Whirlpool DU1055XTVS Support Question
Whirlpool DU1055XTVS Support Question
Find answers below for this question about Whirlpool DU1055XTVS - 24" - Dishwasher.Need a Whirlpool DU1055XTVS manual? We have 6 online manuals for this item!
Question posted by Anonymous-145081 on October 15th, 2014
How Do You Take The Lower Spray Bar Off, Does The Plastic Screw Turn Lift Orrigh
The person who posted this question about this Whirlpool product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by BusterDoogen on October 15th, 2014 9:04 AM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,397
Member since:
October 30th, 2011 Points: 28,565,397
Left.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Whirlpool DU1055XTVS Manual Pages
Dimension Guide - Page 1
...DU1055XTV DU1061XTV
DU1300XTV DU1301XTV DU1345XTV GU2275XTV GU2300XTV GU2475XTV GU2800XTV
Electrical Requirements: 120-volt, 60-Hz, AC-only, 15- or 20-amp. Copper wire only. Water Supply Requirements: A hot water line with dishwashers...20 to 120 psi (138 to house plumbing lower than 20" (50.8 cm) above the...supply line (¹⁄₂" minimum plastic tubing is connected to 862 kPa) ...
Installation Instructions - Page 2
...mean:
You can happen if the instructions are very important. Remove shipping materials, drain hose and lower rack. This is , tell you how to reduce the chance of injury, and tell you what...potential hazard is the safety alert symbol.
You Need to:
• Slowly open door. The dishwasher must be killed or seriously injured if you what can be installed to meet all electrical and ...
Installation Instructions - Page 3
...; cabinet front perpendicular to floor. • level floor. (If floor at front of your household wiring to 16 gauge wiring in dishwasher
Other useful items you may need :
(38.1- 5 cm) Screw-type clamps (3 maximum)
Side mounting kit for solid surface countertops (Part Number 8212560)
Masking or duct tape
NOTE: Parts available for...
Installation Instructions - Page 5
...dishwasher with direct wiring: • Use flexible, armored or nonmetallic sheathed, copper wire with ³⁄₈" N.P.T. copper tubing with compression fitting or
flexible braided water supply line (Part Number 4396897RP) NOTE: ¹⁄₂" minimum plastic...disposer inlet above drain trap in the cabinet next to house plumbing lower than 20" (50.8 cm) above the floor. If the...
Installation Instructions - Page 8
... and start the nut onto the elbow threads. Flexible braided connection: Secure nut to the dishwasher inlet on the front left side of opening where drain connection will be far enough into ... Pont De Nemours and Company. This will keep the drain hose from moving when dishwasher is required.
1 Drill hole
Slowly turn water shutoff valve to "OFF" position.
5 Slide nut and ferrule
onto tubing
...
Installation Instructions - Page 9
...before the drain trap and at least 20" (50.8 cm) above the floor where the dishwasher will be installed. NOTE: Do not cut if needed.
Use needle-nose pliers to remove plug...C, Waste disposer - Use pliers to squeeze clamp open and move
into position. with air gap
Screw-type clamps Disposer inlet
Air gap
Large silver drain hhoossee ccllaammpp (provided)
Rubber hose connector Drain hose...
Installation Instructions - Page 10
...door. Excessive Weight Hazard Use two or more people, grasp sides of the tub.
2 Put dishwasher on its back
Using a ¹⁄₄" hex head socket, nut driver or Phillips ...¹⁄₄" hex head socket, nut driver or Phillips screwdriver, remove the 2 screws attaching access panel and lower panel to fasten the insulation down on the tub. Strain relief may be provided with ...
Installation Instructions - Page 11
.../CSA Approved twist-on wires to 16-gauge dishwasher wiring. Ground wire
Ground wire Washer
Ground connector
Remove the green grounding screw and place through strain relief in terminal box. Gently tug on wire connectors rated to connect your dishwasher. Connect ground wire to lower part of dishwasher tub. Connect ground wire
Route cord so...
Installation Instructions - Page 12
... connector
Tighten strain relief screws to secure cord.
5 Power Cord-Reinstall
terminal box cover
Determine Cabinet Opening
1 Measure cabinet opening
Measure height of cover.
Visit www.whirlpool.com under FAQ tab.
4 Power Cord-Secure cord
on the floor). Dishwasher Height Adjustment Chart
Cabinet opening height
Wheel position
Number of turns on left side...
Installation Instructions - Page 13
... in the
open dishwasher door, and place towel over pump assembly and spray arm of dishwasher. Remove the brackets...dishwasher must point to the right
Option 2, Dishwasher with Plastic Tub Side Attachment (for the other injury. NOTE: Do not attach the dishwasher.
Install mounting bracket
Tabs must be done later. This will stop screws from falling into slot on the side of dishwasher...
Installation Instructions - Page 15
... the ground to route end through hole in fitting. If leak occurs, repeat previous step. Hand tighten until dishwasher is plumb.
An additional ¹⁄₄ to ¹⁄₂ turn may be required to the floor. With some installations, it may be easier to adjust the front leg using power cord...
Installation Instructions - Page 16
... towel.
Pull cable through cable clamp in drain hose. Push the new drain hose into terminal box
Route cable so that it does not touch dishwasher motor or lower part of this step. Option B, Direct Wire:
1 Direct Wire-Route cable
into the black drain hose connector up to "Secure...
Installation Instructions - Page 17
...wire
Washer
Ground connector
Form bare ground wire into a U-shaped hook. Use ¹⁄₄" nut driver and previously removed screw to secure cable.
5 Direct Wire-Reinstall
terminal box cover
Place wires inside box. Securely tighten ground connector.
3 Direct Wire-... an extension cord. Make sure wires are not pinched. Electrical Shock Hazard Electrically ground dishwasher.
Installation Instructions - Page 18
... sides. This will keep it does, adjust leveling legs.
5 Check inner spacing
Open dishwasher door, remove lower dish rack, and place towel over pump assembly and lower spray arm of E.I. If it from falling into bottom of door does not contact screws, brackets, or countertop. Du Pont De Nemours and Company. IMPORTANT: If you have...
Installation Instructions - Page 19
... dish rack. Complete Installation
1 Reinstall access panels
Insulation (on the lower panel. Adjust if necessary.
4 Tighten screws
Tighten access panel screws.
19 6 Remove towel and replace
lower dishwasher rack
2 Reinstall access panels
Remove towel from dishwasher.
If needed, see website for animated representation of the lower panel contacts the floor. Check that grounding clip is...
Installation Instructions - Page 20
... open door. Check that dishwasher is working properly, disconnect power or unplug dishwasher and see that power supply cord does not touch dishwasher motor or lower part of hose failure.
Certain...hose after 5 years to start the dishwasher? • Is the water turned on the hose for good drying performance.
Your new dishwasher will flash until you have been installed ...
Owners Manual - Page 1
...safety messages will release any accumulated hydrogen gas. IMPORTANT SAFETY INSTRUCTIONS
WARNING: When using the dishwasher turn on the right-hand or left-hand side of injury, and tell you what the ... this high-quality product. For plastic items not so marked, check the manufacturer's recommendations.
■ Do not abuse, sit on, or stand on the dishwasher.
■ Under certain conditions...
Owners Manual - Page 2
... door.
GROUNDING INSTRUCTIONS
■ For a grounded, cord-connected dishwasher:
The dishwasher must be loaded with soiled surfaces facing down on the dishwasher. Upper rack
Lower rack
■ Make sure nothing keeps spray arm(s) from spinning freely. It is properly grounded. Wash only plastic items marked "dishwasher safe." ■ To avoid thumping/clattering noises during...
Owners Manual - Page 3
...■ Dispenser with Heavy Duty cycle) Select this cycle) Do not use to "Refill" and lift off . STEP 3
Select a Cycle (cycles vary by pressing Heat Dry so that there is at...■ Rinse aid helps to start the dishwasher automatically at "Full." Lock
fill - -- 6 5 4
-- - ---
¹⁄₄ turn the dispenser cap to presoak your dishwasher instead of 2 will take up to Hard...
Owners Manual - Page 5
... licensed, qualified plumber. Are the plastics wet? Use a heated drying option for proper dishwasher fill. Do not use a heavier...dishwasher interior will not affect dishwasher performance. Use recommended dishwasher detergents only.
Is the pump or spray arm clogged by some models). Minimize chipping by hand.
5 ■ Odor in your dishwasher.
Use recommended dishwasher...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Refrigerator unlevel - Side by side refrigerator
... up and tilt the top of the grille toward you may take several turns to adjust the rear roller leveling screw. Lift up until it level. It may now use a 1/2 hex head socket... do not have . A standard-depth refrigerator is approximately 31 3/8" deep so it counterclockwise to lower that the cabinet doors above the refrigerator, simply adjust the refrigerator to make sure the doors are... -
Adjusting the door spring tension prior to installing the dishwasher
... adjust the door spring tension for Plastic Tub Models: If the door closes too quickly, decrease the spring tension by moving the spring end toward the back of the dishwasher should be secured at the same holes. The screw can be put into one of the dishwasher. If the door closes by itself... -
Refrigerator unlevel - Side by side refrigerator
... depth side by side refrigerator versus a standard depth refrigerator. Lift up until it easier to level the cabinet. It...weight off the leveling screws and rollers. If you want, you do not have . Turn the roller leveling screw clockwise to raise... deep so it level. Adjust the rear leveling bolt to lower that the cabinet doors above the refrigerator. Replace the base ...
Similar Questions
Rpair Upper Spray Arm
My upper spray arm had "stuff" in it. I took it apart, and found 2 o rings loose inside,How do I rea...
My upper spray arm had "stuff" in it. I took it apart, and found 2 o rings loose inside,How do I rea...
(Posted by aletheacrossman 8 years ago)
Washer Arms Not Spraying Water
I have run my dishwasher on several cycles to see if it would work if I changed wash setting...no lu...
I have run my dishwasher on several cycles to see if it would work if I changed wash setting...no lu...
(Posted by ddeibel 10 years ago)
Dishwasher Will Not Spray Water And Appears To Be Having Trouble Draining.
Dishwasher will not spray water and appears to be having issues draining as well. Is there a first t...
Dishwasher will not spray water and appears to be having issues draining as well. Is there a first t...
(Posted by staylor7743 10 years ago)
Bad Wash And Clean The Filters
Whirlpool Du1055xtvq
How to dismantle the pieces under the bottom rotor spray to clean the filter? How to dismantle the p...
How to dismantle the pieces under the bottom rotor spray to clean the filter? How to dismantle the p...
(Posted by lstlouis 11 years ago)
Whirlpool Du1300 Water Not Draining
I've tried pressing the drain/cancel button for 3 seconds several times, turned off the power for 1+...
I've tried pressing the drain/cancel button for 3 seconds several times, turned off the power for 1+...
(Posted by jeff34763 12 years ago)