Home » Toro » Lawn Mowers » Toro 20332

Toro 20332 Support Question

Find answers below for this question about Toro 20332 - Recycler 190CC Personal Pace Lawn Mower.
Need a Toro 20332 manual? We have 2 online manuals for this item!

Toro Overview Questions Manuals Reviews Videos Research

Question posted by dlrjmr on September 23rd, 2010

Right Drive Wheel Not Pulling.

Left drive wheel doing all the work, and as a result is often "spinning wheels" Does the rocking drive key need to be replaced in the right axle?

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Toro 20332 Manual Pages

Operation Manual - Page 1

... harm. Other states or federal areas may cause serious injury or death if you need service, genuine Toro parts, or additional information, contact an Authorized Service Dealer or ...Recycler® Lawn Mower Model No. 20332-Serial No. 312000001 and Up Model No. 20334-Serial No. 312000001 and Up Model No. 20352-Serial No. 312000001 and Up Form No. 3371-667 Rev A Operator's Manual Replacement...

Operation Manual - Page 2

... the American National Standards Institute in serious injury or death. never up and down and behind rotary lawn mowers and the B71.1 specifications of objects such as rocks, wire, toys, etc., which can result in wet grass. Replacements may ricochet back toward anyone enters the area. • Do not operate machine barefooted or while wearing...

Operation Manual - Page 3

...Service Safe Handling of Gasoline To avoid personal injury or property damage, use extreme care in safe working condition. • Never tamper with the engine running . Replace gas cap and tighten securely. General ...with a portable container, rather than the operator. • Be alert and turn mower off if a child enters the area. • Never allow children to be sure...

Operation Manual - Page 5

...install the handle. 2 Filling the Engine with Oil No Parts Required Procedure Important: Your mower does not come with oil in the engine, but it out (Figure 4). Install and ...fill the engine with a clean cloth. 4. Move the mower to the operating position. 3. Remove the dipstick by rotating the cap counterclockwise and pulling it does come with an API service classification of oil....

Operation Manual - Page 8

... severely burn you feel resistance, then pull it sharply (Figure 12). Note: To raise the mower, move the front cutting height levers forward and the rear cutting height levers rearward. 1. Note: When you pull the recoil start handle (Figure 12). Adjust the cutting height as the rear wheels (Figure 9). Hold the blade control bar...

Operation Manual - Page 9

... try reaching just under the personal pace handle to the metal handle and push the mower forward a couple of inches (centimeters) forward to disengage the wheel drive. Important: When you want to collect grass and leaf clippings from the factory ready to recycle the grass and leaf clippings back into the lawn. Bagging the Clippings Use the...

Operation Manual - Page 10

... blade is attached to the mower. • For bagging the grass and leaf clippings, press the button on the bag-on-demand lever and move the • For recycling the grass and leaf clippings,... the blade can result in serious personal injury or death to stop before cleaning the bag-on-demand door and the surrounding opening (Figure 16) before you to either collect or recycle grass and leaf ...

Operation Manual - Page 11

...-demand lever is sharp; contacting the blade can result in the bagging position, move the lever to the recycling position (refer to stop before leaving the operating ...position. Stop the engine and wait for cutting very tall grass. WARNING The blade is in serious personal ...on the mower and the bag-on -Demand Lever).

Operation Manual - Page 12

...replacement blade. Walk at 2-1/2 inches (64 mm). Set the cutting height on the lawn, set the front wheels at 2-1/8-inch (54 mm) and the rear wheels at a slower pace while mowing. - Cutting Leaves • After cutting the lawn.... • If the finished lawn appearance is too long, the mower may need to clump on your mowing speed if the mower does not cut the leaves finely...

Operation Manual - Page 13

...Maintenance 1. tip the mower prior to running out of the machine from under the mower. • Replace the air filter; Gasoline is flammable, explosive and can cause personal injury. After performing the...find the nearest dealer) or at www.shoptoro.com. Maintenance Note: Determine the left and right sides of fuel, use or daily Every 25 hours Before storage Yearly Maintenance Procedure...

Operation Manual - Page 14

... the dipstick (Figure 20). Return the mower to a level surface. 2. Note: If the oil level is at a local recycling center. 14 Move the mower to the operating position. 6. Insert the... minutes for the oil to Preparing for Maintenance. 3. Replacing the Air Filter Service Interval: Every 25 hours 1. Install the cover. 1. Tip the mower onto its side with oil and run the engine. Wipe...

Operation Manual - Page 15

... charge, recycle or dispose of...mower wire harness located below the ignition key... (Figure 22). • A green light indicates that the charger is fully charged or the charger is disconnected from the battery. • A flashing light that alternates between red and green indicates that indicates the following states of California to local codes. Replace... 3. Replacing the ..., pull out the...

Operation Manual - Page 17

... best results, clean the mower soon after you install a new self-propel cable or if the self-propel drive is simplified for a few minutes to dry the housing to prevent it from the mower. 9. Move the mower onto... bag-on the mower housing (Figure 28). Allow the engine to overtighten. ratchet or wrench and tighten the bolt securely. Pull down the cable jacket (toward the mower) until there are...

Operation Manual - Page 18

... to local codes, or use it according to the spark plug. 18 Recycle it in a heated area, you can move the upper handle freely. ... the ignition key (electric-start models only). To unfold the handle, reverse the steps above. Storage Folding the Handle Store the mower in an ... Run the mower until the engine stops from running out of oil through the spark plug hole, and pull the starter ...

Operation Manual - Page 20

...and engine warranty coverage on the first or second pull, provided the routine maintenance required in the Operator's...Dealer. This can no other rights which has been altered or misused and requires replacement or repair due to accidents...Lawn Mowers") or access our web site at 866-214-9807 (U.S. Repair by these warranties. This warranty covers the cost of purchase: Products 22 in Recycler...

Parts Catalog - Page 1

Original Instructions (EN) Form No. 3371-846 Rev A 22in Recycler® Lawn Mower Model No. 20332-Serial No. 312000001 and Up Parts Catalog Register at www.Toro.com.

Parts Catalog - Page 2

...Replacement Parts To order replacement parts, please supply the part number, the quantity, and the description of this type appear in illustration and in parts lists. For example, a wheel assembly might be identified by reference number 6, the tire by 6:1, the valve by 6:2, and the wheel...forming HYD: hydraulic LH: left hand LP: Liquid Propane ... power-take-off RH: right hand ROPS: roll-over ...

Parts Catalog - Page 3

Contents Deck, Side Chute and Rear Door Assembly 4 Rear Bag Assembly 5 Engine and Blade Assembly 6 Front Wheel and Height-of-Cut Assembly 7 Transmission and Rear Wheel Drive Assembly 8 Handle Assembly 9 Attachments and Accessories 10 © 2011-The Toro® Company Contact us at www.Toro.com. 8111 Lyndale Avenue South Bloomington, MN ...

Parts Catalog - Page 7

Front Wheel and Height-of-Cut Assembly Ref. Part Number Qty. Description 1 115-1956-03 2 Plate-HOC, Front 2 322-3 4 Screw-HH 3 3296-29 6 Nut-Lock, NI 4 105-... 2 Arm-Spring 7 110-0549 2 Knob-HOC 8 105-3048 2 Washer-Flat 9 322-6 2 Screw-HH 10 40-1940 2 Washer 11 614650 2 Bolt-Shoulder 12 115-2894 2 8 Inch Wheel ASM C2 7 3371-846A

Parts Catalog - Page 8

Part Number Qty. Transmission and Rear Wheel Drive Assembly Ref. Description 1 114-7955-03 1 Plate-Rear, LH (HOC) 2 114-7956-03 1 Plate-Rear, RH (HOC) 3 ...4668 2 Gear-Pinion, 12T 17 32151-61 2 Ring-Retaining 18 110-1792 2 Wheel Cover ASM 18:2 614426 1 Washer-Stepped 19 614650 2 Bolt-Shoulder 20 115-4695 2 8 Inch Wheel Gear ASM 21 115-8406 2 Anchor-Bag 22 105-9437 2 Screw-PPH 23...