Maytag MDE2400AYW Support Question
Maytag MDE2400AYW Support Question
Find answers below for this question about Maytag MDE2400AYW - 3.7 cu. Ft. Electric Dryer.Need a Maytag MDE2400AYW manual? We have 2 online manuals for this item!
Question posted by bensmithson on July 7th, 2010
Heating Element Replacement?
Any wiring details for replacing a heating element? I'm waiting on the part to arrive.... and I'm sure it's the heating element that died, because the wires are broken/cooked.
Current Answers
Related Maytag MDE2400AYW Manual Pages
Owners Manual - Page 1
...
Using the Controls 5-7
Select Cycle Select Dryness Level Select Temperature Select Options Press Start/Pause
Use & Care Guide
Care & Cleaning 8
Control Panel Dryer Exterior Dryer Exhaust System Stainless Steel Special Laundry Tips
Dryer Exhaust Tips 9
Troubleshooting 10
Service & Warranty 11 Guide d'utilisation et
d'entretien 12 Guía de uso y cuidado 22
Form No. A/01...
Owners Manual - Page 2
... items may prevent heat from the clothes dryer hot or interrupt... the drying cycle until the items have run through the Cool Down cycle.
Hazards or unsafe practices which COULD result in minor personal injury.
1
WARNING
FIRE HAZARD - Heat sources, such as proof of our appliances, it may occur. All washed and unwashed fabrics that contain vegetable oil or cooking...
Owners Manual - Page 3
...electric shock, or personal injury when using the appliance.
2. The interior of the clothes dryer.... Do not sit on , in, or in front of the appliance or attempt any part of the appliance. Note
• Because of fire or explosion:
a. For complete details...not repair or replace any servicing unless...heat setting. SAVE THESE INSTRUCTIONS
2 Before the appliance is saturated with cooking...
Owners Manual - Page 4
... from the grid. 3. Note
• Do not operate the dryer without the lint filter grid in place.
• Do not operate the dryer without the filter in uneven drying as well as excessive wrinkling of...grid in the filter opening
and push the right side in the dryer at a time. • Mixed loads of some fabrics.
3
Load the Dryer Properly
• Place only one washload in until it lays ...
Owners Manual - Page 5
...Start/Pause pad to cancel the cycle and stop the dryer. Turn the Dryer Off
Power Off
Press the Power Off pad to start the dryer. The estimated time remaining may fluctuate as the cycle progresses... will illuminate, until the cycle is complete.
When the dryer is pressed. To pause the cycle, press Start/Pause again.
If the dryer is paused during a cycle, the indicator lights will resume...
Owners Manual - Page 6
... Wrinkle Release cycle will illuminate.
Air Fluff
The Air Fluff cycle tumbles the load in the dryer too long after the cycle has ended.
Damp Dry
The Damp Dry cycle is designed to...slightly wrinkled, such as towels, underwear, jeans, etc.
Delicates
The Delicates cycle is designed to dry heat-sensitive items at the end of the cycle. Using the Controls
STEP 1
Select Cycle
To select ...
Owners Manual - Page 7
... or bulkier size may require the More Dry Setting to the desired temperature. Low
For heat sensitive items labeled
Tumble Dry Low or Tumble Dry
Warm.
6
Loads of the cycle.
Use the chart below as a guide:
DRYER TEMPS
LOAD TYPE
Regular
For sturdy cottons or those labeled Tumble Dry. An indicator light...
Owners Manual - Page 9
...heat may damage it or be a fire hazard.
• Use the Normal cycle. • Add a couple of dry towels and a pair of dry towels shortens dry time and absorbs moisture.
• DO NOT dry on the label. • Vegetable or cooking oil soaked items (see page 2).
8 Protect the surface from the dryer...8226; Be sure the item is...laundry pre-treatment soil and stain-remover products. Special Laundry...
Owners Manual - Page 11
... heavy items from lightweight items. • Check the washer to be sure it is draining properly to tumble properly. Remove promptly from dryer. • It is normal to hear the heating element cycle on a solid floor. • It is normal for the dryer to hum due to the high velocity of air moving through the...
Owners Manual - Page 12
...688-2002 Canada to locate an authorized servicer.
• Be sure to retain proof of your dealer to verify warranty status. Misuse, abuse, accidents, unreasonable use will be repaired or replaced free of any breach of service or service call 1-800-... normal home use , or acts of the problem you may not apply. c. Incorrect electric current, voltage, electrical and/or gas supply.
Installation Instructions - Page 2
Tools needed for electric dryers (except Canada). 3.
POWER CORD for installation
Printed in U.S.A.. • Impreso en los Estados Unidos ... DIMENSIONS
24" / 60 cm
33.5" / 85 cm
24" / 60 cm (Depth with dryer door open 90o -3388".2/ 59"7c/ m97) cm)
2 Make sure you have everything necessary for proper installation. 1. GROUNDED ELECTRICAL OUTLET is the responsibility of the owner. See...
Installation Instructions - Page 4
...
The installation of exhaust air, heat and lint. In the United States: • Electric dryers located in a confined area such as possible.
4 plastic or nonmetal flexible duct presents a potential fire hazard.
Use only metal exhaust duct that will not support combustion to insure the containment of the dryer in diameter can result if flexible...
Installation Instructions - Page 5
...DRYER.
• Plastic flexible duct can kink, sag, be sure the exhaust hood damper opens and closes freely. Never install a screen over the exhaust outlet.
• When possible, do not exhaust the dryer...may collect lint.
• The exhaust duct should have at least once a year. Disconnect electrical service prior to cleaning.
• Frequently check to avoid lint build-up .
• ...
Installation Instructions - Page 6
... the dryer.
Maintain a 6" (15.2 cm) clearance between the back of fire, electrical shock or personal injury, all wiring and grounding must be expelled into the laundry area.
• WARNING: IF THE DRYER IS NOT...the frame of water column, or be measured with the dryer running with a Dacron mesh lint bag (see Accessories). A no heat setting should be done in accordance with local codes, or...
Installation Instructions - Page 7
... it is to operate on a 120/208 volt electrical system. • If a power cord is used and the electric dryer is to provide adequate electrical services for use with clothes dryer, that is U.L. Latest Revisions and local codes and ordinances. B149 Installation Codes - The power cord electric supply wiring must be done in the absence of local...
Installation Instructions - Page 8
... and terminated as above, may be plugged into a 30 ampere receptacle.
• If the dryer is to 208 volts. ELECTRIC MODELS - REPLACEMENT PARTS AND ACCESSORIES
If your dryer requires replacement parts or accessories, contact the dealer from whom you purchased your dryer or Maytag Customer Service, Box 2370, Cleveland, Tennessee 373202370, phone 423-472-3333, for...
Installation Instructions - Page 9
... block. Never use sheet metal screws when assembling ducting. Review Electrical Requirements Section. BEFORE OPERATING OR TESTING, follow the grounding instructions in dryer cabinet.
4. If the 4-wire system is used . and 4-WIRE SYSTEM CONNECTIONS. Insert the power cord with a U.L.
Install the ductwork from the dryer. Use duct tape to secure this section to the neutral...
Installation Instructions - Page 10
... cord to the neutral conductor.
4-WIRE SYSTEM CONNECTIONS
1. Secure the power cord in the parts package. 4. Level The Dryer:
With a level, check the dryer, and make necessary adjustments to the cord. 9. Secure in place using the ground strap screw.
5. Use the cupped washers ahead of the terminal block.
6. Replace the terminal block cover. Fold...
Installation Instructions - Page 11
Check All Connections:
At this time, make sure all legs firmly on gas models), exhaust and electrical connections are complete. FINAL INSTALLATION CHECK LIST
❏q Dryer is plugged into electrical outlet and is properly grounded.
❏q Exhaust ductwork is hooked up to dryer and all joints taped.
❏q Plastic flexible duct is NOT used.
❏q Rigid...
Installation Instructions - Page 12
...Ground Wire
using the nuts provided in power cord must be sure the machine is agency listed, rated at the dryer cabinet with a ground wire. The power cord or electric supply wiring must ...60 Hz approved electric service. Secure the power cord ground wire to the center (silver colored) post of the nuts.
Tighten the strain relief screw(s) in position.
3. Replace the terminal ...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Dryer does not heat - Electric dryer
... Only temperature does not add heat to make sure that the power supply cord is properly installed. Electric dryers use 2 household fuses or circuit breakers. dryer does not dry Dryer does not heat - Expect loads dried with the other temperature selections. If the problem continues, call an electrician. Loads are damp; Replace the fuses or reset... -
Display shows L2 - Dryer
..., but will stop appearing after three cycles. Replace the fuse(s) or reset the circuit breaker(s). Electric dryer This code indicates that there may be incorrectly installed. Review the Installation Instructions for proper installation. Select a Timed Dry heated cycle, and restart the dryer. If the problem continues, call an electrician. Select... -
My dryer or load has an odor
... load to avoid odors. The odor will result in the washer or dryer? My dryer or load has an odor Have you recently been painting, staining or ...Dryer Is the dryer being used for a long time will begin to grow mildew, which will be gone after the first cycle. Was a damp or wet load left in the washer or dryer for the first time? (Electric dryers) A new electric heating element...
Similar Questions
What Is The Capacity Of Maytag Centennial Electric Dryer Model No. Medc400vw0?
(Posted by rhalliburton1 9 years ago)
How To Put On Replacement Belt On Maytag Dryer Mde2400ayw
(Posted by herh 10 years ago)
How Do I Remove The Heating Element In My Maytag Centennial Electric Dryer
(Posted by bobisciub 10 years ago)
How To Replace Drive Belt On Maytag Dryer Mde2400ayw
(Posted by plantna 10 years ago)
Maytag Electric Dryer 2400ayw Heating Element
does my dryer need a new heating element/ repairman say its ony heating to 75 percent and it will co...
does my dryer need a new heating element/ repairman say its ony heating to 75 percent and it will co...
(Posted by mbolante 13 years ago)