Hotpoint HDA1100NWH Support Question
Hotpoint HDA1100NWH Support Question
Find answers below for this question about Hotpoint HDA1100NWH - 24 Inch Full Console Dishwasher.Need a Hotpoint HDA1100NWH manual? We have 4 online manuals for this item!
Question posted by henle on May 13th, 2013
Clicking Noise
While running dishwasher a noise starts up - a 'clicking' - from what sounds to be the bottom the of the unit, by the motor. Checked to see if there's anything in the intake area that might be floating... Nothing.
Current Answers
Related Hotpoint HDA1100NWH Manual Pages
Energy Guide - Page 1
Dishwasher Capacity: Standard
General Electric Models HDA****N, ADW1***N, GSM2***N,GSC3***N,GSD****N,GHDA3***N
Estimated Yearly Operating Cost
(when used with an electric water heater)
$38
$20
$50
...
Installation Instructions - Page 1
...should be
installed to 3 Hours.
READ CAREFULLY. New installations require more time than replacement installations. See the Owner's Manual for available custom panel kits. The dishwasher MUST be worn. KEEP THESE INSTRUCTIONS.
Optional Accessories - IMPORTANT - Proper installation is the responsibility of this booklet, gloves and safety glasses should immediately contact your...
Installation Instructions - Page 3
... reduce the risk of shock, fire, or injury to persons, the installer must ensure that the dishwasher is ��l�e�ve�l�inside the opening must have a minimum width and depth of 24" and height of 34-1/2" ± 1/4" #fr2o82mFrtehncehfloor to the underside of the countertop.
• The...
Installation Instructions - Page 4
...less than 18" above . When
connecting the drain line to a disposer, check to be made in
a later step. Dishwasher will not drain if plug is connected to waste tee or disposer lower ...cause damage.
307Dia51 Cabinet Preparation
Drill a 1-1/2" diameter hole in the cabinet wall within
307Dia50 the shaded area shown in Figure A for proper drain performance.
32" 18" Min. The drain
hose will be ...
Installation Instructions - Page 5
...connection of 24" from ...by a qualified technician.
18"
Receptacle
18"
Location Area
6"
6"
Alternate Receptacle Location
1-1/2" Dia. Permanent wiring ...Dishwasher Electrical connection is metal, the hole edge must be connected to a grounded metal, permanent wiring system, or an equipment grounding conductor must be run...is properly grounded. Check with a cord protector. Installation Preparation...
Installation Instructions - Page 6
...line, using 3/8" or larger copper tubing. If a power cord with plug is on the left side of the dishwasher. Shut-off Hole
5"
4"
Valve Hot
2" From Cabinet
19" From Wall
5" 4" 6"
Cabinet Face
2" From ... water line must be at least 19" from either side, rear, or floor
within the shaded area shown in an accessible
location, such as the
electrical cable and drain hose, or cut an additional...
Installation Instructions - Page 7
...remove 1/4"
machine thread screws
in this step. Latch the door and adjust springs to install the dishwasher. Do not remove the two top 8-32x1/4"
machine thread screws.
• Slide the access ...Factory-equipped Power Cord
Models Only) -Appendix
STEP 2: CHECK DOOR BALANCE
• With the dishwasher on the wood base, check the door balance by opening and closing the door.
• The door...
Installation Instructions - Page 8
..., available for purchase from the left side of the dishwasher through the strain relief attached to at least 15 inch-pounds of the dishwasher as shown in the
junction box bracket. • Connect power cord white (or ribbed) to
dishwasher white, black (or smooth) to dishwasher black and ground to the house electrical system or...
Installation Instructions - Page 9
...of the cabinet opening to avoid interference with the base of the junction box avoiding contact with anything under the dishwasher. If a longer hose is approximately 78" long. Drain Power
Drain Hose Collection Chamber
Figure M
Drain Port
... through a separate hole cut for no fill, drain, or noise concerns Position utility lines so they do not interfere with the door spring and other...
Installation Instructions - Page 10
...
Check Level Front-to-Back
• Check the tub insulation blanket, if equipped, to back. They should fit in the adjacent cabinet while sliding the dishwasher into position.
10
Figure R
Check ... the holes in the tub opening a few inches at a time. Dishwasher must not interfere with hands or knees when sliding dishwasher into position. Tip: Avoid unnecessary service charges for...
Installation Instructions - Page 11
... If countertop is wood or woodlike material, fasten the dishwasher to the countertop by opening .
Interference with the compression nut.
Check to be centered
in cabinet opening and closing the
488Dia2... Bracket
Side Mount Brackets (optional) 3/4"
Figure T
Tip: Avoid unnecessary service charges for noise or leaks Make sure the door spring does not rub against the elbow and secure
with...
Installation Instructions - Page 12
...;a�in place.
• Connect drain line to the underside of the countertop with Hanger
32" 18" Min.
Min. Secure the hose with hose clamps. Dishwasher Installation
STEP 15: CONNECT DRAIN LINE
The molded end of the drain hose will fit 5/8" through the cabinet opening. Secure the
connection
with a screw type...
Installation Instructions - Page 13
.... listed anti-oxidant compound and aluminum-to-copper connectors.
• Secure house wiring to the back of the dishwasher. ■ Check to the instructions on the hot water faucet at the source. ■ Open the dishwasher door and remove all foam
and cardboard packaging. ■ Read the Owner's Manual to verify that harness...
Installation Instructions - Page 14
...
■ At the end of debris.
■ Let the dishwasher run through another fill and drain cycle. For dial models, unlatch ...START RESET
-
Check the drain line for leaks under the dishwasher. Cycles
Pots Heavy Normal Hot Hi-Temp Heated Reset & Pans Wash Wash Start Wash Dry
Cycle on - Check the electrical connection to 4 minutes. Not all models have pushbuttons.
■ Check to start...
Installation Instructions - Page 15
...16 x 3/8"
Sheet Metal Thread Screws
Figure AA
Tip: Prevent tub damage and reduce sound from under the dishwasher Use the machine thread screws in the top holes and the sheet metal thread screws in... the top holes in the proper location. The 10-16 x 3/8" screws are not
interchangeable. Dishwasher Installation
STEP 20: REPLACE ACCESS PANEL AND TOEKICK
In this step you will need the panels and...
Quick Specs - Page 1
..., 1993
Wood Insert Cut-Out Dimensions (in inches)
25-3/4 MAX.
24
23-3/8
34 MIN. adj. from cabinet
C
1-1/2 1/2
water line on adequately wired 120-volt, 15-amp circuit having 2-wire service with a separate ground wire.
Hotpoint Built-In DishwasGheEr/Hotpoint/RCA
Dishwasher Dimensions (in inches) HDA1100N - This wall area must be free of pipes or wires...
Quick Specs - Page 2
...; motor - Resists chipping and staining, holding up to keep the kitchen peaceful and quiet • Durable tub and door liner - Grinds leftover food into small particles that are easily
washed away • Model HDA1100NWH - White, with ExtraFine™ filter - Hotpoint Built-In Dishwasher
Features and Benefits
• 4-level PowerScrub™ wash system - Runs quietly...
Use and Care Manual / Warranty - Page 9
...dishwashing detergent tabs, simply place one month. Too much detergent with dishwashers.
9
Troubleshooting Tips
Consumer Support A snapping sound...dishwasher. A full dispenser should last about one tab in a glass and let the water
Use Jet-Dry® Rinse Agent
run...it releases. Using the dishwasher
ge.com
Safety Instructions
Operating Instructions
Check the Water Temperature
The...
Use and Care Manual / Warranty - Page 13
... of the sounds • ...Dishwashing Detergents have an air gap, clean it.
• Check to pump water out.
• Timer control as cycle progresses.
• Detergent cup opening.
• The motor...dishwashers.
• To remove suds from the circuit.
• Try pressing the START/RESET pad (Electronic models) two times. Contact a water softener company. minerals
• Run dishwasher...
Use and Care Manual / Warranty - Page 15
... Authorized GE Service location.
I Damage caused after delivery. If the product is located in an area where service by our Factory Service Centers, or an authorized Customer Care® technician. Safety Instructions
Operating Instructions
GE Dishwasher Warranty
All warranty service provided by a GE Authorized Servicer is not available, you may be responsible...
Similar Questions
Hotpoint Aquarius 1100 Washer Will Not Work
MACHINE WAS MAKING A CLONKING NOISE (POSSIBLE BEARING GONE)WHEN ON SPIN...HAD A LEAK FROM STOP COCK ...
MACHINE WAS MAKING A CLONKING NOISE (POSSIBLE BEARING GONE)WHEN ON SPIN...HAD A LEAK FROM STOP COCK ...
(Posted by anolanjones 11 years ago)
Dishwasher Will Not Pump Out The Water To The Drain
I recently purchased the model HDA2100VWW dishwasher. It will not pump the water out of the tub.
I recently purchased the model HDA2100VWW dishwasher. It will not pump the water out of the tub.
(Posted by kelliot9 11 years ago)
Dishwasher Racks Are Rusting. Are They Under Warranty Or Can They Be Replacerd
Dishwasher is 6 years old and works fine.
Dishwasher is 6 years old and works fine.
(Posted by 22stuart 11 years ago)
Under The Sink Dishwasher
(Posted by Anonymous-48550 12 years ago)
Dishwasher Runs Through Cycle But Makes A High Pitched Whining Noise.
Dishwasher is a Hotpoint, model HDA2000TBB
Dishwasher is a Hotpoint, model HDA2000TBB
(Posted by mgs61 12 years ago)