Hunter 28484 Support Question
Hunter 28484 Support Question
Find answers below for this question about Hunter 28484.Need a Hunter 28484 manual? We have 1 online manual for this item!
Question posted by tttran000 on September 23rd, 2015
Anyone Have Instructions How To Remove The Limiter On These Ceiling Fans.
My fan lights flicker after 2 years use.
Current Answers
Answer #1: Posted by TechSupport101 on September 23rd, 2015 11:47 PM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,285
Member since:
May 24th, 2013 Points: 12,171,285
Related Hunter 28484 Manual Pages
Operation Manual - Page 2
...Operating and Cleaning Your Fan ... 14
12 • Troubleshooting 15
© 2005 Hunter Fan Company
Hunter Fan Company
Your new Hunter® ceiling fan is an addition to your fan. Use only Hunter speed ...fan. Save these instructions.
• Use only Hunter replacement parts. • To reduce the risk of personal injury, attach the fan directly to the manual. If you complete instructions ...
Operation Manual - Page 3
... in this manual include instructions for ceilings 8 feet or higher
For ceilings higher than 8 feet high
Standard Mounting hangs from
the ceiling by a downrod (included),
3
recommended for all three Installer's Choice mounting methods. You can purchase Hunter extension downrods. All Hunter fans use sturdy 3/4" diameter pipe to the ceiling, recommended for ceilings less than 8 feet...
Operation Manual - Page 4
..., as they were shipped. If one fan, keep the fan blades in shipment, return all the instructions in ceiling. • Drill holes for replacement.
1 • Getting Ready
4
Installing Multiple Fans?
Preparing the Fan Site
Before you to the fan parts. To install a ceiling fan, be sure you can direct you begin installing the fan, follow all the blades for and...
Operation Manual - Page 5
Drill two pilot holes into the holes in the ceiling plate.
2-3. read the lead wires from each other. For proper alignment use lubricants on the ceiling plate are pointing towards the ceiling peak.
10/24/2005, 11:04 AM
Hunter Fan Company
Step 2-2
5
Flat Washer
Steps 2-3 - 2-5
3" Screw
42501-01 • 10/24/05
42501 Sunset...
Operation Manual - Page 6
...visible;
Once assembled, do not remove the downrod. 3-3. Raise the fan and place the hook on the adapter to hang down from a flat or angled ceiling,
insert the downrod through the ...washer (lip up toward the ceiling. Loosen the set screw with the holes in these installation instructions.
#8-32 x 3/4" Screw
Step 3-5
U-shaped Hole
Hunter Fan Company
42501 Sunset Boulevard.indd...
Operation Manual - Page 7
...the fan to ...fan to the ground wire from the ceiling • Connect the white wire from the fan to the common wire from the ceiling... • Connect the black wire and the black and white striped wire from the ceiling... back through the ceiling plate hole into the outlet box.
4 • Wiring the Fan
Step 4-3
7
...
Operation Manual - Page 8
...tabs.
2. Press firmly on the ceiling plate. 5-3. Hunter Fan Company
42501 Sunset Boulevard.indd
8
...ceiling plate totally engage with the tabs on opposite sides of the ring towards the canopy. e tabs will snap and lock into the canopy one at a time. Align the slots in the canopy with the slots in , tighten them. 5-5. Using both hands, push the canopy trim ring up to remove...
Operation Manual - Page 9
... tightened. is is normal. 6-3. Remove the blade armature screws and rubber shipping bumpers from the motor.
Insert the second blade armature screw, then securely tighten both armature screws. Install three blade assembly screws through the blade iron, and attach loosely to the fan). 6-1. If you used grommets, the blades may include blade...
Operation Manual - Page 10
... the housing assembly screws.
7-4. Align the keyhole slots in the narrow end of the housing.
7-3. Steps 7-1 - 7-3 Housing Assembly Screw
10
Upper Switch Housing
Step 7-4
Hunter Fan Company
42501 Sunset Boulevard.indd
10
10/24/2005, 11:05 AM
42501-01 • 10/24/05 Install the remaining #6-32 x 3/8" screw into the...
Operation Manual - Page 11
... Remote Transmitter and Receiver
Setting Jumper Switches When two or more fans are very small. Before you can move them most easily using a small pair of pliers or tweezers. Install the included 12... receiver/transmitter for each fan set to a different code, so that may not cause harmful interference. 2. is not connected to the transmitter. For instructions on how to operate this...
Operation Manual - Page 12
... could cause improper operation and damage to the upper switch housing with three #6-32 x 1/2" housing assembly screws.
12
Plug
Connector
Detail
Housing Assembly Screw
Hunter Fan Company
42501 Sunset Boulevard.indd
12
10/24/2005, 11:05 AM
42501-01 • 10/24/05
To attach the lower switch housing, connect...
Operation Manual - Page 13
... with a 12-volt type 23A,
MN-21 battery or equivalent.
10-6. Or, you reach your
High
desired speed.
10-3. e light button turns the light on the wall. Fan Reverse Fan Speed
Medium Fan Off
Fan Light
Steps 10-1 - 10-4
13
Step 10-5
42501-01 • 10/24/05
42501 Sunset Boulevard.indd
13
10/24/2005...
Operation Manual - Page 14
... trapped at the ceiling around the room without causing a draft. A vacuum cleaner brush nozzle can remove heavier dust. Occasionally, apply a light coat of furniture polish for added protection and beauty. Turn on electrical power to cool the room with a furniture polishing cloth. In warm weather, use upward air flow pattern
Hunter Fan Company
42501 Sunset...
Operation Manual - Page 15
...Remove the shipping bumpers.
Tighten the blade bracket screws until snug. 2. Check to the wiring the fan section. 3. If so, replace all blade iron screws. 3.
Problem: Excessive wobbling. 1. Hunter Fan... housing. 4. Problem: Noisy operation. 1. If your fan wobbles when operating, use the enclosed balancing kit and instructions to ensure it is properly seated.
12 • ...
Similar Questions
I Need A Remote To Operate This Fan Was Told The Fan Was Discontinued
(Posted by joanneabatemarco 2 years ago)
Ceiling Fan Hook Up
how do I wire up my Hunter MOD-CAT 21955-380 ceiling fan
how do I wire up my Hunter MOD-CAT 21955-380 ceiling fan
(Posted by kinneyjosh69 3 years ago)
Troubleshooting - Hunter Ceiling Fan 21315-530
Our ceiling fan lights just started to blink when you turn the light on. Sometimes it will stop but ...
Our ceiling fan lights just started to blink when you turn the light on. Sometimes it will stop but ...
(Posted by Robwelker 10 years ago)
Need Hunter Part No. 98378.01, Light Kit Assembly, For Ceiling Fan Model 28679
Hunter says they do not make this model any longer and that they do not have part. Can you help me f...
Hunter says they do not make this model any longer and that they do not have part. Can you help me f...
(Posted by larrypricesimmons 10 years ago)
Where Can You Buy A 22563 Ceiling Fan?
Where can I buy a 22563 ceiling fan?
Where can I buy a 22563 ceiling fan?
(Posted by jimvogt7 11 years ago)