Insignia NS-UZ17SS0 Support Question
Find answers below for this question about Insignia NS-UZ17SS0.Need a Insignia NS-UZ17SS0 manual? We have 3 online manuals for this item!
Question posted by syedaf786 on April 1st, 2022
Current Temperature Display..
Current Answers
Answer #2: Posted by SonuKumar on April 1st, 2022 8:39 PM
High Temp Alert The freezer is having trouble maintaining a cold temperature. You will get this alert if: R26; FREEZER MODE: the inside temperature is over 18° F (-8° C) for 36 hours. R26; FRIDGE MODE: If the inside temperature is over 59° F (15° C) for 36 hours. The LED on control panel turns on and a beep sounds. If the temperature returns to a normal range, the alert turns off. You can also press any button to turn it off. Here are some possible causes: R26; The room is too warm. For example, the freezer is in a garage in the summer next to a car with a hot engine. R26; The ventilation openings are blocked or dusty. R26; There is too much frost build up. R26; There are door seal gaps. Door Open Alert If the door is open for more than five minutes, the door open alert is activated a buzzer sounds intermittently. Close the door to turn off the alert and check to make sure that nothing is blocking the door, preventing it from closing. Also, check to make sure that the freezer is level. An unlevel freezer may prevent the door from closing properly. How do I reset my freezer to factory defaults? 1 Press and hold Lock for three seconds to unlock the control panel. 2 Press the Lock and + buttons at the same time for three seconds to reset the freezer to factory defaults. The panel beeps and all of the indicators turn on for three seconds. If the compressor is running, it pauses for five minutes, then restarts.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Insignia NS-UZ17SS0 Manual Pages
Similar Questions
I replaced the fan. The voltage going to the fan is only 6v, but it should be 12v. What could cause ...
I need a part number and supplier for the stainless steel door handle for the Insignia model ns-uz17...
Deep freeze NS-CZ70WH6
NS-CZ70WH0 quits freezing periodically. Power lite stays on. Must turn off and back on to reset/rest...
I can't find power supply on E-bay for NS-LTDVD19. I can only find it for the 19" LCD. Is this the ...