Maytag MHWE450WW Support Question
Maytag MHWE450WW Support Question
Find answers below for this question about Maytag MHWE450WW - 4.5 cu. Ft. Front Load Washer.Need a Maytag MHWE450WW manual? We have 2 online manuals for this item!
Question posted by look1068 on March 16th, 2012
Front Loader Flashing E3. Repairman Said Needs New Control Board, Can I Fix This
My Maytag front loader was repaired with new sensors at both the hot and cold inlet. After the repairman left, the washer started flashing E3. Repair man came back and said it needed a new control board. Could the repairman have caused the problem. Is there anything I can try to get it to work?
Current Answers
Related Maytag MHWE450WW Manual Pages
Owners Manual - Page 3
... you what can kill or hurt you and others are not followed.
3 WARNING
You can be killed or seriously injured if you don't follow instructions. WASHER SAFETY
Your safety and the safety of injury, and tell you what the potential hazard is the safety alert symbol.
We have provided many important...
Owners Manual - Page 4
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Tools needed for connecting the water inlet hoses
Tools needed for connecting the drain hose „ Locking pliers (that open to 19/16" [39.5 mm])
„ Pliers (that open to 19/16" [39.5 mm])
„ Flashlight (optional)
4
The parts supplied are in the washer drum.
Owners Manual - Page 5
... refer to stack your dryer or refer to purchase a Stack Kit. Inlet hose washers (4) D. and connector kit, Part Number 285835
4 ft (1.2 m) drain hose extension kit, Part Number 285863
2 longer water fill hoses: 6 ft (1.8 m) Part Number 76314, 10 ft (3.0 m) Part Number 350008
Optional pedestal
This pedestal is available in the "Assistance or Service" section. Hose clamp...
Owners Manual - Page 6
...)
381/4" (970 mm)
„ Hot and cold water faucets located within 6 ft (1.8 m) of where the power cord is attached to the back of the washer is not recommended.
321/2" (820 mm)
„ A sturdy and solid floor to reduce
noise transfer. Installing the washer on all sides of the washer. You will need
„ A water heater set to...
Owners Manual - Page 7
...24 in .2 * (155 cm2)
1" 31½" 4" (25 mm) (800 mm) (102 mm)
3" (76 mm)
A
B
A. Washer on pedestal
18" min. (457 mm)
1" (25 mm)
27" (686 mm)
A
1" (25 mm)
1" 31½" 4" (... mm)(102 mm)
B
A. Recessed area B. Side view - Side view - Closet door with stacked washer and dryer
The dimensions shown are for recessed or closet installation, with vents
Recessed or closet installation -...
Owners Manual - Page 8
...) (800 mm) (25 mm) (25 mm) (686 mm) (25 mm)
Drain System
The washer can result in the top are for cabinet installation
„ The dimensions shown are
required.
7" (178 mm) 7" (178 mm)
Laundry tub drain system (view C) The laundry tub needs a minimum 20 gal. (76 L) capacity. It is recommended. wall or floor (views...
Owners Manual - Page 10
... hose failure. Screw on coupling by hand until it easier to the Hot (left) inlet valve. A
B
A. Washer
2. H.
Using pliers, check the tightness of the hose couplings already attached to reduce the risk of use to the washer. Hot water inlet C.
Connect the Inlet Hoses
1. Insert new flat washers (supplied) into each end of drain
hose.
2. Damage to the coupling...
Owners Manual - Page 11
...the washer cabinet, the washer may need additional parts. Complete Installation
1. Check the electrical requirements. Check that all of your washer avoids excessive noise and vibration.
1. A
B
A.
If the washer is... 6. Tightly wrap the beaded strap around the water inlet hoses and the drain hose. Slide the washer to back. Laundry tub drain or standpipe drain Connect the drain hose ...
Owners Manual - Page 12
... front onto the center of all the laundry products before they touch any garments. This factory setting can be easily removed. Heating Element This washer has a heating element that automatically heats the water to complete the entire Clean Washer Cycle without interruption. Automatic temperature control regulates incoming hot and cold water.
Do not use an extension...
Owners Manual - Page 13
The suspension system and controls are made to produce the right amount of suds for the best performance.
Do not store laundry products on load size.
Use 1/2 the manufacturer's recommended amount for the first time, if not completed during operation. The Efficient Detergent System ensures that of your washer. Starting Your Washer
Using the Proper Detergent
Use...
Owners Manual - Page 14
.... The signal is helpful when you do not select START/PAUSE within 60 minutes of detergent to add them. Using the Dispenser
Your new washer has a dispenser drawer with all cycles and options.
...and the wash load can be removed from the washer as soon as it firmly until the lock clicks. Not all modifiers are available with three separate compartments for your laundry products-one is...
Owners Manual - Page 15
...in the correct position for load size.
„ If... and begin a new cycle
1.
Detergent type selector...washer. Changing Cycles, Options, and Modifiers
Not all cycles. Select START/PAUSE (for approximately 1 second). The detergent type selector (A) must always be left in position for powdered detergent A. To pause the washer...Delay Wash option, powdered laundry products should be changed anytime...
Owners Manual - Page 16
... the controls are locked. Hot washing temperatures assure optimal bleach activity. This cycle combines high-speed tumbling, longer wash time, and fast-speed spin to continue the cycle. Select START/PAUSE (for the selected cycle.
„ The preset settings can be changed anytime before START is lower than needed for different types of the washer.
The CONTROL...
Owners Manual - Page 17
...
Extra High
Normal/Casual Normal (0:50)
Warm/Cold
High
Delicate
Normal (0:40)
Cold/Cold
Low
Quick Wash (2-3 Items)
Light (0:30)
Warm/Cold
Extra High
Sanitary
Normal (1:50)
Hot/Cold
High
Power Wash
Heavy (1:55)
Hot/Cold
Extra High
Clean Washer N/A
N/A
N/A
with any new product, you want from your washer. Normal Washer Sounds
As with AFFRESH™
(1:05)
Rinse & Spin...
Owners Manual - Page 18
... (Fresh Hold) indicator light will flash. Modifiers
Preset cycle settings of the cycle starts. Not all modifiers are available with all cycles. Fresh Spin (Fresh Hold) NOTE: The panel shown above may save energy.
„ In wash water temperatures colder than cold rinses. Automatic temperature control regulates incoming hot and cold water. Not all options are...
Owners Manual - Page 21
...CONTROLS LOCK lights will rotate while the
washer runs a short sensing cycle. To winterize washer: 1. Disconnect water inlet hoses from faucets and drain.
Failure to follow these instructions can damage your inlet...and Moving Care
Install and store your washer for other items are detected in death, fire, or electrical shock.
2. Press START/PAUSE.
b) If any detergent to...
Owners Manual - Page 22
... antifreeze
in death, fire, or electrical shock.
22 3. Disconnect the water inlet hoses from closing completely. In the U.S.A. Are screens at the end of your load size if needed. Check the following : Is the washer door firmly shut? Re-select cycle and press START/PAUSE. Check the following : Is the drain hose kinked?
Re-select...
Owners Manual - Page 24
... Delicate cycle, you use Quick Wash on the load size and the hot water inlet temperature.
„ Is "SUD" shown in suspension. Sort dark clothes from whites and lights.
„ Was the wash temperature too low? Unload the washer as soon as it in a load. Make sure your hot water system is complete, then resume with...
Owners Manual - Page 25
...Mississauga, Ontario L5N 3A7
MAYTAG® LAUNDRY LIMITED WARRANTY
This Maytag Limited Warranty supersedes and ...132; Accessory and repair parts sales. If you need replacement parts If you still need to order replacement ...need help us to better respond to build every new Maytag® appliance.
Maytag® appliances designated service technicians are made with the product, Maytag...
Owners Manual - Page 26
... so these parts that prevent function of the washer and that vary from defects in a remote area where service by a Maytag designated service company. SIXTH THROUGH TENTH YEAR ...REMEDY UNDER THIS LIMITED WARRANTY SHALL BE PRODUCT REPAIR AS PROVIDED HEREIN. MAYTAG SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. If you need repair service, first see the "Troubleshooting" section ...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How to remove odors from a front-load washer without a Clean Washer cycle.
... odors from a front-load washer without a Clean Washer cycle. Remove any clothing or items from a front-load washer without a Clean Washer cycle. Use of more times. This may be necessary if this maintenance cycle every month to maintain washer freshness. This procedure helps keep odors from your laundry room is complete, leave... -
Loads are wrinkled - Top-load washer
...-load washer are wrinkled. What can set in the search tool below to avoid the same problem. Top-load washer Loads are tangling and twisting - Loads are wrinkled - Were the clothes left in the washer is not correct - A load that the cold-water inlet hose is also important to promptly remove loads from the dryer to find them online. Are the hot and cold water inlet... -
Loads are wrinkled - Top-load HE washer with Dispenser Drawer
... the load spins. Are the hot and cold water inlet hoses reversed? Top-load washer Not rinsing well - Top-load HE washer with Dispenser Drawer - Were the clothes left in the washer is on . If the load sits for proper connection to relax wrinkles and reduce setting of the cycle, wrinkles can also cause more likely to avoid the same problem. Load items need room...
Similar Questions
How Much Is Control Board For Epic Z Washer
(Posted by aremarkut 9 years ago)
Why Is My Front Load Washer Flashing F H
(Posted by mcuRabbi 10 years ago)
After Lightning Storm All Lights On Control Panel Lit Must Unplug,washing Work
Maytag MHWE300VW - Front Load Washer. Able to wash clothes, but in normal cycle since can't tell wha...
Maytag MHWE300VW - Front Load Washer. Able to wash clothes, but in normal cycle since can't tell wha...
(Posted by blarsen 11 years ago)
I Have A Maytag Front Loading Washer And It Flashes F20 And Shuts Off. ???
How do you fix th
How do you fix th
(Posted by lajoyes 12 years ago)
I Have A Maytag Nepture Model # Mah6500aww Front Loading Washer, The Control Li
I have a maytag NEPTURE MODEL # MAH6500AWW front loading washer, the control light START BUTTON IS F...
I have a maytag NEPTURE MODEL # MAH6500AWW front loading washer, the control light START BUTTON IS F...
(Posted by MRAY441 13 years ago)