Hoover FH40010B Support Question
Hoover FH40010B Support Question
Find answers below for this question about Hoover FH40010B.Need a Hoover FH40010B manual? We have 1 online manual for this item!
Question posted by fran34 on July 23rd, 2014
Model Fh40005. How Disassambly Upper Handle From Body Of Cleaner?
How put in his place rubber ring that connect with upper part of recovery tank for make vacum and suck dirtywater and debrits from floor. This is a model FH40005.
Current Answers
Related Hoover FH40010B Manual Pages
Manual - Page 1
...
Español - All rights reserved. #960009623 ID100507-R0 THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY. página E1
FloorMate™ SpinScrub® Hard Floor Cleaner
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE.
Questions or concerns? IF USED COMMERCIALLY WARRANTY IS VOID.
©2009 Techtronic...
Manual - Page 2
... under cleaner)
Contents
Important Safeguards 3 Cleaner Assembly...5
Carton Contents 5 Attach Handle...5 Install Brushes and Nozzle 5 Unfold Handle...6 How to Fold Handle 6 How To Use...6 Cleaner Description 6 ON/OFF Switch...6 Handle Release Pedal 6 Transporting...7 Mode Selector Dial 7 The Tanks ...8 Filters...9 How To Clean...10 Recommended Cleaning Sequence 10 Cleaning Floors 10...
Manual - Page 3
... not in use flammable or combustible materials such as a handle, close door on bare floors or sealed wood floors. See "Grounding Instructions". • Do not clean over cord. IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
When using recommended chemicals with the cleaner. NOT for use without tanks in areas where they may be used by the...
Manual - Page 4
...adapter must be connected to freezing temperatures. • Do not use with this plug to clean a floor. • Use only commercially available Hoover® cleaners intended for its.... This appliance is used, it should be used only until a properly grounded outlet (B) can
result in place by the Canadian Electrical Code.
1
B
2
A
C
D
GROUNDING OUTLET BOX
F
D
G
E
4...
Manual - Page 5
... assembly. Align post (A) on brush block with opening (E) on cleaner. Nozzle E. Attach handle
1.2 Rotate bottom handle support (A) up to the upright position until a snap is felt.
1.3 Align control rod (B) on the
floor.
Turn brushes slightly until you hear it rests on upper handle (C) with slot in place.
1.3
C D B
1.5
1.7
5 Make sure all the way down until post fits easily into...
Manual - Page 6
...
behind nozzle)
12. Clean Water Solution Tank
5
4
20
7. Dirty Water Tank: collects dry
debris as well as dirty cleaning solution 11. Soft-tread Wheels
cleaner.
16. Clean Water Solution Tank
Release
6
8. Nozzle Release Buttons: release 15
8
18
9 10 11 19
nozzle for
drying and vacuuming
5. Upper Handle Release Button
This cleaner is intended for
quick cord release
19...
Manual - Page 7
... instructions.
2.6
2.7
A
VACUWUAMSDHRY
7
Transporting
2.4. Refer to "How to the VACUUM position.
To move your cleaner from room to room, put handle in upright position, tilt cleaner back on rear wheels and push forward.
2.5 The cleaner may also be lifted using the carrying handle (A) on the front of the cleaner.
2.4
2.5
A
Mode selector dial
2.6 The Mode selector dial (A) turns the...
Manual - Page 8
... it with warm water.
2.12 If rubber ring (E) on cap has become dislodged, reposition it locks in place for worn spots or joint separations before using, as these conditions could lead to damaged flooring when using water, use cleaning concentrates that is to prevent leaking.
2.14 Slide tank straight into tank (C). Check for proper performance and...
Manual - Page 9
...Tank be cleaned by tapping the filter or gently brushing using your hand. Allow filter to Empty
Turn cleaner off and disconnect from electrical outlet.
The filter screen may also be emptied after dry vacuuming... pleated filter in place. Dirty Water Tank (lower tank)
Automatic "Shut Off"
An automatic suction shut-off is built into cleaner body until it is locked in the tank lid.
2.19 ...
Manual - Page 10
... HOOVER® FloorMate™ SpinScrub® Cleaner to: • VACUUM: Vacuum to WASH position. The brushes will pick up the dirty solution. Turn Mode selector dial to the WASH position.
When cleaning sealed wood floors, make sure all areas are raised off . Fill Clean Water Solution Tank with water. Turn cleaner ON.
3.2 To release solution, squeeze trigger...
Manual - Page 11
... the spill.
! Do not use the cleaner to Clean
Your carpet cleaner is equipped with a damp cloth.
4.4 To replace nozzle, make sure latches (D) are out.
MAINTENANCE
Familiarize yourself with opening (F) on cleaner.
4.5 While holding nozzle in place, slide latches inward to exceed 1/4 inch in depth) on non-carpeted floors. Any other servicing should be in the...
Manual - Page 12
..., align post (C) on brush block with hole (D) on bottom of nozzle with opening (G) on cleaner.
4.10 While holding nozzle in place, slide latches inward to Remove
Place handle in place.
Remove tanks to upright position. Allow to air dry.
• Press on upper handle release button to motor bearings.
12 Do not use a solvent based detergent.
Do not...
Manual - Page 13
... the ON/OFF switch again to turn cleaner ON.
Tanks not in place.
5. Make sure tanks are properly positioned. Make sure Nozzle is empty.
1. Won't pick up dirty solution
1. Make sure Dirty Water Tank is found by an authorized service representative.
! Empty Dirty Water Tank.
4. Make sure Filter and Filter lid are locked in place. Blown fuse or tripped breaker.
1. If...
Manual - Page 14
... ordering parts. (The model number appears on the bottom of the vacuum.) Please do not return this product to find the service outlet nearest you need further assistance: To speak with a customer service representative call1-800-263-6376; Do not send your vacuum by :
• Checking the Yellow Pages under "Vacuum Cleaners" or "Household". •...
Manual - Page 15
... intended for use Hoover® brand
detergents, wipes, and spot cleaners available at
Hoover.com and retailers nationwide.
15
For optimal performance...
Platinum
Collection® Collection®
Deep
Professional Pet Plus
Product Name Cleansing Premium Pet
Oxy
Anti-Allergen1 Hard Floor
Strength
Hoover® Quick & Light™
PPP P
PP
Hoover® SteamVac®
P
P
P
...
Manual - Page 16
... normal household use outside of shipping will be extended by the original owner.
Military Exchange and outside the country in the United States, U.S. HOW TO MAKE A WARRANTY CLAIM If this Warranty. In Canada, contact Hoover® Canada, Carson Building, 100 Carson St., Etobicoke, Ontario M8W 3R9, Phone: 1-800-2636376, Mon-Fri...
Similar Questions
We Are Missing The Long Screw That The Attaches The Handle To The Body
We are missing the long screw that attaches the handle to the body of hoover floormate deluxe hard f...
We are missing the long screw that attaches the handle to the body of hoover floormate deluxe hard f...
(Posted by matthewpolivo 1 year ago)
Disassambly
How to disassamble upper handle from body cleaner?. I need put in his place rubber ring package that...
How to disassamble upper handle from body cleaner?. I need put in his place rubber ring package that...
(Posted by fran34 9 years ago)
How Do You Remove Handle On Hoover Spin Scrub Fh40010b
The handle snaps in place when installing. But I need to know how to take it back off.
The handle snaps in place when installing. But I need to know how to take it back off.
(Posted by jim606 12 years ago)
How Do You Take The Upper Handle Off To Repack The Cleaner
(Posted by dvmiller 12 years ago)