InSinkErator Invite H990-SS Support Question
InSinkErator Invite H990-SS Support Question
Find answers below for this question about InSinkErator Invite H990-SS.Need a InSinkErator Invite H990-SS manual? We have 2 online manuals for this item!
Question posted by goldenpanther76 on February 28th, 2013
Where Can I Purchase Just The Tank For My Hot Water Dispenser?
Where can I purchase just the tank for my insinkerator hot water dispenser?
Current Answers
Answer #1: Posted by incarnate on February 28th, 2013 5:12 PM
incarnate
Member since:
February 28th, 2013 Points: 9,940
Member since:
February 28th, 2013 Points: 9,940
Related InSinkErator Invite H990-SS Manual Pages
Specifications - Page 1
... & Use booklet packed with Lead Plumbing Law
1-800-558-5700 www.insinkerator.com
Printed in the specifications at 200˚F)
Insulation
Meets U.L. 94HF-1 flammabiltiy specification
Valve
Instant, self-closing hot valve.
Instant Hot Water Dispensers
The Next Necessity™
H990-SS
Easy-grip handle to dispense instant near -boiling water • 3-Year We Come To You® In-Home...
Owners Manual - Page 1
TranScape™ View™ TranScape™ Wave™ HC3/GN3 H990 H770
Instant Hot Water Dispenser
Owner's Manual
Installation, Care & Use
Instalacion, cuidado & uso Installation, soin et utilisation
Owners Manual - Page 2
... step-by the same wall switch that operates the
disposer, unless you have a SinkTop Switch™ from operating properly. I Moving parts inside the tank causing a rattling noise is normal. I Make sure that all instructions, cautions, warnings and dangers before installing or using an InSinkErator Instant Hot Water Dispenser.
We are drilling into a surface other than stainless...
Owners Manual - Page 3
.... What you'll see in death or serious injury. Do not distort the last 1 inch of your instant hot water dispenser and record it here
HC-View-SS H-View-SS HC-Wave-SS H-Wave-SS HC3-SS GN3-SS H990-SS H770-SS
HOW TO USE THIS INSTRUCTION MANUAL
These instructions are separated into main sections, indicated by numbers, and subsections, indicated...
Owners Manual - Page 4
... Small Steel Large Steel
2-1/4"
Fiber
Snap-Connect Fitting (3 pieces)
Tank
H-View-SS H-Wave-SS GN3-SS
Extension & Star Nut (View & Wave only)
Washers
1-5/8"
1-5/8"
3/4" Screws (2)
2-1/4"
2-1/4"
Rubber Small Steel Large Steel
Fiber
Wing Nut (HC3/GN3 only)
Snap-Connect Fitting (3 pieces)
Tank
3/4" Screws (2)
H990-SS
Semi-Circular Mounting Plate
Wing Nut
Snap-Connect Rubber Gasket...
Owners Manual - Page 5
...;4 3" H770-SS .......... 2 3⁄4"
* HC3/GN3, extension is a grounded electrical outlet under the sink. B
If you have a sprayer hole or don't want to it ? I Plug hose opening with an instant hot water dispenser.
I Turn off water supply.
It should not be fused. I Make sure there is available by the same wall switch
that operates your disposer, unless...
Owners Manual - Page 6
.... Hot & Cool models only
I Feed tubes down through the hole in
the sink/counter until the base is at rest. I Attach the quick connector to hold the dispenser head...Wave
For a standard 11⁄2" sink/counter hole I Unscrew and remove threaded extension from the dispenser. I Unpack dispenser components.
I Install a white 3/8" tube into hole smaller than 11⁄2"
I Feed tubes...
Owners Manual - Page 7
...8260;4"
BOTH 15⁄8" small steel and rubber washers MUST BE INSTALLED to hold the dispenser head in the sink or counter until the base is at rest.
I Slide 21&#...fiber washer over faucet base under sink. I Feed tubes down through the hole in place while securing the dispenser.
HC3 / GN3
I On a firm, flat surface, carefully straighten the copper tubing using black plastic wing...
Owners Manual - Page 8
... onto the threaded stud. I Feed tubes down the hole in place while securing the dispenser. Property Damage: Do not pinch or break copper tubing.
H990
A
H990
I On a firm, flat surface, carefully straighten the copper tubing using
hands only. I Unpack dispenser components.
Tighten the wing nut until the base is at rest on the sink...
Owners Manual - Page 9
...9
I Position faucet head at rest on the sink or countertop surface.
I Unpack dispenser components. Property Damage: Do not pinch or break copper tubing. DO NOT remove mounting... is at the desired angle.
H770
I Feed tubes down the hole in place while securing the dispenser. H770
I From below the sink, place semicircular metal mounting plate over so that the fiber gasket...
Owners Manual - Page 10
... are connected properly and are
pushed down
approximately 1/2". (3)
Property Damage: Pinched or blocked water lines may cause damage to the dispenser tank. tank vertically within 30" or less of the
tank for 2 hanging screws.
Use wall anchors (not supplied) for hanging tank. I While holding tank in wood studs or cabinets only.
B
Leave 1/4" for installation into drywall. I Turn...
Owners Manual - Page 11
... the brass tube insert.
I Depress the dispenser's HOT handle and hold it until water flows from the quick-connector, slide the supplied brass nut and ferrule over the tube. Do not use an extension cord set with the control valve over the tube and then push in instant hot water tank.
I At the end of the...
Owners Manual - Page 12
... modify this instant hot water dispenser should be grounded. Install using genuine InSinkErator® manufactured components only.
Electric Shock Hazard: Using an ungrounded or improperly connected appliance can result in your home at no cost to you. Use only the InSinkErator dispenser faucet supplied. If warranty service is equipped with the appliance - Purchase or installation...
Owners Manual - Page 13
... for 20 seconds to reach new temperature. InSinkErator offers the only water filtration system designed specifically for water to bring in those applications where any signs of water tank and drain the water into the bottom of the plastic components and void the warranty. SEASONAL STORAGE/DRAINAGE
Anytime the instant hot water dispenser is 200˚F. May result in...
Owners Manual - Page 14
Please read Troubleshooting Guide and/or visit www.insinkerator.com before calling AnswerLine™
TROUBLESHOOTING
PROBLEM
Water and steam spits forcefully from the tank.
• Adjust water temperature using dial on the dispenser faucet. WHAT TO DO
• Activate faucet lever to release some water from spout without turning on tank front.
If the dripping doesn't stop after...
Owners Manual - Page 43
... its sole discretion, without notice or obligation and further reserves the right to change or discontinue models.
© 2008 InSinkErator, a division of Emerson Electric Co. 1.800.558.5700 www.insinkerator.com
44228 REV. InSinkErator may make improvements and/or changes in the specifications at any time, in USA
The Emerson logo is a trademark...
Similar Questions
Faucet Handle Came Off
our hot water dispensor faucet handle came off, now we are not able to use it to dispense water. We ...
our hot water dispensor faucet handle came off, now we are not able to use it to dispense water. We ...
(Posted by mingminghao 9 years ago)
Why Is My Garbage Disposal Leaking On The Bottom
(Posted by shrnwashington 10 years ago)
Threaded Stud
my threaded stud has fallen out - how do I put it back in? My dispenser moves around without this in...
my threaded stud has fallen out - how do I put it back in? My dispenser moves around without this in...
(Posted by TOPanic 11 years ago)
Ball Bearing In Garbage Disposal
We heard a bad sound and found two ball bearing inside our disposal that we did not put in?? It is a...
We heard a bad sound and found two ball bearing inside our disposal that we did not put in?? It is a...
(Posted by Gbobeczko 11 years ago)
Dishwasher Is Not Draining After Installing The Garbage Disposal.
Have checked the dishwasher drainage and there is no problem. There appears to be a blockage on the ...
Have checked the dishwasher drainage and there is no problem. There appears to be a blockage on the ...
(Posted by Drkisa 11 years ago)