Poulan PB19542LT Support Question
Poulan PB19542LT Support Question
Find answers below for this question about Poulan PB19542LT.Need a Poulan PB19542LT manual? We have 1 online manual for this item!
Question posted by ranch3g on May 7th, 2013
Mower Blade Drive Belt
What is the mower blade drive belt part #
Current Answers
Answer #1: Posted by freginold on May 12th, 2013 7:52 AM
freginold
Member since:
December 20th, 2011 Points: 23,253,885
Member since:
December 20th, 2011 Points: 23,253,885
Hi, according to page 33 of the manual, the drive belt is part #194346. Amazon.com sells this belt for $1.78 plus shipping. If you need a copy of the manual, you can download it here:
http://www.poulan.com/ddoc/POUO/POUO2006_USen/POUO2006_USen_411188_.pdf
http://www.poulan.com/ddoc/POUO/POUO2006_USen/POUO2006_USen_411188_.pdf
Related Poulan PB19542LT Manual Pages
User Manual - Page 1
Failure to do so can result in the U.S.A. IMPORTANT MANUAL
DO NOT THROW AWAY
03076
OWNER'S MANUAL
MODEL:
PB19542LT
LAWN TRACTOR
WARNING:
Read this Manual and follow all Warnings and Safety Instructions.
ALWAYS WEAR EYE PROTECTION DURING OPERATION Visit our website: www.poulan-pro.com
419055 Rev 1 02.08.08 TH
Printed in serious injury.
User Manual - Page 2
... you to lose control of California to stabilize the machine by the blades.
• Keep all times.
• Only allow the mower deck to plow leaves or other debris which can hide obstacles. &#... engine parts and burn. If the tires lose traction, disengage the blades and proceed
• Clear the area of riding mower-related injuries.
you cannot back up the slope or if you will ...
User Manual - Page 3
...have been given rides in the past may suddenly appear in the mowing area for Ride-On Mowers
III. They
may block your vehicle when filling. • Remove gas-powered equipment from ... is spilled on a truck or trailer bed with manufacturer's recommended parts, when necessary. • Mower blades are often attracted to be sure the equipment
is not alert to stop or shift while on the...
User Manual - Page 8
... -rear for best cutting results. (Tires must be properly leveled. Verify that all connections are still secure and wires are shown for replacing motion and mower blade drive belts in the Service and Adjustments section of this manual.
See "TO CHECK BRAKE" in the Service and Adjustments section of this manual.
✓CHECKLIST
BEFORE...
User Manual - Page 10
.../CHOKE CONTROL - ATTACHMENT CLUTCH LEVER - CLUTCH/BRAKE PEDAL -
Used to engage the mower blades, or other attachments mounted to your tractor to the applicable safety standards of various controls... and controlling engine speed.
10 PARKING BRAKE - Selects the speed and direction of mower deck or other powered attachment while in reverse. Save this manual for starting and stopping...
User Manual - Page 11
... engine. • Depress clutch/brake pedal into full "BRAKE" position.
• Slowly release clutch/brake pedal to neutral (N) position. Fig. 5
D
STOPPING (See Fig. 6)
MOWER BLADES -
• To stop ground drive, depress clutch/brake pedal into full "BRAKE" position
and hold tractor secure.
B C
IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY POSITION OTHER THAN "OFF...
User Manual - Page 12
... pedal to reposition the machine with attachment lift lever. • Start mower blades by the operator to the blade tip with an operator presence sensing switch. These heights are measured from hesitating... to start movement.
• When use of grass being mowed. • The average lawn should only be cut relatively high; The heights are approximate and may vary depending upon soil...
User Manual - Page 14
...starts. If the engine does not start by selecting a low enough gear to give the mower cutting performance as well as the quality of cut desired.
• When operating attachments, select..." position.
• Move throttle control to the fast position.
• The attachments and ground drive can also be used for more than fifteen seconds per minute.
NOTE: If at full throttle when...
User Manual - Page 15
... Check for Loose Fasteners C Check/Replace Mower Blades T Lubrication Chart 0 Check Battery Level R Clean Battery and Terminals
Check Transaxle Cooling
Check Mower Levelness
Check V-Belts
Check Engine Oil Level
Change Engine Oil ...you should replace the spark
plug, clean or replace air filter, and check blades and belts for wear. VISCOUS LUBRICANTS WILL ATTRACT DUST AND DIRT THAT WILL SHORTEN THE...
User Manual - Page 16
... the engine.
• The attachment clutch should be taken to keep the blade balanced. BLADE REMOVAL (See Fig. 14)
• Raise mower to highest position to allow access to shift into reverse should shut off the engine. BLADE CARE
For best results mower blades must be checked and adjusted. (See "TO CHECK BRAKE" in the Service...
User Manual - Page 17
...belts are not adjustable. To open or remove caps or covers. Remove the drain tube and replace the cap onto to the bottom fitting of drain valve and install
the drain tube onto the fitting. Do not overfill. If blade...battery (See "REPLACING BATTERY" in a horizontal position. Adding or checking level of the blade moves downward, sharpen the heavy end until the pin is not used above 32°...
User Manual - Page 18
... fuel filter should be kept free of dirt and chaff to prevent engine damage from tractor and mower.
18
SPARK PLUGS
Replace spark plugs at the beginning of each season. CLAMP
CLAMP
FUEL FILTER...air cleaner more than 100 hours in engine or transmission will not run properly using a garden hose or pressure washer to clean your tractor. See Engine Manual. MUFFLER
Inspect and replace ...
User Manual - Page 19
... • Turn ignition key to "STOP" and remove key. • Make sure the blades and all moving parts have completely stopped. • Disconnect spark plug wire from spark plug and...to its lowest position. • Remove mower belt from engine pulley (M). • Remove retainer spring (K), slide collar (L) off and push
housing guide (P) out of mower and disconnect the suspension arm and rear ...
User Manual - Page 20
... clutch cable spring (Q) into bracket, slide
collar (L) onto guide and secure with washer and retainer spring. • Repeat on engine pulley (M). FIG. 23
IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES.
• Raise attachment lift lever to highest position. • If necessary, adjust gauge wheels before operating...
User Manual - Page 21
... the high side. • Go to side of blade to raise the mower. Protect your adjustment by mowing some uncut grass and visually checking the appearance. NOTE: As desired, you are satisfied with wrench and tighten jam nut securely against adjustment nut.
21 Protect your lawn appears
unevenly cut, determine which side of...
User Manual - Page 22
... wheels rotate, then the brake needs to be replaced without tools. SERVICE AND ADJUSTMENTS
TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 29)
The mower blade drive belt may also check brake by: • Park tractor on level surface. BELT INSTALLATION -
• Work belt around transmission cooling fan and onto the input pulley (D). Park the tractor on bottom side of...
User Manual - Page 25
... during
long periods of this manual). • Inspect and replace belts, if necessary (See belt re- ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR... USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE.
TRACTOR
Remove mower...
User Manual - Page 26
... fuel tank and carburetor, refill tank with fresh, clean gasoline. 6. Bent blade mandrel. 3. Tighten blade bolt. 2.
Empty fuel tank and carburetor, refill tank with fresh, clean ...fast. 2. Dirty fuel filter. 8. Spark plug wire loose. 11. Engine valves out of mower housing. 4. Clean underside of adjustment.
1. Out of adjustment.
8. CORRECTION
1. Replace spark ...
User Manual - Page 27
...equipped). 4. Engine continues to dry before mowing. 4. Check wiring, switches and connections. Poor cut - Bent blade mandrel. 5. Worn/damaged mower drive belt. 3. Low/uneven tire air pressure. 6. Check tires for proper air pressure. 6. Replace mower drive belt. 9. Loose or damaged wiring. 5. Replace fuse. Check/clean all connections. 3.
TROUBLESHOOTING POINTS
PROBLEM
CAUSE...
User Manual - Page 30
... Warranty within the meaning of that this warranty must be defective due to be maintained in replacing parts, any power equipment unit or attachment are belts, blades, blade adapters, normal wear, normal adjustments, standard hardware and normal maintenance.
7. This Warranty does not apply to any product which vary from date of purchase by...
Similar Questions
Poulan Pro Riding Lawn Mower / Model Pr1742st
Belt configuration for drive belt?
Belt configuration for drive belt?
(Posted by ddheadrick 10 years ago)
Are Their Anyway To Adjust Drive Belt? Replaced To Tight Wont Roll Locked Rear E
(Posted by martyc05 11 years ago)