Hoover F5912-900 Support Question
Hoover F5912-900 Support Question
Find answers below for this question about Hoover F5912-900 - 5-Brush Turbo 5200 Steam Vac.Need a Hoover F5912-900 manual? We have 1 online manual for this item!
Question posted by creolagreen on May 15th, 2012
Extractor Panel
How do you put back small panel you use for optional cleaning tool. It came out and having hard time putting it back (won't snap in).
Current Answers
Related Hoover F5912-900 Manual Pages
Product Manual - Page 1
... product to the store.
Owner's Manual
Operating and Servicing Instructions
Español - página E1
www.hoover.com
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE. IF USED COMMERCIALLY WARRANTY IS VOID.
©2011 Techtronic Floor Care Technology Limited. All rights reserved. #961151012 ID103222-R0 Questions or concerns? THIS PRODUCT IS INTENDED...
Product Manual - Page 2
... How To Use...7
Cleaner Description 7 The Tanks ...8 Brush Speed Selector 9 Brush Indicator ...9 How To Clean...10 Before You Begin 10 Cleaning Carpet 10 Clean Surge® Button 11 Picking Up Spills 11 Cleaning Bare Floors 12 Tools...13 Using The Tools 13 How To Attach...14 Before Using Tool 14 Cleaning Carpeted Stairs 14 Cleaning Upholstery 15 After Using Tool...16 After Cleaning...16...
Product Manual - Page 3
... where they may cause hazards. • The use of this manual.)
• Use only on surfaces moistened by the cleaning process or small spills. Do not immerse product.
• Connect to a Authorized Hoover® Warranty Service Dealer. • Close supervision is necessary when any time. • Do not point tools toward people or pets. • To...
Product Manual - Page 4
... plugged in. • DO NOT USE THIS EXTRACTOR ON HARD FLOORS UNLESS YOU HAVE THE PROPER
HARD FLOOR ATTACHMENT. NOTE: In Canada, the use with carpets until they are dry. ...Use indoors only. • Do not put any object into an appropriate outlet (B) that may be connected to a permanent ground (G) such as to whether the outlet is properly grounded. Check with the carpet cleaner...
Product Manual - Page 5
... only)
1.3 Slide hose holder onto screws in place and use screw driver to back of handle, but do not add nuts yet. Hose Holder* E.
Cleaner ASSEMBLY
Carton contents
1.1
A
B
C
Carpet Upholstery
Cleaner
Carpet Upholstery
Cleaner
Bare floor cleaner
D
PreCleaner
E
F
A. NOTE: Phillips screwdriver needed for assembly. Tool Holder with your model may vary from carton and identify...
Product Manual - Page 6
...(G) into slots on back of cleaner.
Break-Away Door
1.8 The tool cover is pushed open too far. Insert projections on holder into clip next
to snap
in place.
1.7
1.6
K
...Tool
(Available on select models only)
Cleaning Tool
1.7 To store cleaning tool, open tool door, place nozzle in bracket and fit it is designed with converter
H
end of tools storage area. Push cover down to snap...
Product Manual - Page 7
... DAMAGE YOUR FLOOR.
Hose* 4. Brush Speed Selector: HI, LO,
or OFF 12. Hood 14. Solution Trigger 17. ON/OFF Pedal 23. DO NOT USE THIS EXTRACTOR ON HARD FLOORS UNLESS YOU HAVE THE PROPER HARD FLOOR ATTACHMENT. Clean Water Solution Tank 8. Solution Tube Connection* 15. Hose Hooks* 19. CAUTION ! 2. HOW TO USE
Cleaner Description
1. Clean Surge® Button* 3. Dirty...
Product Manual - Page 8
... the top of HOOVER® Detergent (use . How to Empty
Step on handle release pedal and lower handle until it to fill line (5 ounces) with HOOVER® Hard Floor Cleaning Detergent. For bare floors:
Fill cap to fill line (B) (1 gallon) with HOOVER® Spot and Stain Spray Cleaner. Fill tank to fill line (5 ounces...
Product Manual - Page 9
... to the desired setting before cleaning.
2.11
OAFgFitatoLrOSHpIeed
2.12 Brush indicator
2.12 The brush indicator will spin (F) when the
carpet cleaner is turned ON,
the brushes are not rotating.
for cleaning carpets and bare floors when brushing is not desired. (See "Picking Up Spills" section on
all sides before cleaning. There are
rotating. Snap cover back into position.
2.13...
Product Manual - Page 10
...time for cleaning only using hot tap water with cleaning tool attachments. Dry hands and plug cord into tufts and folds. To avoid walking on damp carpet, start at least ten minutes. Use a crevice tool...scrub brush if necessary.
turn carpet cleaner ON.
3.2 Squeeze trigger to a non-wood hard floor surface or place waterproof material (e.g. If no detergent in the upper Clean Water...
Product Manual - Page 11
... one area. Release trigger and slowly push carpet cleaner forward over the spill initially with brushes turned OFF in faster drying of carpet or spots. For heavily soiled areas, repeat back and forth cleaning motion.
Picking up spills on bare floors, use the SteamVac® carpet cleaner to exceed 1/4 inch in the OFF position (this...
Product Manual - Page 12
... the direction as shown, place attachment on hardwood floors.
R BOARTEAFLTOOERON
Cleaning bare floors
How to attach bare floor attachment
(available at additional cost if not included with your SteamVac® cleaner. DO NOT USE THIS EXTRACTOR ON HARD FLOORS UNLESS YOU HAVE THE PROPER HARD FLOOR ATTACHMENT.
Move speed selector to remove Dirty Water Tank. Remove...
Product Manual - Page 13
... Cleaning Tool for extra scrubbing action on the floor. E Remove hose from nozzle before cleaning. F
4.4 Replace panel with converter (F). Slide converter halfway down firmly to ensure that the Dirty Water Tank lid is properly secured before storage
C
How to remove hose and solution tube. For full suction, it is important that
it rests on small...
Product Manual - Page 14
... before using tool (Available on select models only)
! Agitator brushes will flow to help prevent streaking.
IMPORTANT
Do not place carpet cleaner on ...cleaner. Put the tool on a hard surface or against your thumb, push forward and up to instructions on stairs. Then squeeze the trigger and begin cleaning. Cleaning carpeted stairs
(Tool available on stairs.
Attach tool to clean...
Product Manual - Page 15
... the upholstery is completely dry before using tool" section to repeat the cleaning process. Cleaning upholstery
(Tool available on select models only) 4.10 Be sure to check the cleaning code on upholstery marked "W" or "W/S". Use your HOOVER® SteamVac® carpet cleaner only on your upholstery.
If necessary, refer to "Before using the tool again.
4.10
Manufacturers tag
4.11
4.12...
Product Manual - Page 16
...by the carpet cleaner's brushes.
4.18
Actual model may be replaced before cleaning floor.
4.17 If the front panel is accidentally removed from the tank, it is completely dry. After using tool
(Available on ...Remove debris from surface until panel snaps into position making sure solution hose (N) is dry, use plastic or aluminum foil pads under legs of hose up for cleaning, it is dry.
...
Product Manual - Page 17
... other debris becomes lodged in cleaner housing. How to snap into hole.
Set tanks aside. To clean the outside of your SteamVac® carpet cleaner. Press brush assembly firmly to Remove
To prevent possible leaking, remove Clean Water Solution Tank and Dirty Water Tank.
5. Some models have a nozzle clean-out tool for easy cleaning.
! Press handle release pedal to...
Product Manual - Page 18
... trigger and push
carpet cleaner forward and back several times to be "primed" (when using the checklist below.
Allow brushes and underside of hose.
3. Do not store carpet cleaner with clean water. The addition of personal injury - TROUBLESHOOTING
If a minor problem occurs, it usually can be done by using tool). 1. WARNING !
PROBLEM
Cleaner won 't dispense. Not firmly...
Product Manual - Page 19
....)
Please do not return this product to Hoover®, Inc., Company in Glenwillow for service. Unplug the cleaner before cleaning.
• Empty Dirty Water Tank when full or when automatic shut-off engages.
• Use extra dry strokes to find the service outlet nearest you need further assistance: To speak with a customer service...
Product Manual - Page 20
... below must be used (optional if not included): 5 Brush/Dual Brush Hoover® part # 48417008. ClLeEaAnNiInNG pPrRoOdDuUCtTsS
WARNING: To reduce the risk of fire and electric shock due to internal component damage, use only Hoover® cleaning products and Hoover® hard surface attachments intended for use Hoover® brand
detergents, wipes, and spot cleaners available at
Hoover...
Similar Questions
The Brushes Are Not Spinning On My Hoover F7410-900.
it sprays cleaner and water out and sucks it up ok, just no spin on brushes.
it sprays cleaner and water out and sucks it up ok, just no spin on brushes.
(Posted by nevasouza 8 years ago)
How Do You Replace The Brush On/off Switch On Hoover Uh70086?
(Posted by wfburditt 8 years ago)
Replacing Hose
i have a hoover steam vac F5837-900 model and the hose cracked by the end inside the unit.. How can ...
i have a hoover steam vac F5837-900 model and the hose cracked by the end inside the unit.. How can ...
(Posted by mbeaulieu722 11 years ago)
How To Use Furniture Steam Cleaner
I have lost my manual can you help me. I am trying to clean a couch. thanks
I have lost my manual can you help me. I am trying to clean a couch. thanks
(Posted by vroy53 12 years ago)
Instructions For Using A Hoover Steam Vac Dual V F7220-900
(Posted by wmiles 12 years ago)