LiftMaster 3585 Support Question
LiftMaster 3585 Support Question
Find answers below for this question about LiftMaster 3585.Need a LiftMaster 3585 manual? We have 1 online manual for this item!
Question posted by richards350z on November 26th, 2011
Cost.
What is the price of the 3585 Liftmaster garage door opener?
Current Answers
Related LiftMaster 3585 Manual Pages
3585 Elite Series Manual - Page 1
®
GARAGE DOOR OPENER Model 3585 3/4 HP
For Residential Use Only
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196
www.liftmaster.com
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■ The door WILL NOT CLOSE unless the Protector System®...
3585 Elite Series Manual - Page 2
...
Test the Protector System 25
Operation
26-31
Operation safety instructions 26
Using your garage door opener 26
Using the wall-mounted door control 27
Using the remote control 28
To open the door manually 29
Care of your garage door and/or the garage door opener if you do not comply with the instructions and warnings contained in strict accordance...
3585 Elite Series Manual - Page 3
... technician.
If balanced, it should stay in place, supported entirely by its springs. 2. To prevent damage to garage door and opener:
• ALWAYS disable locks BEFORE installing and operating the opener.
• ONLY operate garage door opener at 120V, 60 Hz to avoid entanglement. Carpenter's Level (optional)
12
Tape Measure
Pencil Wire Cutters
Drill
3/16", 5/16" and...
3585 Elite Series Manual - Page 4
...Door
Access Door
Wallmounted Door Control
Safety
Gap between floor and bottom of door
Reversing Sensor
must not exceed 1/4" (6 mm)
Reversing Sensor
ONE-PIECE DOOR...Door Control
Access Door
ONE-PIECE DOOR WITH TRACK
Safety Reversing Sensor
Gap between floor and bottom of
Safety
door must not exceed 1/4" (6 mm)
Reversing Sensor
4
Access Door...your garage door. Survey your garage area...
3585 Elite Series Manual - Page 5
... contain the motor unit and all parts illustrated below . Hardware for installation is also listed below . Carton Inventory
Your garage door opener is packaged in the foam.
LOCK
LIGHT
SmLCarDt CMoontitoronl DPeatneecltTMing Door Control Console
SECURITY✚® 3-Button Remote Control Model 373P (1)
Remote Control TVrisaonrsmCliitpter Visor Clip
Belt
Belt Cap Retainer Styrofoam...
3585 Elite Series Manual - Page 6
... Remember to do not run the garage door opener until the spring releases and snaps the nut ring against the trolley (Figure 3). This extends the spring for optimum belt tension.
Liftmaster Synchro Drive
• Cut tape ...and brace it is finger tight against the trolley (Figure 2).
• Place a 7/16" open end wrench on the motor unit and align the back hole with the hole in top of ...
3585 Elite Series Manual - Page 7
... on wall next to avoid entanglement.
5. Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing opener to garage door control.
11.
installing or servicing opener. Install garage door opener only on the floor.
7. An improperly balanced door may
9. Mount emergency release handle 6 feet (1.83 m) above floor.
6. Place entrapment warning label on inside...
3585 Elite Series Manual - Page 8
... track: jamb hardware
8
One-piece door without track. Open your garage, use lag screws (not provided) to securely fasten the 2x4 to page 9 for one -piece door with horizontal track
Header Wall 8" (20 cm)
Door
Highest Point of Travel
Header Wall 8" (20 cm)
Door
Highest Point of the door.
An unbalanced garage door might not reverse when required.
NOTE...
3585 Elite Series Manual - Page 10
.... • Align the bracket holes and join with a clevis pin
as a protective base. Garage Door
Header Bracket
Ring Fastener
Clevis Pin 5/16"x2-3/4"
Belt Pulley Bracket
Rail
Temporary Support
HARDWARE SHOWN ... the opener on a temporary support to allow the rail to secure. NOTE: If the door spring is in the way you'll need help. Have someone hold the opener securely on the garage floor ...
3585 Elite Series Manual - Page 11
... determine the correct mounting height from ceiling.
11 To prevent damage to your door type as illustrated.
INSTALLATION STEP 4
Position the Opener
Follow instructions which apply to garage door, rest garage door opener rail on 2x4 placed on top section of door. Do not position the opener more than 4" (10 cm) above this point if the ladder is not...
3585 Elite Series Manual - Page 12
... in line with 5/16"-18x1-7/8" lag screws.
5. Remove the 2x4. Measure the distance from a falling garage door opener, fasten it SECURELY to opener at this time.
INSTALLATION STEP 5
Hang the Opener
Three representative installations are not provided.
1. Operate the door manually. Yours may be used if installing any brackets into masonry. Attach one end of each...
3585 Elite Series Manual - Page 13
... insulated staples to avoid cracking plastic housing. NEVER permit anyone to use the anchors provided.
If additional wall controls are desired to operate the same garage door opener, it can be connected to temperatures below -22° F (-30° C) may be seen clearly, is properly adjusted, and there are no obstructions to the...
3585 Elite Series Manual - Page 14
.... Then the lights will turn OFF.
• Reverse the procedure to close the lens.
• Use A19, standard neck garage door opener bulbs for approximately 4-1/2 minutes when power is necessary to prevent unraveling.
If rope knot becomes untied, you could result in each socket.
Secure with a match ...
3585 Elite Series Manual - Page 15
... BEFORE removing cover to the green ground screw. the white (neutral) wire to the following procedure. RIGHT
WRONG
If permanent wiring is required by your garage door opener has a grounding type plug with all local electrical and building codes.
• NEVER use an extension cord, 2-wire adapter, or change plug in ANY way...
3585 Elite Series Manual - Page 16
...
Either can be installed on the wall, the brackets must be connected and aligned correctly before the garage door opener will move in masonry construction, add a piece of its electronic beam. Be sure power is closing garage door: • Correctly connect and align the safety reversing sensor. above floor
Invisible Light Beam Protection Area
Facing...
3585 Elite Series Manual - Page 17
... floor.
• Carefully measure and place right and left assemblies to the opener is disconnected. It should lie flush, with curved arms facing the door. Wall installation (Figure 2 & 3):
• Place the bracket against the side of three ways, as shown.
Garage door track installation (preferred):
• Slip the curved arms over the rounded edge...
3585 Elite Series Manual - Page 19
... across the top of the door, OR directly below or on wood doors.
The best solution is to your garage door manufacturer for an opener installation door reinforcement kit. Metal, insulated or light weight factory reinforced doors:
• Drill 3/16" fastening holes. Center the door bracket on your door manufacturer for direct attachment of door bracket. Position the top edge...
3585 Elite Series Manual - Page 21
... DOORS ONLY
Make sure garage door is horizontal. Slide the outer trolley back (away from the door) about 6" (15 cm) from the inner trolley. Figure 1:
• Fasten straight door arm section to your door ...the emergency release handle toward the opener at a 45° angle so that the trolley release arm is fully closed.
Proceed to increase door arm rigidity.
Figure 3, Hole alignment...
3585 Elite Series Manual - Page 23
... If the door does not open and close the door.
Cover Protection Bolt
2-4" (5-10 cm)
Left Side Panel
Limit Adjustment Screws
ADJUSTMENT LABEL
• If the door reverses when closing garage door.
•...: Pull the emergency release handle. If anything interferes with proper operation of garage door travel limits will reverse. See Adjustment Step 2.
23 ADJUSTMENT STEP 1
Adjust...
3585 Elite Series Manual - Page 40
... be shipped at prevailing prices and you will be ...6050 S. Failure to comply strictly with new or factory-rebuilt parts at no cost to you . Please include a brief description of the problem and a ...Tucson, Arizona 85706
SERVICE INFORMATION TOLL FREE NUMBER:
1-800-528-9131
LIFTMASTER® GARAGE DOOR OPENER FIVE-YEAR LIMITED WARRANTY
LIFETIME MOTOR AND BELT LIMITED WARRANTY
The Chamberlain Group...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 7 months ago)
How To Program New Car To Open Garage Door
where is the learn button to program my car to open garage door
where is the learn button to program my car to open garage door
(Posted by lrothberg 6 years ago)
How Much Does A Lift Master 3255 Garage Door Opener Cost
(Posted by cosin 9 years ago)
Liftmaster Elite Garage Door Opener Manual
i have a 3585s opener. always workusing inside control. it has been failing to open at times useing ...
i have a 3585s opener. always workusing inside control. it has been failing to open at times useing ...
(Posted by lgwinnjr 10 years ago)