Husqvarna 924HV Support Question
Husqvarna 924HV Support Question
Find answers below for this question about Husqvarna 924HV.Need a Husqvarna 924HV manual? We have 2 online manuals for this item!
Question posted by POCONO1CODYDOG on March 31st, 2013
How To Check And Clean Drive Train On Snow Blower Model#5524ste
The person who posted this question about this Husqvarna product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Husqvarna 924HV Manual Pages
Owners Manual - Page 12
... for a few seconds, remove and read oil level.
Your snow thrower engine is not a 120 Volt A.C. three-wire grounded system. Use a middle position if the surface to desired position. Check engine oil with both plates are uncertain, consult a licensed electrician. Use fresh, clean, regular unleaded gasoline with a three-wire power cord and plug...
Owners Manual - Page 13
...TO ADJUST SKID PLATES" in deep, freezing or heavy wet snow. This will help dry off the engine.
• Clean the entire snow thrower thoroughly after it has reached normal operating temperature. Insert ...
Use the drive speed control, NOT the ON / OFF switch, to adjust speed.
• It is ready for a few minutes to snap back.
6. WARNING: Do not operate snow thrower if weather...
Owners Manual - Page 20
...tank & carburetor, refill with ice or 3.
Friction drive wheel is 1. Primer not depressed.
6. Remove ice and snow on and around fuel tank cap. Check / replace drive belt. 2. Insert safety ignition key.
3. Water in fuel.
11. Tighten all fasteners. Check / replace auger belt. 3. Fill fuel tank with fresh, clean gasoline.
5. Dirty or clogged muffler.
4. Recoil starter...
Parts List - Page 2
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
2 REPAIR PARTS
AUGER HOUSING / IMPELLER ASSEMBLY
SNOW THROWER - inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
5
11 6
11
13
12
4
11
3 12
10
11 7
8
14
1
9
34...
Parts List - Page 3
...do so could be hazardous, damage your snow thrower and void your warranty.
3 inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00... 20-90
DESCRIPTION
IMPELLER GEARBOX ASSEMBLY BEARING IMPELLER PULLEY DISCHARGE BASE CORNER BRACKET CLEAN OUT TOOL TOOL CLIP NUT 1/4-20 SCREW 1/4-20 X .625 NUT 5/...
Parts List - Page 4
inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
1
3 (5x) 4 (5x) 2
01.07.001-A
KEY NO.
1 2 3 4
PART...: All component dimensions given in U.S. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
4 REPAIR PARTS
AUGER HOUSING / IMPELLER ASSEMBLY...
Parts List - Page 5
... - inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
5 MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
4
2
3
1
1 4 2
3
5
01.07.029-B
5
KEY NO.
1 2 3 4 5
PART NO.
532 18 81-70 532 42 77-62 532...
Parts List - Page 6
... SERVICE PART NUMBERS TO ALLOW PURCHASE OF INDIVIDUAL ITEMS IF NECESSARY. REPAIR PARTS
CONTROL PANEL / DISCHARGE CHUTE
SNOW THROWER -
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
6 MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
5
7
15
3 16
*14 *11
2
4
KEY PART NO. ALL ITEMS INDICATED...
Parts List - Page 7
ITEMS INDICATED WITH AN * ARE LISTED AS REFERENCE FOR SERVICE PARTS ONLY. NOTE: All component dimensions given in U.S. MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
2 2
*3
1 *7
*6
*4
*5
01.09.010-C
KEY NO.
1 2 ... (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
7
REPAIR PARTS
CONTROL PANEL / DISCHARGE CHUTE...
Parts List - Page 8
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
8 REPAIR PARTS
HANDLES
SNOW THROWER - DESCRIPTION
1
532 42 95-88 LOOP HANDLE LH
2
532 ... 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
4 5
4 3
2
3
4
4
3
01.08.013-C
3
KEY PART NO. NO.
Parts List - Page 9
... and void your warranty.
9 inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. REPAIR PARTS
HANDLES
SNOW THROWER - MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
9
2
9
56
4
7
8
10 11
12
3
1
10
13
12
10 11
11 12
12 10 11
01.08.022-A
KEY ...
Parts List - Page 10
MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
2
1
3
8 9
4
10 5
5 7
6
01.12.013-B
KEY NO.
1 2 3 4 5 6 7 8 9 10
PART NO.
584 80 87-01 584 ...4
NOTE: All component dimensions given in U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. REPAIR PARTS
HANDLES
SNOW THROWER - Failure to do so could be hazardous, damage your...
Parts List - Page 11
REPAIR PARTS
HANDLES
SNOW THROWER - DESCRIPTION
3
1
532 41 62-88 INTERLOCK SPRING
2
532 44 52-91 INTERLOCK CAM
3
532 ...625
6
532 42 18-14 INTERLOCK STOP
NOTE: All component dimensions given in U.S. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
11 MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
2 5
3
1 3
4
01.10.056-A
KEY NO. 1 2 3
4 ...
Parts List - Page 12
MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
ITEM 42 EXPLODED
2
46
45
1
16
17
1514 15
11 12 911
20
9
9 10
11
53 13 53
... given in U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
12 REPAIR PARTS
DRIVE
SNOW THROWER -
Parts List - Page 13
.... 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. REPAIR PARTS
DRIVE
SNOW THROWER - MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
KEY NO.
1 2
3 4 5 6 7...PIVOT ROD E-RING .375 SHOULDER SCREW BOTTOM PAN SPRING BRACKET DRIVE PLATE ASSEMBLY IDLER SPRING IDLER SPRING PULLEY SHAFT DRIVE PLATE BEARING PULLEY HALF SCREW 10-24 X .50 SPACER BEARING...
Parts List - Page 14
MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
7
8 1b
6
8 6
1b
1a
5
4 3
2
3
5
4
01.03.005-C
KEY NO.
1 1a 1b 2 3 4 5 6 7 8
PART NO.
532 18 ... U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
14 REPAIR PARTS
DRIVE
SNOW THROWER -
Parts List - Page 15
... - inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts.
Failure to do so could be hazardous, damage your snow thrower and void your warranty.
15 MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
2 3
2
3 1
1
01.00.034-A
01.01.004-A
1
KEY NO. - -
1 2 3
PART NO. 532 44 33-23
532...
Parts List - Page 16
MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
21
19 20
18
11
17
14 20 18 22
16 15
13
6
12
7
10
4
5
3
8
1
2 9
01.21.... given in U.S. inches. 1 inch = 25.4 mm IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your snow thrower and void your warranty.
16 REPAIR PARTS
CHASSIS / ENGINE / PULLEYS...
Parts List - Page 17
... - Failure to do so could be hazardous, damage your snow thrower and void your warranty.
17 MODEL NO. 924HV (96193007005), PRODUCT NO. 961 93 00-70
1
2
01.06.010-A
KEY NO.
1 2
PART NO.
532 43 65-15 532 43 65-16
DESCRIPTION
WHEEL 16 X 4....
Parts List - Page 21
...Knob-Snow Governor Linkage Shield Plate Recoil Starter Assembly-Snow Starter Cup Small Snow Starter Grip Snow Starter Grip (Deluxe) Blower Housing Assembly, Electric Start-Snow (Black) Blower Housing Assembly Manual Start-Snow ...-Snow Non-Removable Oil Plug Ce Compliant Muffler Shield Red Key Set
*This Part Is Used On Pw4 Models Only. NOTE: All component dimensions given in U.S. MODEL NO. 924HV ...
Similar Questions
Need Owner Manual For A Husqvarna 924-hvx Snow Blower Can You Help?
(Posted by steffeseven 1 year ago)
Husqvarna 924hv Oil Drain Plug Location
Where is the oil drain plug on a Husqvarna 924HV. I see one on each side of engine
Where is the oil drain plug on a Husqvarna 924HV. I see one on each side of engine
(Posted by billconnors 2 years ago)
Muffler Replacement St131 Snow Blower
How do I obtain step by step instructions for replacing the muffler on my ST131 single stage snow bl...
How do I obtain step by step instructions for replacing the muffler on my ST131 single stage snow bl...
(Posted by wzamplas 2 years ago)
Husqvarna Gas Shut Off
The gas shut off no longer works correctly - if you put it in the off position the snowblower just c...
The gas shut off no longer works correctly - if you put it in the off position the snowblower just c...
(Posted by raclairmont 11 years ago)