Home » Mazda » Technical Support » 2004 Mazda MAZDA6

2004 Mazda MAZDA6 Support Question

Find answers below for this question about 2004 Mazda MAZDA6.
Need a 2004 Mazda MAZDA6 manual? We have 1 online manual for this item!

Mazda Overview Questions Manuals Reviews Videos Research

Question posted by JAXL99 on January 3rd, 2015

Remove And Replace Radiator / Radiator Leaks Top Left Corner ?

remove and replace radiator / radiator leaks top left corner ?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by BusterDoogen on January 3rd, 2015 4:27 PM

This answer was accepted by the poster of the original question.

BusterDoogen

Member since:
October 30th, 2011

Points: 28,565,447

1,100
points

Go here for the lengthy process.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!

Related Manual Pages

Owner's Manual - Page 20

...suddenly flips forward. Always remove the child-restraint system from inside the vehicle. 1. Operating the remote handle levers without checking could flip forward faster than on the left seatback. After checking that ...with levers, pull the rear seatback forward from the rear seat before folding the rear-left and right. The rear seat area is difficult to a child seated in the ...

Owner's Manual - Page 32

...the seat belt will not provide adequate protection and you could be seriously injured. NEVER use , remove the seat belt extender and store it is dangerous. The seat belt will not fit properly. NOTE...'s buckle and the center of an Extender: Using a seat belt extender when not necessary is left connected, the seat belt warning light will not illuminate and function properly. 2-22 Form No. ...

Owner's Manual - Page 38

...EA-03G Push the child-restraint system firmly into the vehicle seat. Anchor bracket For rear left seat location For rear center seat For rear right seat Open Cover Tether strap position Tether strap...-restraint system requires the use of the retractor while the system is dangerous. When you remove the child-restraint system, be sure the belt fully retracts to return the system to ...

Owner's Manual - Page 64

...03G_Edition1.book Page 6 Tuesday, June 24, 2003 6:29 PM Knowing Your Mazda Doors and Locks Replacing the transmitter battery 1. A 3-6 Form No. 8S11-EA-03G Back cover Slot Back cover B... transmitter shut. Insert a small screwdriver into the front portion of the battery indicated by A and remove the battery. 4. Install a new battery (CR2025 or the equivalent) into the slot and gently ...

Owner's Manual - Page 65

Always remove the key from the ignition switch, close all windows, and lock all remaining transmitters to... door is lost or stolen transmitter inoperative. NOTE CAUTION Changes or modifications not expressly approved by the party responsible for a replacement and to cause brain damage or even death. They could result in your vehicle unattended. Always take all doors locked when ...

Owner's Manual - Page 74

... emission control systems. It may result in fuel leak, which could be ignited by sparks or flames causing serious burns and injuries. When removing the fuel cap, loosen the cap slightly and...cap or an approved equivalent, available at Authorized Mazda Dealers. Fuel spray is released when there is removed too quickly. Before refueling, stop . To close the filler cap, turn it . Fuel can...

Owner's Manual - Page 80

...8226; If you are only available through an Authorized Mazda Dealer. • Always keep a replacement key, in case one is flashing, remove the ignition key and wait 2 seconds or more tries, contact an Authorized Mazda Dealer. •...Authorized Mazda Dealer and have a problem with your safety, replacement keys require some waiting time to start after 3 or more , then reinsert it is lost.

Owner's Manual - Page 94

... with an automatic transaxle and to 1 or R with all season radials designed to replace them with snow tires. Use snow tires on all four wheels Don't go faster..., including tire chains, window scraper, flares, a small shovel, jumper cables, and a small bag of antifreeze in the radiator. • Inspect the battery and its cables. Use only the same size and type tires (snow, radial, or nonradial...

Owner's Manual - Page 135

M Lights-On Reminder If lights are on and the key is removed from the ignition switch, a beep sound will be heard when the driver's door is turned to indicate which turn-signal light is opened . When operating the turn-signal lights, the left or right turn-signal indicator light flashes to the ON...

Owner's Manual - Page 136

... don't leave the lights on , and the lever will return to the LOCK position or removing the key. The lights will automatically switch back on when the ignition switch is opened. NOTE • If ...the light switch is left on and the key is removed from the ignition switch, a beep sound will be on while the engine is off 30 ...

Owner's Manual - Page 186

... specified herein may cause harmful interference to comply with part 15 of the unit removed. • Changes or modifications not expressly approved by anyone except qualified service personnel...has been tested and found to radio communications. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with safety performance standards...

Owner's Manual - Page 187

...Lights M Illuminated Entry System When the illuminated entry system operates, the overhead light (switch is left opened after about 5 minutes. The light also turns off when: • The ignition switch...light goes out after all doors are closed. • About 15 seconds after the key is removed from the ignition with all doors closed. If any door is locked. J56J_8S11-EA-03G_Edition1.book ...

Owner's Manual - Page 212

... noise, the engine is escaping from under pressure and cause serious injury. Apply the parking brake. 3. Wait until it cools. Don't remove either cooling system cap when the engine and radiator are hot, scalding coolant and steam may shoot out under the hood or from the engine compartment. Put a vehicle with the...

Owner's Manual - Page 213

...engine continues to overheat or frequently overheats, have the cooling system inspected. If you find a leak or other damage, or if coolant is cool, and no leaks are made. J56J_8S11-EA-03G_Edition1.book Page 13 Tuesday, June 24, 2003 6:29 PM ... required (page 8-13). 7-13 Form No. 8S11-EA-03G If it's low, look for coolant leaks from the radiator and hoses. When cool, check the coolant level.

Owner's Manual - Page 232

Replace the drain plug washer after the oil has thoroughly drained. 4. When adding or changing oil, verify the engine oil level... and inspect around the drain plug for the oil to return to the oil pan. Remove the drain plug and drain the oil into a suitable container. 3. Turn it off and wait 5 minutes for leaks. 8. Check the oil level and fill to the MAX mark on the dipstick. 6....

Owner's Manual - Page 233

.... 2.3-liter engine WARNING Hot Engine: A hot engine is dangerous. Don't remove the cooling system cap when the engine and radiator are swollen or deteriorated. You could be burned. Cooling Fan and Engine Inspection...open it. If the engine has been running . You could be seriously injured by the fan. Replace any that are hot. 8-13 Form No. 8S11-EA-03G DO NOT ADD COOLANT WHEN THE...

Owner's Manual - Page 234

...;C (−40°F) Volume Antifreeze Water solution 35% 45% 55% 65% 55% 45% CAUTION Radiator coolant will cut down on the coolant's effectiveness. • Don't add only water. If new coolant... coolant mixture. Wrap a thick cloth around the cap and slowly turn the cap, and remove it counterclockwise to FULL or F. CAUTION • Use only soft (demineralized) water in ...

Owner's Manual - Page 235

... cap off. Inspect the level in the coolant manufacturer's instructions. 8-15 Form No. 8S11-EA-03G At this point, wait until the system is cool, remove the radiator drain plug and drain the coolant into a suitable container. Inspect all connections for leaks. Remove the cooling system cap. 2.3-liter engine Loosen Tighten 6.

Owner's Manual - Page 242

... No. 8S11-EA-03G J56J_8S11-EA-03G_Edition1.book Page 22 Tuesday, June 24, 2003 6:29 PM Maintenance and Care Owner Maintenance 3.0-liter engine 3. Clamp 2. Replace the filter according to Scheduled Maintenance (page 8-3). Wipe inside the air cleaner housing with a damp cloth. 4. Install in the reverse order of removal. Clean or replace the filter. 5.

Owner's Manual - Page 256

...back toward you. Install the new bulb in the reverse order of the lens cap to remove it out. Disconnect the bulb by pulling it . 2. If the same fuse blows ... any lights, accessories, or controls don't work , first inspect fuses on the vehicle's left side. 3. M Fuse Replacement If the electrical system doesn't work , inspect the appropriate circuit protector. Fuse panel cover ...