Toro 20332 Support Question
Toro 20332 Support Question
Find answers below for this question about Toro 20332 - Recycler 190CC Personal Pace Lawn Mower.Need a Toro 20332 manual? We have 2 online manuals for this item!
Question posted by mrajkp2 on August 8th, 2014
How To Replace Spring On Toro Recycler Lawn Mower
The person who posted this question about this Toro product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by freginold on September 14th, 2014 5:11 AM
freginold
Member since:
December 20th, 2011 Points: 23,253,885
Member since:
December 20th, 2011 Points: 23,253,885
Hi, you can find instructions for replacing that spring on FixYa:
http://www.fixya.com/support/t12634843-replace_torsion_spring_in_handle_toro
http://www.fixya.com/support/t12634843-replace_torsion_spring_in_handle_toro
Related Toro 20332 Manual Pages
Operation Manual - Page 1
... Toro directly at www.Toro.com for cutting grass on well-maintained lawns ...Toro.com. It is not equipped with Canadian ICES-002.
© 2011-The Toro...Toro parts, or additional information, contact an Authorized Service Dealer or Toro...blade, walk-behind lawn mower is not designed for...California to highlight information. 22in Recycler® Lawn Mower
Model No. 20332-Serial No. 312000001 and Up...
Operation Manual - Page 2
...and the California Emission Control Regulation of accessories. Replacements may ricochet back toward anyone enters the area....observe the following safety instructions could be sure of lawn mower will be ordered through the engine manufacturer. Exercise ...ANSI/OPEI standard B71.1-2003. As configured to potential personal injury hazards.
The following safety instructions. Always look down...
Operation Manual - Page 3
...• Check grass catcher components and the discharge guard frequently and replace with manufacturer's recommended parts, when necessary.
• Mower blades are explosive.
• Extinguish all cigarettes, cigars, pipes,...foreign object, stop and inspect the machine. Service
Safe Handling of Gasoline
To avoid personal injury or property damage, use a nozzle lock-open flame, spark, or pilot ...
Operation Manual - Page 4
...blade is identified as a part from moving parts.
5. Cutting/dismemberment hazard of hand or foot, mower blade-stay away from the original machine manufacturer.
94-8072
104-7953
1. stop the engine before ...near areas of hand or foot, mower blade-remove the ignition key and read the Operator's Manual.
2. Replace damaged decals. Cutting/dismemberment hazard of potential danger.
Operation Manual - Page 5
...sheet that you install the handle.
2
Filling the Engine with Oil
No Parts Required
Procedure
Important: Your mower does not come with an API service classification of oil into the oil fill tube, then remove the ...as you
removed in step 1 .
1. Move the handle to a level surface. 2. Move the mower to the operating position. 3. Note: If the oil level is below the Add mark on the dipstick. Remove...
Operation Manual - Page 7
...gasoline (having an octane rating of 87 or higher) from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in an approved fuel container, out of the reach of oil into...or sparks.
• Store gasoline in a vehicle or on the dipstick. Move the mower to the fuel all season, mixing it with oil and run the engine. Note: Never use or daily
Note: Max...
Operation Manual - Page 8
...) (electric-start models only) or pull the recoil start handle, pull it lightly until you . Lower the mower
Note: The cutting height settings are 1 inch (25 mm); 1-3/8 inches (35 mm); 1-3/4 inches (44 ...(83 mm); 3-5/8 inches (92 mm); Starting the Engine
1. To lower the mower, move the front cutting height levers rearward and the rear cutting height levers forward. Keep away from the hot...
Operation Manual - Page 9
... Authorized Service Dealer. If they do not stop properly, stop the engine, release the blade control bar. Recycling the Clippings
Your mower comes from the lawn. contacting the blade can also try reaching just under the personal pace handle to Operating the Bag-on -Demand Lever) before bagging the clippings. Figure 12
Stopping the Engine...
Operation Manual - Page 10
...other similar debris to be thrown in the operator's or bystander's direction and result in serious personal injury.
Rear deflector
Figure 14 3. Important: For proper operation, remove any grass clippings and ...allows you to either collect or recycle grass and leaf clippings while the grass bag is sharp; Stop the engine and wait for all moving parts to the mower. • For bagging the ...
Operation Manual - Page 11
...is sharp;
contacting the blade can result in the bagging position, move the lever to the recycling position (refer to stop before leaving the operating position. Installing the Side Discharge Chute
Lift up ...discharge chute, and lower the side discharge deflector.
11 If the grass bag is on the mower and the bag-on -Demand Lever). Stop the engine and wait for cutting very tall grass...
Operation Manual - Page 12
... examine the mower for damage.
• For best performance, install a new blade before the cutting season begins.
• Replace the blade when necessary with a Toro replacement blade. Replace the blade or...blade at a slower pace while mowing.
- then mow again at 2-1/2 inches (64 mm). For example, set the front cutting height one pass over the lawn for the best lawn appearance. Mow only in...
Operation Manual - Page 13
... plug wire from an Authorized Service Dealer (go to www.toro.com to remove the fuel. After performing the maintenance procedure... tip the mower prior to running out of the machine from under the mower.
• Replace the air filter; never siphon. replace it more ...operator's manual for all moving parts to leak. WARNING
Tipping the mower may cause the fuel to stop.
2. If you must
13...
Operation Manual - Page 14
... 21).
Wait 3 minutes for Maintenance. 3.
Replace the air filter (Figure 19). 3. Dipstick
Figure 20
4. Read the oil level on the dipstick reads Full. 11. Tip the mower onto its side with the air filter up ...level on the dipstick. Drain the excess oil until the oil level is at a local recycling center.
14 Wipe the dipstick clean with oil and run the engine. Note: If the...
Operation Manual - Page 15
...Battery compartment
Figure 22
2. Remove the screw that the battery is fully charged. Replacing the Fuse
Electric-start models only
WARNING
CALIFORNIA Proposition 65 Warning Battery posts, terminals,...battery.
2. Note: When the battery no longer holds a charge, recycle or dispose of the lead-acid battery according to the mower wire harness
located below the ignition key (Figure 22).
•...
Operation Manual - Page 16
... 25). Fuse holder
4. Install the covering over the battery compartment. 7.
Tip the mower onto its side with a spare fuse in step 3. 6. 1 2 3
1. Replace the fuse in serious personal injury. If you removed in the battery compartment. 5. Fuse
Figure 24
G017398
2.
Note: Your mower comes with the air filter up. 3. Install the battery compartment with a block...
Operation Manual - Page 17
... engine is out of clarity.
1. ratchet or wrench and tighten the bolt securely. Lower the mower to prevent it for the purpose of adjustment, adjust the self-propel drive cable. 1.
Start the... engine and run it until
there is connected to a water supply to cool before storing the mower in the area. This bolt is simplified for a few minutes to dry the housing to its lowest...
Operation Manual - Page 18
... explode.
• Do not store gasoline more than 30 days.
• Do not store the mower in the fuel tank is the leading cause of the handle knobs as directed by the engine manufacturer... than 30 days, and do not store stabilized fuel more than 90 days.
3. Figure 29
4. Recycle it according to cool before storing it stops. Charge the battery for 24 hours (electric-start the ...
Operation Manual - Page 20
...Recycler® 20 in Mulcher/Bagger
Walk Power Mowers
Conditions and Products Covered
The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly promise to repair the Toro Product listed below if used commercially*.
The following the maintenance procedures described in early spring... "Lawn Mowers") or access our web site at Toro Warranty...
Parts Catalog - Page 1
Original Instructions (EN) Form No. 3371-846 Rev A
22in Recycler® Lawn Mower
Model No. 20332-Serial No. 312000001 and Up
Parts Catalog
Register at www.Toro.com.
Parts Catalog - Page 4
Deck, Side Chute and Rear Door Assembly
Ref. Description
16 114-7959
1 Latch-Recycle
17 117-1031
1 Spring-Compression
18 32104-120
2 Screw-PPH
19 121-5776
1 Rear Door ASM
19:2 114-7982
1 Decal-Warning
20 115-2859
1 Spring-Torsion
21 114-7924
1 Spring-Torsion
22 112-6400
1 Port-Washout
23 112-6401
1 Coupling-Hose...
Similar Questions
How To Replace Personal Pace Cable On Toro 22 Inch Recycler Lawn Mower
(Posted by Ericer 10 years ago)
Toro 190cc Personal Pace Won't Start
(Posted by Soupokef 10 years ago)
How Do You Replace The Traction Bar On A Toro Personal Pace Mower
(Posted by pdfecool 10 years ago)
How To Replace Control Cable# 107-0799 On A Personal Pace Toro Lawn Mower
(Posted by biglou01 10 years ago)
How To Change Oil On A Toro Recycler (22 ) 190cc Personal Pace Lawn Mower
(Posted by tinaScamp1 10 years ago)