Maytag MAH2400AWW Support Question
Maytag MAH2400AWW Support Question
Find answers below for this question about Maytag MAH2400AWW - 2.4 cu. Ft. Compact Front Load Washer.Need a Maytag MAH2400AWW manual? We have 3 online manuals for this item!
Question posted by piBr on July 18th, 2014
I Have A Maytag Washer Mah2400aww, I Can Not Remove Child Lock, What To Do?,
thanks
Current Answers
Related Maytag MAH2400AWW Manual Pages
Owners Manual - Page 1
...maytag.com
©2006 Maytag Appliances Sales Co. MAH-24
Use & Care Guide
Table of Contents
Important Safety Instructions 1-2
Operating Instructions 3
Load the Clothes Washer Start the Washer Water Use
Using the Controls 4-6
Turn the Washer...9-10
Cleaning the Interior Cleaning the Automatic Dispenser Storing the Washer
Troubleshooting 11-13
Information Codes
Operating Sounds 14
Service & ...
Owners Manual - Page 2
...maytag.com
U.S. To avoid the possibility of these substances. Customers using a In our continuing effort to improve the quality and performance of our appliances, it may be placed in the clothes washer..., denatured alcohol, gasoline, kerosene, some liquid household cleaners, some spot removers, turpentine, waxes and wax removers.
• Do not add gasoline, dry-cleaning solvents, or other...
Owners Manual - Page 3
...as vinegar or rust remover) in following loads and cause skin irritation.
16. Do not allow children to the remaining oil, the fabric may contain some oil after laundering. Store laundry aids and other ...12. Hazardous fumes can stick to service your clothes washer.
8. Inlet hoses are soiled with controls.
11. Close supervision of the clothes washer.
18. Due to play on or in published ...
Owners Manual - Page 4
...wrinkling of the cycle.
Operating Instructions
IMPORTANT • Before washing clothes for the Door Lock light to go out and "End" will appear in the display after one to two...must be run .
DO NOT overload. 3. This will illuminate. 8. Load the washer loosely - Close the door. 4. The Wash indicator light will remove any pad or turn the cycle selector dial. 2. Press any water ...
Owners Manual - Page 5
...
Press any pad or turn the cNoytcelse selector knob to turn the washer off . Note • To minimize wrinkling of loads, select the Wrinkle Control cycle.
4 Press the Power Off pad to turn the washer on for your load.
For best results, use liquid detergent. For "wash and wear" and synthetic fabrics and lightly...
Owners Manual - Page 6
....
High -
Press the pad repeatedly to the spin speed will be warm. The other rinses will be appropriate for the load. Use for cleaning lightly soiled loads.
5 washable woolens
IMPORTANT • The washer features an automatic temperature
control (ATC) to scroll through the temperature settings. The light next to scroll through the spin...
Owners Manual - Page 7
... selected: 1. Set the desired options for your load.
2. Press the Start/Pause pad. 2.
Turn...Child Lock light will illuminate progressively to indicate when the washer is in the display.
3. Canceling a Cycle
To cancel a cycle: 1.
Using the Controls Controlst aa glance
STEP 6 Dryer Exhaust tips
Select Cycle Options
Press the pads to select onNeotoesr more thoroughly remove laundry...
Owners Manual - Page 8
... University Extension office in your area. Features Special Fteuares
Your Maytag washer is designed to pay close attentiondtioshtwhaeshseorilusleevel of the control panel.
2. When less sudsopaerraetnipgrotdipusced, the load tumbles more efficiently and cleaning results are added to be in the same form; All laundry additives are maximized.
• When using regular detergent formulated...
Owners Manual - Page 10
... and two cups warm water.
Cabinet - Fill bleach dispenser with soap and water. Repeat the wash cycle if necessary.
The frequency with which the washer should be removed, if needed. clean with bleach solution and a soft cloth. Be careful not to follow these instructions may remain in unsatisfactory conditions, including unpleasant odor...
Owners Manual - Page 11
... Storing the Clothes Washer
Washers can & canneot b
washed
Cleaning the Automatic operatnig tips
Dispenser and Compartment
The Automatic Dispenser may need to be damaged if water is not removed from the fabric ...tumbler.
• If the washer has been stored in below-freezing temperatures, allow time for any load in the washer to thaw out prior to laundry additive buildup.
1.
Press the ...
Owners Manual - Page 12
.... Water temperature control problem.
If problem continues, call Maytag Customer Service at 1-800-688-9900 USA or 1-800-688-2002 Canada.
11
The washer is not draining. Call for service, see below ...., call for service, see below . The washer failed to lock the door. See Troubleshooting "The washer does not drain and/or spin", page 13. The washer has tried to fill but has not reached the...
Owners Manual - Page 13
....
• Make sure the laundry load is not activated, see page 6. Contr•olMst aaakeglsanucree the washer is plugged in the automatic dispenser after the wash cycle is complete
• Make sure the washer is running with sufficient water pressure. See Installation Instructions.
• Make sure that the shipping bolts are removed. Stops
• Plug...
Owners Manual - Page 14
...
Eliminate kinked hoses. For further assistance, call Maytag Customer Service toll-free at end of the water. ... Make sure hoses are selected.
The washer does not drain and/or spin
Load is too small. If there is ...Load is too wet at 1-800-688-9900 USA or 1-800-688-2002 Canada. customers using TTY for deaf, hearing impaired or speech impaired, call for the door lock...
Owners Manual - Page 15
... speed to spin the tub to remove moisture from the dispenser area.
• Detergent is hitting the outer tub before draining out of -balance load.
• The tumbler will begin... spin speed slightly for a while.
• The Maytag Neptune® clothes washer uses a true adaptive fill and adds more evenly when an unbalanced load occurs. Whirring or sloshing sound followed by a pause,...
Owners Manual - Page 16
...incidental damages, so the above exclusion may also have been removed, altered,
The above are void if the original serial ... ALLOWED BY LAW. customers using TTY for product service in loading normal home use will be used. Proof of Canada unless... to
ducting must be repaired or replaced free of charge. MAYTAG CORPORATION SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES.
...
Installation Instructions - Page 2
... electrical requirements.
READ THIS BEFORE YOU START... Tools needed for installation:
• Multi wrench • Utility knife • Channel lock • Level
PARTS supplied for installation: Cable tie to secure drain hose to standpipe, inlet hose or laundry tub
ELECTRICAL
Refer to section on Electrical Requirements. Width D. With Washer Door Open 90° E.
Installation Instructions - Page 5
... immediately.
5 If the washing machine was damaged during shipping or you have all of the items, contact your washer requires replacement parts or accessories, contact Maytag Customer Service, toll-free 1-888-4-Maytag for operation on page 2. This model is not designed for shipping damage and have you do not have received all of...
Installation Instructions - Page 6
... THE WASHING MACHINE
Selecting a location
Before you must remove the five shipping bolts from sources of heat such ... the washer. Fill the holes with the supplied wrench before removing them.
2.
Slide the bolt and spacer up and remove the bolt... Carefully Before Installing The Washing Machine. STEP 1
PREPARE WASHER
Removing The Shipping Bolts
Before using the washing machine, you ...
Installation Instructions - Page 7
...lock nuts up to 10 feet.
4. Standpipe must be at least 18", the drain hose must be conveniently elevated to avoid collapsing or damaging the drain hose.
For best performance the drain hose should be restricted in excess of the washer.
Slide washer...top. STEP 3
INSTALL THE WASHER
(NOTE: Under the counter installation do not require removal of the washer.
7 Plug power cord ...
Installation Instructions - Page 8
... leg lock nuts tightened up or down to be stored, after use, where it 's final location. Gently lift up against the bottom of the washer and slide back into drain facility and is turned on all temperature selections. With the washer in respect to prevent excessive vibration. o Shipping bolts and spacers have been removed...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Lint is on the load - Top-load HE washer with Dispensers in Corners
...-load washer Why is HE High Efficiency detergent the only type of a dryer removes lint from lint takers (corduroys, synthetics, permanent press). Cycles such as Super Wash use enough detergent? Did you using HE High Efficiency detergent? Is your laundered items when line drying. Sort lint-producing fabrics (towels, chenille) from the laundry load... -
Lint is on the load - Top-load washer
... you washing new clothing or linen items? FAQs Knowledgebase search tips Detergent is on the load - Was the laundry sorted? Sort lint-producing fabrics (towels, chenille) from the laundry load. Always check all pockets and the interior of the washer before laundering. Cycles such as low-twist terry cloth towels, will produce more lint... -
Lint is on the load - Top-load HE washer with Dispenser Drawer - video
... detergent manufacturer's directions. Regular detergent creates too many suds for sturdy fabrics. Always check all pockets and the interior of the washer prior to starting a new load of a dryer removes lint from the laundry load. The lint may appear as low-twist terry cloth towels, will produce more lint in pockets? Cycles such as...
Similar Questions
Maytag Washer, Mah2400aww 45 Second Timer.
Have a Maytag MAH2400AWW top loading washer and had the all too ofter problem with coins obstructing...
Have a Maytag MAH2400AWW top loading washer and had the all too ofter problem with coins obstructing...
(Posted by kkdman2 10 years ago)
Maytag Washer Mah2400aww Alarm Sounds And Door Lock Flashes
Push the power button and then the start button the alarm goes off and the dl flashes. What is wrong...
Push the power button and then the start button the alarm goes off and the dl flashes. What is wrong...
(Posted by cathibohannon 10 years ago)
Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer
Is there any recall info for Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer?
Is there any recall info for Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer?
(Posted by hhppjj 10 years ago)
Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer.
The washer makes extremely loud noise during spinning. Do you know what's going on?
The washer makes extremely loud noise during spinning. Do you know what's going on?
(Posted by hhppjj 10 years ago)
Maytag Washer Mah2400aww
this washer starts vibrate like crazy with a load it look like nothing is preventing it from shaking...
this washer starts vibrate like crazy with a load it look like nothing is preventing it from shaking...
(Posted by cleveru 11 years ago)