Husqvarna HU675AWD Support Question
Husqvarna HU675AWD Support Question
Find answers below for this question about Husqvarna HU675AWD.Need a Husqvarna HU675AWD manual? We have 2 online manuals for this item!
Question posted by rweaver58421 on July 10th, 2015
Mower Will Not Start. Has Not Been Used Since October
The person who posted this question about this Husqvarna product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by TechSupport101 on July 10th, 2015 10:49 AM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Please see the answer here for assistance will troubleshooting your non-stater lawn mower.
Related Husqvarna HU675AWD Manual Pages
Owners Manual - Page 2
...or drugs.
• Never operate machine in order to vibrate abnormally, stop before starting when setting up and down for proper operation and installation of your nearest authorized ... RULES
Safe Operation Practices for the cause. BECOME ALERT!!! WARNING: This lawn mower is equipped with the controls and the proper use accessories approved by the blade.
• Be sure the area is...
Owners Manual - Page 3
...
• Read and observe the safety rules.
• Follow a regular schedule in maintaining, caring for and using your purchase of a new lawn mower. Allow engine to assemble and maintain your nearest authorized service center/department. Do not use extra caution when servicing it on a truck or trailer bed with a plastic liner. Should you experience...
Owners Manual - Page 4
...KNOB
FIG. 1
BOLT
LOWER HANDLE
LOWER HANDLE "STANDARD" KNOB
HANDLE BRACKET
FIG. 2
4 Roll lawn mower out of this manual in the parts bag. Remove protective padding, raise upper handle section into ...to assemble or operate your mowing comfort. Raise lower handle section to ensure proper tightness. Use the correct tools as nuts, washers, bolts, etc., necessary to complete the assembly have...
Owners Manual - Page 5
... T-knob. Slip vinyl bindings over frame. To convert mower to be used as a mulcher. Loosen T-knob.
2. FRAME HANDLE
VINYL... BINDINGS
FIG. 3
FRAME OPENING
CONTROL BAR
UPPER HANDLE
ROPE GUIDE
T-KNOB
ENGINE STARTER ROPE
FIG. 4
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to bagging or discharging, see "TO CONVERT MOWER...
Owners Manual - Page 6
... the product. Release to start the engine. used for starting the engine. OPERATOR PRESENCE CONTROL BAR
DRIVE CONTROL BAR
STARTER HANDLE
GRASS CATCHER
WHEEL HEIGHT ADJUSTER (ON EACH WHEEL)
HANDLE KNOBS
GASOLINE FILLER CAP AIR FILTER DRIVE COVER
ENGINE OIL CAP WITH DIPSTICK
HOUSING
SPARK PLUG
MUFFLER
IMPORTANT: This lawn mower is running. Consumer Product...
Owners Manual - Page 7
... control bar which can result in foreign objects thrown into hole in order to start and operate the mower. To stop when either the operator presence control bar or drive control bar are...to be positioned behind the mower handle to minimize the risk of blade contact injury. HOW TO USE YOUR LAWN MOWER
ENGINE SPEED
The engine speed was set at the factory for most lawns. • To change ...
Owners Manual - Page 8
... BAGGING (See Fig. 8) • Lift rear door of the lawn mower and place the grass
catcher frame hooks onto the grass bag brackets. • To convert to bottom of 87 octane. BEFORE STARTING ENGINE
ADD OIL (See Fig. 10)
Your lawnmower is level.
2. Use fresh, clean, regular unleaded gasoline with the unit. See "TO...
Owners Manual - Page 9
...be exposed to direct sunlight. • For best results, adjust the lawn mower cutting height so that the lawn mower cuts off with use and catchers will be noticed. TO STOP ENGINE
• To stop ... be necessary to raise the height of cut path.
• Change your lawn is required before starting.
• To start the engine and let it may not enter the grass catcher. Always mulch ...
Owners Manual - Page 10
... Lawn Mower **** Clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Battery **
Check Engine Oil level Change Engine Oil Clean Air Filter Inspect Muffler Replace Spark Plug Replace Air Filter Paper Cartridge Empty fuel system or add Stabilizer
* (if so equipped)
** Electric-Start mowers
*** Power-Propelled mowers
****
Use...
Owners Manual - Page 11
... free drive wheels. Put wheels back in good condition to prevent blade from wheel adjusters.
3.
Using a blade not approved by the manufacturer of wood between blade and mower housing to work properly. Use a wood block between blade and lawn mower housing and tighten the blade bolt, turning clockwise.
• The recommended tightening torque is hazardous...
Owners Manual - Page 12
...;er on the gear case. TO CHANGE ENGINE OIL (See Fig. 14)
NOTE: Before tipping lawn mower to drain oil, empty fuel tank by using a cone balancer, follow the instructions supplied with lubricant to retighten oil dipstick before starting engine. 9. CONTAINER
FIG. 14 4. MAINTENANCE
• To check blade balance, you will not run properly...
Owners Manual - Page 13
...line with a fitting that allows quick and easy cleaning of the underside of the housing. Start engine (as it cannot come in the Operation section of this manual.
• Keep fi... of the water washout port (if
equipped), we do not recommend using a garden hose to clean the outside of your lawn mower by scraping to remove build-up any spilled gasoline. CLAMP
CLAMP
FUEL...
Owners Manual - Page 14
...and place where it should be thrown out of the rear of this manual. Turn lawn mower on its side with plug. Disconnect return spring from rear gearcase.
7. If the ...: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: 1.
Remove rear baffle.
5.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in contact with air filter and carburetor...
Owners Manual - Page 16
... handle brackets for a period of this manual).
2. Clean entire lawn mower (See "CLEANING" in a clean, dry area.
1. Reinstall "standard" knobs and carriage bolts to an authorized service center for repair and adjustment. If your engine does not operate properly due to be used for storage.
1.
Align opposite side of handle with same positioning...
Owners Manual - Page 17
...Use fresh fuel next season. Plastic cannot breathe, which allows condensation to form and will cause problems.
• If possible, store your unit to reach the carburetor.
Always follow the mix ratio found on stabilizer container. CAUTION: Never store the lawn mower...WHILE IN STORAGE.
• Empty the fuel tank by starting the engine and letting it to distribute oil.
4.
Allow ...
Owners Manual - Page 18
...Rear of pulley. 3. Check oil level. 6. Worn, bent or loose blade. 2. Clean underside of lawn mower housing one (1)
setting higher. 3. Empty grass catcher. 4. Belt off .
(if so equipped) 3. ... air.
1. Adjust drive control.
18 TROUBLESHOOTING POINTS
PROBLEM
CAUSE
CORRECTION
Does not start
1. Empty fuel tank and refill tank with fresh,
clean gasoline.
...
Owners Manual - Page 20
...obtain warranty coverage it is approved; (h) Use of ether or any starting fluids; (i) Pressure cleaning or steam cleaning the product; (j) Use of spark plugs other than those meeting ... (Armor Protected) 10 Year Limited & Fabricated Limited Lifetime, Deck Warranties. (a) Abrasion to mower decks; (b) Tires damaged by external punctures; (c) Natural discoloration of materials due to ultraviolet ...
Owners Manual - Page 21
...Year Pro-rated
No Warranty No Warranty No Warranty
Other Non-Expendable Components Residential Zero Turn Mowers ( RZ Only )
3 Years
No Warranty
Engine*
*
*
Transmission **
**
No Warranty...
Engine*
*
Pump
2 Years
Other Non-Expendable Components
2 Years
All other than Rental Use)
Riding Lawn Tractors:
Frame, Chassis, Front Axle
5 Years
No Warranty
Engine*
*
*
Transmission (if...
Parts List - Page 3
... 33 00-01 - - 115 66 18-96
DESCRIPTION
Screw, Dogpoint 3/8-16 x 1-1/8 Kit, Lawn Mower Housing Blade Adapter Blade, 22" Washer, Hardened Washer, Helical Bolt, Hex Head, Grade 8 ..., English / Spanish
3
NOTE: All component dimensions given in U.S. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. HU675AWD (96143010801) PRODUCT NO. 961 43 01-08
KEY PART NO. inches. ...
Parts List - Page 5
HU675AWD (96143010801) PRODUCT NO. 961 43 01-08
KEY PART NO. inches. 1 inch = 25.4 mm. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. NO.
1 586 03 33-01
2 586 07 ...Hex Head 1/4-20 Mounting Bracket, Debris Shield Belt Keeper, Gearcase, Rear Washer, Flat
KEY PART NO. HUSQVARNA ROTARY LAWN MOWER - MODEL NO. NO.
28 812 00 00-58 29 581 84 04-01 30 532 43 81-30 31 ...
Similar Questions
Engine Will Start After One Pass It Dies Will Not Start Again
(Posted by Anonymous-171367 1 year ago)
Husqvarna Riding Lawn Mower Starts, Blade Spins, Won't Go Forward Nor Reverse
(Posted by shywolfalways82 3 years ago)
What Spark Plug Do We Need For A Hu675awd Push Mower
(Posted by Anonymous-150226 9 years ago)
