Home » Husqvarna » Lawn Mowers » Husqvarna RZ4219

Husqvarna RZ4219 Support Question

Find answers below for this question about Husqvarna RZ4219.
Need a Husqvarna RZ4219 manual? We have 2 online manuals for this item!

Husqvarna Overview Questions Manuals Reviews Videos Research

Question posted by pstoman on May 16th, 2016

Rz4219 Mower Deck Belt Drive

The mower deck on my 2013 RZ4219, , is having problems with the mower deck shredding belts. Has there been a recall or arecommended modification? If so, do you know the parts number. Thank you Pat Stroman,

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on May 16th, 2016 8:22 AM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,660

1,100
points

There has been no recall. As for a recommended modification, you'll have to ask Husqvarna--see the contact information here: https://www.contacthelp.com/Husqvarna/customer-service. For the part number, go to http://bit.ly/22dGlLH (look at the left). The same site may be able to provide a repair solution: click the link to Repair Help for Lawn Mowers.

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Husqvarna RZ4219 Manual Pages

Owners Manual - Page 3

Contents INTRODUCTION 5 Driving and Transport on Public Roads 5 Towing 5 Operating 5 Good Service 6 Manufacturing Number 6 Symbols and Decals 7 Safety 9 Safety Instructions...Safety System 37 Tire Pressures 38 Parking Brake 38 V-belts 39 Deck Belt 39 Cutting Blades 40 Blade replacement 40 Adjusting the Mower Deck 41 Leveling deck 41 Anti-scalp rollers 42 Cleaning 43 Caster Wheels...

Owners Manual - Page 10

Do not allow the mower deck to plow leaves or other debris, causing buildup to occur. • Clean any oil or fuel spillage ... which is a odorless, colorless, poisonous gas. The engine exhaust contains carbon monoxide, which can touch the hot exhaust or engine parts and burn. Never take passengers 8011-520 WARNING! Do not use the machine in a large percentage of grass, leaves or other...

Owners Manual - Page 13

...! There is extremely flammable and the vapors are explosive. • Extinguish all times until problem has been resolved. • Check the fuel level before refueling. 13 Allow engine and ... be started when the driver's floor plate or any protective plate for the mower deck's drive belt is spilled on clothing, change clothing immediately. • Never overfill fuel tank. Gasoline is ...

Owners Manual - Page 19

... the left of the blades, assuming the blade switch is depressed. 8058-020 8052-001 Blade switch 8052-001 19 In order to engage the mower deck, pull the knob out; CONTROLS Parking Brake IMPORTANT INFORMATION The machine must stand absolutely still when applying the parking brake. Release the parking brake before...

Owners Manual - Page 20

Ignition switch Choke Control The choke control is used to provide the engine with ratings and functions: 20 Amp Primary fuse 7.5 Amp Mower deck coupling Fuses 20 8052-001 8052-001 8011-420 Choke control Fuses Fuses are two fuses with a richer fuel mixture. CONTROLS Ignition Switch The ignition ...

Owners Manual - Page 22

...fuel shut off valve in the CLOSED position 8011-419 Cutting Height Adjuster To set the desired deck cutting height, press the release button and move the lever forward to the correct cutting height ...from 1½" (38mm) to 4" (102mm) in ½" (13mm) increments. The mower deck's lifting lever 8058-019 22 The cutting height range is turned perpendicular to the blade tip with the engine not...

Owners Manual - Page 25

... Sit on the seat. • Raise the mower deck by pushing the release button in and pulling the lever fully upwards. Disengage the mower blades by pressing the blade switch downwards. 8058-020... the daily maintenance before the engine can be started: • The blade switch for engaging the mower blades must be depressed. • The parking brake must be on. • Both steering controls...

Owners Manual - Page 29

... secure the opposite side with the cutting height adjustment lever. 8058-020 8058-024 Mower deck lifting lever 8058-019 29 WARNING! When the engine is free from objects that ...steering controls to the pin, release the button. 5. Parking brake released 3. NOTE: The mower is near mower when engaging blade switch. operation Running 1. Release the parking brake by the rotating blades. ...

Owners Manual - Page 30

...blade switch. 7. Place controls in a straight line forward or backward respectively. Do not drive up or down hills with slopes greater than 10 degrees. When both controls an equal ...right. By moving the other steering control forward from its neutral position. Engage the mower deck by moving one control backward (behind the neutral position) and carefully moving both controls ...

Owners Manual - Page 31

..., the driving speed can be best with a high engine speed (the blades rotate rapidly) and low speed (the rider moves slowly). The mowing result is frequent. Mowing pattern 8011-603 WARNING! When cleaning, the mower deck shall be thrown out by mowing often. Clear the lawn of the deck. For healthier and better looking lawns, mow...

Owners Manual - Page 32

... spark plugs fouling. • Disengage the mower deck by depressing the blade switch. 8052-001 Disengage the mower deck and move throttle to minimum • Raise the mower deck by pressing the release button on the lever...by pushing the lever release button and pulling the lever upward. Mower deck lifting lever • Move the throttle to stop position. • Move the steering controls outward. ...

Owners Manual - Page 34

... oil leakages Check/clean the engine's cooling air intake Check the mower deck Check for loose hardware (screws, nuts) Clean under the mower deck Start the engine and blades, listen for unusual sounds Check for damage Thoroughly clean around the engine Clean around belts, belt pulleys Check the tire pressures Before After Check battery connections Sharpen3...

Owners Manual - Page 35

...belts, belt pulleys Change the engine oil 1) Replace the engine oil filter Clean/replace the spark plugs Replace the fuel filter Replace air filter 2) (paper filter) Check the caster wheels (every 200 hours) Replace the air cleaner's pre-filter 2) (foam) Check/adjust the mower deck...key. • Make sure the blades and all moving parts have completely stopped. • Disconnect the spark plug wire...

Owners Manual - Page 37

... the seated position. Fuel Pump Air Filter Regularly check that the engine stops if the mower blades are in the seat and release the parking brake before using the machine again. ... hoses need be started when: 1. The mower deck is free from dirt. The engine can be cleaned with a safety system that the safety system works by attempting to drive, the driver must sit in the outer...

Owners Manual - Page 39

... have accumulated around the electric clutch pulley that may have any dirt or grass that is properly routed, slowly release idler arm to slip from belt shields and remove shields. 4. Remove belt shields Deck belt installation NOTE: For ease in normal operation. Push inward on both mandrel housings and secure with fasteners. Double check...

Owners Manual - Page 41

... the rear, follow the front adjustment instructions that measurement is the same. Additional adjustment may be properly adjusted. Deck front adjustment nuts 8058-030 8058-031 41 NOTE: To insure accuracy of leveling procedure, mower deck drive belt must be adjusted slightly higher in frontto-rear manner. Turn any blade to -side measurement. Adjust nuts...

Owners Manual - Page 43

... spraying engine and electrical components with water Do not rinse hot surfaces with normal water pressure. IMPORTANT INFORMATION DO NOT add any type of the mower deck. Hardware Check daily. Caster yoke 2. Do not spray water on the top of tire liner or foam fill material to clean the top side of...

Owners Manual - Page 47

TROUBLESHOOTING Problem Engine overheats Battery not charging The machine moves slowly, unevenly, or not at all Mower deck not engaging Transaxle leaks oil Uneven mowing ...• Bypass valve on pump open • Drive belt for the transmission slack or has come off • Air trapped in hydraulic system • Drive belt for the mower deck has come loose • Contact for the electromagnetic...

Owners Manual - Page 48

... in use the mixing ratios specified by the manufacturer of the mower deck to stand for cleaning. Handle the fuel with open flame. Empty...parts. Thoroughly clean the machine, especially under the mower deck. dispose of the mowing season, the machine should be readied for extra protection. Service When ordering spare parts, please specify the purchase year, model, type, and serial number...

Owners Manual - Page 58

.... SERVICE JOURNAL Action Date, mtr reading, stamp, sign Delivery Service Charge the battery. Check: The safety switch for the mower deck. The safety switch for the parking brake. Driving forward. No remaining notes. Certified: Driving backward. The safety switch in the normal position. Mount the steering controls in the seat. Application areas for Mulching...