Panasonic EP1015 Support Question
Panasonic EP1015 Support Question
Find answers below for this question about Panasonic EP1015 - MASSAGE LOUNGER - MULTI-LANG.Need a Panasonic EP1015 manual? We have 1 online manual for this item!
Question posted by anil7sahai on November 29th, 2014
Does Not Power On
The lounger just will not power on. the controller does not light up when powered on.
Current Answers
Answer #1: Posted by sabrie on December 12th, 2014 11:46 PM
sabrie
Member since:
May 23rd, 2013 Points: 3,306,778
Member since:
May 23rd, 2013 Points: 3,306,778
TROUBLESHOOTING GUIDE on the link below
http://www.manualslib.com/manual/305588/Panasonic-Ep-1015.html?page=18
www.techboss.co.za
Related Panasonic EP1015 Manual Pages
EP1015 User Guide - Page 3
... properly or if it has been damaged. Unplug from massage
lounger. This appliance should not be followed, including the following: Read all controls to the "off" position, then remove plug from ... necessary when this massage lounger. Do not use outdoors. 11. Thank you for purchasing the Panasonic Household Massage Lounger EP1015. To disconnect, turn all instructions before cleaning.
EP1015 User Guide - Page 4
... injury
1. Do not use immediately. While using the massager, if you adjust to the massager can irritate the skin.
4. The chair may cause injury. Thin clothing increases the effectiveness, but exposing the skin directly to the chair. always wear clothing. Do not massage any part of the massage heads may fall over.
8. Do not sit on...
EP1015 User Guide - Page 5
... the heads' movement. Do not pull the controller cord or the power cord. Be careful not to the "off the power and have ample space behind the chair before cleaning. • If the covering becomes soiled, dampen with liquid soap on or drop the controller. After each massage, slide the power switch, which is normal.
9. If the...
EP1015 User Guide - Page 6
...as the plug. therefore, place a mat or cloth on the floor and move the chair if the massage heads have been moved to observe this product. Caster
CORRECT
6
WRONG GROUNDING INSTRUCTIONS
•...the risk of electric shock. GROUNDING PIN
Figure A
GROUNDED OUTLET
HOW TO MOVE THE CHAIR
CAUTION
Do not move the chair is by putting your foot on a nominal 120-volt circuit and has a grounding ...
EP1015 User Guide - Page 7
... back
Leg massage on/off button
Massage heads adjustment (neck roller position) button
tapping on /off
Manual Operation
knead
up
width
narrow
wide
stroke 24in.
4in. Headrest • Drapes over the back cushion. Legrest lever • For extending or
lowering the legrest. PARTS IDENTIFICATION
MASSAGE LOUNGER
Back cushion • Attaches to the chair with zipper...
EP1015 User Guide - Page 8
...
• Do not use the massage lounger in the center of the massage lounger.
8
Power switch
Controller Controller storage pocket
Power plug
Power switch
on
Operating lock
off
• As a further precaution, unplug the power cord from any other obstacle to ensure adequate reclining space.
Wait for long periods of the chair. 2. NOTE: Position the chair at the rear of time...
EP1015 User Guide - Page 9
... be raised to 90° by the legrest lever. RECLINING THE CHAIR
By using the reclining button on the controller, the legrest can be raised and lowered automatically in concert with the movement of the massage lounger's backrest.
• To avoid possible tipping of the chair, do not sit or lean on the backrest while...
EP1015 User Guide - Page 10
... USE
TO START/STOP MASSAGE ACTION
Before using the massager as the section on /off" button. To stop button
Automatic timer for massage lounger • To prevent excessive massage, there is a built... stop the massage immediately, press the "quick stop
reclining
leg massage
on /off " button to store the controller in use. The massage heads will automatically turn on the leg massager. •...
EP1015 User Guide - Page 11
... about 40 seconds after pressing the button. • If you turn on off
1. See massage course on the different massage courses.) • Check to be sure that a person who is 6 ft. (1.82 ...
2. Programmed Operation whole back neck shoulder lower back
tapping on the massager.
• Massage will start of the massage heads against your neck.
Press the "on off " button. 2....
EP1015 User Guide - Page 12
... lower them , press the "down" button.
3. Press the "knead" button. Press the "tap" button. Manual Operation
knead
up down up " button. Kneading massage (upward & downward)
1. Rolling massage
1. Kneading (upward/downward) massage
intensity down
tap
roll
Press the button for more than approximately
15 minutes at one time. To lower them , press the "down...
EP1015 User Guide - Page 13
... lower them , press the "down " button.
• All functions that function's control button. MANUAL MASSAGE
Kneading rolling massage
1. Press the "knead" button and the "roll" button. To adjust the intensity of massage, press the "intensity"
buttons.
Press the "width" adjustment button to just rolling by pressing on that include rolling are available for the entire...
EP1015 User Guide - Page 14
... of the intensity adjustment buttons allows you want.
To lower them, press the "down" button.
NOTE: • When you can adjust the height of the massage heads to the desired position with the up/down adjustment buttons. Press the "width" button to change the stroke.
NOTE: • Switches between the...
EP1015 User Guide - Page 15
...; This massage lounger is placed underneath the back cushion at the waist position for supporting the back and the waist, and for a full shiatsu massage, but be used, remove the headrest or flip the headrest over the back of the massage you will be aware of the intensity of the chair
before starting the massage.
sit...
EP1015 User Guide - Page 16
...kneading
Tapping
10
9
8
7
6
Kneading rolling/ Kneading rolling/
Rolling
Tapping rolling
Tapping
Upward kneading/ Kneading rolling
Rolling
Neck and shoulder course
1
2
3
4
5
Concentrated massage of neck and shoulders
Rolling
Tapping rolling/ Kneading rolling
Upward kneading
Downward/ upward kneading
Tapping
10
9
8
7
6
Kneading rolling/ Kneading rolling Rolling
Tapping...
EP1015 User Guide - Page 17
.... Neck
3 5/16 in. (85 mm) 4 5/16 in. (110 mm)
23 5/8 in .
Kneading (upward/downward), Kneading rolling, and Regional kneading rolling. MASSAGE HEADS' RANGE OF MOVEMENT
• The vertical movement of the massage heads can be adjusted in two ranges. or 4 5/16 in. (85 mm or 110 mm)
The width (distance) between the...
EP1015 User Guide - Page 18
... . If not, repeat this unit, check the table below for a
a rolling massage. Plug the power cord into an AC outlet (120 V). The power switch is not plugged in the manual operation mode. If all operation indicator lamps on the controller blink and the chair stops, turn off " position. TROUBLESHOOTING GUIDE
Before requesting service for this...
EP1015 User Guide - Page 19
... . (45 mm) range. See precautions on page 5.
19
Shoulder position adjustment: 5 steps
Automatic shut-off:
Approx. 15 min. SPECIFICATIONS
Power source:
120 V AC, 60 Hz
Power consumption:
200 W
Kneading speed:
Approx. 28 times/min. Massage width:
Shoulder / lower back section: Approx. 2 15/16 in. (75 mm)
Back rolling width/tapping width: Narrow: Approx...
EP1015 User Guide - Page 54
www.panasonic.com/massage
Printed in USA No. 1 EN, FR, SP
Panasonic Consumer Electronics Company
One Panasonic Way 4A-3 Secaucus, New Jersey 07094 1-800-338-0552 for questions and comments.
Similar Questions
I Need A Power Cord For A Panasonic Ep3513 Massage Chair
I need a power cord for a Panasonic ep3513 massage chair
I need a power cord for a Panasonic ep3513 massage chair
(Posted by Verretkodie41 2 years ago)
For Panasonic Model Ep3513 Massage Chair, We Have Problem With The Control Panel
it always stop working even running a few minutes for any options buttons. How can we solve this kin...
it always stop working even running a few minutes for any options buttons. How can we solve this kin...
(Posted by ericsmkong1 2 years ago)
Remote Blinks All Lights Then Power Shuts Off
if I turn the chair on using the power button on the remote all the ligts start blinking and the pow...
if I turn the chair on using the power button on the remote all the ligts start blinking and the pow...
(Posted by Manwithbike 9 years ago)
Fixing Panasonic Massage Chair Ep1015
My Massage chair wont work The motor runs but the massage units dont come up into place. How can I f...
My Massage chair wont work The motor runs but the massage units dont come up into place. How can I f...
(Posted by waddellbillie 10 years ago)
Massage Wheel Is Broken.
Where can I get parts or at least a labeled diagram of inner mechanism?
Where can I get parts or at least a labeled diagram of inner mechanism?
(Posted by jonpdacus 13 years ago)