2012 Nissan Titan Support Question
2012 Nissan Titan Support Question
Find answers below for this question about 2012 Nissan Titan.Need a 2012 Nissan Titan manual? We have 1 online manual for this item!
Question posted by myjoy on October 29th, 2014
Add A Electric Brake
I want to know how to connect the reese elec brake controller to my 2012 nissan titan.
Current Answers
Answer #1: Posted by waelsaidani1 on October 30th, 2014 11:10 PM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,797
Member since:
May 12th, 2013 Points: 19,501,797
The Nissan OEM brake control pigtail would connect to your Pilot brake controller as follows:
Harness Red Wire to Black Wire on Controller
Harness Red/Green Wire to Red Wire on Controller
Harness Black Wire to White Wire on Controller
Harness Brown/White Wire to Blue Wire on Controller
The Red/Blue wire on the harness is for an illumination circuit that is NOT used. This wire should be bundled
up out of the way and the end capped off so it does not short out on anything.
Harness Red Wire to Black Wire on Controller
Harness Red/Green Wire to Red Wire on Controller
Harness Black Wire to White Wire on Controller
Harness Brown/White Wire to Blue Wire on Controller
The Red/Blue wire on the harness is for an illumination circuit that is NOT used. This wire should be bundled
up out of the way and the end capped off so it does not short out on anything.
Related Manual Pages
Owner's Manual - Page 94
...may indicate a burned-out bulb or an open circuit in the electrical system.
Have the system repaired promptly. Instruments and controls 2-13 WARNING/INDICATOR LIGHTS AND AUDIBLE REMINDERS
Low fuel warning light High...)
Malfunction indicator light (MIL) Security indicator light (if so equipped)
or
Brake warning light
Seat belt warning light and chime
Slip indicator light
Charge warning light...
Owner's Manual - Page 95
... light illuminates and the parking brake is applied. If the light comes on when the parking brake is set. See "Brake fluid" in the ON position, the Anti-lock Braking System (ABS) warning light illuminates and then turns off . If the brake fluid level is operational. Have the system checked by a NISSAN dealer.
2-14 Instruments and controls
Owner's Manual - Page 96
... of this manual. Also see a NISSAN dealer immediately. CAUTION
● Do not ground electrical accessories directly to the nearest service station for repairs. CAUTION
● Running the engine with the dipstick and check the coolant level on , see "If your stopping distance and braking will bypass the variable control system and the vehicle battery...
Owner's Manual - Page 105
... pressure is set and the vehicle is pushed again. Parking brake warning This warning illuminates when the parking brake is set in the 4LO position and the indicator blinks,... vehicle" in the "Pre-driving checks and adjustments" section. Add windshieldwasher fluid as it may indicate the cruise control system is controlled by a NISSAN dealer. You cannot move the shift selector to the N (...
Owner's Manual - Page 256
...minute. Starting and driving 5-5 Contact your NISSAN dealer as soon as this may cause a malfunction of the tire pressure sensors. Facilities or electric devices using similar radio frequencies are : ...the low tire pressure warning light illuminates while driving, avoid sudden steering maneuvers or abrupt braking, reduce vehicle speed, pull off the road to a safe location and stop the ...
Owner's Manual - Page 262
... the "Instruments and controls" section of the ...NISSAN recommends placing the registered key on the ignition system and the electrical... accessories. See "Warning/indicator lights and audible reminders" in the ON position. If the no start without the use of this manual. As soon as the radio when the engine is clear. ● Check fluid levels such as engine oil, coolant, brake...
Owner's Manual - Page 270
...and the brake pedal is driven under extreme conditions, such as excessive wheel spinning and subsequent hard braking, the fail...pushing down to its normal operating condition, have a NISSAN dealer check the automatic transmission system as soon as shown...please note that the transmission will occur even if all electrical circuits are functioning properly.
Starting and driving 5-19
Use...
Owner's Manual - Page 284
...Self-test feature
The ABS includes electronic sensors, electric pumps, hydraulic solenoids and a computer. The brake system then operates normally, but without anti-lock...driving, have the vehicle checked by a NISSAN dealer.
● ABLS system uses automatic braking to transfer power from the actuator when it switches the ABS off , normal brake function will function even when the VDC...
Owner's Manual - Page 289
... a fire or electrical shock and cause serious personal injury. To use your vehicle. Try not to keep it . Engine block heaters are available through NISSAN dealers to assist ... cruise control (if so equipped) on . 6. Plug the extension cord into a grounded 3-wire, 3-pronged extension cord. 4. Braking should be seriously injured by an electrical shock if you use an ungrounded connection. &#...
Owner's Manual - Page 298
... the parking brake. Cover the... does not start the engine of the vehicle being jump started. CAUTION
● Always connect positive (ϩ) to positive (ϩ) and negative (Ϫ) to body ground (for more...at about 2,000 RPM, and start right away, turn the key off all unnecessary electrical systems (lights, heater, air conditioner, etc.).
3. After starting the engine, carefully disconnect...
Owner's Manual - Page 320
... and automatic transmission durability, and may also be hot. WDI0505
CAUTION
● Use Genuine NISSAN Matic S ATF. The specified automatic transmission fluid is felt, then tighten an additional 2/3...turning it -yourself 8-11
Turn the engine off . Add engine oil if necessary. Screw on a level surface and apply the parking brake. 2. Then remove the oil filter by hand. CAUTION
...
Owner's Manual - Page 321
...176;F (0° - 30°C). Remove the cap and fill through the opening.
● Brake fluid is spilled, immediately wash the surface with water.
8-12 Maintenance and do-it-yourself If... the COLD MAX range on the power steering fluid reservoir at or below the MIN line, add Genuine NISSAN PSF to "Capacities and recommended fuel/lubricants" in marked containers out of reach of children. Genuine...
Owner's Manual - Page 322
... windshieldwasher fluid reservoir. ● Pre-mix washer fluid concentrates with washer fluid concentrates at full strength.
Add windshield-washer fluid when the low windshield-washer fluid warning light comes on , add Genuine NISSAN Super Heavy Duty Brake Fluid or equivalent DOT 3 fluid up to the washer for the mixture ratio. In the winter season...
Owner's Manual - Page 324
.... Maintenance and do-it is necessary, see "Jump starting" in the "In case of emergency" section of electrical discharge from the battery and controls voltage generated by jump starting is necessary to add fluid, add only distilled water to bring the level up to avoid discharging the vehicle battery.
Doing so will bypass the...
Owner's Manual - Page 325
...add electrical accessories to your vehicle, be sure to ground them to a suitable body ground such as the frame or engine block area.
1.
If the belt is loose, have it -yourself
The engine could rotate unexpectedly.
8-16 Maintenance and do-it replaced or adjusted by a NISSAN...schedule found in poor condition or is in the "NISSAN Service and Maintenance Guide". WDI0661
1. 2. 3. 4....
Owner's Manual - Page 386
...regulations where you plan to have it installed. Surge brakes are activated by the trailer pushing against the hitch ... into the vehicle electrical system, a commercially available powertype module/converter must draw no hydraulic or electric connection for all trailer lights... cause damage to the vehicle. Adapters are available at NISSAN dealers as well as a signal source. See a reputable...
Owner's Manual - Page 387
... brake controller. WARNING
Never connect a trailer brake system directly to the rearmost position. Your vehicle is specifically designed to be used , see "Electric trailer brake controller" in this section.
To install the electric trailer brake controller jumper harness, perform the following procedure: 1. Electric Trailer Brakes - example
LTI0117
Electric trailer brake controller...
Owner's Manual - Page 388
... for electric trailer brake controller jumper harness.
Locate the jumper harness connector under the lower portion of the instrument panel. WIRE COLOR RED/GREEN BLACK BROWN/WHITE RED/BLUE RED LTI0118 LTI0115 NOTE Vehicle stop lamp switch to the wiring harness 1 as indicated. ᭺ ● The connector is marked with a white tag with "elec brake...
Owner's Manual - Page 389
...coupler from traffic. LTI0116
4. Peel off the tape and connect the jumper 2 . Trailer towing tips
In order to ..., you are backing up in an area which you want the trailer to go. Do not drive the vehicle if...and consumer information Install the aftermarket electric trailer brake controller according to the connector ᭺ 5. Release the parking brake. 6. check for towing before driving...
Owner's Manual - Page 402
...switch...Recorders Event data ...Refrigerant recommendation ...Registering your vehicle in another country Remote controller (See NISSAN mobile entertainment system) ...Remote keyless entry system ...Reporting safety defects (US ... indicator light...2-20 Security system (NISSAN vehicle immobilizer system), engine start ...2-26, 3-2, 5-11 Self-adjusting brakes ...8-21 Service manual order form ...
Similar Questions
2004 Nissan Brakes
Need to do a brake job on my Nissan. It has 173,000 miles.
Need to do a brake job on my Nissan. It has 173,000 miles.
(Posted by blondell1936 9 years ago)
Manual For How To Change Brake Fluid On A 2006 Nissan Titan
(Posted by Brsw 10 years ago)
Add Homelink Feature
I have a factory overhead console in my 08 Titan w/o dvd but, I want to add the homelink feature wha...
I have a factory overhead console in my 08 Titan w/o dvd but, I want to add the homelink feature wha...
(Posted by earleywinston 11 years ago)