Kenmore HE2t Support Question
Kenmore HE2t Support Question
Find answers below for this question about Kenmore HE2t - 3.7 cu. Ft. Front Load Washer.Need a Kenmore HE2t manual? We have 1 online manual for this item!
Question posted by kurlygirly81 on June 23rd, 2012
When My Machine Spins It Makes A Loud Clicking Noise Like A Loud Ratchet.
whats wrong?
Current Answers
Related Kenmore HE2t Manual Pages
User Guide - Page 8
... Weight (approx)
WFW8300SW
WFW8500SW
WFW8500SR
Front Load Washer
Front Load Washer
Front Load Washer
White with Gray Accents
White with Gray ...Model Number Model Description
Color
Capacity (Cu.Ft. IEC) Temperature Control
Heater Sensors
Tumble Speed
Spin Speed
Motor Voltage Frequency Amps Water Consumption Average DOE (Gallons-Per-Cycle) Rated Load Load Pounds
Height Install Depth: Min -...
User Guide - Page 10
...or surfaces with a maximum slope of where the power cord is your washer improves performance and minimizes noise and possible washer "walk." Washer Dimensions
50¹⁄4 " (127.6 cm)
27" (68.6 ...washer with a total weight (water and load) of installation and servicing. To order, call the dealer from whom you purchased your dryer or refer to stack your washer in a basement, laundry...
User Guide - Page 14
...washer.
3. Screw on coupling by hand until it is loose, move and install washer. INSTALLATION INSTRUCTIONS
REMOVE TRANSPORT SYSTEM
4. NOTE: If the washer is within approximately 3 ft...washer that the rear of the unit is to be transported at a later date, call your machine...2. Damage to the water faucets
Make sure the washer drum is seated on the washer.
1. Using pliers, tighten the...
User Guide - Page 15
... tighten the couplings with an additional two-thirds turn. Turn on the washer.
2. Bend drain hose over drain hose form and snap into a laundry tub, drainpipe or bucket, to get rid of particles in the water... it is connected to water leakage. ROUTE THE DRAIN HOSE
Proper routing of the water to make sure that the hot water hose is seated on the water faucets completely and check for future...
User Guide - Page 16
... prop the back and adjust feet as necessary; If the washer faucets and the drain standpipe are stable and resting on your washer will minimize excessive noise and vibration. 1. Confirm the levelness of the drain hose in the laundry tub or standpipe. LEVEL THE WASHER
One foot has been installed at the factory.
Then check...
User Guide - Page 19
... than with smaller amounts of water needed for a conventional washer. The motor can obtain the same washing results for the best performance.
ADD A GARMENT
This option is no agitator, you can obtain the same results with traditional top load machines.
For some cycles, the default spin speed can wash a pillow or a large stuffed teddy...
User Guide - Page 22
... Avoid washing a single item. Open the dispenser drawer and add laundry additives to select ON or OFF.
7. Select one garment bag...will illuminate. To load washer
Open the washer door by pulling on the washer by turning the cycle selector. Place a load of the tub for...;ers and Options, Water Temp, and Spin Speed for the selected cycle will be fully loaded, but not tightly packed. Select the ...
User Guide - Page 23
...laundry additives.
This wash system, along with a regular non-HE detergent. It may also result in the dispensers when the wash cycle is complete, the CYCLE COMPLETE status light illuminates, the door unlocks, and the wash load can be removed from the washer... making it unnecessary for the best performance.
Liquid chlorine bleach compartment D. The washer powers down the washer ...
User Guide - Page 24
...8226; Liquid detergent: Measure the amount of colorsafe bleach to your load.
• Always measure liquid chlorine bleach. Chlorine bleach compartment (Letter...temperature is not available, the machine will drain automatically before START is complete, the door unlocks. Select DRAIN/SPIN.
3. To change Options after the wash cycle. To drain the washer manually
1.
Select the desired ...
User Guide - Page 26
.../ Hand Wash Clean Washer Rinse/Spin Drain/Spin Soak
Estimated
Time* ...machine increasing the wash time. The preset settings provide the recommended fabric care for cleaning loads of no bleach is especially designed for the selected cycle. See chart.
It also includes Extra Rinse as socks.
3-8 It is unbalanced. This cycle combines medium-speed tumbling, high-speed spin, and a load...
User Guide - Page 27
... inside of your washing machine. Rinse/Spin
Use this cycle to drain your washer or to your wash load.
You can customize your wash by selecting the speed you will hear water spraying and splashing during the Clean Washer cycle. Not all options are available with all cycles.
• See the "Laundry Guide" section for delicate...
User Guide - Page 30
...rotate, then the door will unlock, lock again, and then the cycle will continue.
• The machine will not fill, but the basket will take approximately 3 minutes.
7. Pull back the seal/... of the seal/bellow, using a damp cloth. A RINSE/SPIN cycle must then be interrupted by pressing the PAUSE/CANCEL button.
Open the washer door and remove any detergent to start the cycle again.
...
User Guide - Page 31
... procedure does not sufficiently improve the machine freshness, please evaluate your washer. VACATION, STORAGE, & MOVING CARE
Install and store your washer where it . If storing or moving your ...you should:
• Unplug washer or disconnect power.
• Turn off both water faucets.
3-13 Flush water pipes.
2. Turn on a Drain/Spin cycle.
3. Do not use washer again:
1. Wash the ...
User Guide - Page 32
...and structural damage, your machine must be transported in death, fire, or electrical shock.
4.
Failure to rear panel clips.
4.
If washer will be properly set ... the washer
1. Use 1/2 the manufacturer's recommended amount for a medium sized load. Run washer on a Drain/Spin cycle.
2. Do not use an adapter. sual cycle. To transport the washer:
1. Run the washer through ...
User Guide - Page 33
...end of the machine removed? Do not use an extension cord. Do not use an adapter.
As water is excessive water in the washer.
Are water ...washer clogged? This happens during the washing, rinsing, or spinning process. TROUBLESHOOTING
WASHER & COMPONENTS
ERROR CODES
When all four pedestal feet must be in firm contact with the floor.
• Washer making a different noise...
User Guide - Page 36
...Make sure your garments. This routine will also affect the cycle times that are washing. Spin time is added if an unbalanced load is normal. RESIDUE, LINT, STAINS ON LOAD; Do not overload the washer... loads? For best performance, use small loads. This ensures a gentle wash for your wet laundry in this activity is designed for the fabric load. Dye transfer can reduce spin ...
User Guide - Page 80
... occurs during high-speed spin the door unlocks after 6 minutes. Unplug washer or disconnect power. 2....Reference Status LEDs chart, page 6-4
NO WATER DETECTED ENTERING MACHINE OR PRESSURE SWITCH TRIP NOT DETECTED. Replace the pump. Reference...and make sure it is water in the inlet valves. -
Unplug washer or disconnect power. 8. Unplug washer or disconnect power. 2. Unplug washer ...
User Guide - Page 81
....
Check the drain hose and make sure it is detected inside the...washer or disconnect power. 3. Unplug washer or disconnect power. 2. Check mechanical linkage from drum and start of the CLEANING WASHER cycle a load...to properly detect motor speed, the machine shuts down . Check wire harness ...opened during high-speed spin, the door unlocks after 3 minutes. Unplug washer or disconnect power....
User Guide - Page 82
... drain pump filter of the excess detergent.
1. Check the drain hose and make sure it will be drained and it is not plugged or kinked.
2. Plug in washer or reconnect power. 6. Run a NORMAL cycle without tumbling, the water will try to spin or drain again. Check the pressure switch. 8. They use the status...
User Guide - Page 89
... to confirm the touchpad/LED is responding.
4. If no click, replace CCU.
3. Unplug washer or disconnect power.
5. Check the wire harness connections.
6. Verify dispenser drawer is level. 2. Plug in washer or reconnect power. 6. Plug in washer or reconnect power. 8. Unplug washer or disconnect power. 4. Plug in washer or reconnect power. 7. Verify the unit is not clogged...
Similar Questions
Does Lg Make Kenmore Front Load Washers
(Posted by Jb02 10 years ago)
He2t Washer Is Loud When In Spin Cycle
(Posted by bbridcar 10 years ago)
Flashing Spin Light
The machines spin light is flashing with 9 minutes left on cycle and the door is locked. I push the ...
The machines spin light is flashing with 9 minutes left on cycle and the door is locked. I push the ...
(Posted by landbbarber 10 years ago)
Kenmore Oasis Top Loading Washer Making Ticking Sound And Displays Ld On Screen.
Removed the washer basket and cleaned out underneath. ran cleaning cycle (partiall). Do I need to re...
Removed the washer basket and cleaned out underneath. ran cleaning cycle (partiall). Do I need to re...
(Posted by jjacky 11 years ago)
Kenmore Washing Machine
Hi I have a kenmore washing machine model #110.22722101 it fills up and agitates but wont spin and d...
Hi I have a kenmore washing machine model #110.22722101 it fills up and agitates but wont spin and d...
(Posted by hunter22818 12 years ago)