Hoover F5808 Support Question
Hoover F5808 Support Question
Find answers below for this question about Hoover F5808.Need a Hoover F5808 manual? We have 1 online manual for this item!
Question posted by leslieyaggi on April 25th, 2011
Hoover F5808 Suction Problem
My steam vac will not suction water. I have checked for debris on the brushes, and removed hair and debris as suggested. It appears that the suction isn't working at all. I have only had this for a few months. Any suggestions?
Current Answers
Related Hoover F5808 Manual Pages
Manual - Page 1
Owner's
Manual
™
ENGLISH § pp. 1-16
ESPAÑOL § pág. 17-25
The Easy to Use
FRANÇAIS § p. 26-34
Carpet Cleaner with attached tools
®
Review this manual before operating carpet cleaner
SteamVac™ Carpet Cleaner cleans carpet fibers by applying, scrubbing and removing hot tap water and cleaning solution.
www.hoover.com
Manual - Page 2
...a Hoover Sales & Service Center or Authorized Hoover Warranty Service Dealer.
• Close supervision is necessary when any object into openings. Do not allow carpet cleaner to be plugged into water,...or pets.
• Use only commercially available floor cleaners intended for electrical current to reduce the risk of dust, lint, hair, and anything that is absolutely necessary, use without ...
Manual - Page 3
...& accessories mail order form 35
1. Assembly
Carton contents
1-1
Carpet Upholstery
Cleaner
Carpet Upholstery
Cleaner
Bare floor cleaner
PreCleaner
Carpet Upholstery
Cleaner
Bare floor cleaner
Carpet Upholstery
Cleaner
PreCleaner
Bare floor cleaner
PreCleaner
C
Carpet Upholstery
Cleaner
Bare floor cleaner
PreCleaner
D
© 2007 Hoover, Inc. Nozzle clean-out tool* H. Fill in and Save...
Manual - Page 4
...If bolts will look like this model. Only two nuts are completely together, squeeze trigger (C) on back of carpet cleaner, push upper handle down .
4
Place nuts in recessed areas on upper handle to snap trigger rod in place ....
1-5
1-6
1-7
C
Push bolts into holes on this drawing.
1-2
1-3
1-4
A B
Attach upper handle
Remove clean solution tank (upper tank) from carpet cleaner.
Manual - Page 5
...arrows, place extension (K) into bottom of converter opening, then push converter firmly against carpet cleaner until it helpful when storing the hose and nozzle to refer to the informa- Solution ... pull off bottom.
Press on rack.
3
Secure hose to rack at numbered locations as shown. To remove, first pull top of hose
H. Secure solution hose to converter as shown. Press cord into cord clip...
Manual - Page 6
... for quick and
19.
Stair/upholstery nozzle*
operating (floor) position.
7. Clean solution tank: holds for household use
Carpet cleaner description
2-1
1
2
3
4
5
7 6
10
8
9
5
7
11
13 4
14 17
18
1. on pedal... on top of tab (M) as shown. 1-16
L
N
B A
L
M
Place brushes of nozzle on data plate
solution. Gently push the nozzle downward while pivoting it into the...
Manual - Page 7
...Check clean solution tank also; it may also be noticeably reduced). The tanks
Clean solution tank (upper tank)
The clean solution tank holds the cleaning solution that time the yellow float disk will become noticeably higher in pitch. How to fill
Disconnect carpet cleaner...lower handle to remove cap. When this happens turn carpet cleaner off the carpet cleaner suction (suction will be lifted...
Manual - Page 8
...of contact with eyes, flush with your SteamVac™ carpet cleaner.
*Available at additional cost if not included with cold water for proper performance and to serve as shown. If rubber ring...traffic areas: Pre-treat with hot tap water.
Fill tank to snap tank into tank.
Rotate cap clockwise until it with water. NOTE: Use only HOOVER detergents. Cap must be locked in ...
Manual - Page 9
...emptied.
For full suction, it is properly secured before placing tank on cleaner. Rotate latches (E) (one on each side of tank).
If cleaning stairs or upholstery, remove hose by pressing ...13. Position the front of tank lid and remove lid.
Pour dirty water out from electrical outlet.
To prevent possible leaking, remove clean solution tank (Fig. 2-6) by reversing ...
Manual - Page 10
.... Use your SteamVac™ carpet cleaner.
Wait ten minutes and check for best results. Pin up water with an agitator for color removal or bleed with white paper towels or cloth. Do not use a vacuum cleaner with your HOOVER SteamVac™ carpet cleaner only if the upholstery fabric is dry.
Repeat until debris is completely dry. per 1 gallon...
Manual - Page 11
...or bare floors. Picking up spills
Your HOOVER SteamVac™ carpet cleaner may also be treated by following the...cleaner forward (equals one area. Do not use only the floor nozzle with more dry strokes. (Continue using dry strokes until little water... to remove clean solution tank. Repeat with dry strokes.
Step on end of nozzle (B).
Always end with spray and suction. When...
Manual - Page 12
...there is firmly in suction (see "Automatic shut-off", page 7). Remove hose from attachment. Replace panel with your SteamVac™ carpet cleaner. Slide converter halfway ...SteamVac™ carpet cleaner on pages 7 and 8. Fill clean solution tank with HOOVER Hard Floor Cleaning Solution (available at additional cost if not included with converter (D). Remove attachment from electrical...
Manual - Page 13
... solution tube connector onto
round projection inside of water. Rotate lid down firmly to connector end of tank. Reverse procedure to upright
position. H
1. Occasionally, debris may become lodged inside door. Press the trigger.
6. For full suction, it is important that it securely. Raise carpet cleaner handle to remove hose and solution tube.
Drain hose by...
Manual - Page 14
...the tool one inch above .
Attach tool to remove more moisture. 8. Do not place carpet cleaner on .
3-19
6. Dry hands and plug carpet cleaner into a properly grounded outlet. 5. Pull tool...8. 3. overlap each pass. 14
Make no more dry strokes to check the cleaning code on your HOOVER SteamVac™ carpet cleaner only on upholstery marked "W" or "W/S". 1. It is completely dry ...
Manual - Page 15
... solved quite easily when the cause is securely fastened
at www.hoover.com
Please do not send your cleaner by the complete model number when requesting information or ordering parts. (The model number appears on connector by :
• checking the Yellow Pages under Vacuum Cleaners - Problem: Machine won 't connect
Possible cause Possible solution
• Connector collar...
Manual - Page 16
... paid one of parts only.
Mon-Fri 8am-7pm EST. In Canada, contact Hoover Canada, Carson Building, 100 Carson St., Etobicoke, Ontario M8W 3R9. Appliances purchased ...warranted in normal household use in the country or territory in a commercial or rental application. Hoover Authorized Warranty Service Dealers (Depots). For an automated referral of warranty service outlets, phone ...
Manual - Page 35
... Cleaner - 32 oz. 16 oz. residents only. u Visa u MasterCard u Discover
Number Exp.
Floor-to U.S. Mail orders limited to -Floor™ Hard Floor Cleaning Solution - 32 oz. Hoover,...Area Code
¢
Name
Street
City
State__________ Zip
PAYMENT METHOD:
u Check or Money Order made payable to :
Hoover, Inc.
®
7005 Cochran Road
Glenwillow, OH 44139
Attn:...
Similar Questions
Hoover F5808 Spray Problem
doesnt spray solution evenly, instead shoots in a heavy stream.
doesnt spray solution evenly, instead shoots in a heavy stream.
(Posted by kmob46 9 years ago)
My Hoover Steam Vac Sucks Up But Wont Dispense To The Dirty Water Tank
(Posted by mdp913 9 years ago)
Pump On My Hoover Steam Vac Quit Working. How Do I Trouble Shoot The Problem?
I was using my steam vac to suck water on the basement floor when our sump pump stopped working. I r...
I was using my steam vac to suck water on the basement floor when our sump pump stopped working. I r...
(Posted by crazymama1227 10 years ago)
Hoover Steam Vac #6207-900-how Do I Change The Belt To The Brushes
how to change the belt that drives the brushes on hoover steam vac #6207-900
how to change the belt that drives the brushes on hoover steam vac #6207-900
(Posted by matflip93 12 years ago)