Toro 20333 Support Question
Toro 20333 Support Question
Find answers below for this question about Toro 20333 - BBC Personal Pace Walk Power Mower.Need a Toro 20333 manual? We have 2 online manuals for this item!
Question posted by jn967pa on January 19th, 2014
How To Replace Toro 20333 Lawn Mower Control Cable
The person who posted this question about this Toro product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Toro 20333 Manual Pages
Operation Manual - Page 1
... This rotary-blade, walk-behind lawn mower is not designed for cutting brush or for cutting grass on well-maintained lawns on residential properties....Lawn Mower
Model No. 20333-Serial No. 312000001 and Up Model No. 20333C-Serial No. 312000001 and Up
Form No. 3371-840 Rev A
Operator's Manual
Replacement parts are responsible for information regarding the US Environmental
© 2011-The Toro...
Operation Manual - Page 2
...Replacements... guard, rear guard, or other hidden objects. walk; Uneven terrain could be ordered through the engine manufacturer...until the blade comes to operate this symbol to potential personal injury hazards. Always wear substantial footwear.
• Do...Control Regulation of objects such as rocks, wire, toys, etc., which can result in serious injury or death.
Safety
This lawn mower...
Operation Manual - Page 3
... the discharge guard frequently and replace with manufacturer's recommended parts, when necessary.
• Mower blades are explosive.
•...containers inside a vehicle or on other sources of Gasoline
To avoid personal injury or property damage, use extreme care in an enclosed area....attracted to cool before filling.
• Remove gas-powered equipment from your view of the fuel tank or ...
Operation Manual - Page 4
... parts.
5. Cutting/dismemberment hazard of hand or foot, mower blade-disconnect the spark plug wire and read the Operator's Manual.
2. operate side to side on slopes;
Thrown object hazard-keep bystanders a safe distance from the original
machine manufacturer.
94-8072
114-7982
1. Unlock
4 Replace damaged decals. stop the engine before servicing or...
Operation Manual - Page 5
... and tighten the handle knobs that covers the engine.
1
Installing the Blade Control Bar
No Parts Required
Procedure
Install the blade control bar into the upper handle (Figure 3).
1.
Remove the handle knobs from the mower housing (Figure 4). Important: Route the cables to the operating position. 3. Setup
Important: Remove and discard the protective plastic sheet...
Operation Manual - Page 6
...
4. Recoil start handle
7. Install the dipstick securely. Figure 6
1. Air filter 10. Control bar lock
1. Dipstick
Figure 5
2. fill: 20 oz. (0.59 l), type: SAE 30...Oil
Product Overview
No Parts Required
Procedure
Your mower does not come with a bottle of SF, SG, SH, SJ, SL, or higher.)
3. Side discharge chute
6 Blade control bar 3. Oil fill/dipstick
12. Spark ...
Operation Manual - Page 9
... can also try reaching just under the personal pace handle to the metal handle and push the mower forward a couple of inches (centimeters) forward to disengage the wheel drive. Pull the blade control bar to mow. 1.
Note: If the mower does not freely roll backward after self-propelling, stop walking, hold down the switch in place...
Operation Manual - Page 10
..., the blade did not go under the mower, repeat steps 4 through 10.
11. Not Using the Grass Bag
1. Take a half sheet of newspaper and crumple it into the lawn. Start the engine.
6. Release the blade control bar.
8. Checking the Blade Brake Clutch Operation
Check the control bar before each use or daily
You can...
Operation Manual - Page 11
...the bag is seated in serious personal injury. contacting the blade can ...lawn. Install the grass bag, ensuring that the pins on the mower..., remove it is on the bag rest in the recycling position, move it to the bagging position (refer to the operator or bystanders.
Raise and hold up the rear deflector (Figure 19). If the side discharge chute is damaged, install a new Toro replacement...
Operation Manual - Page 13
... Replace the blade when necessary with a Toro replacement blade. This helps disperse the clippings over any object.
• If the mower strikes an object or starts to clump on your mower....mower to plug or the engine to Adjusting the Cutting Height.
• When cutting grass over 6 inches (15 cm) tall, mow at a slower pace while mowing.
- Walk at the highest cutting height setting and walk...
Operation Manual - Page 14
...front cutting height one or two notches higher than 5 inches (13 cm) of the lawn shows through the cut the leaves finely enough.
14 You may need to make more than... cutting height.
• Slow down your mowing speed if the mower does not cut leaf cover. Cutting Leaves
• After cutting the lawn, ensure that half of leaves on the lawn, set the front wheels at 2-1/8-inch (54 mm) and the...
Operation Manual - Page 15
... is flammable, explosive and can cause personal injury. Use a screw driver to leak. Important: Before tipping the mower to change the oil or replace the blade, allow the fuel tank to... 3 seconds after releasing the blade control bar. • Check the blade brake clutch operation. • Clean grass clippings and dirt from under the mower.
• Replace the air filter; Stop the engine...
Operation Manual - Page 16
...cable. 1. Refer to warm it.
Dipstick
Figure 26
3. Figure 28 This figure is out of clarity.
2. Pull down the cable jacket (toward the mower...fill tube until there is no slack in the cable (Figure 29).
16 fill: 20 oz. (0....SH, SJ, SL, or higher.)
5.
Loosen the cable support nut (Figure 28).
1.
Remove the dipstick (... local recycling
center. Tip the mower onto its side with the air ...
Operation Manual - Page 17
...the blade properly.
If the blade edge is damaged or cracked, replace it sharpened (more frequently if the edge dulls quickly).
Figure 29...(Figure 30). 6. Tip the mower onto its side with the air filter up . 3. contacting the blade can result in serious personal injury. Cleaning the Blade Brake Clutch...cable support. Remove the blade (Figure 31). 5. Blade nuts
Figure 30 2.
Operation Manual - Page 19
... with a torque wrench to 15 ft-lb (20 N-m). 9. Fold the upper handle forward as shown in your automobile. Important: Route the cables to local codes, or use it .
1. Preparing the Mower for Storage
WARNING
Gasoline vapors can no longer start models only). 2. Recycle it according to the outside of the handle knobs...
Operation Manual - Page 20
...Toro-approved replacement parts. You may not apply to arrange service at 866-214-9808 (Canadian customers)
Owner Responsibilities
You must maintain your sole remedy under "Lawn Mowers") or access our web site at Toro...blade sharpening or worn blades, cable/linkage adjustments, or brake and ...
Walk Power Mowers
Conditions and Products Covered
The Toro Company and its affiliate, Toro Warranty...
Parts Catalog - Page 1
Original Instructions (EN) Form No. 3371-848 Rev A
22in Recycler® Lawn Mower
Model No. 20333-Serial No. 312000001 and Up
Parts Catalog
Register at www.Toro.com.
Parts Catalog - Page 2
...PRH: phillips round head PTH: phillips truss head PTO: power-take-off RH: right hand ROPS: roll-over protection ...Abbreviations
AR: as required ASM: assembly BBC: blade brake control BHTF: button head thread forming CARR: carriage CCW: ...symbol, and the y represents the reference number. Ordering Replacement Parts
To order replacement parts, please supply the part number, the quantity, and...
Parts Catalog - Page 6
... Qty. Description
19 108-3792
1 Spring-Tension, Brake
20 117-5970
1 Pulley-BBC
21 110-1790
1 Belt-BBC
22 107-0754
1 Drum
23 3211-42
2 Screw-HH
24 108-9342
1 Nut-Hex
25 115-2892...Nut-Lock
33 3229-5
1 Screw-CARR
34 106-6801 35 121-2371
1 Anchor-Cable, BBC 1 Decal-Shroud
● Not serviced separately
■ Obtain parts from www.briggsandstratton.com
3371-848A
6
B3 Part Number...
Parts Catalog - Page 9
...14 99-1588
1 Bar-Control, Traction
15 3256-23
1 Washer-Flat
16 99-1589
1 Lever-Traction
17 104-8690
1 Spring-Torsion
20 99-5239
1 Anchor-Cable
21 115-8435
1 Cable-Traction
D3
9
3371-848A ...119-3810-05 1 Handle
2 3230-6
2 Screw-CARR
3 117-5976
2 Knob-Handle, Locking
4 114-7988
1 Guide-Cable
5 86-9671
1 Guide-Rope
6 3296-73
2 Nut-Lock, NI
7 3256-1
1 Washer-Flat
8 105-6842
1...
Similar Questions
How Do I Replace Toro Model 20333 Blade Control Cable
(Posted by sfmycorv 9 years ago)
How To Replace The Torsion Spring On A Toro Personal Pace Lawn Mower
(Posted by vlsteevette 10 years ago)
How Do You Replace The Traction Bar On A Toro Personal Pace Mower
(Posted by pdfecool 10 years ago)
Blade For Model 20037 Personal Pace Lawn Mower
where can i buy a replacement 21 inch bladefor my 2003 Toro model 20037 personal Pace lawn mower???
where can i buy a replacement 21 inch bladefor my 2003 Toro model 20037 personal Pace lawn mower???
(Posted by lynnegrede 12 years ago)
Person Pace Feature Stopped Working, Is There An Adjustment I Can Make?
The Personal Pace feature stopped within 10 minutes of first use. The grass was damp at the time. Is...
The Personal Pace feature stopped within 10 minutes of first use. The grass was damp at the time. Is...
(Posted by jhcook1755 13 years ago)