Pfaff hobbylock 774 Support Question
Pfaff hobbylock 774 Support Question
Find answers below for this question about Pfaff hobbylock 774.Need a Pfaff hobbylock 774 manual? We have 1 online manual for this item!
Question posted by momolloy2003 on September 25th, 2014
How Much Does A New Pfaff Hobby Lock 774 Cost?
The person who posted this question about this Pfaff product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by TommyKervz on September 25th, 2014 11:37 PM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,813
Member since:
January 10th, 2013 Points: 17,776,813
Related Pfaff hobbylock 774 Manual Pages
Owner's Manual - Page 2
...
6
C. Some adjustments / Maintenance
15
a. Replacing the upper knife
17
e. Preparation for fabrics and thread stitch length
10
e. How to obseave during sewing
13
i. 3-thread overedge seam
14
D. Operating the machine
9
a. Adjusting the stitch length
15
c. Points to adjust the foot controller
4
d. Adjusting the seam width
15
b. Dial chart for thread tension...
Owner's Manual - Page 5
... controller First, insert the controller connector into the connector socket on a flat and horizontal surface or purpose-built sewing machine table. When you press down gently, the machine will run faster. To stop the machine, lift your foot lightly on and by the master switch located right side of your foot from the pedal...
Owner's Manual - Page 6
Apply just one or two drops of oil to use a good quality sewing machine oil. Lubrication The bushings and other important parts are made from special materials and only require lubrication once or twice a month. When oiling always be sure to the areas indicated.
5 e.
Owner's Manual - Page 7
... seam.
3. To close the looper cover, push the looper cover upwards lightly towards you.
3. g.
Ensure that it locks.
2. Tweezers from the accessories bag will assist you to the right, swing it down towards the machine until it clicks and it will close side cover, push it to the right until it immediately...
Owner's Manual - Page 9
... commencing to sew) that the correct results are to avoid any breakage of thread that are achieved.
8 Lastly thread the left needle
surplus thread about 5 cm (about 2") beyond needle eyes. Once you are satisfied that the tension balance is not taken. Be careful when passing these threads through the machine, so as...
Owner's Manual - Page 10
... the machine
a. b. Thread tension adjustment (Normal hemming) The correct thread tension varies depending on the fabric and type and thickness of the upper cutter and start sewing slowly...right hand. c. Procedure 1. Checking the threads being interlocked. 2.
By refering to make a test sewing before actual operation.
Insert the cloth under the presser foot up to the edge of the thread...
Owner's Manual - Page 13
... lower the shank until connecting points are in contact, then lower the presser foot and the new foot will then be taken off.
2. g. The foot for normal sewing can be achieved.
1 . By following this instruction, very good sewing results can then be engaged.
• Correct thread tension of roll hemming
Top side Narrow...
Owner's Manual - Page 14
... of the seam then cut the thread chain.
• Securing the seam: Tie the thread chain. Then, flip fabric over and sew over the seam ap proximately 2 cm.
• This machine will feed automatically and genUy guide by hand. • Do not push or pull the material so as to very heavy...
Owner's Manual - Page 15
For wide seam sewing. 1. Seam width can be changed from 5 mm to 5 mm.(Standard seam width is possible by using either...is 5.5 mm). Remove the right hand needle. 2. Use the right hand needle thread and right & left hand needle. 2.
For narrow seam sewing. 1. Remove the left looper thread. 3. Use the left hand needle thread and right & left hand needle only. Seam width can be changed...
Owner's Manual - Page 17
... size is important to No. 90 may be used. Ensure you carry out this position, insert new needle(s) fully upwards into the needle holder(s) making sure that the long groove in the needle(s) ...hand, (in this procedure correctly as to the highest position. It is No.90.
Fitting new needle(s) Whilst in the direction of the illustrations below:
The needle clamp screw for heavier ...
Owner's Manual - Page 18
... will be brought firmly against the lower knife and behind the guard on the presser foot. If it to touch the blade.
2. Fitting a new upper knife Place the new knife onto the carrier stopper (in this position, re-tighten the screw (A) securely, using a screwdriver, retighten the retaining screw (A) securely. When in the...
Owner's Manual - Page 19
Fitting a new lower knife Insert the knife into the right the upper knile release knob turning it anti-clockwise to release the upper knife (as described on ...
Owner's Manual - Page 20
Insert the new bulb by pushing upward, turning it . f. Caution: Use a maximum 1 5 watt bulb only.
19 Replace cover. Replacing the light bulb FIRST DISCONNECT THE MAINS PLUG FROM THE POWER SOURCE • Loosen the screw of the rear of the machine body and remove the lamp cover.
• Turn the bulb in direction (1) and remove it in the direction (2).
Owner's Manual - Page 21
... needle. Incorrect stitch formation
Incorrect setting of these difficulties. E. Sewing problems and solutions
Used correctly, your machine should operate efficiently and without difficulty. Check whether thread is bent or point damaged Needle not correctly inserted Material pulled
Insert new needle.
Problem
Cause
Solution
Needle breakage
Needle is caught at the reel stand, etc...
Similar Questions
Pfaff 774 Hobbylock Serger
what is the piece that holds the 2 needles and has a screw called?
what is the piece that holds the 2 needles and has a screw called?
(Posted by Cupuls04 1 year ago)
Open Machine Hobby Lock 788 Serger Something Loose Inside
how to open hobby lock 788 serger something loose inside
how to open hobby lock 788 serger something loose inside
(Posted by andredutoit57 3 years ago)
Doing Hem Roll On My Hobbylock 774
How do I do a hem roll on my hobbylock 774. Do I need yo change the footer
How do I do a hem roll on my hobbylock 774. Do I need yo change the footer
(Posted by litasansan 7 years ago)
Does The Pfaff Hobby Lock 788 Have A Flat Lock Option?
Does the Pfaff hobby lock 788 have a flat lock option?
Does the Pfaff hobby lock 788 have a flat lock option?
(Posted by wethreewanchas 9 years ago)
I Need A Tiny Screw To Hold The Needle In My Pfaff Hobbylock 774 Serger
this tiny screw has a leg to it. i have found screws that have no leg and does not keep the needle s...
this tiny screw has a leg to it. i have found screws that have no leg and does not keep the needle s...
(Posted by rebeccazamora012 11 years ago)