Hoover UH70210 Support Question
Hoover UH70210 Support Question
Find answers below for this question about Hoover UH70210 - WindTunnel T-Series Pet Rewind.Need a Hoover UH70210 manual? We have 1 online manual for this item!
Question posted by chadekao on August 1st, 2013
No Floor Solution Spray Max Extract 77
The hand hose works. The pump changes pitch if you pull the trigger or push the handle slide. Sucks and spins fine. No Leaks
Current Answers
Related Hoover UH70210 Manual Pages
Manual - Page 1
... 1-800-944-9200 Mon-Fri 8am-7pm EST. THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY. IF USED COMMERCIALLY WARRANTY IS VOID.
©2010 Techtronic Floor Care Technology Limited. página E1
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE.
PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE...
Manual - Page 2
...Cup 5 Position Tools 5 How To Use...6 Vacuum Description 6 On-Off Switch 6 Suction Only Mode 6 Cord Rewind and Storage 6 Folding Handle 6 Carpet Height Adjustment 7 Tools ...7 Select Proper Tool 7 Removing Hose 7 Attach Wand And Tools 7 Stair Cleaning 8 How To Clean Tools 8 Maintenance...8 Dirt Cup...9 Filters...9 Brushroll...11 Hose...11 Powered Hand Tool 11 Headlight...12 Belt...13...
Manual - Page 3
...HANDS AFTER HANDLING.
3 Use only manufacturer's recommended attachments and products. • Do not use cord as a handle, close a door on floor...Operate vacuum only at bottom of stairs on cord, or pull cord ..., unless the cleaner is not working as a toy. Unplug from outlet... by pulling on stairs or furniture, as gasoline, or fine wood ...• Hold plug when rewinding onto cord reel. Do ...
Manual - Page 4
...carpet, rugs, furniture and flooring, avoid tipping cleaner or setting...Do not use . PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE.
4 Do not change the plug in a dry place. IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE. CAUTION: TO... during tool use sharp objects to turn while product is turned on and handle is wider than the other).
Questions or concerns? Always put the cleaner ...
Manual - Page 5
... Hand Tool Clip E.
Make sure all parts from images shown. Handle* B. Push down firmly.
1.3 Using a Phillips screwdriver, fasten (1) screw behind handle into vacuum base.
1.2
1.3
Attach dirt cup
1.4 Place bottom of handle. Dirt Cup
1.1
A
*Varies per model) Note: Remove the screw located in the vacuum base and set aside until secure.
1.6 Place Crevice Tool into Wand and slide...
Manual - Page 6
... vacuum is reached.
Do not allow plug to release cord from images shown. 6 FOLDING HANDLE for bare floors and tool use.
(Available on select models only)
2.3
2.3 For optimal cleaning performance on side of the plug and pull to whip when rewinding. Dirt Cup Release Button 4. Powered Hand Tool** 16. Handle Release Pedal 20. Hose Tube 21.
A
IMPORTANT When pulling...
Manual - Page 7
... knob to push, push down and turn while product is turned on furniture, fringed area rugs, or carpeted stairs during tool use , press the hose release button and pull hose end out. Select Proper Tool
(Tools may be used for reaching hard to your hose.
WARNING
Unplug vacuum before connecting Powered Hand Tool. IMPORTANT
If the vacuum is used...
Manual - Page 8
...hose connector, hose, dirt cup inlet, cyclonic filter, Rinsable filter, and HEPA filter. 4. PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION...as proper use and
care of stairs on floor. MAINTENANCE
4.1 Familiarize yourself with a detergent...vacuum standing on stairs when not cleaning.
3.4
3.5
3.5 Use the Hose and Powered Hand... brushroll off by Stair Cleaning Handle and position on stairs.
Clean...
Manual - Page 9
...cup out.
4.3
A 4.4
4.4 Hold dirt cup over trash receptacle, push dirt cup door release lever (B) to open .
4.7 Pull on both sides of dirt cup into place.
4.5
Filters: When to ...vacuum in Fig. 4.3.
4.6 Pull up to open dirt cup door (C). A To reduce the risk of injury from images shown. Very fine materials, such as described in the upright position before the dirt cup reaches the max...
Manual - Page 10
... to Clean
(Available on filter with HEPA media. Do not use vacuum without dirt cup or filters in place.
4.9
A
4.10
Remove dirt cup as described in slots, pull filter frame (A) straight out. Actual model may need replacement
within the warranty period. Slide back into position.
4.12 The Hoover® emblem and center lines...
Manual - Page 11
Rotate red upper latch (A) counterclockwise.
4.14 Slide red lower latch (B) to the unlock position.
4.15 Pivot out bottom plate and remove any debris and/ or hair from brushroll. CAUTION ! Do not use , press the hose release button (A) and pull hose end out. To lock back into place, push hose into position. Replace bottom plate by aligning tabs...
Manual - Page 12
...
Press Handle Release Pedal and place handle in low position. 4.21 Using a Phillips screwdriver, remove (2) screws as shown and lift off bottom plate.
4.27 Remove used belt from brushroll (C) then from images shown. 12 Push new bulb straight into socket until locked in good condition.
Rotate red upper latch (A) counter clockwise.
4.25 Slide red...
Manual - Page 13
...1-800-944-9200
4.28 With lettering on outside of belt, slide new belt over metal pulley*, then slip around area of brushroll ... shown.
When purchasing a new belt for models with your vacuum. Rotate back into nozzle making sure that the brushroll end ...metal rod) (E). HOOVER® part No. 38528058 or AH20080.
Slide red lower latch to Lock position, and rotate red upper latch clockwise...
Manual - Page 14
... Hoover® dealer.
1. Dirt cup full.
1. Empty dirt cup - Pg. 9.
2. Review Hose installation - Pg. 7.
4. Blockage. 3. Check items under "Vacuum won 't pick up or Low suction
Cord Rewind does not work Dust escaping from brushroll -
Pg. Too much pressure being cleaned - Low vacuum suction.
1. Continue using the checklist below. Replace brushroll belt - Pg. 13...
Manual - Page 15
... outlet nearest you need further assistance: To speak with a customer service representative call 1-800-944-9200. If you . • For an automated referral of the vacuum.) PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE.
15 6. Service
To obtain approved Hoover® service and genuine Hoover® parts, locate the nearest...
Similar Questions
Hoover Windtunnel T Series Pet Rewind Turned Off While Vacuuming And Wont Turn
back on
back on
(Posted by DocfKazi 9 years ago)
Hoover Windtunnel T-series Pet Rewind Plus Upright Vacuum Bagless, How To
unclog
unclog
(Posted by egypzodi 9 years ago)
Help With Hoover Windtunnel T-series Pet Rewind Vacuum Wont Turn On
(Posted by mrbaz 10 years ago)
Wont Turn On Hoover Windtunnel T-series Pet Rewind Plus Upright Vacuum Bagless
uh70210
uh70210
(Posted by rerecjrot 10 years ago)
My Hoover Windtunnel T-series Pet Rewind Bagless Upright Vacuum Wont Turn On.
I cleaned out underneath and emptied it and it won't turn on. Plugged into different plugs and still...
I cleaned out underneath and emptied it and it won't turn on. Plugged into different plugs and still...
(Posted by megancorgan 11 years ago)