Get support for TP-Link TD-W8951ND

TP-Link TD-W8951ND Support Question

TP-Link TD-W8951ND Support Question

Find answers below for this question about TP-Link TD-W8951ND.
Need a TP-Link TD-W8951ND manual? We have 2 online manuals for this item!
Question posted by rosjw on May 25th, 2014

How Block Port On Tp Link Router Tp-link Td-w8951nd

The person who posted this question about this TP-Link product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related TP-Link TD-W8951ND Manual Pages

User Guide - Page 4

...DECLARATION OF CONFORMITY For the following equipment: Product Description: 150Mbps Wireless N ADSL2+ Modem Router Model No.: TD-W8951ND Trademark: TP-LINK We declare under our own responsibility that the above products satisfy all the technical regulations applicable... responsible for marking this declaration: Yang Hongliang Product Manager of International Business TP-LINK TECHNOLOGIES CO., LTD.
User Guide - Page 8

... RJ45 LAN ports (Auto MDI/MDIX), one RJ11 port. ¾ Provides external splitter. ¾ Adopts Advanced DMT modulation and demodulation technology. ¾ Supports bridge mode and Router function. ¾...TD-W8951ND supports full-rate ADSL2+ connectivity conforming to the Internet using ordinary telephone line with standard connectors. Wireless In the most attentive wireless security, the Router...
User Guide - Page 10

...no successful PPP connection or the Router works on the corresponding 1-4 (LAN) port but no activity. TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide Chapter 2 Hardware Installation ...port is being transmitted. Data is linked down. There is abnormal. There is no connection on the corresponding 1-4 (LAN) port or the connection is a successful connection on Bridge...
User Guide - Page 11

...LAN): Through the port, you can connect the router with the telephone. Or you can be exposed to moisture or excessive heat. ¾ Place the Router in a location ...Router will be connected to the various devices as well as to a power source. ¾ Make sure the cables and power cord are two ways to reset the Router's factory defaults. TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router...
User Guide - Page 12

...; PHONE: Connect to the phone sets • MODEM: Connect to the ADSL LINE port of TD-W8951ND Plug one end of the twisted-pair ADSL cable into the ADSL LINE port on the rear panel of electromagnetic sensitive. 2.4 Connecting the Router Before installing the device, please make calls at the same time. Step 2: Connect the...
User Guide - Page 17

...Router correct? Figure 3-7 11 The LEDs of the Router in the URL field: 192.168.1.1. You can check it means that , you link... to the Router. TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide ...port which you will see the screen shown below, enter the default User Name admin and the default Password admin, and then click OK to access to the Quick Setup screen. If the Router...
User Guide - Page 23

... total Bytes Receive Statistics Receive CRC Errors The total bytes received over the Ethernet port. TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide ¾ Interface: You can select Ethernet, ADSL and WLAN to view the corresponding network traffic over different ports. ¾ Select Ethernet, and you will see the statistics table as below . 17...
User Guide - Page 24

...WLAN when wireless data is being transmitted. The total errors occurred over the ADSL port when data is being transmitted. Statistics Table: Tx Frames Count Transmit Tx Errors...The drops occurred over the WLAN when wireless data is being transmitted. TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide Statistics Table: Transmit total PDUs Transmit Statistics Transmit total Error ...
User Guide - Page 25

Figure 4-6 19 TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide Figure 4-5 Click any of them, and you will be able to configure the corresponding function. 4.3.1 Internet Choose "Interface Setup→Internet" menu, you can configure the parameters for WAN ports in the next screen (shown in Figure 4-6).
User Guide - Page 30

TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide ¾ MAC Spoofing: Enable the MAC Spoofing, and enter a MAC address to make the settings take ... as a device with this type of the same physical LAN. Please configure the parameters for LAN ports according to the outside world. 4) Bridge Mode If you finish the Internet configuration, please click SAVE to configure the WAN...
User Guide - Page 32

... IP Address: Enter the starting IP address for Dynamic Host Control Protocol. TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide connected to it is necessary for you to enter the primary and...network. If Use User Discovered DNS Server Only is 259200 seconds. • Physical Ports: Specify the Physical Ports of time for the IP lease. The DHCP Server gives out IP addresses when a...
User Guide - Page 33

... IP Address runs on the LAN port, and make sure the routing table has the correct routing entry. To have this function working properly, please run on router mode only, disable the DHCP server...Each of the device's interfaces can be configured as a DHCP Relay. TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide addresses. After type in the address, click SAVE button to the DHCP ...
User Guide - Page 37

... server for each packet transmitted. • AES (Advanced Encryption Standard) - TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide 2) WEP-128Bits To configure WPA-64Bits settings, select the WPA-...wireless encryption protocol that uses symmetric 128-bit block data encryption. ¾ Pre-Shared Key: Enter the key shared by the Router and your other network devices. It must have...
User Guide - Page 44

... (shown in Figure 4-27). Figure 4-26 Click ADD ROUTE button to the destination. TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide Figure 4-25 ¾ Firewall: Select this destination. ¾ Gateway IP ...the subnet mask for this option can automatically detect and block Denial of Service (DoS) attacks, such as Ping of Death, SYN Flood, Port Scan and Land Attack. ¾ SPI: If you...
User Guide - Page 45

... for current VC. It can set to Yes, the route to this link. for routing purposes. A DMZ (demilitarized zone) is to activate the ...Router (shown in Figure 4-6) to specify how many IPs are provided by your Router; If No, this remote node in the next screen. This field is a host between 1 and 15. It prevents outside public network. TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router...
User Guide - Page 46

... though NAT makes your LAN. ¾ Protocol: The protocol used for setting up public services on your whole inside network appear as Start port number. TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide Figure 4-29 ¾ DMZ Host IP Address: Enter the specified IP Address for DMZ host on the LAN side. 4.4.3.2 Virtual...
User Guide - Page 56

...: Enter the Subnet Mask for the rule. ¾ Port Number: Enter the Port Number for the filter rule. ¾ Rule Unmatched: If the current rule can not match, and you can enter 0, which means that all IP addresses are (1, 1), (1, 2) and (1, 3). TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide ) Note: You should set of IP...
User Guide - Page 57

..., click the SAVE to configure the next two rules: Block E-mail received by the IP address 192.168.1.7 on your local network; TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide ) Note: If you complete the IP filter... 3: Enter the "Source IP Address", "Destination IP Address", "Subnet Mask" and "Port Number" in Figure 4-39: Select the IP / MAC Filter Set Index and IP/MAC Filter Rule Index ...
User Guide - Page 68

TD-W8951ND 150Mbps Wireless N ADSL2+ Modem Router User Guide TD-W8951ND Figure 4-54 To restore the Router's settings: Step 1: Click the Browse button to factory default settings in the screen (shown in "New Romfile Location" field. Step 2: Click the UPGRADE button to ...
Setup Guide - Page 1

...) to the DSL port on the router and to the wall socket 3. Enter 192.168.1.1 in the address bar and press Enter 3. Open your computer 2. Enter admin as User Name and Password and click OK (Fig. 1) SETTING UP YOUR INTERNET ACCOUNT 1. Wireless N ADSL2+ TPLink TD-W8951ND Modem/Router STARTING UP THE MODEM ROUTER 1. Click on NEXT...

Similar Questions

Ask a New Question
Use the box below to post a new question about this TP-Link product .
Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

TP-Link Manuals

Find free TP-Link TD-W8951ND manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

TP-Link Reviews

View thousands of TP-Link user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete TP-Link customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed TP-Link customer service rankings, employee comments and much more from our sister site.