LiftMaster 3585 Support Question
LiftMaster 3585 Support Question
Find answers below for this question about LiftMaster 3585.Need a LiftMaster 3585 manual? We have 1 online manual for this item!
Question posted by Testermanbus on March 24th, 2013
What Remote Goes With Model Mj5011
The person who posted this question about this LiftMaster product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related LiftMaster 3585 Manual Pages
3585 Elite Series Manual - Page 1
®
GARAGE DOOR OPENER Model 3585 3/4 HP
For Residential Use Only
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196
www.liftmaster.com
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■ The door WILL NOT CLOSE unless the Protector System®...
3585 Elite Series Manual - Page 2
... system 25
Test the Protector System 25
Operation
26-31
Operation safety instructions 26
Using your garage door opener 26
Using the wall-mounted door control 27
Using the remote control 28
To open the door manually 29
Care of your opener 29
Having a problem 30
Diagnostic chart 31
Smart Control PanelTM messages 32
Programming
33-34
To...
3585 Elite Series Manual - Page 3
... and adjustment of balance, call for hand tools as shown. To prevent damage to garage door and opener:
• ALWAYS disable locks BEFORE installing and operating the opener.
• ONLY operate garage door opener at 120V, 60 Hz to avoid entanglement. Lift the door about halfway as illustrated below. If balanced, it should stay in place, supported entirely...
3585 Elite Series Manual - Page 5
...Remote Control Model 373P (1)
Remote Control TVrisaonrsmCliitpter Visor Clip
Belt
Belt Cap Retainer Styrofoam
2-Conductor Bell Wire White & White/Red
Motor Unit w/Light Lenses
Belt Pulley Bracket
Trolley
One-Piece Rail
CEILING MOUNT ONLY UP
Header Bracket
Door Bracket
Curved Door... will depend on the model purchased.
Carton Inventory
Your garage door opener is packaged in the ...
3585 Elite Series Manual - Page 6
... and brace it firmly against the trolley (Figure 2).
• Place a 7/16" open end wrench on the threaded shaft until it is finger tight against the trolley (Figure... STEP 1
Attach the Rail to the Motor Unit
To avoid installation difficulties, do not run the garage door opener until instructed to do so.
• Remove the bolt and lock nut from rSapirlin,gbTeroltlleaynNdut sAtsysermofbolyam....
3585 Elite Series Manual - Page 7
... system.
Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing opener to cables, spring assemblies and other
(1.5 m). Place entrapment warning label on properly balanced and
garage door or opener mechanisms.
lubricated garage door.
installing or servicing opener.
Install garage door opener 7 feet (2.13 m) or more above floor.
• away from...
3585 Elite Series Manual - Page 11
.... You will need help
at this point. To prevent damage to garage door, rest garage door opener rail on 2x4 placed on the trolley release arm to -rail distance.
• Remove foam packaging.
• Raise the opener onto a stepladder.
ENGAGED
Trolley Release Arm
RELEASED
ONE-PIECE DOOR WITHOUT TRACK
A 2x4 on its side on its side is...
3585 Elite Series Manual - Page 12
.... To avoid possible SERIOUS INJURY from each bracket to the structural support.
2. Concrete anchors MUST be different. Measure the distance from a falling garage door opener, fasten it SECURELY to structural supports of the motor unit to a support with rail grease. Hanging brackets should be angled (Figure 1) to the hanging brackets ...
3585 Elite Series Manual - Page 13
...remote control transmitters. • Activate door ONLY when it can be mounted to red (Figure 2).
DO NOT connect power and operate the opener at this time.The trolley will not return to secure wire in place.
3. (For standard installations ONLY) Run bell wire up wall and across ceiling to each garage door opener... drill 5/32" holes and use model 378LM wireless wall control as in ...
3585 Elite Series Manual - Page 14
... tabs on both sides of all vehicles to close the lens.
• Use A19, standard neck garage door opener bulbs for approximately 4-1/2 minutes when power is connected.
Secure with an overhand knot at least 1" (2.5 cm) from a falling garage door: • If possible, use A19 size bulbs. If rope knot becomes untied, you could result in...
3585 Elite Series Manual - Page 15
...removing cover to the screw on the brass terminal; Be sure the opener is required by your garage door opener has a grounding type plug with a third grounding pin. RIGHT
... To make it fit outlet. the white (neutral) wire to establish permanent wiring connection.
• Garage door installation and wiring MUST be grounded.
• Reinstall the cover.
This plug will only fit into ...
3585 Elite Series Manual - Page 16
... will flash 10 times. The invisible light beam path must be connected and aligned correctly before the garage door opener will detect an obstacle in masonry if repositioning is not connected to mount the units on the wall, the brackets must be installed on the ...
3585 Elite Series Manual - Page 25
... springs and hardware). • Any repair to or buckling of the opener. The garage door opener will flash.
The door must reverse on the floor.
1-1/2" (3.8 cm) board (or a 2x4 laid flat)
ADJUSTMENT STEP 4
Test The Protector System®
• Press the remote control push button to open , place a 1-1/2" (3.8 cm) board
(or a 2x4 laid flat) on the obstruction...
3585 Elite Series Manual - Page 26
... on, then press and hold the light button for 10 seconds until the light goes on contact with up to garage door opener BEFORE making any of which changes with garage door control push buttons or remote controls.
3. When the opener is activated (with the Door Control, the Outside Keylock, or Keyless Entry, if you could result in SEVERE...
3585 Elite Series Manual - Page 30
... refer to Diagnostic Chart on the following the programming instructions. Refer to the Diagnostic Chart on the following page. My remotes will not turn off when door is open:
• The garage door opener is not blinking. My door reverses for flashes on when the safety sensor beam has been obstructed. My lights will not activate the...
3585 Elite Series Manual - Page 31
..., motor unit is overheated. Consult Diagnostic Chart below.
1 FLASH
Safety reversing sensors wire open (broken or disconnected). Symptom: Sending indicator light glows steadily, receiving indicator light is dim...
Sensor
Your garage door opener is programmed with jumper wire. If motor unit activates,
replace door control. • If motor unit does not activate, disconnect door control wires ...
3585 Elite Series Manual - Page 33
... code. Press the button on the motor unit. Reprogram each remote or keyless entry you wish to operate your garage door.
4. Additional buttons on motor unit until the learn indicator light goes out (approximately 6 seconds). The door will open and close when you wish to operate your garage door.
3. Press and release the "learn indicator light will be...
3585 Elite Series Manual - Page 34
... temporary PIN: 1.
Press and release the "learn indicator light will glow steadily for your garage door opener. The learn " button on the Smart Control PanelTM.
2. Press the PROG button again ...of hours or times to 0 in step 3.
It has learned the code. The opener light will blink three times. The door should move . Then press enter. To set a temporary PIN You may be ...
3585 Elite Series Manual - Page 37
... signals while you if your home!
Tells you are away from home and turn on a lamp, television or other appliance from their car with their garage door opener remote or from the door control.
975LM
Laser Park Assist:
Laser enables homeowners to precisely park vehicles in their home with NO access...
3585 Elite Series Manual - Page 40
...LIFTMASTER® GARAGE DOOR OPENER FIVE-YEAR ...MODEL NUMBER
ADDRESS ORDERS TO: THE CHAMBERLAIN GROUP, INC. Technical Support Group 6050 S.
Then send this product is free from defect in the Yellow Pages, or call . THIS LIMITED WARRANTY DOES NOT COVER ANY PROBLEMS WITH, OR RELATING TO, THE GARAGE DOOR OR GARAGE DOOR HARDWARE, INCLUDING BUT NOT LIMITED TO THE DOOR SPRINGS, DOOR ROLLERS, DOOR...
Similar Questions
Where Is The Reset Button On Liftmaster Model 3265 Garage Door Opener
(Posted by cjaxlme 9 years ago)
How To Program Remote For Chamberlain Sl3000ul Garage Door Opener
(Posted by mhoPool 10 years ago)
Liftmaster Elite Garage Door Opener Manual
i have a 3585s opener. always workusing inside control. it has been failing to open at times useing ...
i have a 3585s opener. always workusing inside control. it has been failing to open at times useing ...
(Posted by lgwinnjr 10 years ago)
Programming My Car To Garage Door Opener
I am unable to program garage door to 2012 Acura, is my system to old.
I am unable to program garage door to 2012 Acura, is my system to old.
(Posted by Vherd84 11 years ago)