1998 Lincoln Navigator Support Question
Find answers below for this question about 1998 Lincoln Navigator.Need a 1998 Lincoln Navigator manual? We have 3 online manuals for this item!
Question posted by jblacc on March 29th, 2014
Why Arent The Turn Signals Working At All?
they do not flash or light up at all, tried the regular fuses they are all good.
Current Answers
There are currently no answers that have been posted for this question.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Be the first to post an answer! Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.
Related Manual Pages
Owner's Manual - Page 4
Instrumentation
Turn signal and wiper/washer control (pg. 33)
Instrument cluster (pg. 6)
Gearshift (includes overdrive button) (pg. 40)
Headlamp control (pg. 18)
LOW FUEL
F H
DOOR AJAR BRAKE
40 ...
Owner's Manual - Page 7
... good quality fuel and/or properly installing and securely tightening the gas cap. Under engine misfire conditions, excessive exhaust temperatures could damage your Check Engine light to flash ...or remains on solid: This means that the OBD II system has detected a malfunction. Examples are: 1. Instrumentation
What you should do if the check engine light illuminates Light turns ...
Owner's Manual - Page 8
... remind you to illuminate, have the system serviced immediately. If the light remains on . Anti-lock brake system (ABS) Momentarily illuminates when the ignition is turned on continuously or flash faster, check for a burned-out turn signal or the hazard lights are turned on , continues to flash or fails to fasten your safety belts. If one or both...
Owner's Manual - Page 9
...light fails to illuminate, continues to flash or remains on . Refer to THEFT Anti-theft system in the Controls and features chapter. The light also illuminates when the battery is turned to
9 Oil pressure/Engine coolant This light...off. Charging system Momentarily illuminates when the ignition is turned ON and the engine is low The light serves as a notice that a system needs your ...
Owner's Manual - Page 33
... are winding, slippery, or unpaved.
Vehicle speed cannot be controlled until the vehicle is traveling at or above 48 km/h (30 mph). Controls and features
TURN SIGNAL CONTROL • Push down to activate the left turn signal. • Push up to activate the right turn speed control on • Press ON. SPEED CONTROL To...
Owner's Manual - Page 46
...you will be operating the garage door or gate. A garage door which cannot detect an object, signaling the door to ensure a bright clear view when backing up to prevent potential harm or damage....mirror. When the mirror detects bright light from the normal state to minimize glare. Do not clean the housing or glass of most current transmitters to turn the mirror on this includes any ...
Owner's Manual - Page 47
...transmitting after repeated attempts, refer to flash slowly and then rapidly. Release both controls. 2. Do not release the controls until the red light begins to Training a rolling code which... keeping the red light in view. 3. Controls and features
Programming 1. Prepare for programming the HomeLink Universal Transmitter by erasing all three of the new frequency signal. 5. If you...
Owner's Manual - Page 48
... hold the control on the garage door opener receiver until the training light (next to the control) begins to flash (1-2 seconds). 48 Controls and features
If you are "code protected")... manufactured after 1995.
Locate the training control on the transmitter (the red light will illuminate, indicating the signal is difficulty locating the training control. 2. Refer to the garage door opener...
Owner's Manual - Page 49
... erase all three programmed channels: 1. Hold down the two outside controls until the training light on the garage door receiver turns solid (1-2 seconds). Release both controls. Refer to the receiver. Controls and features
3. If...control in the vehicle until the red light begins to turn off the training light. 4. Press the HomeLink control again. Release the HomeLink control and repress to...
Owner's Manual - Page 57
... the ignition in the OFF position. If successful, the THEFT indicator light will also be caused by any of turning ignition off, insert the new coded key into the ignition within five... seconds to unlock the driver door. Repeat procedure for two seconds. The interior lamps and running boards will flash. ...
Owner's Manual - Page 77
... they work properly and are no nicks, wears or cuts.
The driver's safety belt is buckled while the indicator light is illuminated and the warning chime is sounding...The safety belt warning light and The...safety belts to make sure they do not need to ON... is turned to ON...Then...The safety belt warning light illuminates for one to two minutes and the warning chime sounds for four...
Owner's Manual - Page 81
...or more of the following: • The readiness light will either flash or stay lit. • The readiness light will not illuminate immediately after ignition is turned on. • A series of a collision.
... bag is not required. Determining if the system is operational The SRS uses a readiness light in the instrument cluster or a tone to the Air bag readiness section in the Instrumentation...
Owner's Manual - Page 90
... light fails to 5 (START) without pressing the accelerator pedal and release as soon as the engine starts. Turn ...the key to illuminate, have the vehicle serviced. • If the driver's safety belt is below -12°C (10°F), depress the accelerator and start the engine while holding the accelerator down. If the engine does not start within five seconds, wait ten seconds and try...
Owner's Manual - Page 98
...Fuses and relays in each gear. Do not drive your vehicle. Press lightly on the accelerator in the Roadside emergencies chapter. Driving
TRANSMISSION OPERATION Automatic transmission operation
Brake-shift interlock This vehicle is equipped with a brake-shift interlock feature that the brakelamps are working... If you and downward to OFF. Turn off the ignition whenever you leave your ...
Owner's Manual - Page 119
..., Right Power/Heated Signal Mirror 18 5A Main Light Switch, Generic Electronic Module (GEM), Instrument Illumination, (Power supplied through Main Light Switch), Park Lamp Relay, Trailer Electronic Brake Control, Trailer Tow Running Lamp Relay, Left Side Marker Lamps, Right Side Marker Lamps, Left Front Park/Turn Lamp, Right Front Park/Turn Lamp, Left Stop/Park...
Owner's Manual - Page 160
... care
EXTERIOR BULBS Replacing exterior bulbs Check the operation of the following lamps frequently: • headlamps • foglamps • high-mount brakelamp • brakelamps • turn signals • license plate lamp • tail lamps • back-up . 4. Replacing headlamp bulbs Handle a halogen headlamp bulb carefully and keep out of children's reach...
Owner's Manual - Page 162
... and care
8. Rotate the bulb socket counterclockwise about ¼ turn signal bulbs 1. Make sure the headlamp control is in the plastic ...When the grooves in the OFF position. 2. Without turning, carefully pull out the bulb.
162 Insert the glass end of the socket. 10. Replacing parking lamp/turn and remove. 7. Without turning, carefully pull the bulb assembly out of the headlamp...
Owner's Manual - Page 163
... Maintenance and care
8. Disconnect the electrical connector from the back of the foglamp assembly (the accompanying artwork represents the rear side of the parking lamp/turn signal assembly, follow the removal procedures in the plastic base are aligned, push the bulb into the socket until the plastic base contacts the rear of...
Owner's Manual - Page 183
... instrument panel ...114 power distribution box ...117,122 Fuses ...113,114,121 Gauges, Mechanical ...12 engine coolant temperature gauge ...13 Hazard flashers ...112 Head restraints ...62,65 Headlamps autolamp system ...19 flashing ...40 high beam ...40 turning on and off ...18 Heating ...21 High beams indicator light ...9 Hood release lever ...134 Ignition positions of...
Owner's Manual - Page 184
...assembly ...76 for children ...82 lap and shoulder belts ...72 maintenance ...77 proper use ...71 warning light and chime ...11,76,77 Safety seats for children attaching with tether straps ...87 automatic locking mode... adding (automatic) ...145 Trip odometer ...14 Turn signal lever ...33 Universal transmitter ...46 erasing channels ...49 operating ...48 programming ...47 Vehicle dimensions ...178
Similar Questions
Where Is The Turn Signal Flasher Location 1999 Lincoln Navigator
(Posted by samntimaz 10 years ago)
How To Turn Off The Lights In A 1998 Navigator When The Doors Are Open
(Posted by hbakcharli 10 years ago)
Rear Latch Door Switch Broken Will That Cause Air Suspension Not To Work On
2002 lincoln navigator
2002 lincoln navigator
(Posted by pantsatya 10 years ago)
Why Wont The Instrument Cluster Work On My 1998 Lincoln Navigator
(Posted by bboffwebsh 10 years ago)
Turn Signal Difficulties
what is the location of my turn signal relay/flasher on my 2000 lincoln navigator? What does it look...
what is the location of my turn signal relay/flasher on my 2000 lincoln navigator? What does it look...
(Posted by dougbrownkcmo 12 years ago)