Maytag MFW9700S Support Question
Maytag MFW9700S Support Question
Find answers below for this question about Maytag MFW9700S - 4.0 cu. Ft. Super Size Capacity.Need a Maytag MFW9700S manual? We have 1 online manual for this item!
Question posted by Dbduncan599 on November 22nd, 2017
Washer Gives The Sud And F02 Message Even Without Soap! Sounds Like It Is Draini
washer sounds like it's draining but will not turn off- must be unplugged to stop running! Tech couldn't find problem. Anybideas
Current Answers
Answer #1: Posted by waelsaidani1 on November 22nd, 2017 4:44 PM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,777
Member since:
May 12th, 2013 Points: 19,501,777
Hello here is a video guide on how to solve this problem: https://www.youtube.com/watch?v=79SUFzLjJlc
Related Maytag MFW9700S Manual Pages
Use and Care Guide - Page 3
...and on all safety messages.
Always read and obey all hot water faucets and let the water flow from service or discarded,
substances as they give off vapors that ...Do not repair or replace any part of the washer or attempt any accumulated hydrogen gas. WASHER SAFETY
Your safety and the safety of others .
All safety messages will release
s See "Electrical Requirements" for 2...
Use and Care Guide - Page 4
..., 10 ft (3.0 m) Part Number 350008
Options
Pedestal
A pedestal will need to the total height of the washer for connecting the water inlet hoses s Pliers (that open to Buy
Laundry tub or standpipe taller than 96" (2.4 m)
Sump pump system (if not already available)
Overhead sewer
Standard 20 gal. (76 L), 30" (76.2 cm) tall drain tub...
Use and Care Guide - Page 5
...;₂" 4" (2.5 cm) (80 cm) (10.2 cm)
3" (7.6 cm)
A
B
A. See "Drain System." Proper installation is not recommended. Custom undercounter installation - s Hot and cold water faucets located within 6 ft (1.8 m) of where the power cord is recommended to the back of 400 lbs (180 kg). Do not operate your washer improves performance and minimizes noise and possible...
Use and Care Guide - Page 6
... can be installed using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain system. The top of the washer. Recommended installation spacing for cabinet installation
s The dimensions shown are required.
7" (17.8 cm) 7" (17.8 cm)
A
B
Laundry tub drain system (view A) The laundry tub needs a minimum 20 gal. (76 L) capacity.
Additional hoses might be...
Use and Care Guide - Page 7
...instructions can result in the neutral or ground circuit.
This washer is recommended that a separate circuit serving only this appliance be run with a cord having a 3 prong grounding plug. ...remove ground prong. s This washer is properly installed and grounded in accordance with a qualified electrician if you are not sure the washer is within approximately 3 ft (90 cm) of electric...
Use and Care Guide - Page 8
... inlet
3. Connect the Inlet Hoses
Make sure the washer drum is seated on the water faucets and check for relocation by hand until it is empty.
1.
Turn on the washer.
5. Floor drain You may need additional parts. Damage to the corrugated drain hose.
Laundry tub drain or standpipe drain Connect the drain hose form to the coupling can result.
4.
Use and Care Guide - Page 9
.... Slide the washer to the laundry tub leg or standpipe with a wood block and adjust the feet as necessary. Check the electrical requirements.
Level the Washer
Properly leveling your tools. 4. Check that you have all packaging materials. 5. Plug into the detergent dispenser. Secure the drain hose to its top edges.
5. Check for a medium-size load.
Use and Care Guide - Page 10
... Load Size Since there is wasted. Two sensors determine load size, load composition, and suds level, then the sensors adjust the water level to five different spin speed choices. This washer allows... Garment When this option is heated.
Smart Dispensers The Smart Dispensers make your washer truly automatic. Laundry additives are also able to assure thorough rinse-out and mixture of off -...
Use and Care Guide - Page 11
...of this manual for a medium-size load. The display shows the estimated ...laundry according to produce the right amount of suds for this type of oil on the top surface of detergent to specific sections of this washer. Do not overload washer. Turn...run it firmly until the lock clicks. Not all options are dampened with all cycles. Starting Your Washer
WARNING
First Wash Cycle Without Laundry...
Use and Care Guide - Page 12
...the dispenser drawer slowly and completely (to the washer during the wash cycle, making it stops. s Do not fill beyond the "MAX...C. Liquid or powdered detergent may seep out of suds for your laundry products-two are available with all cycles and options...automatically be removed from the washer.
s When the wash cycle is normal for load size. Use only HE High Efficiency...
Use and Care Guide - Page 13
... HOLD TO START is selected. To change Options or Modifiers after HOLD TO START is too high, the washer will be a gap between guides
A. Select the desired OPTIONS or MODIFIERS. 3. To drain the washer manually 1. Select DRAIN/SPIN. 3. Select HOLD TO START (for
approximately 1 second). When the spin is operating. They also indicate when...
Use and Care Guide - Page 14
...
The SUDs routine removes extra suds and ...super hot water temperature and fast-speed tumbling to help ensure the removal of your laundry. If the water temperature is unbalanced. This cycle combines fast-speed tumbling, a shortened wash time, and extra high speed spin to shorten drying times. Adding items This washer... the CONTROL LOCKED Status light turns off . The Sanitary cycle ...
Use and Care Guide - Page 15
... time)
Spin Speed
Sanitary
Normal (1:55)
Super Hot/Cold Extra High†
Whitest Whites
...Drain/Spin Normal
N/A
(0:11)
Extra High
†Spin speeds may hear various sounds when the door is washable.) This cycle gently tumbles and drains without spin assures gentle treatment, even for equal distribution of the laundry... Use this cycle to drain your washer or to drain and spin your wash...
Use and Care Guide - Page 16
...to the Rapid Wash cycle. Automatic temperature control is automatically turned On when a cycle is the same as the first rinse...Temperature Guide
Wash Water Temperature Suggested Fabrics
SUPER HOT
Sturdy colorfast fabrics Heavy soils
HOT
Whites and ...all cycles. Laundry will be used to light soils
COLD
Colors that need pretreatment. After soaking, the washer drains without drum movement...
Use and Care Guide - Page 17
...Press" or
"Wrinkle Free" or that indicate using a "Gentle"
cycle on the care label. Laundry Guide
Refer to this cycle to each of cotton,
✔
polyester, nylon and cotton blends
...Soak
Fabrics made of cotton, linen, polyester or
✔
✔
nylon
Drain/Spin
Fabrics made of these washer cycles.
CYCLE
SUGGESTED LOAD TYPE
AVAILABLE OPTIONS
Rinse/Hold Prewash* Auto Soak* ...
Use and Care Guide - Page 18
... (maximum size loads). Follow the manufacturer's instructions to determine the amount of detergent to avoid scratching the washer interior.
...if left in washer errors, longer cycle times and reduced rinsing performance. When possible, turn them inside-out....garment bag. LAUNDRY TIPS
Preparing clothes for washing
Follow these recommendations to produce the right amount of suds for the best...
Use and Care Guide - Page 19
... of HE detergent for an extended period of your washer for a medium-size load, to the washer. Unplug washer or disconnect power. 4. Cleaning the dispenser drawer The dispenser drawer is removable for any spills. If you are found. Do not use an adapter.
Unplug the power cord. 3. Run washer on a DRAIN/SPIN cycle. 2. To clean the seal, mix a dilute...
Use and Care Guide - Page 20
... PAUSE/OFF twice to follow these instructions can result in washer or reconnect power.
s "F02" (Drain Problem) Select PAUSE/OFF twice to inform you using an extension cord? Select DRAIN/ SPIN if there is displayed during rinsing and at the plug? Washer displaying code message and tone sounds
Washer won 't fill, wash or rinse s Check the following : Is the...
Use and Care Guide - Page 21
... with liquid detergent. Add items or try again. If the laundry is drained from lint takers (corduroy, synthetics).
s Did you overloaded the washer? Lint can result in the load if overloaded. s Check... hold it in the correct position?
Do not overload the washer.
Use only HE detergent.
Cycle will complete once extra suds are removed.
Load too wet
s Did you using HE ...
Use and Care Guide - Page 22
... detergent to remove soil and hold it stops. Follow the manufacturer's instructions to heat the water. s Did you overload the washer?
s Did you wash a large load using liquid detergent. Use more detergent for smaller load sizes (2-3 items of the drain.
22 This routine will depend on the load size and the hot water inlet temperature...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Vibration - Front-load washer
... in the search tool below give examples of the pedestal and the washer. Make sure the washer is normal. Are all four of the washer before installing it onto the pedestal...drawer. See the Installation Instructions for a front-load washer. FAQs Knowledgebase search tips Sounds during drain - When the washer is uneven can be reduced by entering your hands; Vibration that... -
Sounds different than my previous washer- Front-load washer
... air being pulled through increasingly higher spin speeds. The sounds recorded below give examples of the drain cycle. Front-load washer Vibration - Front-load washer Sounds different than my previous washer; Play the sound of the washer filling with any new product, you will hear sounds that you may sound different in different homes, depending on the floor, load in... -
Not draining, not spinning out water, wet loads - Top-load washer
...spin speeds. Large or unbalanced loads can stop . Front-load washer Washer will leave less water in loads. In this case, the water may flow back into the washer. enter your product model number in the... suds with water, and then to wash, drain, rinse and spin. My loads are 96" (244 cm) maximum and 39" (99 cm) minimum. Straighten the hose for the washer to fill with the problem...
Similar Questions
The Soap Is Leaking Between The Door And Bottom Plate.
My washer has started leaking soap between the bottom of the door and the bottom plate front. The so...
My washer has started leaking soap between the bottom of the door and the bottom plate front. The so...
(Posted by dlscheuerman 1 year ago)
Washer Is Not Draining And Says Ld
My washer will not drain properly and sometimes say LD. I clean it likeI should. Any help??
My washer will not drain properly and sometimes say LD. I clean it likeI should. Any help??
(Posted by Ellismom03 8 years ago)
What Does Dl Stand For On Washer With All Lights Flashing Seconds After
starting and starts clicking sound in beginning turns on then all lights flash and clicks
starting and starts clicking sound in beginning turns on then all lights flash and clicks
(Posted by thegpl13 10 years ago)
'suds' Error Message
My washing machine stops about 15 minutes before the end of the washing cycle, and gives a error mes...
My washing machine stops about 15 minutes before the end of the washing cycle, and gives a error mes...
(Posted by w7cmh 12 years ago)
What Does Dl And F Error Codes Mean?
Washer will click on but no water runs into it. Error codes were DL and F flashing. Same result on a...
Washer will click on but no water runs into it. Error codes were DL and F flashing. Same result on a...
(Posted by heidiann129 13 years ago)