Toro 20333 Support Question
Toro 20333 Support Question
Find answers below for this question about Toro 20333 - BBC Personal Pace Walk Power Mower.Need a Toro 20333 manual? We have 2 online manuals for this item!
Question posted by mpritchard2 on May 18th, 2012
2011 Toro 20333 Belt Cover Removal
After removing the mower blade, I could not figure out how to remove the belt cover. There are two tabs on the front of the cover, but I could not see any tabs or screws on the rear of the cover. Before I destroyed the cover, I figured I better ask how the trick to removing it.
Current Answers
Answer #1: Posted by roadrunnertim on May 18th, 2012 2:45 PM
roadrunnertim
Member since:
May 9th, 2012 Points: 1,071,190
Member since:
May 9th, 2012 Points: 1,071,190
Answer #2: Posted by datamason on April 25th, 2014 5:43 PM
datamason
Member since:
April 25th, 2014 Points: 0
Member since:
April 25th, 2014 Points: 0
There are definitely two screws you must remove, one of them also holds the line for the deadman switch to the engine. The other is near the water intake fitting (for cleaning the undercarriage). Verrrry strange that the manual could not be bothered to describe the situation clearly. As the cover has a flange toward the rear wheels, you may wish to loosen that adjoining back, plastic plate (not remove, just loosen).
Related Toro 20333 Manual Pages
Operation Manual - Page 1
...lawns on the product.
Figure 1 identifies the location of California to cause cancer, birth defects, or other reproductive harm.
It is intended to highlight information.
This rotary-blade, walk-behind lawn mower is a violation of special attention. You may contact Toro...Recycler® Lawn Mower
Model No. 20333-Serial No....-covered, brush-covered, or grass-covered land. Figure ...
Operation Manual - Page 2
... Operation
• Read, understand, and follow this class of lawn mower will be thrown by the manufacturer. Keep clear of the discharge opening at the time of your footing or balance.
2 Material may be sure of production. walk; Only use accessories approved by the blade. Operation on wet grass or excessively steep slopes. Tall...
Operation Manual - Page 3
...
• Keep machine free of Gasoline
To avoid personal injury or property damage, use extra caution when servicing... bed with manufacturer's recommended parts, when necessary.
• Mower blades are often attracted to cool before starting .
• Check...turn mower off if a child enters the area.
• Never allow children to cool before filling.
• Remove gas-powered equipment ...
Operation Manual - Page 5
...Move the handle to the outside of the handle knobs as you
removed in step 1 (Figure 4).
2
Installing the Handle
No Parts Required
Procedure
WARNING
Folding ... handle knobs that covers the engine.
1
Installing the Blade Control Bar
No Parts Required
Procedure
Install the blade control bar into the upper handle (Figure 3).
1. Figure 3
Figure 4
2. Setup
Important: Remove and discard the ...
Operation Manual - Page 6
...Max.
Air filter 10. Bag-on the dipstick (Figure 5). Washout port (not shown) 13. Spark plug.... Cutting height lever (4)
2.
Grass bag
Figure 7 2. Handle knob (2)
6. Blade control bar 3. Ignition switch
9. Remove the dipstick (Figure 5). 3
Filling the Engine with Oil
Product Overview
No Parts Required
Procedure
Your mower does not come with a bottle of SF...
Operation Manual - Page 7
...unleaded regular is cold. Adjust the cutting height as the rear wheels (Figure 10).
7 Wipe up spills.
• Do not... explosion from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in an approved ...tank with an API service classification of children. Remove the dipstick, wipe it with the moving blade, causing serious injury.
• Stop the...
Operation Manual - Page 9
... try reaching just under the personal pace handle to the metal handle and push the mower forward a couple of inches (centimeters) forward to roll a couple of inches (centimeters). Hold the blade control bar against the handle (Figure 17). Note: If the mower does not freely roll backward after self-propelling, stop walking, hold down the switch in...
Operation Manual - Page 10
...the mower.
5. Important: When you release the blade control bar, the blade should begin to inflate, indicating that the blade brake clutch system is still rotating. If it into the lawn. ... on the mower, remove it (refer to check the blade brake clutch. 1. Release the blade control bar.
If the grass bag is on the mower and the bag-on the mower. 2. Release the blade control bar....
Operation Manual - Page 11
...
1.
Notches 2. Rear deflector
Figure 19 3. Grass bag pin (2)
2. Removing the Grass Bag
To remove the bag, reverse the steps above.
11
If the bag-on the mower, remove it is seated in the recycling position, move it to the bagging position (refer to stop before bagging the clippings. contacting the blade can result in serious personal injury or...
Operation Manual - Page 12
...blade is sharp; If the grass bag is on the mower and the bag-on-demand lever is in the bagging position, move the bag-on -demand door
(open rear discharge area could allow small stones and other similar debris to be thrown in the operator's or bystander's direction and result in serious personal...discharge chute (Figure 22).
12 in recycling or
side-discharging position)
Figure 20
1. ...
Operation Manual - Page 13
...warnings, and keep the mower free of the grass blade at a slower pace while mowing.
- Replace the blade or have it is ...the blade. Figure 22
Removing the Side Discharge Chute
To remove the side discharge chute, lift up the side deflector, remove ...walk slower; This helps disperse the clippings over the lawn for even fertilization.
• If the finished lawn appearance is too long, the mower...
Operation Manual - Page 15
...conditions. WARNING
Tipping the mower may cause the fuel to open the air filter cover
(Figure 24). Gasoline is flammable, explosive and can cause personal injury. Use a screw driver to leak.
Refer ...Figure 24
15
Run the engine dry or remove the gasoline with the air filter up. Important: Before tipping the mower to change the oil or replace the blade, allow the fuel tank to remove...
Operation Manual - Page 16
...drive is simplified for Maintenance. 2. Tip the mower onto its side with the air filter up to warm it.
Figure 25
3. Refer to check the oil level ...filter (Figure 25). Remove the dipstick (Figure 26). fill: 20 oz. (0.59 l), type: SAE 30 detergent oil with the dipstick. Loosen the cable support nut (Figure 28).
1. Figure 27
4. Dipstick
Figure 26
3.
Install the cover.
Install...
Operation Manual - Page 17
... replace it immediately.
Refer to Preparing for Maintenance.
2. Remove the 2 blade nuts and the stiffener (Figure 31).
1. Disconnect the spark plug wire from the spark plug. Tip the mower onto its side with the air filter up . 3. Blade nuts 2. Blade
Figure 31
4. contacting the blade can result in serious personal injury.
Stiffener
3.
Install the stiffener you do not have...
Operation Manual - Page 18
... results, clean the mower soon after you previously
removed (Figure 31). 11. Refer to 37 N-m). Install the blade driver and disk that you previously
removed. 10. Install the blade and the stiffener that...come out from under the mower housing.
7. Turn the water on the mower housing (Figure 32).
1. WARNING
The mower may dislodge material from under the rear deflector where the clippings ...
Operation Manual - Page 20
...covers the cost of a component; year full warranty 1 -
The dealer will diagnose the problem and determine if it stops functioning due to Start) engine will not start your Toro Product by following time periods apply from the date of repairs under "Lawn Mowers...Walk Power Mowers
Conditions and Products Covered
The Toro Company and its affiliate, Toro... blade sharpening or worn blades,...
Parts Catalog - Page 1
Original Instructions (EN) Form No. 3371-848 Rev A
22in Recycler® Lawn Mower
Model No. 20333-Serial No. 312000001 and Up
Parts Catalog
Register at www.Toro.com.
Parts Catalog - Page 3
Contents
Deck, Side Chute and Rear Door Assembly 4 Rear Bag Assembly 5 Engine and Blade Assembly 6 Front Wheel and Height-of-Cut Assembly 7 Transmission and Rear Wheel Drive Assembly 8 Upper Handle Assembly 9 Upper Handle Component Assembly 10 Attachments and Accessories 11
© 2011-The Toro® Company
Contact us at www.Toro.com.
8111 Lyndale Avenue South Bloomington, MN...
Parts Catalog - Page 6
...
20 117-5970
1 Pulley-BBC
21 110-1790
1 Belt-BBC
22 107-0754
1 Drum
23 3211-42
2 Screw-HH
24 108-9342
1 Nut-Hex
25 115-2892
1 Cover-BBC
26 2412-72
1 Clip-Closed, Insulated
27 46-8091
2 Screw-HWH
28 108-3787
1 Disc
29 107-7487
1 Support-Blade
30 108-9764-03 1 Blade-22 Inch
31 108-3766...
Parts Catalog - Page 8
...
12 115-4669
1 Belt-V
13 114-7977-03 1 Bracket-Transmission
Ref. Transmission and Rear Wheel Drive Assembly
Ref. Part Number Qty. Part Number Qty. Description
14 108-7476
3 Screw-Plastite
15 110-7191
...110-1792
2 Wheel Cover ASM
18:2 614426
1 Washer-Stepped
19 614650
2 Bolt-Shoulder
20 115-4695
2 8 Inch Wheel Gear ASM
21 115-8406
2 Anchor-Bag
22 105-9437
2 Screw-PPH
23 115-2893...
Similar Questions
How To Change Drive Belt On Toro Personal Pace Mower Model # 20333
(Posted by sewPhila5 10 years ago)
Toro Recycler Personal Pace 20333 How To Clean Air Cooling System
(Posted by Michipgok 10 years ago)
What Is The Crankcase Capacity Toro Personal Pace Lawnmower?
(Posted by paradugeez 10 years ago)
How To Drain The Oil On A Toro Personal Pace Lawnmower
(Posted by fgyuidal 10 years ago)
Person Pace Feature Stopped Working, Is There An Adjustment I Can Make?
The Personal Pace feature stopped within 10 minutes of first use. The grass was damp at the time. Is...
The Personal Pace feature stopped within 10 minutes of first use. The grass was damp at the time. Is...
(Posted by jhcook1755 13 years ago)