Whirlpool WDF111PABB Support Question
Whirlpool WDF111PABB Support Question
Find answers below for this question about Whirlpool WDF111PABB.Need a Whirlpool WDF111PABB manual? We have 3 online manuals for this item!
Question posted by Tb9577 on September 25th, 2017
Dishwasher Model Wdf111pabb
high heat wash and dry buttons do not work. How can they be reset
Current Answers
Answer #1: Posted by Odin on September 25th, 2017 3:07 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WDF111PABB Manual Pages
Energy Guide - Page 1
... Dishwasher Capacity: Standard
Whirlpool Corporation Models: WDF110PAB**,
WDF111PAB**
Estimated Yearly Operating Cost
(when used with an electric water heater)
$29 ▼
$20
$50
Cost Range of Similar Models
...and use.
• Cost range based only on standard capacity models. • Estimated operating cost based on four wash loads a week and a 2007
national average electricity cost of 10...
Dimension Guide - Page 1
...connected to change materials and specifications without notice.
Outlet must be needed to connect to heat and detergent, and fits the 1" (2.5 cm) drain connector of 2
W10435040-D-WH...a 90° elbow with
dishwashers. or 20-amp.
Do not solder within 6" (15.2 cm) from water inlet valve. Undercounter Dishwasher
PRODUCT MODEL NUMBERS
WDF110PAB WDF111PAB WDF310PAA WDF310PCA ...
Installation Guide - Page 2
... injured if you and others are not followed.
You Need to reduce the chance of the dishwasher.
All safety messages will tell you how to : ■ Slowly open door. All safety...symbol and either the word "DANGER" or "WARNING." WARNING
Tip Over Hazard Do not use dishwasher until latched.
■ Observe all safety messages.
Doing so can be exercised when the appliance ...
Installation Guide - Page 3
... needed:
Parts supplied:
Parts needed:
Make sure all these parts are included in the literature package.
*Power cord grommet included only on power cord models or in dishwasher.
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the recommended tools and parts before starting installation. It is recommended that electrical connections be the proper size...
Installation Guide - Page 4
... Number 4396277) is uneven (example: Flooring extends only partway into opening).
Corner locations require a 2" (5.1 cm) minimum clearance between motor and flooring. If dishwasher will be needed to level dishwasher.)
Helpful Tip: Be sure to water, electricity and drain.
The location must provide clearance between the side of time or in the "Product...
Installation Guide - Page 6
...A new drain hose is supplied with grounding wire that meets the wiring requirements for use with dishwasher.
■ Power supply cord must plug into a grounded 3 prong outlet, located in accordance ...with
the air gap installation instructions. If drain hose is resistant to heat and detergent, and fits the 1" (2.5 cm) drain connector of 12 ft (3.7 m) (Part...
Installation Guide - Page 7
... a 1¹⁄₂" (3.8 cm) hole in the "Prepare Cabinet Opening- If the water line and the cable extend to the locations shown, proceed to the dishwasher cabinet opening. Failure to do not reach far enough, follow the instructions in cabinet side or rear. Existing Utilities
Electrical Shock Hazard Disconnect electrical power...
Installation Guide - Page 8
...cabinet: Cover hole with grommet included with grommet (Part Number 302797 not provided). This will prohibit cable from moving when dishwasher is moved into the cabinet opening from power supply through the left side of copper tubing for the water supply line... right front side of cabinet opening .
Option B, Direct Wire:
Helpful Tip: Wiring the dishwasher will make water connection easier.
Installation Guide - Page 9
... the inlet valve. Tape drain hose to "ON" position. This will prohibit it from moving when dishwasher is in area shown.
Install Drain Hose
IMPORTANT: Always use a new drain hose.
Route drain hose...
Slowly turn water shutoff valve to the floor in cabinet to the front center of the dishwasher. Flush water into the cabinet opening closest to the sink. Turn shutoff valve to the...
Installation Guide - Page 10
... vibration of the disposer or a waste tee must be made before the drain trap and at least 20" (50.8 cm) above the floor where the dishwasher will be installed. Attach rubber end of drain hose to waste tee with large drain hose clamp (provided). If the drain hose was cut if...
Installation Guide - Page 11
... both sides of drain hose to squeeze clamp open door.
Helpful Tip: Place cardboard under dishwasher until completely installed. Use pliers to air gap and cut if needed.
Doing so can...drain hose to air gap with a towel to avoid damaging floor covering.
NOTE: Do not cut , use dishwasher until installed in serious injury or cuts. Be sure to 5 cm) screw-type clamp (not provided).
...
Installation Guide - Page 12
... a flat-blade screwdriver, turn the plastic fasteners ¹⁄₄ turn counterclockwise to lower part of dishwasher door frame and place dishwasher on its back. Retain for later use.
Route cord so that it does not touch dishwasher motor to unlock them. NOTE: If using Option B, proceed to "Determine Cabinet Opening," to the...
Installation Guide - Page 13
...Tighten strain relief screws to 16-gauge dishwasher wiring. Gently tug on wire connectors. Place wires inside box. If power cord supplied model, remove the first tie strap closest to...ground connector screw.
Twist on left side of cover.
Electrical Shock Hazard
Electrically ground dishwasher.
If needed, see website for animated representation of the green ground wire. Visit www...
Installation Guide - Page 14
... leveling legs. NOTE: If the minimum cabinet opening , but the dishwasher will need to the same height. This will allow the dishwasher to fit into a 33¹⁄₂" (85.1 cm) high cabinet opening height is less than 33⁷⁄₈" (86 cm), the rear leveling legs and spacers can be more...
Installation Guide - Page 15
... as shown.
Option 2, Side Attachment For marble, granite, or other side. IMPORTANT: The dishwasher must be done later. Remove the brackets from the package and insert into the cabinet opening ... avoid vibration during operation, route the water supply line so that it does not touch the dishwasher base, frame or motor.
15 Option 1, Countertop Attachment
Built-up floors: If the kitchen ...
Installation Guide - Page 16
... is facing upward as it from moving the spring end toward the front of E.I. Move Dishwasher Close to cabinet opening .
†®TEFLON is moved into the 90° elbow fitting...16
If the door closes too quickly, decrease the spring tension by moving when dishwasher is a registered trademark of the dishwasher. Copper tubing only: Put the tubing into the cabinet opening . NOTE: Do...
Installation Guide - Page 17
...9632; If using the hex-head socket or adjustable wrench.
Check that dishwasher is plumb. Helpful Tip: Push up or down until dishwasher is centered from front to back in the opening . With some ...power cord, make sure to route end through hole in the same notches on front of dishwasher. Check that leveling legs are firmly against the floor.
IMPORTANT: If rear leveling legs and ...
Installation Guide - Page 19
...around ground connector screw and under the washer. Failure to 16-gauge dishwasher wiring.
Connect ground wire to "Secure Dishwasher in Cabinet Opening" section. Twist on wires to be sure both ... use an extension cord. Route cable so that it does not touch dishwasher motor or lower part of dishwasher tub.
Securely tighten ground connector screw. Make Direct Wire Electrical Connection
NOTE...
Installation Guide - Page 20
...; T20® screwdriver and previously removed screw to countertop with two #10 x ¹⁄₂" Phillips-head screws (included). Close cover ensuring wires are securing dishwasher to countertop.
Place wires inside box.
NOTE: Do not drop screws into pump area when you are not pinched. Locate brackets on top of...
Installation Guide - Page 22
... exceptional cleaning. If none of these instructions can result in the bottom of rinse aid for good drying results: For models with a low wattage, low energy consumption motor, your dishwasher.
■ Check that there is working properly, disconnect power or unplug dishwasher and see the Use and Care Guide for future reference.
22 Your new...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Filming or etching on glasses
...; appliances Here Check afterwards: Did the film come off? Do not use detergent. Do not use heated drying. Alkaline washing solution. Order Jet-Dry Rinse Agent Cleaner. Do not use Finish Glass Magic Cleaner in my dishwasher? Long/hot cycles. The vinegar will mix with certain types of glassware. This may be removed... -
Stains on tub or dishes in my dishwasher
... wax or petroleum-based, so a high-temperature wash is required to the dishwasher detergent removing the cookware seasoning. Reseason the cookware after food soil has been removed). Stains gradually fade over time. Regular use of heated drying will slow fading. Stains will not affect dishwasher performance. Regular use detergent. Follow... -
My dishes are not dry
...F as it enters the dishwasher. Loads may not wash as well if the water temperature is too low. Water that is very important, especially for good drying performance. Without rinse aid,... rinse aid used? Is the water temperature too low? Use the Heated Dry option for better drying results. Water "sheets" off dishes rather than forming water droplets that creates...
Similar Questions
Not Able To Choose Dishwashing Cycle/options On Wdf111pabb Dishwasher
We purchased our dishwasher 7months ago. Up until today, I could choose cycle/options I wanted for r...
We purchased our dishwasher 7months ago. Up until today, I could choose cycle/options I wanted for r...
(Posted by Anonymous-152689 8 years ago)
My Recently Installed Dishwasher 1 Week Ago Does Not Dry The Dishes.
newly Installed Dishwasher Moded Wdf520padwo Does Not Dry Dishes
newly Installed Dishwasher Moded Wdf520padwo Does Not Dry Dishes
(Posted by rsmgior 9 years ago)
When Dishwasher Was On Process After Finishing Drying The Water Remained At Boto
(Posted by scaly60 10 years ago)
Whirlpool Portable Dishwasher Model Dp940pwsq Overflowing
We have a Whirlpool portable dishwasher model dp940pwsq. When I ran it today water started overflowi...
We have a Whirlpool portable dishwasher model dp940pwsq. When I ran it today water started overflowi...
(Posted by DBILLINGS2 11 years ago)
Heating Element Will Not Work
hello, i replaced the heating element and it still doesnt work? is there anything i can do to troubl...
hello, i replaced the heating element and it still doesnt work? is there anything i can do to troubl...
(Posted by part23333 12 years ago)