Troy-Bilt Storm 2410 Support Question
Troy-Bilt Storm 2410 Support Question
Find answers below for this question about Troy-Bilt Storm 2410.Need a Troy-Bilt Storm 2410 manual? We have 1 online manual for this item!
Question posted by re2222 on December 28th, 2020
What Is The Spark Plug Gap
what is the spark plug gap
Current Answers
Answer #1: Posted by Odin on December 28th, 2020 10:22 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,630
Member since:
April 10th, 2010 Points: 41,236,630
Related Troy-Bilt Storm 2410 Manual Pages
Operation Manual - Page 1
Storm 2410, 2620, 2840 & 3090XP
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. Printed In USA
TROY-...
Operation Manual - Page 4
... gasoline is
operating on yourself or your vehicle
the engine, disconnect the spark plug wire and ground it against the engine. Engine exhaust contains carbon monoxide,... c. Safe Handling of Gasoline
To avoid personal injury or property damage use a nozzle lock-open flame, spark or pilot light
14.
Keep children away. Thus, avoiding possible property damage or personal injury caused by ...
Operation Manual - Page 5
...Do not crank engine with factory setting of engine governor.
Spark Arrestor
Warning! A spark arrestor for instructions.
7. Disconnect the spark plug wire and ground against the engine to the Consumer Products ...4442 of the engine.
5. According to prevent unintended starting.
3. Never tamper with spark plug removed.
14. Refer to a complete stop the engine. to wear and damage....
Operation Manual - Page 7
...guides. Position the chute assembly over the base.
Figure 3-2
Chute Assembly (Model 2410)
1. Secure the handle by tightening the plastic knob located on both cables ...
Manual • One Engine Manual
• Two Replacement Auger Shear Pins • One Chute Assembly (Model 2410)
• One Product Registration Card
• One Chute Control Rod (Models 2620, 2840 and 3090XP)
Assembly...
Operation Manual - Page 8
... pin, wing nut and hex screw from chute control head. Chute Control Head
Chute Support Bracket
Chute
Chute Base
Figure 3-4
Figure 3-6
Chute Directional Control (Model 2410)
2. See Fig. 3-7.
Insert the end of the chute directional control. Assembly & Set-Up
Figure 3-7 Insert chute control rod into the lower bracket and secure with...
Operation Manual - Page 11
... seating beads may cause tire/rim assembly to burst with force sufficient to the Engine Operator's Manual. To adjust the skid shoes:
1.
Chute Assembly (Models 2410 and 2620)
NOTE: The upper chute on models 2840 and 3090XP is thrown can easily pick up and throw loose gravel, causing personal injury or...
Operation Manual - Page 17
... so will hinder the snow thrower's drive system. Remove the carriage bolts and hex nuts which secure it to Fig 7-3.
4.
Standard Chute Directional Control (Model 2410)
Once a season, lubricate the eye-bolt bushing and the spiral with 3-in -1 oil) to wear. Wipe off any oil on the auger housing.
3. NOTE: Augers...
Operation Manual - Page 19
... adjust the chute control rod, proceed as instructed earlier in it lines up section for instructions on adjusting the chute assembly. Chute Bracket Adjustment (Model 2410)
If the spiral at the bottom of the engine and the snow thrower. Loosen the two nuts which secure the chute bracket and reposition it...
Operation Manual - Page 22
... screws which secure it rests on ordering a Service Manual. Allow the engine to be removed in the reverse order.
Stop Bolt
Friction Wheel Removal (Models 2410, 2620 & 2840)
If the snow thrower fails to drive with the drive control engaged, and performing the drive control cable adjustment fails to correct the...
Operation Manual - Page 24
... (hunting or surging) Engine overheats Excessive vibration Loss of adjustment.
4. Clean, adjust gap, or replace. 6. Contact an authorized Service Center. 5. Drive belt loose or damaged...to Service section.
1. Stop engine immediately and disconnect spark plug wire. Stop engine immediately and disconnect spark plug wire. Faulty spark plug. 6. Fill tank with fresh fuel. 4. Insert ...
Operation Manual - Page 25
... Shoe, Deluxe
931-2643
Chute Clean-out Tool
790-00120 790-00121 790-00118 790-00119
Shave Plate (Storm 2410) Shave Plate (Storm 2620) Shave Plate (Storm 2840) Shave Plate ((Storm 3090XP)
731-05632
Key
951-10292
Spark Plug
Phone (800) 828-5500 to order replacement parts or a complete Parts Manual (have your full model number and...
Operation Manual - Page 26
... Snow Thrower Maintenance Kit
26 Model Number
Description
753-05762A OEM-390-679 490-241-0010 OEM-390-995 490-241-Y014 *Not compatible with Storm 2410.
Attachments & Accessories
10
The following attachments and accessories are available for information regarding compatibility, price and availability (have your Troy-Bilt snow thrower. Phone (800...
Operation Manual - Page 28
... their property arising out of any kind be liable for incidental or consequential loss or damage including, without limitation, expenses incurred for substitute or replacement lawn care services or for loss, damage, or injury to you may not apply to you. You assume the risk and liability for rental expenses to...
Similar Questions
Snowblower Starving For Gas. Tank Is Full,so I Start And Let It Run, Then Died?
we drained a nd added new fuel and new spark plug. Start w full choke let it run. Turn down choke th...
we drained a nd added new fuel and new spark plug. Start w full choke let it run. Turn down choke th...
(Posted by LINNICI 2 years ago)
Not Starting
I changed oil and replaced spark plug but it will not start I also forgot to drain out old fuel so I...
I changed oil and replaced spark plug but it will not start I also forgot to drain out old fuel so I...
(Posted by Joepupi 3 years ago)
What Is The Spark Plug Gap Setting For The Troy Biltolt Ft?
what is the correct spark plug gap for the Troy Bolt colt FT?
what is the correct spark plug gap for the Troy Bolt colt FT?
(Posted by Anonymous-165415 5 years ago)
Spark Plug Gap Set
what should the spark plug for. my tb625 ec troy built weed eater be gapped at?
what should the spark plug for. my tb625 ec troy built weed eater be gapped at?
(Posted by ginac566 6 years ago)