LiftMaster 3585 Support Question
LiftMaster 3585 Support Question
Find answers below for this question about LiftMaster 3585.Need a LiftMaster 3585 manual? We have 1 online manual for this item!
Question posted by brandon91208 on April 17th, 2012
Mega Arm Tower
The person who posted this question about this LiftMaster product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related LiftMaster 3585 Manual Pages
3585 Elite Series Manual - Page 1
®
GARAGE DOOR OPENER Model 3585 3/4 HP
For Residential Use Only
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196
www.liftmaster.com
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■ The door WILL NOT CLOSE unless the Protector System...
3585 Elite Series Manual - Page 2
...opener 12
Install the door control 13
Install the light 14
Attach the emergency release rope and handle . . . . . .14
Electrical requirements 15
Install the Protector System 16-18
Fasten the door bracket 19-20
Connect the door arm...
40
Warranty
40
INTRODUCTION
Safety Symbol and Signal Word Review
This garage door opener has been designed and tested to offer safe service provided it ...
3585 Elite Series Manual - Page 3
..., it should stay in place, supported entirely by its springs. 2. To prevent damage to garage door and opener:
• ALWAYS disable locks BEFORE installing and operating the opener.
• ONLY operate garage door opener at 120V, 60 Hz to loosen, move or adjust garage door, door springs, cables, pulleys, brackets or their hardware, all of balance, call for hand tools...
3585 Elite Series Manual - Page 5
...the foam. Carton Inventory
Your garage door opener is missing, carefully check the packing material.
LOCK
LIGHT
SmLCarDt CMoontitoronl DPeatneecltTMing Door Control Console
SECURITY✚® ...Belt Pulley Bracket
Trolley
One-Piece Rail
CEILING MOUNT ONLY UP
Header Bracket
Door Bracket
Curved Door Arm Section
Safety Sensor Bracket (2)
The Protector System® (2) Safety Reversing ...
3585 Elite Series Manual - Page 6
... turn until it firmly against the trolley (Figure 2).
• Place a 7/16" open end wrench on the square end. This extends the spring for optimum belt tension. Figure... STEP 1
Attach the Rail to the Motor Unit
To avoid installation difficulties, do not run the garage door opener until instructed to do so.
• Remove the bolt and lock nut from rSapirlin,gbTeroltlleaynNdut sAtsysermofbolyam...
3585 Elite Series Manual - Page 7
HARDWARE SHOWN ACTUAL SIZE
To avoid possible SERIOUS INJURY to garage door control.
11. installing or servicing opener. Install garage door opener only on inside of the door.
10. An improperly balanced door may
9. Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing opener to do so.
7 Place manual release/safety reverse test label in plain view on...
3585 Elite Series Manual - Page 11
... completed. Slide the outer trolley toward the motor unit. To prevent damage to garage door, rest garage door opener rail on 2x4 placed on its side on the trolley release arm to determine the correct mounting height from ceiling.
11
Do not position the opener more than 4" (10 cm) above this point if the ladder is not...
3585 Elite Series Manual - Page 12
... may be used if installing any brackets into masonry. Measure the distance from a falling garage door opener, fasten it SECURELY to a support with rail grease.
This bracket and fastening hardware are shown. Grease the top and underside of the garage. To avoid possible SERIOUS INJURY from each bracket to structural supports of the rail...
3585 Elite Series Manual - Page 13
... height of 5' (1.5 m) where small children cannot reach, away from moving parts of door. • NEVER permit children to operate or play with door control push buttons or remote control transmitters. • Activate door ONLY when it can be connected to each garage door opener.
Adjust screw for snug fit.
• Drill and install top screw with...
3585 Elite Series Manual - Page 14
... or lighter to close the lens.
• Use A19, standard neck garage door opener bulbs for approximately 4-1/2 minutes when power is CLOSED. If rope knot becomes untied, you could result in the top of the rope through the hole in the release arm of the outer trolley.
• Adjust rope length so the handle...
3585 Elite Series Manual - Page 15
... silver terminal; To make it fit outlet. INSTALLATION STEP 9
Electrical Requirements
To avoid installation difficulties, do not run the opener at this time. RIGHT
WRONG
If permanent wiring is required by your garage door opener has a grounding type plug with all local electrical and building codes.
• NEVER use an extension cord, 2-wire adapter...
3585 Elite Series Manual - Page 16
...eye (with an amber indicator light) transmits an invisible light beam to the garage door opener BEFORE installing the safety reversing sensor. INSTALLATION STEP 10
Install The Protector System®...;
The safety reversing sensor must be connected and aligned correctly before the garage door opener will flash 10 times. IMPORTANT INFORMATION ABOUT THE SAFETY REVERSING SENSOR
When properly ...
3585 Elite Series Manual - Page 25
... force the door arm beyond a straight up and down direction.
Without a properly installed safety reversal system, persons (particularly small children) could be tested. If the opener closes the door when the safety reversing sensor is obstructed (and the sensors are made, the safety reversal system
MUST be SERIOUSLY INJURED or KILLED by a closing garage door. ADJUST...
3585 Elite Series Manual - Page 26
... this feature may be tested.
11. NEVER permit children to disengage trolley ONLY when garage door is broken. If rope knot becomes untied, you could result in an open door falling rapidly and/or unexpectedly.
7. SAVE THESE INSTRUCTIONS. Activate your garage door opener, it must be made , the safety reversal system MUST be turned off as follows...
3585 Elite Series Manual - Page 30
... hums briefly: • First verify that the trolley is against the stop . Refer to Programming.
• If remote will not turn off when door is open:
• The garage door opener is normal.
If it is normal. The need for occasional adjustment for the force and limit settings is blinking, deactivate the Lock Mode following...
3585 Elite Series Manual - Page 31
...Reversing Sensor
"Learn" Button LED or Diagnostic
LED
Diagnostic Chart
Installed Safety Reversing
Sensor
Your garage door opener is programmed with jumper wire. The "Learn" button/diagnostic LED will not operate replace ...FLASHES
Safety reversing sensors wire shorted or black/white wire reversed.
3 FLASHES
Door control or wire shorted.
4 FLASHES
Safety reversing sensors slightly misaligned (dim...
3585 Elite Series Manual - Page 33
...again to operate your garage door.
4. If light bulbs are now erased. Your garage door opener has already been programmed at the factory to operate with your garage door opener, the large button is operated with a non-rolling code transmitter, the technical measure in the garage door opener does not authorize the purchaser or supplier of the garage door opener, which provides security against...
3585 Elite Series Manual - Page 34
...button when the motor unit lights blink. Press the four buttons for your garage door opener. The motor unit lights will blink three times. Test by pressing only the ENTER button if...the present PIN, then press
and hold the # button. LOCK
LIGHT
4. The keypad will no longer open the door. To set the number of hours this temporary PIN will work , press the number of your choice ...
3585 Elite Series Manual - Page 37
...CLOSED
by entering a password on a lamp, television or other appliance from their car with their garage door opener remote or from anywhere in the garage.
990LM
Surge Protector:
The Garage Door Opener Surge Protector is open garage door manually from outside by disengaging trolley.
373W
Extension Brackets:
(Optional) For safety sensor installation onto the wall or floor.
370LM
Designer...
3585 Elite Series Manual - Page 40
... IMPLIED WARRANTIES WILL EXIST OR APPLY AFTER SUCH PERIOD. Country Club Road
Tucson, Arizona 85706
SERVICE INFORMATION TOLL FREE NUMBER:
1-800-528-9131
LIFTMASTER® GARAGE DOOR OPENER FIVE-YEAR LIMITED WARRANTY
LIFETIME MOTOR AND BELT LIMITED WARRANTY
The Chamberlain Group, Inc. ("Seller") warrants to you .
ANY SERVICE CALL THAT DETERMINES THE PROBLEM...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 8 months ago)
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
Liftmaster Elite Garage Door Opener Manual
i have a 3585s opener. always workusing inside control. it has been failing to open at times useing ...
i have a 3585s opener. always workusing inside control. it has been failing to open at times useing ...
(Posted by lgwinnjr 10 years ago)
Programming My Car To Garage Door Opener
I am unable to program garage door to 2012 Acura, is my system to old.
I am unable to program garage door to 2012 Acura, is my system to old.
(Posted by Vherd84 11 years ago)