2011 Nissan Versa Support Question
2011 Nissan Versa Support Question
Find answers below for this question about 2011 Nissan Versa.Need a 2011 Nissan Versa manual? We have 1 online manual for this item!
Question posted by Bullardcalvin9 on March 9th, 2022
Car Will Not Crank
When I put the ignition switch in the on position everything comes on but the when I go to crank the engine I get nothing. What could cause thisThe car is a Nissan Versa 201
Current Answers
Answer #1: Posted by SonuKumar on March 10th, 2022 7:12 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,621,300
Member since:
May 9th, 2021 Points: 16,621,300
https://www.youtube.com/watch?v=gwNfbQRn1bo
https://www.youtube.com/watch?v=tZiqC7_YMHY
What can cause a Nissan Versa not to start?
The most common reasons a Nissan Versa won't start are a dead battery, an alternator problem, or failed starter.
https://repairpal.com/nissan/versa/wont-start
https://forums.anandtech.com/threads/nissan-versa-2011-starter-not-cranking.2468225/
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Manual Pages
Owner's Manual - Page 82
... warning message after the ignition switch is getting low. TACHOMETER
The tachometer indicates engine speed in the tank. The low fuel warning light comes on when the amount ...cause serious engine damage. Instruments and controls 2-5 FUEL GAUGE
The gauge indicates the approximate fuel level in revolutions per minute (rpm). Operating the engine in the OFF position.
CAUTION
When engine...
Owner's Manual - Page 85
...position, the Anti-lock Braking System (ABS) warning light illuminates and then turns off. The brake system then operates normally, but without starting the engine. If the light comes on : or , , , , , (blue),
WARNING LIGHTS or Anti-lock Braking System (ABS) warning light (if so equipped)
When the ignition switch... system checked by a NISSAN dealer. The following lights will come on , it may ...
Owner's Manual - Page 86
.... level is placed in this light comes on , see a NISSAN dealer immediately. You will still have control of the doors are not closed securely while the ignition switch is below the mark on when any of the vehicle. When the power steering warning light illuminates with the engine running, there will still have control of...
Owner's Manual - Page 87
...light comes on could cause ... the engine immediately and call a NISSAN dealer...position, the high temperature warning light illuminates and then turns off the road in the driver's door opening.
Use a tire pressure gauge to indicate a low oil level.
High temperature warning light (red)
When the ignition switch is overheated, continuing vehicle operation may indicate the engine...
Owner's Manual - Page 89
.... ● The supplemental air bag warning light does not come on seat belt usage. The Intelligent Key should be taken to...NISSAN Intelligent Key™" in the "Predriving checks and adjustments" section. Refer to ignition switch, then place the ignition switch in either the LOCK or ACC position. The light illuminates whenever the ignition switch is placed in the ON or START position...
Owner's Manual - Page 90
....
High beam indicator light (blue)
This blue light comes on when the headlight high beams are on how the front passenger seat is low. When the ignition switch is controlled by a NISSAN dealer promptly.
If the light blinks while the engine is placed in the ON position, the low temperature indicator light illuminates and then turns...
Owner's Manual - Page 91
...ignition switch is placed in the LOCK, OFF or ACC position.
2-14 Instruments and controls
The Malfunction Indicator Light may indicate a potential emission control malfunction. Operation The Malfunction Indicator Light will come...the vehicle inspected by a NISSAN dealer. If this indicator light comes on steady or blinks while the engine is running , it may also come on steady. If the ...
Owner's Manual - Page 92
...switch is placed in the ignition switch. AUDIBLE REMINDERS Brake pad wear warning
The disc brake pads have the Vehicle Dynamic Control system checked by a NISSAN... comes on when the Vehicle Dynamic Control off switch again or restart the engine ...position with the key removed from the ignition switch. Vehicle Dynamic Control (VDC) off indicator light (if so equipped)
This indicator light comes...
Owner's Manual - Page 94
... interference is caused by the key, a request switch, the keyfob or Intelligent Key, or if the ignition switch is unlocked by : ● opening a door without the use of a registered key. If the engine fails to indicate all doors with again. indicator light comes 4. The alarm is turned beyond the vertical position toward the unlock position to glow for...
Owner's Manual - Page 97
...switch clockwise from the OFF position...mirrors (if so equipped), start the engine and push the rear window defroster switch on .
CAUTION
When cleaning the inner... rear window defroster indicator light on the switch comes on . Warm the rear window with the defroster ...washer operate when the ignition switch is empty. REAR WINDOW AND OUTSIDE MIRROR (if so equipped) DEFROSTER SWITCH
CAUTION
● Do...
Owner's Manual - Page 98
... light illuminates.
Instruments and controls 2-21
When turning the switch to the position, the front parking, tail, license plate and instrument panel lights come on and off.
2 3
2
Battery saver system
If the ignition switch is placed in the OFF position while the headlight switch is in the or position, the headlights will turn off after 5 minutes. Pulling and...
Owner's Manual - Page 101
... will operate with the ignition switch placed in mud or snow, the VDC system reduces the engine output to turn off . The Push the VDC OFF switch again or restart the engine to reduce wheel spin. If the vehicle is stuck in any position. To turn on the system. HORN
The flashers will come on. Some state...
Owner's Manual - Page 110
...switch. 3. Release the power window switch. Perform steps 2 through 4 above procedure, see a NISSAN dealer for other windows. Operate the window by automatic function to something being caught in the ON position... ignition switch in the window occurs.
If this occurs, please contact a NISSAN dealer to initialize the power window system. 1. Pull up and hold the window switch ...
Owner's Manual - Page 113
... minutes unless the ignition switch is removed from becoming discharged.
When the switch is in the ON position 1 , the interior lights illuminate, regardless of door position. CAUTION
Do not use for extended periods of ignition switch position. LIC1472
The interior light has a three-position switch and operates regardless of time with the engine stopped. When the switch is in the...
Owner's Manual - Page 135
... you when the door is placed in the LOCK position. Alarm and warning when the engine starts
When the Intelligent Key system warning light ( ) blinks red and the outside the vehicle, check for about 30 seconds after the ignition switch is placed in the LOCK position. ● The mechanical key is not inserted into the...
Owner's Manual - Page 218
... Transmission (CVT) (if so equipped) ...5-9 Automatic transmission (if so equipped)...5-10 Manual transmission (if so equipped) ...5-11 Ignition switch positions ...5-11 NISSAN vehicle immobilizer system ...5-12 Before starting the engine ...5-12 Starting the engine ...5-13 Driving the vehicle ...5-14 Automatic transmission (if so equipped)...5-14 Continuously Variable Transmission (CVT) (if so...
Owner's Manual - Page 225
... Key is within the operating range, it is within the specified operating range. Sedan The operating range of the engine start the engine. LSD0172
WSD0165
WSD0191
M/T models
Hatchback
CAUTION
● Be sure to start function is inside of the vehicle 1... who does not carry the Intelligent Key, to turn the ignition switch to carry the Intelligent Key with you leave the vehicle.
Owner's Manual - Page 228
... the key in, then turn the ignition switch to LOCK. See "Intelligent Key lock warning light" in order to turn the key to Intelthe LOCK position although the ligent Key lock warning light will not blink and the buzzer will not sound.
IGNITION SWITCH POSITIONS
LOCK: Normal parking position (0) OFF: (1) The engine is not running. Starting and driving...
Owner's Manual - Page 230
... for the following operations: ● Return the ignition switch to the floor) and hold it and then crank the engine. Crank the engine with your foot off by turning the ignition key to N (Neutral). Release the key when the engine starts. P (Park) is performed: ● Return the ignition switch to the LOCK position. The Intelligent Key must be turned. Manual transmission...
Owner's Manual - Page 231
... before cranking again, otherwise the starter could cause you to lose control and have an accident. ● Cold engine idle speed is high, so use caution when shifting into a driving gear. 3. Release the ignition switch when the engine starts. CAUTION
● When stopping the vehicle on an uphill grade, do not shift to the N (Neutral) position while...
Similar Questions
How To Repair The Window Switch For A 2011 Nissan Versa
(Posted by padn 10 years ago)
Is It Normal For Brakes To Squeak On A New Car When Applying Light Pressure On
a nissan versa
a nissan versa
(Posted by Latekurt02 10 years ago)
