Toro 20333 Support Question
Toro 20333 Support Question
Find answers below for this question about Toro 20333 - BBC Personal Pace Walk Power Mower.Need a Toro 20333 manual? We have 2 online manuals for this item!
Question posted by xbacathe on June 27th, 2014
22in Recycler Lawn Mower Blade Control Bar Does Not Work
The person who posted this question about this Toro product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Toro 20333 Manual Pages
Operation Manual - Page 1
... contact an Authorized Service Dealer or Toro Customer Service and have similar laws. 22in Recycler® Lawn Mower
Model No. 20333-Serial No. 312000001 and Up Model No. 20333C-Serial No. 312000001 and Up... for cutting grass on well-maintained lawns on the product. It is not equipped with Canadian ICES-002. This rotary-blade, walk-behind lawn mower is supplied for agricultural uses. Model...
Operation Manual - Page 2
... may be significantly lower. walk;
Slope Operation
Slopes are...down . Stop the blade when crossing gravel ...mower could cause a slip and fall accident. Failure to potential personal injury hazards. Avoid discharging material against a wall or obstruction. never up and down and behind rotary lawn mowers...in place and working.
• ...and the California Emission Control Regulation of the ...
Operation Manual - Page 3
...Mower blades are sharp. Wrap the blade... or wear gloves, and use extreme care in handling gasoline. Children are often attracted to the presence of children. General Service
• Never operate machine in a closed area.
• Keep all nuts and bolts tight to cool before filling.
• Remove gas-powered...avoid personal injury ...working condition.
• Never tamper with safety devices. Repair, ...
Operation Manual - Page 4
... engine before servicing or performing maintenance.
4. Cutting/dismemberment hazard of hand or foot, mower blade-do not operate up .
108-8117
1. Thrown object hazard-keep bystanders a safe ... located near areas of hand or foot, mower blade-stay away from moving parts.
5. Replace damaged decals. operate side to side on slopes; Indicates the blade is identified as a part from the machine...
Operation Manual - Page 5
Remove the handle knobs from the mower housing (Figure 4).
Figure 3
Figure 4
2. Important: Route the cables to the operating position. 3. Move the handle to the ...sheet that you install the handle. Install and tighten the handle knobs that covers the engine.
1
Installing the Blade Control Bar
No Parts Required
Procedure
Install the blade control bar into the upper handle (Figure 3).
1.
Operation Manual - Page 6
Figure 6
1. Blade control bar 3. Handle knob (2)
6. Spark plug
14. Slowly pour oil into the oil fill tube until the oil...adding oil to Changing the Engine Oil.
1. Grass bag
Figure 7 2. 3
Filling the Engine with Oil
Product Overview
No Parts Required
Procedure
Your mower does not come with a bottle of SF, SG, SH, SJ, SL, or higher.)
3. Cutting height lever (4)
2. Wait 3 minutes after...
Operation Manual - Page 7
...(Figure 9).
1. Important: To reduce starting problems, add fuel stabilizer to the fuel all moving blade, causing serious injury.
• Stop the engine and wait for automotive use (87 pump octane ... others.
• To prevent a static charge from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in an approved fuel container, out of the reach of...
Operation Manual - Page 9
... the engine stops.
3. Hold the blade control bar against the handle (Figure 17).
Figure 17
Figure 14 1. Pull the control bar lock back (Figure 15). Ignition toggle switch
Disengaging the Blade
Release the blade control bar (Figure 18).
You can also try reaching just under the personal pace handle to the metal handle and push the mower forward a couple of inches (centimeters...
Operation Manual - Page 10
... bagging position, move the lever to the recycling position (refer to Operating the Bag-on the mower, remove it into the lawn. Release the blade control bar.
8. If it does not stop properly, stop within 3 seconds. Important: When you release the blade control bar, the blade should begin to inflate, indicating that the blade brake clutch system is on -Demand Lever...
Operation Manual - Page 11
...).
WARNING
The blade is in serious personal injury or death to collect grass and leaf clippings from the lawn. Rear deflector
Figure...in the operator's or bystander's direction and result in the recycling position, move it to the bagging position (refer to stop...If the side discharge chute is on the mower, remove it is seated in serious personal injury. Stop the engine and wait for all...
Operation Manual - Page 12
...the lever pops up. contacting the blade can result in recycling or
side-discharging position)
Figure 20...mower and the bag-on-demand lever is attached to stop before leaving the operating position. Figure 21
1. Bag-on the lever pops up the side deflector and install the side discharge chute (Figure 22).
12 in serious personal injury. WARNING
The blade is sharp; contacting the blade...
Operation Manual - Page 13
... and examine the mower for the best lawn appearance. Cutting Grass
• Cut only about a third of the grass blade at the highest cutting height setting and walk slower; Cut the... new blade before the cutting season begins.
• Replace the blade when necessary with the blade. Raise the cutting height on the front wheels one or more frequently.
- then mow again at a slower pace while...
Operation Manual - Page 14
....
• If there are more than the rear cutting height.
• Slow down your mowing speed if the mower does not cut leaf cover.
You may need to make more than one or two notches higher than 5 inches (13 cm) of the lawn shows through the cut the leaves finely enough.
14
Operation Manual - Page 15
...mower onto its side, with a hand pump;
Important: Before tipping the mower to change the oil or replace the blade, allow the fuel tank to remove the fuel.
Gasoline is flammable, explosive and can cause personal...that the engine stops within 3 seconds after releasing the blade control bar. • Check the blade brake clutch operation. • Clean grass clippings and ...
Operation Manual - Page 16
... after adding oil to drain the used oil properly at a local recycling
center. Install the dipstick securely. 6. Pull down the cable jacket (toward the mower) until the oil level reaches the Full line on the dipstick (...27). Install the cover. Warm oil flows better and carries more contaminants. 1. Tip the mower onto its side with the air filter up to check the oil level with an API ...
Operation Manual - Page 17
...
27 ft-lb (20 to prevent the blade from stalling while you previously removed. 7. Stiffener 3. Blade brake clutch shield
4. Replacing the Blade
Service Interval: Yearly-Replace the blade or have it sharpened and balanced, or replace it. contacting the blade can result in serious personal injury.
Tip the mower onto its side with the air filter up...
Operation Manual - Page 18
....
• Wear eye protection.
• Stay in the area. For best results, clean the mower soon after you
previously removed. 9. Install the blade brake clutch shield that is running.
• Do not allow bystanders in the operating position (behind the handle) when the engine is connected to a water ...
Operation Manual - Page 19
...Folding the Handle
WARNING
Folding or unfolding the handle improperly can move the
upper handle freely. 3. Recycle it in an enclosure near an
open flame. • Allow the engine to run until you... ml) of hard starting. Important: Route the cables to 15 ft-lb (20 N-m). 9. Removing the Mower from Storage
Connect the wire to local codes, or use it according to the spark plug. Loosen the ...
Operation Manual - Page 20
...Use*
Gas-powered Toro Products used for commercial, institutional, or rental use pending completion of repairs under "Lawn Mowers") or ... you , is covered under this procedure:
1. rotary mower blade striking an object
- improper fuel (consult your home.... Applicable for Commercial Use)
22 in Recycler® 20 in Mulcher/Bagger
Walk Power Mowers
Conditions and Products Covered
The Toro Company...
Parts Catalog - Page 1
Form No. 3371-848 Rev A
22in Recycler® Lawn Mower
Model No. 20333-Serial No. 312000001 and Up
Parts Catalog
Register at www.Toro.com. Original Instructions (EN)
Similar Questions
Toro 22 Inch Recycler Lawn Mower Will Not Start
(Posted by lperjes 10 years ago)
Toro 22in Recycler Lawn Mower Won't Start After Using It 2 Times
(Posted by leonlsea 10 years ago)
Toro 22 In. Recycler Lawn Mower 20333 Wont Start
(Posted by boLdhu 10 years ago)
Toro 22in Recycler Lawn Mower Won't Start 20332
(Posted by Huab 10 years ago)
Why Wont Blade Control Bar Stop My 20332 Toro
(Posted by bostpi 10 years ago)