays "- -" during a cycle if it is leaking Lights flashing on top of the cycle. If this is installed backward will also cause incomplete door closure. Is the Start/Resume indicator flashing? Has the motor stopped for obstructions (spoons, etc), interfering with lock icon) for you press Start/Resume, the dishwasher is turned on top of the preferred cycle... -
Reasons to use rinse aid in my tall tub dishwasher
... use a rinse aid: Make sure the dishwasher door is at 2; Place the knob back into...tall tub dishwasher? To adjust the setting Remove the dispenser knob. Do not use a liquid rinse aid. Clean up any spilled rinse aid with a damp cloth. for about 1 to the "Lock" position. Use Jet...and receive a 10% discount on dishes, try a higher setting. Reasons to the "Add" level, add more rinse aid. -
Reasons to use rinse aid in my tall tub dishwasher
...Add" level, add more rinse aid. Spotting and filming on dishes, try a higher setting. To use a rinse aid: Make sure the dishwasher door is at 2; Clean up any spilled rinse aid with a damp cloth....tall tub dishwasher Why should I use a rinse aid in the Order Review and Payment screen when you checkout. Place the knob back into the opening and turn to the "Lock" position. Here ...
Similar Questions
Whirlpool Dishwasher Is Not Getting Enough Water
My two-year-old Whirlpool WDT910SAYM3 dishwasher is not getting enough water. It cycles as if it's r...
My two-year-old Whirlpool WDT910SAYM3 dishwasher is not getting enough water. It cycles as if it's r...
(Posted by Gregfennessy 7 years ago)
What Parts I Need To Install My New Dishwasher
I just got delivered a new whirpool dishwasher wdt910saym3, the delivery guy said I need new water h...
I just got delivered a new whirpool dishwasher wdt910saym3, the delivery guy said I need new water h...
(Posted by sfdbogota 9 years ago)
The Clean Light Is Flashing On My Quiet Partner I Dishwasher. How Do I Reset ?
(Posted by tracyhough19 10 years ago)
