Husqvarna ST 227P Support Question
Husqvarna ST 227P Support Question
Find answers below for this question about Husqvarna ST 227P.Need a Husqvarna ST 227P manual? We have 1 online manual for this item!
Question posted by thomasgordon on November 23rd, 2015
Snow Thrower St227p Manual Does Not Illustrate Where Oil Drain Plugor Spark Plu
Manual does not illustrate where oil drain plug or spark plug is locatedNo luck finding anything on internetplease advise
Current Answers
Answer #1: Posted by TommyKervz on November 25th, 2015 6:01 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,813
Member since:
January 10th, 2013 Points: 17,776,813
Click here and follow the instructions
or page 14 here: https://www.manualowl.com/m/Husqvarna/ST-227P/Manual/430755?page=14
or page 14 here: https://www.manualowl.com/m/Husqvarna/ST-227P/Manual/430755?page=14
Related Husqvarna ST 227P Manual Pages
Owners Manual - Page 2
WARNING: Always disconnect spark plug wire and place it where it cannot contact plug in the manual(s) before unclogging the collector/impeller housing or ...whenever you leave the operating position, before operating this unit. It means CAUTION!!! WARNING: This snow thrower is for use snow thrower on the machine and in order to the State of residences, garages, porches or other ground...
Owners Manual - Page 3
... 5W-30 (below 32°F)
Oil Capacity:
32 Ounces (0,9 Liters)
Spark Plug: Gap:
F6RTC 0.030" (0,762 mm)
CUSTOMER RESPONSIBILITIES
• Read and observe the safety rules.
• Follow a regular schedule in maintaining, caring for an extended period.
4. Never operate the machine at frequent intervals for transporting the snow thrower in any problem you to assemble...
Owners Manual - Page 5
... handle. CARRIAGE BOLT
MOUNTING HOLES
TEMPORARY MOUNTING BOLT
HANDLE KNOB
FIG. 2
3. ASSEMBLY / PRE-OPERATION
Read these instructions and this manual in its entirety before you attempt to assemble or operate your snow thrower, all accessible loose parts and parts boxes from skid plate if equipped.
4.
All parts such as necessary to ensure proper...
Owners Manual - Page 6
... pressing them down onto the control levers. Position chute rotator head over chute bracket. Install locknut and cable guide on pin and threaded stud of snow thrower.
2. Install remote cable bracket to discharge chute with holes in chute bracket.
3. ROTATOR CABLES CABLE GUIDE
REMOTE CABLE
BRACKET
5/16-18 LOCKNUT
FIG. 6
4. Eyelet will...
Owners Manual - Page 7
....
Learn and understand their meaning. Compare the illustrations with your snow thrower or in literature supplied with the location of various controls and adjustments. DANGER OR WARNING
EAR PROTECTION RECOMMENDED
READ AND FOLLOW ALL SAFETY INFORMATION AND INSTRUCTIONS BEFORE USE OF THIS PRODUCT. DANGER READ OPERATORS MANUAL DO NOT OPERATE ON STEEP SLOPES WATCH FOR...
Owners Manual - Page 8
...-
Skid plate - ACTUAL LOCATION MAY VARY WITH THE ENGINE
ON YOUR UNIT. used for starting a cold engine. Fuel shut off the fuel flow to the standards of snow thrower. Auger control lever - ... when snow thrower is thrown. Electric start and run. ON / OFF switch - used to start button -
MUFFLER
GASOLINE FILLER CAP
CHOKE CONTROL
ON / OFF SWITCH
OPERATION
POWER CORD PLUG
ELECTRIC...
Owners Manual - Page 9
... key to prevent unauthorized use choke to "FULL" position.
TO CONTROL SNOW DISCHARGE (See Fig. 11)
WARNING: Snow throwers have exposed rotating parts, which snow is to "OFF" position.
2.
The DISTANCE that snow is thrown is located on the engine. Move lever back to throw snow a short distance; Use the choke control whenever you are starting a cold...
Owners Manual - Page 10
..., the discharge chute may become clogged with the operation of the snow thrower. Disconnect the spark plug wire and keep the wire away from its mounting clip. SPEED and DIRECTION are controlled by the traction drive control lever located on that side of snow thrower and allows it disengages the drive wheel on the left side handle...
Owners Manual - Page 11
... season. Be sure both plates are located on each side of this manual. Skid plates are adjusted evenly. OPERATION
TO ADJUST SKID PLATES (See Fig. 16)
NOTE: The wrench provided in your snow thrower has been shipped from the factory already filled with snow thrower on level ground.
2. ACTUAL LOCATION MAY VARY WITH ENGINE ON YOUR UNIT...
Owners Manual - Page 12
...manual.
• For extremely heavy snow, reduce the width of snow removal by overlapping previous path and moving slowly.
• Keep engine clean and clear of the starter as possible.
2. household current.
• Ensure your snow thrower...(tied to start . Push the primer three (3) times. Plug the other end of the snow thrower.
12 receptacle.
7.
If you are uncertain, consult a ...
Owners Manual - Page 13
... spark plug and check belts for loose fasteners.
3.
A new spark plug will need to be sure they are functioning properly. NOTE: Use only Original Equipment Manufacturer (OEM) parts to service this snow thrower does not cover items that have been subjected to the interlock bosses. LUBRICATION CHART
➀ SAE 5w30 Motor Oil ➁ See "Engine" in this manual...
Owners Manual - Page 14
...the snow thrower. CAUTION: Any lubricating of this manual).
7.
Check the crankcase oil level before next oil change. Clean area around drain plug.
3. Be sure to your snow thrower are ...or damage. Water in contact with spark plug.
2. CLEANING
IMPORTANT: For best performance, keep water out.
Do not overfill. We do not recommend using a garden hose to enter the engine.
...
Owners Manual - Page 15
... secured to the impeller shaft with your snow thrower.
4. WARNING: To avoid serious injury, never operate your snow thrower.
4. Remove safety ignition key and disconnect spark plug wire from the operator. Install 1/4-20 lock nut and tighten securely.
Place wire where it cannot come in the Operation section of this manual. Install 1/4-20 locknuts and tighten securely...
Owners Manual - Page 16
...
MOUNTING BRACKET
FIG. 20
3. Serious personal injury and/or damage to the snow thrower. BEFORE REPLACING BELTS 1. Drain
gasoline from fuel tank into a suitable container, outdoors, away from under the... this manual.
16
FRAME
UPPER
ASSEMBLY 5/16"
BOLT
LOWER LOWER 1/4" BOLT 5/16" BOLT
FIG. 21
AUGER PULLEY Do not discard bolts.
2. Remove the auger belt from your snow thrower are ...
Owners Manual - Page 17
....
5. Pivot and hold swing plate away from your snow thrower to 2,134 meters. Pivot and hold the swing plate away from snow thrower and remove drive belt from engine.
6. Place drive belt onto drive pulley. Lbs. / 41-47 Nm).
5. See "TO INSTALL AUGER BELT" in this manual.
WHEEL PIN (INSTALL IN OUTER HOLE OF AXLE...
Owners Manual - Page 19
... formation of this manual.
4. NOTE: Fuel stabilizer is important to prevent gum deposits from dust and dirt.
• Cover your snow thrower with new spark plug. Rust and/or dirt in the Maintenance section of time, clean it from forming in the Service and Adjustments section of fuel gum deposits during storage.
ENGINE OIL
Drain oil (with engine...
Owners Manual - Page 20
... (or ON/OFF switch to ON position). Choke in the Operation section of this manual.
7. Prime as instructed in OFF position.
5. Reconnect spark plug wire.
2. Engine idles or runs roughly
1. If vibration
impeller. Bad spark plug.
9. Replace spark plug.
10. Throwing too much snow.
2. Recoil starter is worn. 3. Check wire connections at engine and light.
3. PROBLEM...
Owners Manual - Page 21
...maintenance parts and items ("Expendable Parts"), including without limitation spark plugs, bulbs, filters, lubricants, starter cords, belts, blades,... purchase and beyond, such as described in the operator's manual. In addition, you purchased the unit from the date ... The following the preventative maintenance, storage, fuel and oil usages as otherwise directed in either NO WARRANTY (whether...
Owners Manual - Page 23
...stamped deck shell. Limited Lifetime Warranty Battery Other Non-Expendable Components Snow Throwers, Tillers, LE475 Edger Engine* Auger Gearbox Other Non-Expendable Components ...
professional, institutional,
agricultural, or income producing use,
Product/Component
other than Rental Use)
Riding Lawn Tractors:
Frame, Chassis, Front Axle
5 Years
No Warranty
Engine*
*
*
Transmission (if ...
Owners Manual - Page 24
... decks within the Limited Lifetime Warranty.
M-ZT - (ZT3400 transmission) Two (2) Year warranty, parts & labor, with Hydro-Gear Distributor network.
*** "Limited Lifetime Warranty" on specific Snow Throwers & Tillers, warranty through
Husqvarna.
** See reference 4 (b) of the complete unit's final production, whichever comes first.
Two (2) Year Consumer warranty, parts & labor, with...
Similar Questions
Model St227p Broken Spring
the spring to the traction control cable broke. where does this connect underneath when the bottom p...
the spring to the traction control cable broke. where does this connect underneath when the bottom p...
(Posted by hopthebop 1 year ago)
Husqvarna 924hv Oil Drain Plug Location
Where is the oil drain plug on a Husqvarna 924HV. I see one on each side of engine
Where is the oil drain plug on a Husqvarna 924HV. I see one on each side of engine
(Posted by billconnors 2 years ago)
St227p Drive Locks Wheels But Goes Forward If Steering Levers Are Used.
Is there a fix for the above? Sometimes one side will lock. Put in reverse and will back up like its...
Is there a fix for the above? Sometimes one side will lock. Put in reverse and will back up like its...
(Posted by Edlutkus 3 years ago)
Husqvarna Snowblower St227p Manual How Many Belts On In This Machine???
How many belts in this unit?
How many belts in this unit?
(Posted by m55hump 8 years ago)
How Much Wt. Will This Tractor Pull And Is It Strong Enough For A Snow Thrower?
(Posted by jrdevlin146 10 years ago)