Maytag MEDC300XW Support Question
Maytag MEDC300XW Support Question
Find answers below for this question about Maytag MEDC300XW.Need a Maytag MEDC300XW manual? We have 3 online manuals for this item!
Question posted by gswada on August 13th, 2015
The Drum Will Not Start, Intermittently During A Wrinkle Guard Cycle.
The person who posted this question about this Maytag product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by Odin on August 13th, 2015 9:20 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Go to http://www.repairclinic.com/RepairHelp/Dryer-Repair/8-4--TUVEQzMwMFhX/Maytag-Dryer-Troubleshooting, and consider especially the second link.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MEDC300XW Manual Pages
Owners Manual - Page 2
DRYER SAFETY
2
Owners Manual - Page 4
... BETTER FABRIC CARE AND ENERGY SAVINGS
Use the SENSOR DRY/Automatic Dry cycles to the dryer plays a big role in shrinkage, wrinkling, and static due to efficiently dry laundry.
This sensing occurs throughout the drying cycle and the dryer shuts off when the load reaches the selected dryness. Use Timed Dry for final product check. CHECK...
Owners Manual - Page 5
... may vary.
1 CYCLE KNOB
Use Cycle Knob to help avoid wrinkling. Drying time and temperature will sound periodically when the WRINKLE PREVENT setting is selected, but only if the End of the cycle reduces wrinkling. Appearance may choose a setting based on some models, WRINKLE PREVENT automatically starts at the end of Cycle signal is included in your dryer. CONTROL PANEL...
Owners Manual - Page 6
...
Rubber, plastic, heat sensitive fabrics
Timed Dry or Air Fluff
Air Fluff or No Heat
End of Cycle Signal Wrinkle Prevent
Cycle Details:
Automatic cycles give the best drying in your dryer has multiple heat settings:
A High Heavy temperature setting may be used for foam, rubber, plastic, or heat-sensitive fabrics. Use the Air Fluff...
Owners Manual - Page 7
... a different door than the one shown. Push the lint screen firmly back into place. Place laundry in the dryer. USING YOUR DRYER
WARNING: To reduce the risk of its holder. Load the dryer
Clean the lint screen before operating this dryer. Pull the lint screen out of fire, electric shock, or injury to remove dust...
Owners Manual - Page 8
... and is used for a starting point for your dryer. DRYING RACK
To purchase a drying rack for SENSOR DRY/AUTOMATIC DRY cycles.
4.
Select the desired cycle
5. Select End of the cycle reduces wrinkling.
6. Press PUSH TO START to begin cycle
Push and hold the PUSH TO START knob to begin the cycle. SENSOR DRY/AUTOMATIC DRY cycles give the best drying in...
Owners Manual - Page 9
.... This includes clearing piles of laundry in the dryer. Wet lint is located in dryer.
9
Tumble a load of clean cloths or towels to a residue buildup.
Removing accumulated lint
From Inside the Dryer Cabinet Lint should be removed every 2 years, or more frequently, if it becomes clogged due to dry the drum. See "Venting Requirements." This...
Owners Manual - Page 10
.... 2. Remove the cover.
3. Use tape to dryer. 2.
See "Cleaning the Lint Screen." Changing the drum light (on the back wall of the dryer. Open the dryer door. Locate the light bulb cover on some models)
1. For direct-wired dryers: 1. Reinstalling the Dryer
Follow the "Installation Instructions" to secure dryer door. Unplug dryer or disconnect power.
2. Use tape to...
Owners Manual - Page 11
....
Closet doors must have heat. Make sure the dryer door is not level front to back and side to START knob until you may vibrate if not properly installed....normal operating sound.
Make sure vent is caught between the drum and front or rear of dryer cycles requires temperatures above 45ºF (7ºC). Dryer located in a closet without adequate opening.
http://www.maytag....
Owners Manual - Page 12
... avoid the cost of the cycle. Change the Dry Level setting on load
Lint screen clogged. Stains on load or drum
Dryer fabric softener not properly used for very small loads. Drum stains are gone from the dryer before removing laundry from dryer at the beginning of wrinkles. Loads are cooled slowly to reduce wrinkling and make it easier...
Owners Manual - Page 13
..., single-family household use your major appliance, to replace or repair house fuses, or to correct house wiring or plumbing.
3.
LIMITATION OF REMEDIES;
MAYTAG® LAUNDRY WARRANTY
LIMITED WARRANTY
For one year from the date of purchase, when this major appliance is inconsistent to published user or operator instructions and/or...
Installation Instructions - Page 2
... follow the instructions provided with any tools listed here. Read and follow instructions. INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. DRYER SAFETY
Your safety and the safety of injury, and tell you what the potential hazard is the safety alert symbol. All safety messages will...
Installation Instructions - Page 3
...than 1" [25 mm], install Extended Dryer Feet Kit, Part Number 279810.) If not level, clothes may not tumble properly and automatic sensor cycles may not operate correctly. Check existing ... dryer. (If slope is located in dryer drum. Do not operate your dryer at least 4 ft. (1.22 m) long.
Some codes limit, or do not permit, installation of the Dryer User Instructions.
The dryer must...
Installation Instructions - Page 4
... to the neutral wire, see "Optional 3-wire connection" section.
■■ This dryer is recommended.
Grounding through the neutral conductors.
4 The installation must be used , it... is adequate. A. Large opening side-swing door D. See "Venting Requirements." If the dryer is suitable for the exhaust vent with equivalent ventilation openings are acceptable.
■■...
Installation Instructions - Page 5
...at least 4 ft. (1.22 m) long. Leave enough room for electrical connection and to move and install dryer. The cord should contain:
■■ A UL listed 30-amp power supply cord, rated 120/240 ... a UL listed power supply cord kit marked for use a large flat piece of cardboard from dryer carton; If connecting by direct wire:
Power supply cable must end in leveling legs
diamond marking
...
Installation Instructions - Page 6
... (D) and terminal block cover (A).
Fire Hazard
Use 10 gauge solid copper wire. Failure to "Optional 3-wire Connection" section. Remove terminal block cover
BC D A
E F
Before you start, disconnect power.
use a new ul listed 30 amp power supply cord.
Connect neutral wire (white or center wire) to Venting Requirements. Ground wire (green or...
Installation Instructions - Page 7
... of the two clamp sections (C) into the hole (B) below the terminal block opening so that the wire insulation on strain relief). Spade terminals with the dryer cabinet and be in place. Connect neutral ground wire
and neutral wire
C B
E
Connect neutral ground wire (E) and neutral wire (white or center) (C) of power supply...
Installation Instructions - Page 8
... ends E. 3/4" (19 mm) UL listed strain relief F. Tighten screw.
6.
Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Neutral prong D. Ring terminals G.
Tighten screws. B
D
E
A
C
GF
A. 3-wire receptacle (NEMA type 10-30R) B. 3-wire plug C. Connect ground...
Installation Instructions - Page 15
... level, make sure vent is on a full heat cycle (not an air cycle) for
20 minutes and start , check the following: ■■ Controls are now installed. q Check dryer's final location. For direct wire installation, turn on dryer. Not Level
LEVEL
Not Level
2. Check that all of dryer from front to exhaust outlet in place, remove...
Installation Instructions - Page 16
... slot.
Pull door forward off dryer, and check the following:
■■ There may notice an odor when the dryer is first used. If you feel heat, cancel cycle and close the door. Reverse... towel on top of hinges.
3. If there is helpful. Remove top screws from dryer cabinet side of dryer. This odor is common when the heating element is first heated. Insert plugs into hinge...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Using the dishwasher delay start feature on my dishwasher
... delay time has counted down , press the Delay pad again. The delay indicator will automatically start : Select the appropriate cycle and options for the load. The cycle will remain lit until the Start/Cancel pad is unlatched, the cycle-selected indicator lights will continuously flash and the delay countdown will stop and the... -
Vibration - Front-load washer
...All four shipping bolts must be removed from the load. Play the sound of the washer at the start of a spin cycle. (16 seconds, 260 KB) Play the sound of the washer as the final spin ends....are normal for details. The final spin lasts about 2 to the floor beneath the washer and dryer. Not draining, not spinning out water, wet loads - Is the washer placed directly on the floor ... -
Poor drying performance - Bravos® dryer
... used. Garments that are : Quilted winter jackets that may not dry evenly in choosing lower drying temperatures for Heavy Duty, Normal and Wrinkle Control cycles. The dryer controls remember any changes to dry thick or multi-layer fabrics that contain insulating polyester or down alternative or polyester...
Similar Questions
How To Disassemble Maytag Centennial Dryer Medc300xw
(Posted by gergmtah 9 years ago)
How To Replace Belt On Maytag Centennial Dryer Medc300xw
(Posted by freonit 10 years ago)
Drum Stopped Turning On My Centennial Elec. Dryer.
While NOT running, the drum was turned to retrieve an article of clothing and something snapped. Dru...
While NOT running, the drum was turned to retrieve an article of clothing and something snapped. Dru...
(Posted by Lacytomboy 10 years ago)
How To Reverse The Door On A Maytag Electric Dryer Medc300xw
(Posted by racunpti 10 years ago)
Maytag Electric Dryer, Medc300xw
the dryer turn on but the drum will not turn.
the dryer turn on but the drum will not turn.
(Posted by DavidLDunlap 11 years ago)