2001 Mazda Tribute Support Question
2001 Mazda Tribute Support Question
Find answers below for this question about 2001 Mazda Tribute.Need a 2001 Mazda Tribute manual? We have 1 online manual for this item!
Question posted by miwal on November 14th, 2012
Mazda Tribute 6 Cylinder Does It Need A Timing Belt Replacement At 150-000km
The person who posted this question about this Mazda automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 3
... this vehicle correctly may change the contents without notice and without incurring obligation. During the first 1,600 km (1,000 miles) of vehicles. Mazda may result in effect at the time of what is covered and what is not covered, refer to the Warranty Guide that is necessary to give the moving parts...
Owner's Manual - Page 10
...parking brake is turned ON.
If the brake warning lamp does not illuminate at these times, seek service immediately.
Brake system warning Momentarily illuminates when the ignition is functional. to ...brake system (ABS) (if equipped) Momentarily illuminates when the ignition is functional. Safety belt Momentarily illuminates when the ignition is turned to the ON position to remind you to...
Owner's Manual - Page 14
... lamps are on, the ignition is properly re-installed, the light(s) will vary depending on the safety belt warning chime, refer to the Seating and safety restraints chapter. CAP When this light turns on the SRS...to ensure your bulb is opened .
14 When the fuel filler cap is off after a period of time for the system to Fuel filler cap in the ignition) and the driver's door is not in the ...
Owner's Manual - Page 28
... minutes will automatically reverse one hour. NOTE: If the power supply to 00. RDM will need to be set to stop and eject a CD. NOTE: If the time is not adjusted while the clock's current time is flashing (if neither or is pressed), and the CLOCK control is within the first half of...
Owner's Manual - Page 47
...EQUIPPED) To operate the moon roof: • The moon roof is installed, the moon roof needs to be converted to accommodate a variety of aftermarket garage door openers: • Remove the ...hold the rear portion of the control. To stop motion at any time during the one -touch, express opening , press the control a second time. • To close , press and hold the front portion of the control.
Owner's Manual - Page 59
Controls and features
Replacing lost transmitters If a remote transmitter has been lost and you would like to beginning this procedure. NOTE: This procedure must be completed within the specified times. If not completed within the specified time period, reprograming procedures must be restarted from the vehicle's memory, or you would like to purchase additional...
Owner's Manual - Page 61
...2 4
1
The light in vehicle starting problems and a loss of time or flashes rapidly, have the system serviced by your authorized Mazda dealership.
61 If the light stays on for three seconds and then ...vehicle is armed immediately after switching the ignition to the 3 (ON) position with non-Mazda aftermarket remote start systems. Use of these systems may result in the instrument cluster will ...
Owner's Manual - Page 62
...objects, electronic devices on the key chain that can be purchased from your key or you need to keep these systems may cause vehicle starting issues. Check to purchase gasoline or similar items...start . Your dealership can be used to make sure the encoded ignition key is an approved Mazda encoded ignition key.
62 NOTE: If a problem occurs, turn ignition OFF and restart the engine...
Owner's Manual - Page 63
... be erased from the vehicle in the ignition it will need to an authorized Mazda dealership. . Programming spare keys A maximum of each step in the procedure. To program a coded key yourself, you begin. If not completed within the specified times. If two previously programmed coded keys are lost or stolen you may want...
Owner's Manual - Page 77
...). The automatic locking mode is the normal retractor mode, allowing free shoulder belt length adjustment to use the automatic locking mode • Any time a child safety seat is automatically pre-locked. How to your movements and locking in the shoulder belt. When to vehicle movement.
For example, if the driver brakes suddenly or...
Owner's Manual - Page 78
...belt is now in collisions.
78 WARNING: BELT AND RETRACTOR ASSEMBLY MUST BE REPLACED if the seat belt assembly "automatic locking retractor" feature or any vehicle collision, the front passenger outboard seat belt... the combination lap/shoulder belt and allow it to retract completely to retract. In addition, all seat belts should be checked by an authorized Mazda dealership to verify that ...
Owner's Manual - Page 80
... seats. NOTE:Do not use to change the fit of the belt through the tongue until it fits snugly across the hips. To tighten the belt, pull the loose end of the shoulder belt across your authorized Mazda dealership. Shorten and fasten the belt when not in the instrument cluster and a chime sounds to remind...
Owner's Manual - Page 82
...times more likely to be replaced.
All safety belt assemblies, including retractors, buckles, front seat belt buckle assemblies, buckle support assemblies (slide bar-if equipped), shoulder belt height adjusters (if equipped), shoulder belt... an authorized Mazda technician finds that all safety belt assemblies used with don't wear belts I have an air bag I 'm with safety belts. Children and...
Owner's Manual - Page 89
...is provided.
89 WARNING: All occupants of the supplemental restraint system is moving with seat belts worn properly. WARNING: Modification of the Supplemental Restraint System Modifying the components or wiring ...the sides of the seat while the vehicle is dangerous. An Authorized Mazda Dealer can provide the special care needed in the center of the front seatbacks. Don't make it or...
Owner's Manual - Page 93
...encourages safer seating posture and better fit of lap and shoulder belts on children who have outgrown child safety seats, Mazda recommends use a rear-facing child restraint system in the front ...seat with an air bag that is labelled as conforming to discuss the special needs of a belt-positioning booster ...
Owner's Manual - Page 108
...front of your vehicle serviced immediately by an authorized Mazda dealership.) Using four wheel ABS (if equipped)...
108 Driving
WARNING: The Anti-Lock system does not decrease the time necessary to apply the brakes or always reduce stopping distance. NOTE..., apply continuous force on or continues to flash, the ABS needs to be activated immediately, thus allowing you to retain full steering...
Owner's Manual - Page 156
...) (22.5) (30) (37.5) (45) (52.5) (60) (67.5) (75) (82.5) (95)
ENGINE Engine valve clearance I (for 2.0L engine) Engine timing belt (for 2.0L engine) Replace every 144,000 km (90,000 miles) Engine oil R R R R R R R R R R R R Oil filter R R R R R R R R R R R R Drive belts I I I PCV valve (for 2.0L engine) *1 Replace every 96,000 km (60,000 miles PCV valve (for 3.0L engine...
Owner's Manual - Page 158
...) (60)
ENGINE Engine valve clearance I (for 2.0L engine) Engine timing belt (for 2.0L engine) Replace every 144,000 km (90,000 miles) Engine oil R R R R R R R R R R R R Engine oil (for Puerto Rico) Replace every 4,800 km (3,000 miles) (or 3 months) Oil filter R R R R R R R R R R R R Drive belts I I PCV valve (for 2.0L engine) *1 Replace every 96,000 km (60,000 miles) PCV valve...
Owner's Manual - Page 193
Cleaner air Mazda endorses the use of reformulated "cleaner-burning" gasolines to the engine. Fuel Filler Cap Your fuel tank ...cap, align the tabs on . Pull to the Instrumentation chapter. Turn the engine off feature. indicator may need to cycle the ignition from OFF to ON several times after refueling, to allow the fuel system to pump the fuel from the fuel filler pipe. 4. Maintenance...
Owner's Manual - Page 223
... death or serious bodily injury OR 2. The consumer has the right to choose whether to either replace the vehicle with one time) In the case of 1 or 2 above, the consumer must also notify the manufacturer of the need for the repair of a new vehicle or the first 29 000 km (18 000 miles...
Similar Questions
Why My Mazda Tribute 2,0ldelay To Develop When Start Move And It Sounds Loud T
Why my Mazda tribute 2.0L takes a time to change gear when it starts moving, It sounds laud to chang...
Why my Mazda tribute 2.0L takes a time to change gear when it starts moving, It sounds laud to chang...
(Posted by camachoze 10 years ago)
How To Remove The Pcv Valve From A 2001 Mazda Tribute 4 Cylinder
(Posted by eueuFire 10 years ago)
Bleeding De Coooling System In A Mazda Tribute 2003 6 Cylinders
for bleeding de cooling system in a mazda tribute 2003 6 cylinders
for bleeding de cooling system in a mazda tribute 2003 6 cylinders
(Posted by armandoduro 11 years ago)
Catalytic Converter
Which catalytic converter would need to be replaced if the efficency is low in bank 2?
Which catalytic converter would need to be replaced if the efficency is low in bank 2?
(Posted by jhmiller 11 years ago)
Where Is The Egr Solenoid & Tps Sensor Located?
Origonal parts may need to be replaced for a 2001 Mazda Tribute. Codes showed up for P9122 and P1409...
Origonal parts may need to be replaced for a 2001 Mazda Tribute. Codes showed up for P9122 and P1409...
(Posted by tim4tinstar7 12 years ago)