Husqvarna 128LD Support Question
Husqvarna 128LD Support Question
Find answers below for this question about Husqvarna 128LD.Need a Husqvarna 128LD manual? We have 2 online manuals for this item!
Question posted by Scotthanseth on June 26th, 2016
How Does The Throttle Lock Install On Husqavarna 128ld String Trimmer
I am replacing the handle, how does the throttle lock install?
Current Answers
Answer #1: Posted by Odin on June 26th, 2016 11:00 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Husqvarna 128LD Manual Pages
Owners Manual - Page 2
... trimmer 12
ASSEMBLY Fitting the loop handle 13 Assembling and dismantling the two--piece shaft 13 Fitting the trimmer guard and trimmer head 13
FUEL HANDLING ...TRIMMER Know your trimmer: Model Number:
Serial Number:
Purchase Date:
Purchased From:
WARNING: A clearing saw,
brushcutter or trimmer can cause serious or fatal injury to the operator or others . authorized accessories or replacement...
Owners Manual - Page 3
speed of output shaft, rpm
Watch out for handle positioning.
Arrows which show limits for thrown objects and ricochets.
...at a ratio of the machine must always be dangerous!
Always wear approved protective gloves. Wear sturdy, non--slip boots. trimmer heads with trimmer line.
115275126 Rev. 1 9/15/09
English--- 3 The operator of 2% (1:50).
Careless or incorrect use non--...
Owners Manual - Page 4
..., but it releases the throttle control (B). When you release the handle the throttle control and the throttle lock--out both move back to prevent accidental operation of the throttle control.
Secure hair so ...Gloves should be reduced and the risk of an accident. See the "Know your trimmer " section to ensure that can increase if machine maintenance is controlled by the authorities...
Owners Manual - Page 5
...If the retailer who have impaired circulation. See the section on the machine
requires special training. Use of incorrectly wound trimmer line or an incorrect cutting attachment increases the level of strength, changes in skin color or condition. WARNING: Overexposure... stopping. WARNING: Never use and remain so for trimming grass. Cutting equipment A trimmer head is poorly ventilated.
Owners Manual - Page 6
...
S Ensure that the guard is undamaged and is cracked. S Replace the guard if it returns to serious damage.
S Regularly check that the
return springs work properly. SAFETY INSTRUCTIONS
Throttle lock--out S Make sure the throttle control is locked
at a standstill. Start the machine and apply full
throttle. See the Maintenance section.
The mesh should be checked...
Owners Manual - Page 7
... any of days. This is because when clearing using trimmer line the engine must be replaced. S Make sure that it repaired. This section describes...trimmer line is used to cut the trimmer line to work on "Technical data".
1. IMPORTANT! Extend the life of cutting equipment. Refer to the instructions for the cutting attachment to check the correct way to rotate even after the throttle...
Owners Manual - Page 8
... The only accessories you from unstable surfaces such as stones, broken glass, nails, steel wire, string, etc.
S Never use the machine if you are taking medication that has been modified in this... can cause serious burns. S Keep handles free of 50 feet (15 meters). S Hold the unit firmly with loosely hanging ties, straps, tassels, etc. S Keep trimmer head below waist level. S Keep ...
Owners Manual - Page 9
...
S Check that the trimmer head and guard are properly fitted before the unit is started with an anti-spill valve.
S Make sure the handle and safety features are... uncertain how to rotate immediately. Never use approved containers intended for complete instructions.
S Ensure that has parts missing or has been changed in either the choke or start throttle...
Owners Manual - Page 10
... trees and wooden fences. Basic working operation.
Grass trimming using a normal lawn mower.
S Hold the trimmer head just above the ground and tilt it can cause damage and wear to... Reduce the risk of the trimmer line that does the work at full throttle. Avoid pressing the trimmer head against stones, brick, concrete, metal fences, etc., than full throttle so that the engine not...
Owners Manual - Page 11
...onlookers and helpers should use and may
attempt to and fro. Stop the engine and trimmer head before you should be swept and move the tool to remove the cut material while the engine... fan effect of the rotating line can be thrown up . You
could get hot during use full throttle to obtain the best results. WARNING: Watch out for a while afterwards. tance. Stop the machine ...
Owners Manual - Page 12
... 9. Operator's manual (EPA)
115275126 Rev. 1 9/15/09
English--- 12 Trimmer head 2. Grease filler cap 3. Handle adjustment 18. 12
4 1
KNOW YOUR TRIMMER
3
128LD 19
7
6
5 9 10 11
12
128CD
17 8 16
14 15 13
4 21
1
18
20
Know your trimmer
1. Upper shaft 6. Starter handle 13. Stop switch 10.Throttle lock--out 11. Fuel tank 14. Air filter cover 17. Cutting...
Owners Manual - Page 13
... and
upper shaft, pull the attachment straight out of rotation. Fitting the trimmer guard and trimmer head (Model 128LD)
S Position locking/release button (A) of attachment into the coupling
until one of coupling. A...shown in the diagram.
Fitting the loop handle
S Position the handle on the shaft and secure with the trimmer head. Note that the handle must be used in the primary hole ...
Owners Manual - Page 14
... the shaft. The nut
must be completely covered by the dust cup. S Screw the trimmer head (D) onto the shaft.
B A
C S Fit the dust cup (C) on the shaft and secure with the wing nut (B). S Hold the dust cup with the trimmer head. D
S To dismantle, follow the instructions in the reverse order.
115275126 Rev. 1 9/15...
Owners Manual - Page 15
...
WARNING: The catalytic con- verter muffler gets very hot during idling. When mixing small amounts of your trimmer, you run using a mixture of the mixture. Mix (shake) the fuel mixture.
S When working near... the fuel cap slowly so that the fuel is obtained. It is adequate ventilation when
handling fuel. Then add the entire
amount of gasoline. Always stop the engine and let it...
Owners Manual - Page 16
...Replace damaged parts. Use only flexible, nonmetallic line recommended by the
manufacturer. Replace the trimmer head or trimmer guard if they have been exposed to start. The safety distance is properly installed ... the machine.
115275126 Rev. 1 9/15/09
English--- 16 Firmly grip the starter rope handle with your hand. then quickly and powerfully pull the cord. Move the blue engine choke...
Owners Manual - Page 18
... gases away from the operator. Function
S The carburetor governs the engine's speed via the throttle control.
Idle Speed Screw--T
WARNING: If the idle speed can contain sparks, which the ...adjusted or repaired.
If the mesh is idling the idle adjustment screw T should also be replaced. The idle speed is impaired. Then, turn the idle adjustment screw--T clockwise until the cutting...
Owners Manual - Page 20
...
Bevel gear (128LD)
The bevel gear...S Clean the cooling fins on the cylinder and check that the trimmer head is not blocked. S Check that the bevel gear is ...find some general maintenance instructions. Daily maintenance S Check throttle trigger and throttle trigger
lockout function. Weekly maintenance S Check the starter and starter cord. S Replace the spark plug. S Check that may damage the...
Owners Manual - Page 22
...handles:
9/8
9/8
Note 1: Equivalent noise pressure level is calculated as the time--weighted energy total for noise pressure levels under various working conditions with shaft
952 711 612
115275126 Rev. 1 9/15/09
English--- 22 The table indicates the highest and lowest values. Trimmer...130/28.7 2,800--3,200 10,000 8,000 1.1/0.8 Yes Yes
128LD
1.7/28 1.4/35 1.130/28.7 2,800--3,200 11,000 8,...
Parts List - Page 1
...) Screw Screw Spring-Trigger Trigger Lockout-Throttle Housing-Throttle (LH) Kit-Switch Handle - Line
Ref.
20. 21. 22. 23. 24. 25. 26. 27. 28.
Assist Bolt Kit-Driveshaft Upper (Incl. 15, & flex) Clamp - MODEL 128LD (Lowes) Page: 1
1
9
2 3
4
7 8
5 6
12
10 11
WARNING
All repairs, adjustments and maintenance not described in the Operator'sManual must be...
Parts List - Page 5
...128LD (Lowes) Page: 5
Service Reference
Note : Due to product improvements, your unit may have a different fan housing assembly.
Serial Number - 2010-72N and lower, please use the following parts: Ref.# 49 - 530015805 - Housing-throttle (RH)
Ref.# 3 - 530016448 - Trigger
Ref.# 7 - 530059804 - Housing-throttle...Date 5/11/12
545192138 Replaces
545192138 - 8/24/10
R
PAR TS LIST
...
Similar Questions
Gas Oil Mix Ratio For Older Model 322l
what is the correct gas oil mix ratio for an older model 322l husqvarna weed eater string trimmer
what is the correct gas oil mix ratio for an older model 322l husqvarna weed eater string trimmer
(Posted by jd3gilbert 11 months ago)
Can Husqvarna 122c String Trimmer Use .095 Line?
(Posted by Anonymous-174049 1 year ago)
128ld Shaft Not Turning Well
Shaft loosened from motor and wore down the plastic gear (?) that spins the shaft. Parts??
Shaft loosened from motor and wore down the plastic gear (?) that spins the shaft. Parts??
(Posted by mrchristrout 1 year ago)
128ld Throttle And Trigger
I'm having a heck of a time trying to put back together the trigger assembly! Non of the videos show...
I'm having a heck of a time trying to put back together the trigger assembly! Non of the videos show...
(Posted by singingmanny 6 years ago)
What Is The Inside Of The Upper Shaft Called
hello i have a husqvarna trimmer and the plastic in the upper shaft is warn out what is this called
hello i have a husqvarna trimmer and the plastic in the upper shaft is warn out what is this called
(Posted by tsharp82 8 years ago)