Hoover SH40060 Support Question
Hoover SH40060 Support Question
Find answers below for this question about Hoover SH40060.Need a Hoover SH40060 manual? We have 1 online manual for this item!
Question posted by earlchambers on September 9th, 2012
Hoover Motor Assembly Part 440001582
Instructions on how to replace the motor assembly on model sh40060?
Current Answers
Related Hoover SH40060 Manual Pages
Manual - Page 1
... NOT RETURN THIS PRODUCT TO THE STORE. Owner's Manual
Operating and Servicing Instructions
Español -
IF USED COMMERCIALLY WARRANTY IS VOID.
©2010 Techtronic Floor Care Technology Limited. Questions or concerns? página E1
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE. THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY.
Manual - Page 2
Be sure to register your product online at hoover.com. Model
MFG. Mon- Fri 8am- 7pm EST.
CODE
Hint: Attach your HOOVER® product. Verification of date of purchase may be required for choosing a HOOVER® product. Manufacturing code
(Label located on bottom of cleaner)
Contents
Important Safeguards 3 Cleaner Assembly...5
Carton Contents...5 How To Use...6
Cleaner...
Manual - Page 3
...or appliance with damaged cord or plug. IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
When using an electrical appliance, basic precautions should ... this appliance before connecting or disconnecting either hose or motorized nozzle. • Unplug before unplugging. • ...RISK OF FIRE, ELECTRIC SHOCK OR INJURY:
• Fully assemble before cleaning or servicing. • Do not use . ...
Manual - Page 5
... (E) until Latch
clicks. Telescoping Extension Wand
E. IMPORTANT
The flexible hose contains electrical wires for connection to disconnect from nozzle.
1.4 G
5 Actual model may vary from carton and
identify each item shown. Cleaner ASSEMBLY
Carton contents
A. 1. Connect Wand 1.3
1.3 Push Hand Grip
D
(D) firmly into end of Wand and pull
apart. Power Nozzle
F. Canister
1.1
B.
Manual - Page 6
...the dirt cup)
4. Pre-Motor Filter Cover
5. Dirt Cup Quick Release Button
12.
Do not exceed the cord length beyond the red mark.
2.4
Actual model may vary from whipping which ...the power cord indicates the recommended cord length. Cyclone Separator
2.1 1
(Located inside of the vacuum cleaner.
HOW TO USE
Cleaner Description
1. IMPORTANT
When rewinding the power cord, guide the ...
Manual - Page 7
...and storage.
2.9
7 Actual model may be used for grooming a pet
Storage
2.9 For convenience there is a parking slot located at bottom of the vacuum cleaner where the floor tool and... lighting fixtures, blinds, baseboards, shutters and registers.
D.
Brushroll off : Vacuums hard floors. Brushroll off : Vacuums hard floors.
! Power Nozzle: May be attached directly to the hand grip...
Manual - Page 8
...electrical outlet. 2. Very fine materials, such as follows:
1. When cleaner is unplugged and motor cools for this happens proceed as face powder or cornstarch, may vary from images shown. ... close the dirt cup door and replace.
3.1
3.2
Actual model may seal the filter and cause a reduction in place. If this type of personal injury, unplug vacuum before the dirt reaches the fill line...
Manual - Page 9
... water.
3.3
3.4 3.5
Filters
Pre-Motor Filter
3.6
3.7
! To reduce the risk of personal injury, unplug vacuum before servicing.
CAUTION !
To reduce the risk of personal injury, unplug vacuum before servicing. Do not use any detergents or boiling water to air dry for Hoover® Part No. 304285001.
9 Actual model may vary from the filter assembly with a towel or...
Manual - Page 10
... filter is available.
Actual model may vary from images shown. 10 What to Clean
3.10 The Post-Motor filter is recommended that the Pre- To reduce the risk of vacuum cleaner and replace filter door. and Post-Motor filter should be rinsed in place.
3.10
3.11
When to air dry for Hoover® Part No. 304286001...
Manual - Page 11
...3.18 Turn power nozzle over to hose. To reduce the risk of personal injury, unplug vacuum before servicing. Remove any obstructions.
3.16 Remove power nozzle from images shown. 11 Low suction... 3.18
3.15 3.17 3.19
Actual model may vary from wand and attach wand to bottom. CAUTION ! Remove any blockages.
3.17 Remove power nozzle from the vacuum cleaner by pressing the release button on ...
Manual - Page 12
...
3. Broken or worn belt.
2. Brushroll switch set to "ON".
4.
Replace brushes.
1. Refer to Maintenance section regarding the filters - 4. To reduce risk... the Dirt Cup from the vacuum
The vacuum cleaner not run
Power nozzle agitator brushroll won 't run...it to Maintenance section regarding the filters - The motor Thermostat may be solved quite easily when the cause is...
Manual - Page 13
... Service Dealer (Depot) by the complete model number when requesting information or ordering parts. (The model number appears on the bottom of authorized service outlet locations call 1-800-944-9200; This will only result in Glenwillow for service. Customers) or hoover.ca (Canadian customers). Always identify your vacuum to find the service outlet nearest...
Manual - Page 14
... PRODUCTS LIABILITY OR ARISING FROM ANY CAUSE WHATSOEVER.
During the Warranty Period, Hoover® will provide labor and parts, at www.hoover.com. THIS WARRANTY IS THE EXCLUSIVE WARRANTY AND REMEDY PROVIDED BY HOOVER®. However, if you , to correct any replacement or repair performed under the laws of the state of the product...
Similar Questions
How Can You Dismantle And Replace Battery For Model #53020
(Posted by tdkipswich 5 months ago)
How To Remove Agitator Bar On Sh40060 Hoover Vacuum
I need to change the belt on my SH40060 as it broke. How does the agitator bar come off?
I need to change the belt on my SH40060 as it broke. How does the agitator bar come off?
(Posted by agggilli 12 years ago)