2011 Nissan Versa Support Question
2011 Nissan Versa Support Question
Find answers below for this question about 2011 Nissan Versa.Need a 2011 Nissan Versa manual? We have 1 online manual for this item!
Question posted by jamadarwasim on January 9th, 2013
How To Remove Eqt Fuction Or Eqt From Engine
The person who posted this question about this Nissan automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 92
... if the headlights or parking lights are on the vehicle are driving, have audible wear warnings. Remove the key and take it makes a high pitched scraping sound when the vehicle is in the ...position when locking the doors. Turn the headlight control switch off switch again or restart the engine and the system will operate normally. NISSAN Intelligent Key™ door buzzer (if so equipped)...
Owner's Manual - Page 94
.... ● The alarm automatically turns off by pressing the the keyfob or Intelligent Key. If the engine fails to flash once every 3 seconds. Confirm that the doors are in this manual. The to start... the ignition switch in the ACC or ON position, the system will not allow the engine to remove the key, the system may be shut off after approximately 50 seconds. Refer to glow...
Owner's Manual - Page 95
... ASSY - IMMOBILIZER, ANT ASSY - IMMOBILIZER) This device complies with the key removed from other devices. Restart the engine while holding the device (which may cause undesired operation of the device. Security... TO OPERATE THE EQUIPMENT. LIC0474
If the light still remains on and/or the engine will remain on a separate key ring to avoid interference from the ignition switch. This...
Owner's Manual - Page 113
... a key or the power door lock switch while all doors are closed while the key is removed from becoming discharged. CAUTION
Do not use for extended periods of door position. This could result...is in the OFF position 3 , the interior lights do not illuminate, regardless of time with the engine stopped. CAUTION
Do not use for about 15 minutes unless the ignition switch is in the ON ...
Owner's Manual - Page 135
... Key. This warning is performed: - Returning the ignition switch to the LOCK position. - Removing the mechanical key. - Closing the doors. Refer to let you when the door is closed...the doors
When the chime or buzzer sounds from inside the vehicle.
Audible reminder and warning when the engine stops
When the P (Park) position selecting warning ) (CVT or A/T models) in the instrulight...
Owner's Manual - Page 136
...
The Intelligent Key is not in the vehicle.
When opening the driver's door When stopping the engine
When turning the ignition knob When starting the engine
When turning the ignition switch
The ignition switch is low. Remove the mechanical key from the vehicle and push the door handle request switch. See "Battery replacement...
Owner's Manual - Page 137
...
1. Remove the support rod 4 and insert it . Raise the hood
3
Hold the coated parts A when removing or ...resetting the support rod. When closing the hood, return the support rod to its original position, lower the hood to do not open and result in between the hood and grille and push the lever sideways with the metal parts, as they may be hot immediately after the engine...
Owner's Manual - Page 158
...position. Move the air intake lever to the desired position. 4. Air conditioner button (if so equipped)
Start the engine, turn the fan control dial to the button to desired position and push the turn on when the air conditioner is...the desired position between the middle and the hot position. ● To quickly remove ice or fog from the windows, turn off using the air conditioner button.
Owner's Manual - Page 202
...vehicle is in motion, the hands free cellular phone operational mode (if so equipped) is removed before the vehicle enters a garage with a low ceiling. CAUTION
● Always properly ...otherwise, the new equipment may break during installation or the antenna rod may adversely affect the engine control system and other electronic parts. WARNING
● A cellular telephone should not be ...
Owner's Manual - Page 228
... SWITCH POSITIONS
LOCK: Normal parking position (0) OFF: (1) The engine is not running. See "Intelligent Key lock warning light" in , then turn the ignition switch to LOCK. The key can only be removed when the ignition switch is designed so that helps prevent accidental removal of the Intelligent Key lock warning light. ● When...
Owner's Manual - Page 230
... or when restarting, depress the accelerator pedal a little (approximately 1/3 to run, repeat the above procedure. ● If the engine is not inserted into any of the following is removed from the ignition switch. ● Close the doors. 3. If the engine starts, but fails to the floor) and hold it and then crank the...
Owner's Manual - Page 232
...the ignition switch cannot be turned to the LOCK position and the key cannot be removed from the ignition switch. Remove the key. Malfunctioning stop lights may not work. Starting and driving 5-15 If...
while depressing the to shift
A
A
Shift without pushing button
Shifting
After starting the engine, fully depress the brake pedal, push the shift selector button and move unexpectedly or roll...
Owner's Manual - Page 234
... to the N (Neutral) position while holding down the shift lock release. 6.
With the engine running and the brake pedal is discharged, the shift selector may be moved out of P...possible.
Overdrive does not engage until the engine has reached operating temperature. This shifts the transmission down . 5.
Apply the parking brake. Remove the shift lock release cover as shown...
Owner's Manual - Page 236
NOTE: Engine power may be automatically reduced to the ... pushing button
Shifting
After starting the engine, fully depress the foot brake pedal before shifting the selector to protect the CVT if the engine speed increases quickly when driving on ... performance and driving enjoyment. After starting the engine, fully depress the brake pedal and move the shift selector into any drive position...
Owner's Manual - Page 237
... only when the vehicle is completely stopped.
5-20 Starting and driving Move the shift selector to P (Park) to remove the key. Do not use the L (Low) position in any position while the engine is not running. R (Reverse) speed is limited to back up.
WARNING
Apply the parking brake if the shift selector...
Owner's Manual - Page 238
... the Overdrive off . The turn off the Overdrive off indicator light (CVT models)" in the LOCK position and remove the key. 2. Apply the parking brake. To turn off mode when you need improved engine braking. WSD0195 WSD0164
Shift lock release
If the battery is depressed, the stop lights could cause an accident...
Owner's Manual - Page 245
...or in the R (Reverse) position. They could become involved in the LOCK position and remove the key.
5-28 Starting and driving Make sure the shift selector has been pushed as... that both the parking brake be moved without depressing the foot brake pedal. ● Never leave the engine running while the vehicle is a good practice to the P (Park) position. 3. Automatic Transmission (A/T)...
Owner's Manual - Page 251
...maneuvers. ● Do not use an ungrounded connection. ● Disconnect and properly store the engine block heater cord before reaching it firm support. ● A shovel to assist in shaded ...carried in the "Maintenance and do-ityourself" section of snowdrifts. ● Extra washer fluid to remove ice and snow from around your vehicle. The vehicle will lose even more traction. ●...
Owner's Manual - Page 261
... near a battery, always wear suitable eye protectors (for example, goggles or industrial safety spectacles) and remove rings, metal bands, or any time. Battery fluid is discharged, the ignition switch cannot be moved ...burns. It could explode and cause serious injury. ● Your vehicle has an automatic engine cooling fan. ● Do not allow battery fluid to come into contact with anything,...
Owner's Manual - Page 262
...Do not allow the two vehicles to P (Park) (Automatic or Continuously Variable Transmission). If the engine does not start the engine. 6. For Intelligent Key system equipped models, use the mechanical key to start right away, turn...an old cloth to bring their batteries near each other metal. 5.
Remove vent caps on the battery (if so equipped).
CAUTION
Do not keep the starter motor engaged ...
Similar Questions
How To Remove Low Tire Pressure Indicator Light On 2011 Nissan Versa.
(Posted by sedaaleco 10 years ago)
Windshield Washer Pump Rempval
How do you remove the windshield washer pump from a 2011 Nissan Versa?
How do you remove the windshield washer pump from a 2011 Nissan Versa?
(Posted by rark2 10 years ago)
How Do I Remove The Hatchback Interior Panel? I Want To Access The Opener Switch
(Posted by calvinaukeman 11 years ago)
Where Is The Engine Tempature Sensor Located On 2009 Nissan Versa Hatchback
(Posted by MGBGJI 11 years ago)