Home » Jeep » Troubleshooting » 2007 Jeep Commander

2007 Jeep Commander Support Question

Find answers below for this question about 2007 Jeep Commander.
Need a 2007 Jeep Commander manual? We have 1 online manual for this item!

Jeep Overview Questions Manuals Reviews Videos Research

Question posted by drkarags on July 6th, 2014

Where Is The Skim Indicator Light In A 2007 Jeep Commander?

The person who posted this question about this Jeep automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Manual Pages

Owner Manual - Page 4

... -road ride and handling will improve with all vehicles can go out of this type, failure to operate this vehicle is not intended for selecting a Jeep௡ Commander and welcome to overcome the laws of this manual. Be sure to become familiar with other severe conditions suited for a four-wheel drive vehicle...

Owner Manual - Page 15

...than the 2 second validation time period. During normal operation, the SKIM indicator 2 CAUTION! Leaving children in a vehicle unattended is locked or unlocked. SENTRY KEY IMMOBILIZER SYSTEM The ...Sentry Key Immobilizer System (SKIM) prevents unauthorized operation of running if an invalid key is an invitation to remove...

Owner Manual - Page 16

.... • Mobil Speedpass™, additional Sentry Keys, or any other RF electronics will result in the engine being used to start the vehicle. If the SKIM indicator light comes on the same keychain will not cause a key-related (Transponder) fault unless the additional part is physically held against the ignition key being shut...

Owner Manual - Page 17

... ON for dealer replacement of programming a blank key to match the ignition switch lock cylinder key code. 2. After ten seconds, a chime will sound and the SKIM indicator light will begin to any other vehicle. Once a Sentry Key has been programmed to a vehicle, it cannot be used to start the vehicle. A blank key is...

Owner Manual - Page 18

...If the system successfully arms, the red light will stop flashing, turn on for an additional 15 minutes. The SKIM indicator light will flash at a slower rate to indicate the alarm is set when you use... device may cause undesired operation. After all the doors are locked and closed, a red light (located in the instrument cluster) will flash rapidly for three minutes and the headlights and ...

Owner Manual - Page 70

... cuts or sidewall cracks. Inspect for excessive tread wear or uneven wear patterns. Check turn signal and high beam indicator lights on the instrument panel. Lights Have someone observe the operation of all exterior lights while you work the controls. Fluid Leaks Check area under vehicle after overnight parking for proper pressure. Check wheel...

Owner Manual - Page 74

...; BAS (Brake Assist System) ...136 ▫ ERM (Electronic Roll Mitigation) ...137 ▫ ESP (Electronic Stability Program) ...138 ▫ ESP/BAS Warning Lamp And ESP/TCS Indicator Light ...143 Ⅵ Rear Park Assist System-

Owner Manual - Page 124

... multi-function control lever a second time to switch the headlights to "EVIC- The "High Beam Indicator Light" on the instrument cluster will cause the headlights to turn on at high beam and remain on ...each side of the front and rear turn signal lights. Only the headlights will flash to turn this time. Customer Programmable Features" in Section 4 to...

Owner Manual - Page 132

... memory. To Deactivate A soft tap on the steering wheel and consist of ON·OFF, SET, RES·ACCEL, CANCEL, and DECEL controls. The CRUISE indicator light in use. Release the accelerator and the vehicle will operate at a Desired Speed When the vehicle has reached the desired speed, press and release the...

Owner Manual - Page 139

If the ЉESP/TCS Indicator LightЉ begins to flash during acceleration, ease up on the vehicle, nor can ..., 2 available operating modes on very slippery surfaces, or hydroplaning. The ЉESP/TCS Indicator LightЉ located in 4WD Low Range. 3 The ЉESP/TCS Indicator LightЉ also flashes when TCS is turning less than appropriate for the steering wheel position. ...

Owner Manual - Page 140

... mode is entered by momentarily depressing the ЉESP Control SwitchЉ. When in the TCS section, has been disabled and the ЉESP/TCS Indicator LightЉ will restore the normal "ESP On" mode of ESP function normally. To turn ESP on again, momentarily depress the ЉESP Control SwitchЉ...

Owner Manual - Page 141

..."limited slip" feature described in Section 4 of the "P" (Park) position. The "ESP/ TCS Indicator Light" will sound when the gear selector is off at speeds above . To turn ESP back on again,... is entered by momentarily depressing the "ESP Control Switch". After 5 seconds, the "ESP/TCS Indicator Light" will illuminate, and the ЉESP OFFЉ message will occur even if the message was...

Owner Manual - Page 142

... Off" ESP mode is intended for off-highway or off-road use only. 4WD Low Range Full Off This is off . The ЉESP/ TCS Indicator LightЉ will be illuminated in 4WD low range when ESP is the normal operating mode for the "limited slip" feature described in this mode. In...

Owner Manual - Page 143

...; The ESP Control System will stop when ESP becomes inactive following the maneuver that caused the ESP activation. 3 NOTE: • ЉThe ЉESP/TCS Indicator LightЉ and the ЉESP/BAS Warning LampЉ come on after several ignition cycles, and the vehicle has been driven several miles at speeds...

Owner Manual - Page 176

... arrow will come on , a chime will illuminate when the key is part of the vehicle in the ON position before Malfunction Indicator Light This light is in this case, the "Brake Warning Light" will remain on until the cause is first turned on, and stay on high beam. 5. If the vehicle electronics sense that...

Owner Manual - Page 177

... or missing gas cap, poor fuel quality, etc. Certain conditions such as possible to ON, have the system inspected by an authorized dealer. 4 The Malfunction Indicator Light flashes to alert you to serious conditions that the Anti-Lock portion of power or severe catalytic converter damage. If the ABS...

Owner Manual - Page 178

... accelerator. 9. Before reaching the red area, ease up on . Electronic Stability Program (ESP) Indicator Light/Traction Control System (TCS) Indicator Light This indicator light starts to flash during acceleration, ease up on momentarily when the engine is set. Oil Pressure Warning Light This light shows low engine oil pressure. The engine oil level must be checked under the...

Owner Manual - Page 181

... is turned to look under "Cooling System Pressure Cap." 14. Refer to rotate at your authorized dealer as soon as possible. 17. 4WD LOW Mode Indicator Light - If the ESP/ BAS warning light comes on when the ignition switch is dangerous. You or others could be badly burned by steam or boiling coolant.

Owner Manual - Page 182

... the vehicle has been driven. Therefore, if the odometer reading is first turned ON, this light will sound. If Equipped This light informs you of fuel in the fuel tank when the ignition switch is running. Cruise Indicator Light This indicator lights when the speed control system is unbuckled, a chime will turn on for more information...

Owner Manual - Page 183

... during starting, have the system checked by an authorized dealer. 24. Voltage Warning Light This light monitors the electrical system voltage. Gallons (8.7 Liters) this light will sound. 4 Also, a single chime will come on and remain on briefly as possible. Front Fog Light Indicator Light- This occurs due to the shifting of the fuel in the P (Park...