Oreck XL 2600HH Support Question
Oreck XL 2600HH Support Question
Find answers below for this question about Oreck XL 2600HH.Need a Oreck XL 2600HH manual? We have 2 online manuals for this item!
Question posted by joerock on October 18th, 2011
Oreck Xl Owners Manual
wiring diagram for oreck xl upright vacuum cleaner
Current Answers
Related Oreck XL 2600HH Manual Pages
Owners Guide - Page 1
...09 REV A
S I M P LY
A M A Z I N G®
FRANÇAIS
GUIDE D'UTILISATION PAGE 8
E S PA Ñ O L
GUIA DEL USUARIO PAGE 14
USER'S GUIDE
XL2600HH XL2610HH XL2700HH XL2700RH
HIGH SPEED UPRIGHT VACUUM CLEANER WITH
®
CLEANING SYSTEM
•IMPORTANT•
SAVE THIS BOOKLETÀ Includes: • Safety Warnings • Warranty • Operating Instructions • Trouble Diagnosis •...
Owners Guide - Page 2
...cleaner, gasoline, etc. If you may reduce air flow. • Keep hair, loose clothing, fingers and all controls before servicing.
• Do not use outdoors or on wet surfaces. • Do not operate the unit while in the upright...not use cord as described in this manual. with wet hands. • Do ...
Your Oreck vacuum cleaner is necessary when used as a toy. Should your Oreck appliance,...
Owners Guide - Page 3
... following limited warranty for this product only if it was originally purchased for use, not resale, from ORECK or an ORECK Authorized Retail Dealer.)
ORECK will void this product. This limited warranty applies to use this product.
CLEANER
Filter bag is full. See "To Install Paper Filter Dust Bag." Check bearing seal. CALL CUSTOMER...
Owners Guide - Page 4
... instructions in this manual will cause damage to the vacuum cleaner and is not...vacuum.
If the paper bag becomes clogged, no longer loose.
3
Attach cord to trap dirt, but at maximum efficiency, change the dust bag frequently.
Remove
cardboard insert by use your new cleaner greatly depends upon care and maintenance.
Operating Recommendations This new ORECK XL High-Speed Upright...
Owners Guide - Page 5
... very important for replacing belt.
If there is stored in the upright and locked position. The metal strip on concrete or abrasive surfaces, and, therefore, cause damage to it is important the inside out, with the ORECK cleaner. Vacuum the inside of your cleaner looking new and will ensure continued cleaning effectiveness. Increase the cleaning...
Owners Guide - Page 6
...
Intake Opening
Retainer Spring
C
Fan Housing
O-ring
D E
±
1. Pull tube out of bag. Vacuum will not operate properly without the tube O-ring. Then reinsert tube and push down until collar locking tabs are... replace if damaged.
If you can not reach the blockage, remove baseplate. If your vacuum cleaner does not pick up properly, or makes unusual noise and the outer bag does not...
Owners Guide - Page 7
...-989-3535
CANADA: 1-888-676-7325
IMPORTANT: On plush and new carpets, stuffing may occur due to your machine. Using A Fresh Air® Tab
Your ORECK XL vacuum cleaner has a special FRESH AIR tab pocket.
To determine if the brush is first used on the top of the lamp housing.
• Pull burned out...
Parts Diagram - Page 1
Baseplate (Type 3-6 Only) has posts
88
Wireforms non-serviceable Baseplate (Before Type 4) does not have posts
4 Parts
11
Diagram
83
74 4a
79
8a
5
6 4
67
8
66
62 63
76 3 84 2 15
20 68
53 54
55 38
55
56
82
57
59
7
RIGHT
61
...
Parts Diagram - Page 4
... Brush w/Wheels, Right
O-097525002
51 Wheel Axle
O-010-0159
52 Soft Rear Wheel, Black
75187-02-0327
53 Static Wire Type 1, 2, 3, 4 & 5 Units Only
O-010-9856
54 Switch, 2 Position Assembly Type 1, 2, 3, 4...Hinge, Type CC (use w/#4a or order #83)
O-7558210438
User's Manual
75416-05
Magnet Clean Vacuum Protector
MC4BK
79 Stiffener (uses same length screws, notched)
O-7518902
Stiffener...
Similar Questions
Oreck Xl 2600 Brush Issues
I replaced the old worn brush with a new one. i set the "new" tabs up and tried to attach the bottom...
I replaced the old worn brush with a new one. i set the "new" tabs up and tried to attach the bottom...
(Posted by jack21453 9 years ago)
Oreck Xl Model Rxl 2600 Hh- How Do U Adjust Levels On Carpet
(Posted by pbresney 10 years ago)
My 2600hh Sparks On The Armature. Will New Brushes Stop This.
The old brush's don't look bad and motor runs.
The old brush's don't look bad and motor runs.
(Posted by jmyers3940 11 years ago)
Oreck Xl Upright Vacum Cleaner - Belt Spinning In Wrong Direction
Belt seems to be spinning in wrong direction...is there a way to reverse the direction of the motor?
Belt seems to be spinning in wrong direction...is there a way to reverse the direction of the motor?
(Posted by enlchicago 12 years ago)