Maytag MFI2266AES Support Question
Maytag MFI2266AES Support Question
Find answers below for this question about Maytag MFI2266AES.Need a Maytag MFI2266AES manual? We have 2 online manuals for this item!
Question posted by Dwells716 on January 30th, 2016
Where Is The Water Inlet Valve Located
where is the water inlet valve located
Current Answers
Answer #1: Posted by TommyKervz on January 31st, 2016 1:41 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,813
Member since:
January 10th, 2013 Points: 17,776,813
Related Maytag MFI2266AES Manual Pages
Service Manual - Page 1
... for information on specific models This manual includes, but is to the following:
Amana
AFI2237AE* AFI2538AE* AFD25BCZX* AFD25WBZX*
Maytag
MFI2067AE* MFI2266AE* MFI2568AE*
16026312 February 2006 Ice and Water Bottom Mount Refrigerators
This Base Manual covers general information Refer to individual Technical Sheet for improper service procedures done by qualified appliance technicians only...
Service Manual - Page 3
... 5 Service Procedures 10 Service Equipment 10 Drier Replacement 10 Refrigerant Precautions 11 Line Piercing Valves 11 Open Lines 11 Compressor Operational Test 11 Dehydrating Sealed Refrigeration System 12 Leak Testing 12
Testing Systems Containing a Refrigerant Charge 12 Testing Systems Containing No Refrigerant Charge 12 Restrictions 13 Symptoms 13 Testing for Restrictions 13...
Service Manual - Page 7
.... valve
Controlled...Refrigerator Light Switch
Single pole, double throw switch completes circuit for light when door is present. 4. After a short time, current heats the resistor in the circuit through relay to service.
Switch arm depressed
"C" and "NC" terminals Open
"C" and "NO" terminals Closed
Switch arm up "C" and "NC" terminals
Closed
Ice maker water Controls water...
Service Manual - Page 8
...solution.
Reform inlet tube to drier and break. 4. Apply heat trap paste on post condenser tubes to protect grommets from system. 9. If refrigerator is placed at correct location. Evaporator
Thermostat....
1. Do not use high pressure compressed gases in refrigeration systems without a reliable pressure regulator and pressure relief valve in safe place. Do not leave drier with terminal...
Service Manual - Page 10
...inlet tube joint to minute holes pierced in safe place. Valves eventually will drive moisture into system.
!
Cut circumference of system by manufacturer as repaired and/or operational. Remove drier from high heat.
6. If refrigerator...by completing the following steps. Cutting drier at incorrect location will leak where other refrigerants would not. • Swaging tools • Flaring ...
Service Manual - Page 11
... fuses meet specifications for unit under test (see technical data sheet for unit under test).
6.
NOTE: Do not leave line piercing valves on unit serial number identification plate.
Open lines allow refrigerant to be observed. CAUTION
To avoid risk of personal injury, do not indicate a fault), perform the following test: 1.Disconnect power...
Service Manual - Page 17
...ester oil and pressurized with testing.
• Refrigerator must operate minimum of electrical shock, personal injury...;2006 Maytag Services
16026312
17 Positive pressure in specific locations.
Recommended brazing temperature is approximately 1200°F. •...3 lead thermocouple temperature tester in compressor is inlet. Oxygen may result in conjunction with fluoride based...
Service Manual - Page 45
... water supply connection before plugging it snaps into a recess where the top of hinge cap to sit upright for proper air circulation. Allow 1⁄2" space at this temperature.
• Refrigerator is not possible, lay refrigerator on each of the refrigerator.
4. Some clearance may occur at top and 1⁄2" space behind the machine compartment cover (located...
Service Manual - Page 46
... Drawer Removal
Some installations require door/drawer removal to transport the refrigerator to refrigerator before removing water line from power source.
2. WARNING
To avoid electrical shock which can cause severe personal injury or death, observe the following:
• Disconnect power to its final location. Remove center hinge pin with 3⁄8" hex head driver; Remove...
Service Manual - Page 50
... in place.
Vertical Hinged Section
For proper usage and to remove the vertical hinged section from water valve inlet port.
3. Continue to observe the water supply connection for installation. Opening and Closing Your Fresh Food Doors
Your new refrigerator is secure. Either door can cause severe personal injury or death, DO NOT attempt to avoid...
Service Manual - Page 54
... empty storage pan and the water valve may accompany the various cycles of such discolored ice cubes may cause mold/mildew growth.
• Clean up water and ice spills to avoid ...located on the automatic ice making mechanism while the refrigerator is observed, discard the ice cubes and contact your dealer to purchase and install a water line filter.
• Water damage due to improper water ...
Service Manual - Page 55
...Water Filter
Water Filter Removal and Installation
WARNING
To avoid serious illness or death, do not use refrigerator where water is unsafe or of unknown quality without a water filter cartridge.
CAUTION
After installing a new water filter, always dispense water... taste or odor persists, change is located in filter cover and continue with water of unknown quality, except that may be...
Service Manual - Page 64
...of room. Reconnect power to refrigerator and return food to 48 hours. If Odor is two-thirds full runs most efficiently.
• Locate refrigerator in the cleaning instructions every three... compartments.
4. Energy Saving Tips
• Avoid overcrowding refrigerator shelves. Dry surfaces with warm water. Place charcoal briquettes randomly on top shelf of insulation.
•...
Service Manual - Page 66
...
After a Short Vacation or Absence:
• Reconnect the water supply and turn on supply valve (see pages 8-9).
• Plug the refrigerator back in on supply valve (see pages 8-9).
• Monitor water connection for Vacation
CAUTION
If there is located, the water supply system (including the water tank and the water valve) must be checking in and reset controls (see page...
Service Manual - Page 70
... bypass filter. Freezer temperature should be between 35 to ice maker
• Water pressure is too low
• Saddle valve not open completely. • Freezer temperature is recommended for refrigerators with water filters.
• Check water connection procedure in inlet tube to 100 pounds per square inch is too high. Ice storage bin will not close...
User Instructions - Page 3
... an extension cord.
See "Using the Controls."
To ensure proper ventilation for your refrigerator has an ice maker, allow the door to the desired setting. Recommended Grounding Method...or 4.76 mm) saddle valve which reduces water flow and clogs more easily.
■ Use copper tubing and check for the water line connections. Location Requirements
WARNING
Electrical Requirements
...
User Instructions - Page 4
... brass nut and compression sleeve on the copper tubing as it from water supply connection. Do not overtighten.
4. Reverse Osmosis Water Supply IMPORTANT: The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be a minimum of 40 to 60 psi (276 to operate the...
User Instructions - Page 12
...is significant pet traffic in the upper right-hand corner of odors. Water Filtration System
The water filter is located in the home, the condenser should be used without adequate disinfection ... with a clean sponge or soft cloth and a mild detergent in refrigerator or reconnect power.
12 Dry thoroughly with water that you need for three seconds. Do not use the manufacturer's ...
User Instructions - Page 14
...? Wait 72 hours for the
refrigerator to a water supply and the supply shutoff valve turned on model) is an indication of low water pressure. ■ Water shutoff valve not fully open? If the ... be clogged or incorrectly installed. Use airtight, moisture proof packaging to enter
refrigerator. Replace water filter when indicated. Push bin or shelf back in the ice
■ New ...
User Instructions - Page 15
.... This can decrease water pressure. Flush the water system. Make sure the refrigerator is only chilled to a cold water pipe. Connect refrigerator to cool completely.
■ Water not been recently dispensed? See "Water and Ice Dispenser."
■ Is the water pressure at the bottom of water.
■ Refrigerator connected to a water supply and the supply shutoff valve turned on? The...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Water supply hookup - Bottom freezer/French door refrigerators
... using a compression nut and sleeve as it is cleared from the water valve inlet port. Reverse-osmosis water supply The pressure of the water supply coming out of a reverse-osmosis system going to the water inlet valve of the refrigerator to 414 kPa). If a reverse-osmosis water filtration system is clear. Replace the filter if necessary. Allow the storage tank... -
Water supply hookup - French door with exterior dispenser
... and ice maker. If a reverse osmosis water filtration system is required to the water inlet valve of the dispenser. Replace the filter if necessary. Allow the storage tank on the refrigerator before you are ready to plumbing code requirements. If your refrigerator has a water filter, it is available, contact an authorized plumbing technician... -
Water supply hookup - Bottom freezer/French door refrigerator
... an approved water supply line (c). If the refrigerator does not have questions about 3 to the water inlet valve of copper tubing you may further reduce the water pressure when used ? Attach the copper tube to the refrigerator: 1. To connect a refrigerator to a water supply: Connect the refrigerator (a) to a water source, flush the water system. Water supply requirements...
Similar Questions
Where Do I Find & Replace The Water Inlet Valve On My Maytag Mfi2269vem7
(Posted by dchancharuk 9 years ago)
How To Change Dual Inlet Water Solenoid On Maytag French Door Refrigerator
(Posted by ricbgraf 9 years ago)
Water And Ice Dispenser Stopped Working. Buttons Beep, Display Doesn't Change.
Model MFI2266AES Water and Ice dispenser stopped working. Buttons beep, display doesn't change.Any i...
Model MFI2266AES Water and Ice dispenser stopped working. Buttons beep, display doesn't change.Any i...
(Posted by jandjhansen 10 years ago)
Where Is The Water Dispensing Valve On A Maytag Mfi2266aeb
I have removed the water line and lower cover on the back where the water line goes in. It heads dir...
I have removed the water line and lower cover on the back where the water line goes in. It heads dir...
(Posted by Mypalal51 11 years ago)
Water Filter Replacement
Do I need to turn off the water to replace the PUR water filter in my Maytag regrigerator?
Do I need to turn off the water to replace the PUR water filter in my Maytag regrigerator?
(Posted by randyfrederick 13 years ago)