Whirlpool ED5GVEXVD Support Question
Whirlpool ED5GVEXVD Support Question
Find answers below for this question about Whirlpool ED5GVEXVD - 25.3 CF SxS E-Star Adj Dr BIN1.Need a Whirlpool ED5GVEXVD manual? We have 5 online manuals for this item!
Question posted by garzzz46 on May 3rd, 2011
Inoperative Ice Cube Maker
Freezer temperature is at coldest setting, freezer is cold, water in ice cube reservoir is not freezing. I cleaned off ice in the three cold air vents behind the ice maker, was that the problem? Thanks, Gary
Current Answers
Related Whirlpool ED5GVEXVD Manual Pages
Owners Manual - Page 2
...refrigerator. ■ Disconnect power before operating. ■ Remove doors from your refrigerator. even if they are cold.
Shelves and covers may not easily climb inside. Use both hands when removing them to sudden temperature...installing ice maker (on ice maker
kit ready models only). ■ Use a sturdy glass when dispensing ice (on some models). ■ Do not hit the refrigerator ...
Owners Manual - Page 3
...)
NOTES:
■ It is recommended that you move your refrigerator, allow the doors to the desired setting. To ensure proper ventilation for 1" (2.54 cm) of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on the model) to swing open.
1/2" (1.25 cm)
Electrical Shock Hazard
Plug into its final location...
Owners Manual - Page 4
... for cleaning. If you have questions about your refrigerator has a water filter, it is a cold water pipe.
■ Horizontal pipe will work, but drill on before starting installation. If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):
■ Check to operate the water dispenser and ice maker.
Connect Water...
Owners Manual - Page 5
... Shock Hazard Plug into a grounded 3 prong outlet. 2. Settings to produce the first batch of the midsetting make the temperature less cold. NOTE: Adjusting the Refrigerator and Freezer Controls to a higher (colder) than recommended setting will not cool when the REFRIGERATOR Control is needed in water strainer. Household water line
4.
When you first install your nearest...
Owners Manual - Page 6
... and HIGH. Adjust the control to any setting between adjustments. Chilled Door Bin
(on some models)
Cool air from the freezer is directed to the refrigerator door bin directly beneath the vents.
Use a sturdy container to depress and hold the water dispenser lever for 5 seconds, then release it less cold.
■ Slide the door chill control to...
Owners Manual - Page 7
... the LOCK button to unlock the dispenser. Press and hold the LOCK OUT button to a softened water supply.
The ice maker sensors will automatically stop dispensing. NOTE: Some models dispense both cubed and crushed ice. When changing from the ice crusher is not blocked (in the ON (left ) position.
■ To manually turn off the dispenser...
Owners Manual - Page 8
....
5. Both the refrigerator and freezer sections defrost automatically. Wipe up ) position. 3. IMPORTANT: Because air circulates between both hands and press
the release button to your water quality and usage. To Clean Your Refrigerator: NOTE: Do not use with both sections, any odors formed in one section will change from red to the water dispenser or ice maker decreases noticeably...
Owners Manual - Page 9
... installation for routine condenser cleaning in warm water. Do not use an...coldest setting will not operate
WARNING
Refrigerator Operation
■ Household fuse blown or circuit breaker tripped? NOTE: Adjusting the temperature...refrigerator may hear intermittent noises from your old one due to fill the ice
maker
■ Pulsating - NOTE: To clean the light shield, wash it with a clean...
Owners Manual - Page 10
... not stable? Check temperature in the socket or burned out? See "Using the Controls." Wait 72 hours for ice maker to do if the refrigerator rocks and is not stable
■ What do I do so can result in the way? Clean gaskets with a plastic utensil.
■ Reverse osmosis water filtration system connected to your cold water supply? The...
Owners Manual - Page 11
... shutoff valve turned on the refrigerator? Use only cubes produced by the current ice maker.
■ Has the ice melted around the auger (metal spiral) in the home water source line?
Gray or dark discoloration in too long? If it does not close completely, see "The doors will not operate properly
■ Freezer door closed completely? Wait...
Owners Manual - Page 13
... is for cold water use only.
■ Do not use with water that is ...Water Supply Parameters
Water Supply Water Pressure Water Temperature Service Flow Rate
City or Well 30 - 120 psi (207 - 827 kPa) 33° - 100°F (0.6° - 37.8°C) 0.85 gpm (3.2 Lpm) @ 60 psi
Model T2WG2: Change the water filter cartridge every 6 months. If the water flow to the water dispenser or ice maker...
Owners Manual - Page 14
... your water supply. Style 3 - Application Guidelines/Water Supply Parameters
Water Supply Water Pressure Water Temperature Service ...water flow to the water dispenser or ice maker decreases noticeably before or after the system.
■ Refer to the "Warranty" section for the Manufacturer's name, address and telephone number.
■ Refer to red, it is recommended that is for cold water...
Dimension Guide - Page 1
..., cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer control depending on each side (depending on the model) to a fixed wall, leave 2" (5.08 cm) minimum on each side and at the back for the water dispenser and ice maker. Width Door Width Cab. ® Side by a switch. When installing your cold water supply, the water pressure...
User Instructions - Page 3
... to the desired setting. Do not use a piercing-type or ¾e" (4.76 mm) saddle valve which reduces water flow and clogs more easily.
Before you move your refrigerator be turned off by a switch. Do not use an extension cord. Install copper tubing only in a location where the temperature will remain above freezing. Do not remove...
User Instructions - Page 5
... water valve as shown. Then tighten it reaches the OFF position. The Refrigerator Control and the Freezer Control should be set to the "mid-settings." Do not remove ground prong. NOTEA:llow24hoursto productehefirstbatchof ice.Allow
3daysto completefliyll icecontainer.
It is set to OFE
The Refrigerator Control adjusts the refrigerator compartment temperature. Complete...
User Instructions - Page 6
... drawer control comes preset at their optimal storage temperatures. Remember to any setting between adjustments. L,_s led !}00..._... Slide the door chill control to the left (less cold). To Dispense Water: 1.
Repeat until water begins to maintain a fresh supply. Ice dispenses from the freezer is pressed. b._
Cool air from the ice maker storage bin in some households. NOTES: •...
User Instructions - Page 7
... a sturdy glass when dispensing ice. Press a sturdy glass against the ice dispenser lever. Ice can result in the ice maker or storage bin. The ice maker sensors will be made , the ice cubes will fill the ice storage bin, and the ice cubes will not work. Discard the first three batches of ice produced.
• The quality of the water supplied to your dispenser...
User Instructions - Page 9
...; Creaking/Cracking ice maker mold.
-
If the environment is particularly greasy or dusty, or there is no need to clean the condenser:
• Remove the base grille.
• Use a vacuum cleaner with warm water and liquid detergent. Replace the fuse or reset the circuit breaker. Push bin or shelf back in refrigerator or reconnect power...
User Instructions - Page 10
...; Controls set to OFF? Allow several hours for the refrigerator to cool completely.
• Door(s) opened often or left open ?
A kink in ice indicates that the water filtration system needs additional flushing.
10 Straighten the water source line.
• Ice maker turned on the refrigerator? Wait 72 hours for ice production to make new ice. Remove ice from food? The ice cubes are...
User Instructions - Page 11
... on the refrigerator? Use only cubes produced by the current ice maker.
• Has the ice melted around the auger (metal spiral} in too long? See "Water Supply Requirements." Flush the water system. The water dispenser will not close completely."
• Refrigerator connected to a cold water pipe? Make sure
the refrigerator is connected to water supply and turn water shutoff valve...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The ice from the ice maker on my upright freezer has an off taste, odor or gray color
.... Have the ice cubes been stored too long? To prevent ice cubes from my ice maker How do I manually defrost and clean my upright freezer? Each Ice Aid package can last up frozen food odors within the freezer use Ice Aid which contains high absorbency naturally activated charcoal. Order Ice Aid Freezer Deodorizer Here. Odd taste or odor in my ice or water There is... -
Ice cubes are hollow/small - Freezer on Bottom
... Debris in the water line caused by side refrigerator Low ice production - Remove the filter. A clogged filter will flush air from the system, water may improve the water pressure: Allow the storage tank for a problem with a water dispenser, you check out. replace if necessary. Answers others found helpful Ice cubes are hollow/small - Freezer on . A low volume... -
No or low ice production - Bottom freezer/French door refrigerator
... 40-60 psi (276-414 kPa). Dispense water using only a plastic utensil so the ice maker is not jammed in small or hollow ice cubes. Make sure to use . Check that the water shutoff valve is not recommended to use my temperature controls? - replace if necessary. Bottom freezer/French door refrigerator Why is not being produced?
Similar Questions
Refridgerator Portion Of Unit Does Not Keep Cold
Hi. Over the past two weeks I have noticed the refrigerator portion of my unit does not stay cold. t...
Hi. Over the past two weeks I have noticed the refrigerator portion of my unit does not stay cold. t...
(Posted by sacred0225 11 years ago)
Ice Maker Problems
ice maker completely jambed with ice ,leaking water into fridge Of course 12 months old out of warre...
ice maker completely jambed with ice ,leaking water into fridge Of course 12 months old out of warre...
(Posted by keithheld 12 years ago)
Ice Maker Problem
Ice is accumulating in the opening above where you put the glass underneath to get ice to come out. ...
Ice is accumulating in the opening above where you put the glass underneath to get ice to come out. ...
(Posted by jptrax 12 years ago)
Ice Dispenser
Do you know why my ice dispenser would work fine one day and then not the next? It does nothing...no...
Do you know why my ice dispenser would work fine one day and then not the next? It does nothing...no...
(Posted by ccolborn 12 years ago)
The Ice Maker Makes Ice But Won't Dispense It.
(Posted by Anonymous-29692 12 years ago)