Troy-Bilt Storm 2410 Support and Manuals
Get Help and Manuals for this Troy-Bilt item
View All Support Options Below
Free Troy-Bilt Storm 2410 manuals!
Problems with Troy-Bilt Storm 2410?
Ask a Question
Free Troy-Bilt Storm 2410 manuals!
Problems with Troy-Bilt Storm 2410?
Ask a Question
Most Recent Troy-Bilt Storm 2410 Questions
Troy Bilt Snow Blower Engine (storm 2410)
I need to remove the shroud from the engine, and to do so I have to remove the choke knob. Can you t...
I need to remove the shroud from the engine, and to do so I have to remove the choke knob. Can you t...
(Posted by dcook37366 1 year ago)
Auger Won't Engage Belt Is Smoking
Snowblowerauger won't engage belt is smoking
Snowblowerauger won't engage belt is smoking
(Posted by Anonymous-173281 1 year ago)
How To Change Transmission Fluid
(Posted by Tpeshman 1 year ago)
Troy-Bilt Storm 2410 Videos
Troy-Bilt Storm 2410 Snow Thrower
Duration: 2:17
Total Views: 17,629
Duration: 2:17
Total Views: 17,629
Troy Bilt Storm 2410
Duration: 3:03
Total Views: 67
Duration: 3:03
Total Views: 67
My new Troy Bilt Storm 2410
Duration: 1:20
Total Views: 10,613
Duration: 1:20
Total Views: 10,613
Troy-Bilt Storm 2410 Surging/Hunting Problem (Please Help - See Description)
Duration: 1:15
Total Views: 15,626
Duration: 1:15
Total Views: 15,626
Popular Troy-Bilt Storm 2410 Manual Pages
Operation Manual - Page 1
Printed In USA
TROY-BILT LLC, P.O. Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Two-Stage Snow Thrower -
BOX 361131 CLEVELAND, OHIO 44136-0019
Form No. 769-06897 (May 17, 2011) FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
Storm 2410, 2620, 2840 & 3090XP...
Operation Manual - Page 2
... 16 Maintenance & Adjustment 17
Service 20 Troubleshooting 24 Replacement Parts 25 Attachments 26 Warranty Back Cover
Record Product Information
Before setting up , operate and maintain your complete satisfaction at all times. It instructs you how to the right. Review this manual frequently to familiarize yourself with your new equipment, please locate the model plate on the...
Operation Manual - Page 5
... screws for proper tightness at unsafe speeds. Snow thrower shave plates and skid shoes are subject to clean out the discharge chute. Refer to be used , it to operate at frequent intervals to the operator's manual for gas, oil, etc. to verify they engage and disengage properly and adjust, if necessary. Prior to storing, run machine...
Operation Manual - Page 7
Observe the lower rear area of the snow thrower to be sure
both the left and right sides of Carton
• One Snow Thrower • One Snow Thrower Operator's
Manual • One Engine Manual
• Two Replacement Auger Shear Pins • One Chute Assembly (Model 2410)
• One Product Registration Card
• One Chute Control Rod (Models 2620, 2840 and 3090XP)
Assembly
Handle
1. ...
Operation Manual - Page 10
... the pinion gear if required. Chute Clean-Out Tool
Figure 3-13
10
Section 3- 7. NOTE: The second hole is fastened to the left of replacement auger shear pins and bow tie cotter pins are properly routed through the cable guide. Refer to chute support bracket with the hole in your snow thrower.
Cut the cable tie before operating...
Operation Manual - Page 11
... Engine Operator's Manual. Equal tire pressure should be adjusted by the 4-way Chute Directional Control. The tires are adjusted upward at all times. NOTE: If the tire pressure is against the ground to avoid uneven wear on the auger housing.
• Use a middle or lower position when the area to the snow thrower and surrounding property...
Operation Manual - Page 13
...;
Standard Chute Directional Control †
Augers
Skid Shoe
† If Equipped
Figure 4-1
Snow thrower controls and features are two reverse (R) speeds. Skid Shoes
Position the skid shoes based on gravel or crushed rock surfaces. Adjust downward when operating on surface conditions. Skid shoe styles and appearance vary by model. One (1) is the slower and two...
Operation Manual - Page 17
... should be careful not to get any excess or spilled oil.
Carefully pivot the snow thrower up and forward so that it . Wipe off any oil on the bottom of the snow thrower are to the Engine Operator's Manual. NOTE: Augers not shown for information regarding tire pressure. Maintenance & Adjustments
6
Maintenance
Engine
Refer to the inside of housing. Shave...
Operation Manual - Page 19
... the Assembly and Set-up section for information on adjusting the skid shoes.
Chute Bracket Adjustment (Model 2410)
If the spiral at the bottom of the chute directional control is empty and it stops due
to lack of the engine and the snow thrower. Figure 6-6
3. See Fig. 6-6. NOTE: Refer to the Engine Operator's Manual for instructions on storing your...
Operation Manual - Page 20
.... Remove the key to run until it . Remove the belt as follows:
4. Service
7
Belt Replacement
Auger Belt
To remove and replace your snow thrower's auger belt, proceed as follows. Carefully pivot the snow thrower up and forward so that it rests on the front of the snow thrower by removing the two self-tapping screws. Remove the plastic belt cover on...
Operation Manual - Page 21
... 12 to the frame after installing a replacement auger belt.
9. Roll the auger belt off engine pulley.
4. NOTE: Do not forget to reinstall the shoulder bolt and reconnect the spring to verify the belt is adjusted correctly.
Carefully pivot the snow thrower up and forward so that it . See Fig. 7-5. To remove and replace your snow thrower's drive belt, proceed as...
Operation Manual - Page 22
... Wheel Inspection (Model 3090XP)
If the snow thrower fails to drive with the drive control engaged, and performing the drive control cable adjustment fails to correct the problem, the friction wheel may need to replace the snow thrower's friction wheel rubber. To inspect the friction wheel, proceed as instructed on the auger housing.
3. Carefully pivot the snow thrower up and forward...
Operation Manual - Page 25
...
931-2643
Chute Clean-out Tool
790-00120 790-00121 790-00118 790-00119
Shave Plate (Storm 2410) Shave Plate (Storm 2620) Shave Plate (Storm 2840) Shave Plate ((Storm 3090XP)
731-05632
Key
951-10292
Spark Plug
Phone (800) 828-5500 to order replacement parts or a complete Parts Manual (have your full model number and serial number ready).
Parts Manual downloads are also...
Operation Manual - Page 26
... attachments and accessories are available for information regarding compatibility, price and availability (have your Troy-Bilt snow thrower. Heated Grips* Drift Cutter Kit Polymer Skid Shoe Kit Snow Thrower Protective Cover Troy-Bilt Snow Thrower Maintenance Kit
26
Model Number
Description
753-05762A OEM-390-679 490-241-0010 OEM-390-995 490-241-Y014 *Not compatible with Storm 2410.
Operation Manual - Page 28
... the date of any part, accessory or attachment not approved by Troy-Bilt for loss, damage, or injury to you .
Troy-Bilt does not extend any product, shall bind Troy-Bilt.
The provisions as set forth in accordance with the Operator's Manual furnished with the product, and has not been subject to temporarily replace a warranted product.
IMPORTANT: Owner must present Original...
Troy-Bilt Storm 2410 Reviews
We have not received any reviews for Troy-Bilt yet.