2000 Nissan Maxima Support Question
2000 Nissan Maxima Support Question
Find answers below for this question about 2000 Nissan Maxima.Need a 2000 Nissan Maxima manual? We have 1 online manual for this item!
Question posted by jdubberscole782 on September 28th, 2022
Clutch Bleed Process
Where do I start first the tower bleeder on driverside or at slave cylinder 2000 Nissan maxima se
Current Answers
Answer #1: Posted by SonuKumar on September 28th, 2022 7:44 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,604,800
Member since:
May 9th, 2021 Points: 16,604,800
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Manual Pages
Owner's Manual - Page 3
... Design International in North America, starting with the opening of automation and - most modern manufacturing facilities, Nissan Motor Manufacturing Corporation U.S.A. As you and your new Nissan, dozens of checks were made a substantial and growing investment in San Diego, California, and engineering at each stage of the production process, both performance and fuel efficiency through...
Owner's Manual - Page 52
...warning light is safe to do so. Use the dipstick to ON without starting the engine. CAUTION
Running the engine with the charging system. The following ...equipped)
Low fuel warning light Overdrive off the road in a safe area, stop the engine immediately and call a NISSAN dealer or other authorized repair shop. Turn the
Instruments and controls
2-7 See "Engine oil" in the "8. The ...
Owner's Manual - Page 54
... do not drive until the brake system has been checked at a NISSAN dealer. 2. However if the light illuminates while starting the engine, it is pressed to the ON position, the light ...fluid level is functioning properly. See "Brake and clutch fluid" in the event of a low brake fluid level. If you are driving, contact your NISSAN dealer for 2 seconds, have the warning system checked...
Owner's Manual - Page 58
... the horn sounds intermittently. ¼ The alarm automatically turns off .
¼ Opening the hood. NISSAN VEHICLE IMMOBILIZER SYSTEM
The Nissan Vehicle Immobilizer System will give the following procedures: 1. If, during this time, the hazard indicators flash twice to start without the use of the vehicle to remove the key, the system may be...
Owner's Manual - Page 80
... 4 under "Programming HomeLink ") while you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. keeping the indicator light in the Foreword of a second person may make... Owner's Manual. If HomeLink is advised to unplug the device during the "cycling" process to prevent possible damage to a garage door opener with its battery area facing away ...
Owner's Manual - Page 81
... then rapidly. FCC Notice: This device complies with HomeLink your new transmitter information. Press and release the HomeLink button a second time to complete the training process. (Some garage door openers may require you to reprogram the Integrated Universal Transceiver with FCC rules part 15. color of the button may vary by...
Owner's Manual - Page 83
...3-2
Pre-driving checks and adjustments
Never leave these keys in the key head. NISSAN does not record any door, always look for registration. New keys must be registered to keep track... used for the trunk lid or glove box locks. A key number is because the registration process will help keep it is necessary when you have lost all memory of seat belts, this ...
Owner's Manual - Page 128
...clutch pedal is fully depressed. 3.
Automatic transmission: Move the selector lever to P (Park) or N (Neutral). (P preferred.) The selector lever cannot be moved out of P (Park) position and into any of the driving positions. CAUTION
Do not operate the starter for their appearance and condition. If the engine starts...-up Allow the engine to START. Also check tires for proper...
Owner's Manual - Page 132
... normal operating condition. When driving conditions change gears, or when up shifting or down shifting depress the clutch pedal fully, shift into the R (Reverse) position.
If the vehicle is difficult to drive at... next time the key is turned to its normal operating condition, have your NISSAN dealer check the transmission and repair if necessary. First shift into the N (Neutral) position,...
Owner's Manual - Page 133
...the vehicle is stopped for example at a stop light, shift to N (Neutral) and release the clutch pedal with the foot brake
For quick acceleration when the engine is cold or in low altitude areas ... 4th 4th to 5th MPH 15 25 40 45 (km/h) (24) (40) (64) (72)
5-12
Starting and driving Actual up -shift speeds
Shown below are suggested vehicle speeds for shifting into a higher gear. applied.
...
Owner's Manual - Page 135
... winding or hilly roads. ¼ on the accelerator pedal. Should this occur, depress the clutch pedal and turn on the cruise control, push the main switch on .
PRECAUTIONS ON CRUISE .... (The SET indicator light will come on.) Take your NISSAN dealer. ¼ The SET indicator light may cause
5-14
Starting and driving SSD0152
CRUISE CONTROL OPERATIONS
The cruise control allows driving...
Owner's Manual - Page 136
...out.
Release the switch when the vehicle slows down below approximately 8 MPH (13 km/h). ¼ Depress the clutch pedal (manual transmission), or move the selector lever to the desired speed.
c) Turn the main switch off once..., release the switch. To reset at the cruising speed, turn it . Starting and driving
5-15 The SET indicator light will resume the last set switch.
Owner's Manual - Page 163
...are extremely corrosive. TO PROTECT YOUR VEHICLE FROM CORROSION:
¼ Wash and wax your local NISSAN dealer. If present, wash with water as soon as the exhaust system, fuel and brake ... damage to those parts which may damage them. Temperature
A temperature increase will accelerate the corrosion process. In winter, the underbody must be required in coastal areas, or heavy road salt use ...
Owner's Manual - Page 164
... fluid ...8-10 Temperature conditions for checking...8-10 Power steering fluid ...8-11 Brake and clutch fluid ...8-12 Window washer fluid ...8-12 Battery ...8-13 Drive belts ...8-15 Spark plugs...and brake pedal...Checking parking brake ...Checking brake pedal ...Brake booster ...Clutch pedal ...Fuses...Engine compartment ...Passenger compartment ...Multi-remote controller battery replacement...
Owner's Manual - Page 175
BRAKE AND CLUTCH FLUID
tem and affect the vehicle's stopping ability. If fluid is below the MIN line or the brake ... painted surfaces. If fluid must be added frequently, the system should be thoroughly checked by your NISSAN dealer. Old, inferior, or contaminated fluid may damage the brake and clutch systems. The use of improper fluids can damage the brake sys-
8-12
Do-it-yourself
Add...
Owner's Manual - Page 184
... brake pedal, start the engine. With the brake pedal depressed, stop the engine. Keeping the pedal depressed for one pedal application to the next, continue on the fuse box cover. If the brakes do not operate properly, see your NISSAN dealer.
This could damage the electrical system or cause a fire. CLUTCH PEDAL BRAKE...
Owner's Manual - Page 203
...Automatic transaxle P (Park) position mechanism: On a fairly steep hill check that the brake and clutch fluid levels are between the MAX and MIN lines. Check the lines for example, buckles, anchors..., adjusters and retractors) operate properly and smoothly, and are no belt is cold. Starting and driving" section for example, each cell. Parking brake*: Check that the lever has ...
Owner's Manual - Page 211
... oil Automatic transmission fluid Power steering fluid Brake and clutch fluid Multi-purpose grease Air conditioning system refrigerant Air conditioning system lubricants Refill to the proper oil level according to determine the proper refill capacity.
Outside the continental United States and Alaska contact a NISSAN dealer for more information regarding suitable fluids, including...
Owner's Manual - Page 232
... transmission...5-8 Sunroof ...2-29 Transmission selector lever lock release ...5-9 Avoiding collision and rollover ...5-3 Brake and clutch fluid...8-12 Brake booster ...8-21 Brake pedal ...8-20 Brake pedal check...8-20 Parking brake check ...5-13......3-7 Battery, Battery saver system ...2-18 Before starting the engine ...5-7 Belts (See drive belts) ...8-15 Brake Anti-lock brake system (ABS) ...5-19
Owner's Manual - Page 233
...23 Circuit breaker, Fusible link ...8-22 Cleaning exterior and interior ...7-2, 7-4 Clock ...2-30 Clutch Clutch pedal ...8-21 Fluid...8-12 Cold weather driving ...5-21 Compact Disc (CD) player (See ...Emission control information label...10-11 Emission control system warranty ...10-20 Engine Before starting and driving ...5-2
Engine oil...8-7 Engine oil and oil filter recommendation...10-5 Engine...
Similar Questions
Problem - 2005 Maxima & The Ignition
Locking Up When Trying To Start.
Problem w/my 2005 Maxima re: ignition lock-up that seems to be associated with Steering Column. Igni...
Problem w/my 2005 Maxima re: ignition lock-up that seems to be associated with Steering Column. Igni...
(Posted by yhorse 11 years ago)
1999 Nissan Maxima, Cranks But Will Not Start.
Why will the motor not start? I have changed the fuel pump and relay is good.
Why will the motor not start? I have changed the fuel pump and relay is good.
(Posted by Anonymous-106513 11 years ago)