Hoover UH70400 Support Question
Hoover UH70400 Support Question
Find answers below for this question about Hoover UH70400.Need a Hoover UH70400 manual? We have 1 online manual for this item!
Question posted by pboren01 on January 5th, 2013
Hoover Fh50240 Maxextract77 Carpet Shampooer
new clean water tank but will still not dispense soap, just water. any idea's???
Current Answers
Related Hoover UH70400 Manual Pages
Manual - Page 1
..., please call Customer Service at 1-800-944-9200 Mon-Fri 8am-7pm EST. All rights reserved. #961101001-01 ID 100148-R0 página E1
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE.
Manual - Page 2
... bottom of vacuum)
Contents
Important Safety Instructions 3 Vacuum Assembly 5
Carton Contents 5 Attach Handle 5 Attach Dirt Cup 5 Position Tools 5 How To Use...6 Vacuum Description 6 ...Cleaning 8 Maintenance...9 Dirt Cup...9 Filters...10 Brushroll...11 Belt...12 Troubleshooting 13 Service...14 Warranty...15
If you for choosing a HOOVER® product.
CODE
Hint: Attach your HOOVER...
Manual - Page 3
...loose clothing, fingers, and all controls before operating. • Operate vacuum only at bottom of cleaner. • Do not leave appliance when...Fully assemble before unplugging. • Use extra care when cleaning on stairs or furniture, as it may be followed, ... , has been dropped, damaged, left outdoors, or dropped into water, take it to a service center prior to continuing use. &#...
Manual - Page 4
...plug does not fit fully in any way.
! Turn cleaner OFF and unplug it still does not fit, contact a qualified electrican to clean out hose as follows:
1. When cleaner is wider than the other). Empty dirt cup. 3. This plug will fit in a polarized ... the plug in the outlet, reverse the plug. When the thermal protector activates the cleaner will deactivate and cleaning may continue.
Manual - Page 5
... parts from carton and identify each item shown. Stair Hose*
*Available on back side of vacuum.
1.5
1.6
B
5 Attach handle
1.2 Press lever (A) and Insert handle section into vacuum base.
1.3 To remove handle, press lever (A) again and pull handle out of vacuum base.
1.2
A
Attach dirt cup
1.4 Place bottom of packing materials. Press down on the dirt...
Manual - Page 6
..., push switch again.
ON/OFF Brushroll Switch 6. Dirt Cup 9. Rinsable Filter Access 11. 3-in-1 Combination Tool 12.
2. To turn vacuum OFF, push switch again. HOW TO USE
Vacuum Description
1. D-Grip Handle 2. To turn vacuum ON, push ON/OFF switch (A) once. Filter made with HEPA media 10. Cord Release 18.
Hose 13. Hose Connection...
Manual - Page 7
... Proper Tool
3-in such places as dresser drawers, upholstered furniture, stairs and baseboards. Use Upholstery Tool to clean upholstered furniture, draperies, mattresses, clothing, and carpeted stairs. operating position for reaching hard to clean areas. The vacuum is in upright position. Removing Hose
3.2
3.2 To remove hose for tool use when handle is ready for tool...
Manual - Page 8
... the end of stairs on stairs or
furniture, as it may attach the hose to remove. For extended cleaning reach, you may result in injury or damage.
8 Unplug vacuum before connecting wand or tools. Attach Wand and Tools
!
To remove tool, twist and pull apart gently.
*Available on select models only
3.3
Stair...
Manual - Page 9
... the dirt cup release button to secure.
4.4 Place bottom of your vacuum will ensure continued cleaning effectiveness.
When using the vacuum for this type of injury from moving parts, unplug vacuum before servicing. CAUTION !
Press firmly to secure into vacuum body first. 4. Place the vacuum in the upright position before the dirt cup reaches the max...
Manual - Page 10
...use .
! Rinse with water for Hoover® Part No. 303902001.
4.8
A
4.9
10 Allow 24 hours for Hoover® Part No. 303903001. This may take up to Clean
!
CAUTION !
Rinsable ...properly, your Rinsable Filter should be cleaned every two months under normal use vacuum without dirt cup or filters in place.
4.5
4.6
Rinsable Filter: How to Clean
Remove dirt cup as shown in ...
Manual - Page 11
... to Clean
! Clear away debris or obstructions from moving parts, unplug vacuum before ...HOOVER® service provider at 1-800-944-9200.
4.15 Vacuum is fully cleared.
4.14
11
4.15
A
B
To reset the brushroll, press the reset button (B) located on the top of the dirt cup.
4.12 Dirt and debris can cause damage. HOSE: How to flash red after resetting, the brushroll may still be cleaned...
Manual - Page 12
... be checked from time to time to be sure it as shown with your vacuum.
How To Replace
Place handle in the low position and turn the cleaner over... install the 6 screws as shown place belt in good condition. When purchasing a new belt, ask for Belt - To check the damaged belt, refer to Buy
Use only genuine HOOVER® belts with a Phillips screwdriver.
4.17 Lift off bottom plate (A).
4.18...
Manual - Page 13
...Dirt cup full.
1. Dirt cup not installed correctly. 2. Review hose installation - Review filter removal and cleaning - pg 6
2. Brushroll is off
1.Press the brushroll on/off switch - Belt broken or stretched.
... or filter
1. Broken or worn belt.
3. pg 11
1. Unplug and allow vacuum to cool for 30min. (This willl reset the thermal protector)
4. Press brushroll reset...
Manual - Page 14
... parts. (The model number appears on the bottom of authorized service outlet locations call 1-800-944-9200; Customers) or hoover.ca (Canadian customers). If you . • For an automated referral of the vacuum.) Please do not return this product to find the service outlet nearest you need further assistance: To speak with...
Manual - Page 15
... FROM ANY CAUSE WHATSOEVER. For additional assistance or information concerning this Warranty. In Canada, contact Hoover® Canada, Carson Building, 100 Carson St., Etobicoke, Ontario M8W 3R9, Phone: 1-800...to misuse, acts of God, nature, vandalism or other acts beyond the control of Hoover® products. This warranty gives you may not apply to correct any replacement or repair...
Similar Questions
Plastic Cover For Hoover Carpet Cleaner Fits Over Beater Bar To Water Tank Part#
Part # for above hoover Carpet cleaner fh50700. Lost the cover need to get a new one.
Part # for above hoover Carpet cleaner fh50700. Lost the cover need to get a new one.
(Posted by bryankeithrowe 1 year ago)
Seal On The Uh70400 Red Suction Tube
I don't know the proper name for this part but all the dirt is sucking up into the red tube & fi...
I don't know the proper name for this part but all the dirt is sucking up into the red tube & fi...
(Posted by mlallenx3 2 years ago)
When I Use My Hoover Spin Scrub Carpet Shampooer It Lets Off A Burning Smell. Wh
(Posted by judypaz0414 8 years ago)
On A Uh70400 There Is A Bracket That Supports The Rear Wheels. What Is It Called
What is the name of the bracket that supports the rear wheels on a UH70400? It is pictured on the pa...
What is the name of the bracket that supports the rear wheels on a UH70400? It is pictured on the pa...
(Posted by kevinflahertycontracting 11 years ago)
Carpet Is Too Thick
My vacuum is only a couple of months old. I have just had new carpet installed. It is virtually impo...
My vacuum is only a couple of months old. I have just had new carpet installed. It is virtually impo...
(Posted by magjag1960 13 years ago)